Luca Medici
Research Subjects
Luca Medici has a total of 123 co-authors. Here are the top co-authors by number of shared publications:
- Maria Franca Brigatti
Department of Chemical and Geological Sciences, University of Modena and Reggio Emilia, Via Campi 103, I-41125 Modena, Italy
23 shared publications - Daniele Malferrari
Department of Chemical and Geological Sciences, University of Modena and Reggio Emilia, Modena, Italy
15 shared publications Luciano Poppi
12 shared publications- Roberto Terzano
Department of Soil, Plant and Food Sciences, University of Bari “Aldo Moro”, Via Amendola 165/a, 70126 Bari, Italy
8 shared publications - Matteo Spagnuolo
Department of Soil, Plant and Food Sciences, University of Bari “Aldo Moro”, Via Giovanni Amendola 165/A, 70126 Bari, Italy
6 shared publications - Annalisa Ferretti
Department of Chemical and Geological Sciences, University of Modena and Reggio Emilia, Via Campi 103, I-41125 Modena, Italy
5 shared publications
Latest Publications
- Open Access
Nanostructured Thermoelectric PbTe Thin Films with Ag Addition Deposited by Femtosecond Pulsed Laser Ablation
Pulsed laser deposition operated by an ultra-short laser beam was used to grow in a vacuum and at room temperature natively nanostructured thin films of lead telluride (PbTe) for thermoelectric applications. Different percentages of silver (Ag), from 0.5 to 20% of nominal concentration, were added to PbTe deposited on polished technical alumina substrates using a multi-target system. The surface morphology and chemical composition were analyzed by Scanning Electron Microscope and X-ray Photoelectron Spectroscopy, whereas the structural characteristics were investigated by X-ray Diffraction. Electrical resistivity as a function of the sample temperature was measured by the four-point probe method by highlighting a typical semiconducting behavior, apart from the sample with the maximum Ag concentration acting as a degenerate semiconductor, whereas the Seebeck coefficient measurements indicate n-type doping for all the samples. The power factor values (up to 14.9 µW cm−1 K−2 at 540 K for the nominal 10% Ag concentration sample) are competitive for low-power applications on flexible substrates, also presuming the achievement of a large reduction in the thermal conductivity thanks to the native nanostructuring.
Open AccessNanostructured Thermoelectric PbTe Thin Films with Ag Addition Deposited by Femtosecond Pulsed Laser Ablation
Pulsed laser deposition operated by an ultra-short laser beam was used to grow in a vacuum and at room temperature natively nanostructured thin films of lead telluride (PbTe) for thermoelectric applications. Different percentages of silver (Ag), from 0.5 to 20% of nominal concentration, were added to PbTe deposited on polished technical alumina substrates using a multi-target system. The surface morphology and chemical composition were analyzed by Scanning Electron Microscope and X-ray Photoelectron Spectroscopy, whereas the structural characteristics were investigated by X-ray Diffraction. Electrical resistivity as a function of the sample temperature was measured by the four-point probe method by highlighting a typical semiconducting behavior, apart from the sample with the maximum Ag concentration acting as a degenerate semiconductor, whereas the Seebeck coefficient measurements indicate n-type doping for all the samples. The power factor values (up to 14.9 µW cm−1 K−2 at 540 K for the nominal 10% Ag concentration sample) are competitive for low-power applications on flexible substrates, also presuming the achievement of a large reduction in the thermal conductivity thanks to the native nanostructuring.
- 1 October 2021
- Published by Elsevier in Palaeogeography, Palaeoclimatology, Palaeoecology
- Vol. 579
Dead, fossil or alive: Bioapatite diagenesis and fossilization
- 1 October 2021
- Published by Elsevier in Palaeogeography, Palaeoclimatology, Palaeoecology
- Vol. 579
Dead, fossil or alive: Bioapatite diagenesis and fossilization
- 7 January 2021
- Published by Springer Nature in Journal of Earth Science
- Vol. 32 (3) , 501-511
Zooming in REE and Other Trace Elements on Conodonts: Does Taxonomy Guide Diagenesis?
- 7 January 2021
- Published by Springer Nature in Journal of Earth Science
- Vol. 32 (3) , 501-511
Zooming in REE and Other Trace Elements on Conodonts: Does Taxonomy Guide Diagenesis?
