PPPonnusamy Prem

Ponnusamy Prem

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ponnusamy Prem has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A 7L and 11L High Step-Up SCMLI Topology With Reduced Component Voltage Stress

    by Jagabar Sathik Mohamed Ali, Amjad Rehman Khan, Gopinath Narayanan Pandurangan, Prem Ponnusamy, Faten S. Alamri, Saeed Ali Bahaj

    This article proposes a new capacitor-based multilevel inverter topology (CBMLI) with fewer devices and reduced voltage stress on capacitors and switches. In addition, the proposed topology can be configured as either a 7-level (7L) or 11L circuit with a maximum voltage gain of 3 and 2.5 times, respectively. Comparisons are made between the proposed topology and existing recent CBMLI topologies, and various power loss analyses are presented. The capacitance values are determined by selecting the maximum discharging period, and the associated analysis is presented. Using the simulation software MATLAB/Simulink, the performance of the proposed circuit topology is validated, and the same is tested in the hardware setup. The various dynamic performance characteristics, such as loading changes, input variations, and modulation index, are validated, and the resulting data is discussed.


  • Open Access

    High Step-Up Thirteen Level Switched-Capacitor Inverter Topology for HFAC Power System

    by Badr Saleh A. Algadair, Mahmoud F. Elmorshedy, Jagabar Sathik Mohamed Ali, Dhafer Almakhles, Ponnusamy Prem

    This article proposes two new high-frequency, thirteen-level switched capacitor inverter topologies. Compared with the counterpart existing topologies, which were recently published, the switch count, capacitor voltage, and voltage stress on the switch are reduced. In addition, the proposed topologies have inherited merits such as six-time voltage boosting levels and self-balanced capacitor voltages as well. The capacitor ripple voltages and the proposed topology performance are analyzed. The prototype setup is developed for 500W, and the results are verified. The maximum efficiency is approximately equal to 97.5% for simulation. Furthermore, it is approximately equal to 96.1% for experimental, and both are measured at an output power of 500 W. Finally, the characteristics of the proposed topologies are tested under several scenarios, such as modulation index variations and load changes, and the findings are reported.

  • Open Access

    A New Multilevel Inverter Topology with Reduced DC Sources

    by Muhyaddin Rawa, Prem P, Jagabar Sathik Mohamed Ali, Marif Daula Siddique, Saad Mekhilef, Addy Wahyudie, Mehdi Seyedmahmoudian, Alex Stojcevski

    The component count for the multilevel inverter has been a research topic for the last few decades. The higher number of power semiconductor devices and sources leads to a higher power loss with the complex control requirement. A new multilevel inverter topology employing the concept of half-Bridge modules is suggested in this paper. It requires a lower number of dc sources and power components. The inverter is controlled using a fundamental frequency switching scheme. With the basic unit being able to produce 13 level voltage waveforms with three dc voltage sources, higher-level inverter configuration has also been discussed in the paper. The performance of the topology is analyzed in the aspects of circuit parameters and found better when compared to similar topologies proposed in recent literature. The comparison provided in the paper set the benchmark of the proposed topology in terms of lower component requirements. The topology is also optimized with two voltage fixing algorithms for maximizing the number of levels for the given number of IGBTs, drivers and dc sources, and the observations are presented. The efficiency analysis gives the peak efficiency as 98.5%. The simulations were carried out using the PLECS software tool and validated using a prototype rated at 500 W. The results with several test conditions have been reported and discussed in the paper.


  • Design of nine step switched capacitor multilevel inverter and its cascaded extension

    by Suresh Velliangiri, Senthilkumar Ramasamy, Prem Ponnusamy, Jagabar Sathik M

    Summary: Conventionally, multilevel inverter topologies require components like boost converter, voltage balancing circuits in addition to its switches and gate driver circuitry resulting in increased complexity. A new multilevel inverter topology using the concept of switched‐capacitor (SC) is proposed in this article. The basic structure capable of generating 9 level (9L) output voltage waveform with magnitude twice the input voltage at its terminals is proposed. Further, two identical structures are cascaded horizontally to attain 17 level (17L) based on structural modification is suggested. Simulation results are used to analyze the performance of the proposed 9L‐SCMLI and 17L‐SCMLI in the aspects of total harmonic distortion, R, RL, and dynamic loading conditions. The 9L‐SCMLI prototype model is developed to validate the adaptability of the proposed system.


