JVJorge Ruben Vega

Jorge Ruben Vega

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jorge Ruben Vega has a total of 123 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Recurrent Autoencoder for Fault Detection in a Polymerization Reactor Train

    by Mariano M. Perdomo, Luis A. Clementi, Jorge R. Vega

    A fault detection system based on a recurrent autoencoder is proposed, suitable for continuous processes with complex nonlinear dynamics. The system consists of three modules: 1) a recurrent autoencoder; 2) a fault state detection module; and 3) an interpretation module. The training strategy only requires process data obtained under normal operating conditions. The fault detection module analyzes the total reconstruction error of the measured variables obtained by the recurrent autoencoder. The interpretability module examines the reconstruction errors of the individual variables and highlights variables potentially responsible for the detected anomaly. The developed system is applied to a computationally simulated Styrene‐Butadiene rubber latex production process. The latex is synthesized in a train of continuous stirred tank reactors that may be affected by various types of faults. Simulation results show a satisfactory performance of the proposed fault detection system. Failures whose data patterns differ significantly from those of normal operation are effectively detected. In contrast, some subtle faults only cause minor deviations in the data patterns and are therefore difficult to detect rapidly, leading to delays in detection. In most cases, the interpretability module can correctly identify the variable more strongly associated with the detected fault.

  • An Adaptive Soft Sensor for On‐Line Monitoring the Mass Conversion in the Emulsion Copolymerization of the Continuous SBR Process

    by Carlos I. Sanseverinatti, Mariano M. Perdomo, Luis A. Clementi, Jorge R. Vega

    Soft sensors (SS) are of importance in monitoring polymerization processes because numerous production and quality variables cannot be measured online. Adaptive SSs are of interest to maintain accurate estimations under disturbances and changes in operating points. This study proposes an adaptive SS to online estimate the mass conversion in the emulsion copolymerization required for the production of Styrene‐Butadiene rubber (SBR). The SS includes a bias term calculated from sporadic laboratory measurements. Typically, the bias is updated every time a new laboratory report becomes available, but this strategy leads to unnecessarily frequent bias updates. The SS includes a statistic‐based tool to avoid unnecessary bias updates and reduce the variability of the bias with respect to classical approaches. A control chart (CC) for individual determinations combined with an algorithmic Cusum is used to monitor the statistical stability of the average prediction error. The adaptive SS enables a bias update only when a loss of said statistical stability is detected. Several bias update methods are tested on a simulated industrial train of reactors for the latex production in the SBR process. The best results are obtained by combining the proposed CC‐based approach with a previously developed Bayesian bias update strategy.


  • Open Access

    Impacto de los Vehículos Eléctricos sobre la Red de Distribución. Análisis bajo distintos modos de operación

    by Mariano Miguel Perdomo, Ulises Manassero, Jorge Ruben Vega

    La movilidad eléctrica es una alternativa sustentable que permite disminuir el consumo energético y la emisión de gases contaminantes con respecto a la movilidad convencional. Existen proyecciones que predicen un aumento del uso de vehículos eléctricos. Con esto se crean diversas líneas de estudio relacionadas a inferencias sobre las características de la integración de esta nueva demanda y sobre los efectos que generará en los sistemas eléctricos. Entonces, en el presente trabajo se proponen como principales objetivos: (i) determinar el impacto en la red de una inserción moderada de puntos de recarga públicos; (ii) evaluar el nivel de penetración de EVs de usuarios residenciales para modos de carga (G2V) domiciliaria lenta y semirrápida, según restricciones de variables de operación de la red; y (iii) proponer estrategias de gestión de la recarga controlada y la función dual de carga y aporte de energía a la red de los EVs a través de sus baterías de almacenamiento (V2G). Los resultados obtenidos muestran que la incorporación moderada de puntos de recarga públicos no afecta significativamente la operatividad de la red. Además, se muestra que la recarga controlada de los vehículos eléctricos logra disminuir los impactos negativos en el sistema eléctrico bajo estudio permitiendo mayores niveles de inserción y/o retrasando inversiones en infraestructura eléctrica. Un modo de operación con aporte de energía desde los vehículos eléctricos hacia la red permitiría desplazar generación de punta caracterizada por sus altos niveles de contaminación. Aun así, este modo de operación torna al sistema más susceptible a operar dentro de rangos inadmisibles.