- 1 December 2020
- Published by Scandinavian University Press in Lethaia
- Vol. 54 (3) , 300-313
ʻConodont pearlsʼ do not belong to conodonts
We investigated the mineralogical and chemical signatures of enigmatic microspherules commonly recovered in conodont residues and referred to in literature as ‘conodont pearls.’ Comparison between these ‘pearls,’ associated conodonts and other phosphatic skeletal elements present in the same stratigraphical level was run in an effort to reveal any possible relation between ‘conodont pearls’ and the joined groups so to finally provide a response on the affinity of these spherules.
- 1 December 2020
- Published by Scandinavian University Press in Lethaia
- Vol. 54 (3) , 300-313
ʻConodont pearlsʼ do not belong to conodonts
We investigated the mineralogical and chemical signatures of enigmatic microspherules commonly recovered in conodont residues and referred to in literature as ‘conodont pearls.’ Comparison between these ‘pearls,’ associated conodonts and other phosphatic skeletal elements present in the same stratigraphical level was run in an effort to reveal any possible relation between ‘conodont pearls’ and the joined groups so to finally provide a response on the affinity of these spherules.
- Open Access
- 1 January 2018
- Published by Earth Science Dept, University of Florence
- p. 41-43
How did vertebrates sharpen their teeth? A new perspective in bioapatite analysis
Online Open access Research in Palaeontology
- 1 January 2018
- Published by Earth Science Dept, University of Florence
- p. 41-43
Open AccessHow did vertebrates sharpen their teeth? A new perspective in bioapatite analysis
Online Open access Research in Palaeontology
- 1 June 2016
- Published by Elsevier in Applied Surface Science
- Vol. 374, 397-402
Plasmonic angular tunability of gold nanoparticles generated by fs laser ablation
- 1 June 2016
- Published by Elsevier in Applied Surface Science
- Vol. 374, 397-402
Plasmonic angular tunability of gold nanoparticles generated by fs laser ablation
- 1 May 2015
- Published by Elsevier in Applied Surface Science
- Vol. 336, 283-289
Nano-crystalline Ag–PbTe thermoelectric thin films by a multi-target PLD system
- 1 May 2015
- Published by Elsevier in Applied Surface Science
- Vol. 336, 283-289
Nano-crystalline Ag–PbTe thermoelectric thin films by a multi-target PLD system
- 20 June 2014
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 43 (1) , 133-140
Facile Zeolite Synthesis from Municipal Glass and Aluminum Solid Wastes
A clean and cheap procedure for the synthesis of zeolites is presented, using glass and aluminum wastes as starting materials. The products are aluminosilicate materials with a high cation exchange capacity (CEC: 259–389.5 meq/100 g) containing 25–30% of crystalline zeolites. Since the synthesized materials are free of potentially toxic elements, they could be safely used for environmental and agricultural applications. More specifically, a material containing 30% of zeolite A has been synthesized at 60°C in one week, using NaOH as mineralizing agent. About 15% of zeolite A has been obtained at room temperature in six months. When KOH was employed, 25% of edingtonite has been produced in the final material after one week at 90°C. All the materials have been characterized for crystallinity, crystal morphology, particle size, pore size, surface area, and CEC. The whole process has been designed with the aim to recycle useful waste materials and reduce at minimum energy consumption and the production of harmful greenhouse gases.
- 20 June 2014
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 43 (1) , 133-140
Facile Zeolite Synthesis from Municipal Glass and Aluminum Solid Wastes
A clean and cheap procedure for the synthesis of zeolites is presented, using glass and aluminum wastes as starting materials. The products are aluminosilicate materials with a high cation exchange capacity (CEC: 259–389.5 meq/100 g) containing 25–30% of crystalline zeolites. Since the synthesized materials are free of potentially toxic elements, they could be safely used for environmental and agricultural applications. More specifically, a material containing 30% of zeolite A has been synthesized at 60°C in one week, using NaOH as mineralizing agent. About 15% of zeolite A has been obtained at room temperature in six months. When KOH was employed, 25% of edingtonite has been produced in the final material after one week at 90°C. All the materials have been characterized for crystallinity, crystal morphology, particle size, pore size, surface area, and CEC. The whole process has been designed with the aim to recycle useful waste materials and reduce at minimum energy consumption and the production of harmful greenhouse gases.
- 30 May 2014
- Published by Springer Nature in Applied Physics A
- Vol. 117 (1) , 401-407
Fs-pulsed laser deposition of PbTe and PbTe/Ag thermoelectric thin films
- 30 May 2014
- Published by Springer Nature in Applied Physics A
- Vol. 117 (1) , 401-407
Fs-pulsed laser deposition of PbTe and PbTe/Ag thermoelectric thin films