Mohammad Javad Ezadi Yazdi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mohammad Javad Ezadi Yazdi has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Abdolamir Bak Khoshnevis
Department of Mechanical Engineering, Hakim Sabzevari University, Sabzevar, Iran
2 shared publications Abdulamir Bak Khoshnevis
Hakim Sabzevari University
2 shared publicationsAli Safavi Rad
Islamic Azad University South Tehran Branch
1 shared publication
Latest Publications
- Open Access
- 30 April 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (5) , 1-13
Comparing the wake behind circular and elliptical cylinders in a uniform current
- 30 April 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (5) , 1-13
Open AccessComparing the wake behind circular and elliptical cylinders in a uniform current
- 6 May 2019
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 134 (5) , 189
Features of the flow over a rotating circular cylinder at different spin ratios and Reynolds numbers: Experimental and numerical study
- 6 May 2019
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 134 (5) , 189
Features of the flow over a rotating circular cylinder at different spin ratios and Reynolds numbers: Experimental and numerical study
- 20 December 2018
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 133 (12) , 533
Experimental study of the flow across an elliptic cylinder at subcritical Reynolds number
- 20 December 2018
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 133 (12) , 533
Experimental study of the flow across an elliptic cylinder at subcritical Reynolds number
- 1 January 2018
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 19 (7) , 529-552
Wake-boundary layer interaction behind an elliptic cylinder at different Reynolds numbers
In this paper, hot-wire anemometry (HWA) is used to experimentally investigate interactions between a fully developed turbulent boundary layer and wake of an elliptic cylinder where axis ratio (AR) of the cylinder is 2. The elliptic cylinder was located inside and outside a turbulent boundary layer with a thickness () of 0.38B. Furthermore, experiments were conducted at different Reynolds numbers (13,250 and 26,500) based upon the smallest cylinder diameter (B). Mean velocity, turbulence intensity and higher-order central moments of velocity signals (i.e. skewness and flatness) measurements were performed using HWA upon wake-boundary layer interactions on a flat plate. Results showed that profiles of stream-wise mean velocity and turbulence intensity were greatly dependent on gap ratio (G/B) and Reynolds number (Re) in near-wake region. It was also observed that, except for G/B= 0.1, the wake-boundary layer interactions were faster at Reynolds number of 26,500 rather than 13,250. The interactions occurred earlier upon fluctuating the velocity rather than the case where a fixed mean velocity was considered. The results further show that an increase in the gap ratio increases Strouhal number almost independent of /B. Behind the cylinder, relatively smaller wake region was obtained at Re= 26,500 rather than Re= 13,250, where the velocity profiles quickly converged to the flat plate boundary layer velocity profiles.
- 1 January 2018
- Published by Taylor & Francis in Journal of Turbulence
- Vol. 19 (7) , 529-552
Wake-boundary layer interaction behind an elliptic cylinder at different Reynolds numbers
In this paper, hot-wire anemometry (HWA) is used to experimentally investigate interactions between a fully developed turbulent boundary layer and wake of an elliptic cylinder where axis ratio (AR) of the cylinder is 2. The elliptic cylinder was located inside and outside a turbulent boundary layer with a thickness () of 0.38B. Furthermore, experiments were conducted at different Reynolds numbers (13,250 and 26,500) based upon the smallest cylinder diameter (B). Mean velocity, turbulence intensity and higher-order central moments of velocity signals (i.e. skewness and flatness) measurements were performed using HWA upon wake-boundary layer interactions on a flat plate. Results showed that profiles of stream-wise mean velocity and turbulence intensity were greatly dependent on gap ratio (G/B) and Reynolds number (Re) in near-wake region. It was also observed that, except for G/B= 0.1, the wake-boundary layer interactions were faster at Reynolds number of 26,500 rather than 13,250. The interactions occurred earlier upon fluctuating the velocity rather than the case where a fixed mean velocity was considered. The results further show that an increase in the gap ratio increases Strouhal number almost independent of /B. Behind the cylinder, relatively smaller wake region was obtained at Re= 26,500 rather than Re= 13,250, where the velocity profiles quickly converged to the flat plate boundary layer velocity profiles.