  • Optimal Segmentation of Electrical Distribution Networks

    by Carlos Bonetti, Jezabel Bianchotti, Jorge Vega, Gabriel Puccini

    New ways of generating electricity make possible decentralization of energy sources. This scenario of distributed generation allows efficient management of smaller electricity networks, so called microgrids. Additional advantages include a large reliability and the capability to provide a high quality of service. A strategy to design these microgrids consists on taking advantage of existing distribution network by sectoring the system into a set of microgrids with optimal autonomy. This paper presents a one-step methodology for the optimal design of microgrids based on the virtual segmentation of a distribution system. The proposed method focuses on the optimal allocation and sizing of the distributed generation together with the determination of the virtual cut-set lines to form an optimized set of microgrids. The design methodology was implemented on IEEE 119-bus system, and was also applied to Bella Italia distribution system, a real network located in Santa Fe province, Argentina.


  • A Double-Auction Mechanism for Distribution of Electrical Supply Capacities among Enterprises of an Industrial Park

    by Ariel Mariano Rocchi, Érica Soledad Fernández, Jorge Ruben Vega

    Typically, an industry contracts a given electrical supply capacity to the energy distribution company for a relatively long time period. Such kind of contract is often expensive for the industry, because large supply capacities must be considered in order to avoid penalty fees due to an eventually high peak power demand that could occur even along a short time period. This paper proposes a dynamic strategy for simultaneously assigning the price and the fraction of power supply capacity to every industry located in an industrial park. The assignment strategy aims at reaching a joint benefit for all the involved enterprises (i.e., the industries and the energy distribution company). The proposed procedure involves 3 sequential algorithms. The strategy for supply capacity re-assignment is based on a double-auction mechanism, which can be applied at time periods of arbitrary duration. The proposal is evaluated on the basis of two synthetic examples that involve different number of industries and electric power consumptions.


  • Open Access

    Voltage dip diagnosis in electrical distribution systems using extreme learning machines: an empirical evaluation

    by Emiliano Reynares, Emmanuel Sangoi, Jorge Vega, María Laura Caliusco, María Rosa Galli

    An inefficient operation of the utility grid can be inferred from low power quality indexes. Under such conditions, reductions in the useful life of equipments and loads, grid instabilities, service interruptions and breakdowns can be expected, which would produce meaningful economic losses for the end-users as well as for the power supply company. In this context, it is useful to have a diagnosis tool able to identify the underlying cause of a given disturbance. This article proposes a one-step extreme learning machine-based method for the diagnosis of voltage dips detected on an electrical distribution grid. The proposed method was evaluated on the basis of synthetic data generated by the simulation of a real power grid. The performance of 10 hyperparameter combinations on the diagnosis of 20 different classes of voltage dips was assessed through two different strategies, i.e.: 1) a one-for-all approach, with a common classifier for all disturbance classes; and 2) a one-against-all approach, with a classifier per disturbance class. It was proven that strategy 2) has a better generalization ability and lower training and testing times. The obtained results suggest the potential of the proposed approach for power quality disturbance diagnosis, and open the challenge of formulating further hypotheses to be assessed.


  • A Closed‐Loop Control Strategy for Producing Nitrile Rubber of Uniform Chemical Composition in a Semibatch Reactor: A Simulation Study

    by Luis A. Clementi, Romina B. Suvire, Francisco G. Rossomando, Jorge R. Vega

    To improve the quality of industrial nitrile rubbers, the copolymer chemical composition, pA(t), should ideally be kept constant along the reaction. This work proposes a closed‐loop control strategy for the semibatch operation of the reactor with the aim of regulating pA(t) within a reduced range of variability. The proposed strategy is evaluated by simulating a mathematical model of the process. To this effect, a simplified mathematical model of the reaction is first derived and then utilized to obtain a suboptimal control law and a soft‐sensor that estimates the polymerization rates. The suboptimal control law is compensated by adding a term proportional to errors in pA(t). The simulated example considers the production of the low‐composition AJLT grade, with the copolymerization reaction represented by a detailed mathematical model adjusted to an industrial plant. Due to the high performance of the soft‐sensor, the simulation results suggest that the proposed closed‐loop strategy is efficient to adequately regulate pA(t) in spite of structural and parametric uncertainties, while other quality variables remained practically unaffected.


  • Grid parity analysis for low power photovoltaic systems in santa fe (Argentina)

    by Emmanuel Sangoi, Jorge R. Vega, Mauricio E. Samper

    In this work, an analysis of grid parity for residential and commercial photovoltaic generators in an important city of Argentina is presented. The analysis includes installation costs, levelized costs of photovoltaic energy, grid electricity price and incentive programs that promote the insertions of those generators in low demand users. A specific analysis on the economic viability of low power photovoltaic systems is conducted at Santa Fe, the first city of Argentina that has implemented technical (in 2013) and economical (in 2015) regulations to promote renewable generation. Although the installation of photovoltaic distributed generation implies important energy benefits for small users, the results show that the grid parity is still a challenge for these systems. The main causes are the difficulty of small users to access soft loans as well as the subsidized price of electricity.