  • Wide Band Gap semiconductor material for electric vehicle charger

    by J.S. Sakthi Suriya Raj, P. Sivaraman, P. Prem, A. Matheswaran


  • Performance improvement of solar PV power conversion system through low duty cycle DC‐DC converter

    by Matheswaran Alagu, Prem Ponnusamy, Sivaraman Pandarinathan, Jagabar Sathik Mohamed Ali

    Characteristics like reliability and modularity of solar photovoltaic (SPV) units makes them one of the apt options for generating electric power. However, the input intermittency is their major lacuna, and power electronic circuits are being used to nullify this effect. A solar photovoltaic power conversion process includes a DC‐DC converter in the plant side to deliver a fixed DC voltage and a DC‐AC converter in the grid side for converting DC voltage in to grid compatible AC voltage. The high duty ratio of typical DC‐DC boost converters limits the switching frequency and efficiency. In this article, a way to enhance the performance of a SPV unit using an improved quadratic boost converter (IQBC) is analysed. It can deliver a higher output voltage at lower duty ratio with Perturb and Observe (P&O) algorithm‐based Maximum Power Point Tracking (MPPT). A 250 W prototype of IQBC‐based Solar PV power conversion system (SPVPCS) is developed, and its performance is compared against conventional and quadratic boost converters and found that the IQBC‐based solar power conversion system is efficient and the results are presented.


  • Open Access

    Fast charging converter and control algorithm for solar PV battery and electrical grid integrated electric vehicle charging station

    by P. Prem, P. Sivaraman, J. S. Sakthi Suriya Raj, M. Jagabar Sathik, Dhafer Almakhles

    Electric Vehicles (EV) offer eco-friendly transportation, but the growth of the electric vehicle market year over year is very minimal due to insufficient EV charging stations, slow charging time and grid instability during peak hours. This paper proposes a high gain, fast charging DC–DC converter and a control algorithm for grid integrated Solar PV based Electric Vehicle Charging Station (SPV-EVCS) with battery backup. The proposed converter and its control algorithm’s performance are investigated in three different modes using MATLAB/Simulink tool and the simulated results are validated with Real-Time Digital Simulation (RTDS) in OPAL-RT. The observed results meet the Power Quality limits of an IEC61000-3-2 standard and met the level-4 dc charging standard IEC61851.


  • A Hybrid Switched Capacitor Multi-Level Inverter with High Voltage Gain and Self-Voltage Balancing Ability

    by Prem Ponnusamy, Suresh Velliangiri, Jagabar Sathik Mohamed Ali

    —A hybrid switched capacitor multi-level inverter topology is proposed in this paper. The topology has a basic unit and an extendable “n” module. The number of levels synthesized and the voltage gain delivered is based on number of such “n” modules connected in series. For “k” number of “n” modules, 4k + 9 levels can be obtained in the terminal voltage with a voltage boost of 1:(k + 2). Also, the topology has self-balancing ability which is mathematically validated. A 13-level prototype of hybrid switched capacitor multi-level inverter (HSC-MLI) is developed and its performance is analyzed in simulation and experimental environments. The HSC-MLI is compared with recent switched capacitor multi-level inverter topologies in the aspects like number of capacitors, number of diodes, number of drivers, number of levels synthesized and voltage gain and the results are presented. The simulations are done in MATLAB environment and the experimental prototype is fabricated using IGBTs 1HW15N120E1.


  • A novel cross-connected multilevel inverter topology for higher number of voltage levels with reduced switch count

    by Ponnusamy Prem, Vidyasagar Sugavanam, Ahamed Ibrahim Abubakar, Jagabar Sathik Mohamed Ali, Boopathi C Sengodan, Vijayakumar Krishnasamy, Sanjeevikumar Padmanaban


  • A new asymmetric dual source multilevel inverter topology with reduced power switches

    by Prem P., Jagabar Sathik, Sivaraman P., Mathewsaran A., Shady H. E. Abdel Aleem

    Multilevel inverters can synthesize a high-voltage staircase waveform with low- and medium-voltage components. A new multilevel inverter topology called Asymmetric Dual Source Multilevel Inverter (ADS-MLI) is proposed. When compared to the topologies found in the literature, it can produce multiple levels in the output voltage with fewer power switches. Most of the topologies found in the literature require cascading features to achieve asymmetric operation; but the ADS-MLI can operate without the need for cascading. A simulation prototype capable of synthesizing 13 levels is developed in MATLAB Simulink environment. Its performance is evaluated in the aspects of; number of switching components, efficiency, THD, switching voltage stress and common mode voltage. The simulated efficiency and power quality of the DS-MLI is validated using a 1 kW prototype fabricated using FGA25N120-ANTD controlled by FPGA-SPARTAN 6 processor. Further, the DS-MLI is field tested with a 1 kW solar PV unit and the results are presented.