Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Kanagat Kazhmukhanovich Kishibayev has a total of 70 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Supercritical CO2 co-extraction of black cumin and grape seeds: oil yield, composition, and oxidative behavior

    by Rustam Tokpayev, Zair Ibraimov, Kanagat Kishibayev, Tamina Khavaza, Bauyrzhan Bukenov, Abdurakhim Sabyr, Alina Userbayeva, Amina Abdullanova, Anvar Ishkenov

  • Open Access

    Supercritical Fluid CO2 Extraction of Essential Oil from Spearmint Leaves Dried by Vacuum Drying with a Desiccant

    by Rustam Tokpayev, Zair Ibraimov, Khavaza Tamina, Bauyrzhan Bukenov, Bagashar Zhaksybay, Amina Abdullanova, Yekaterina Chshendrygina, Kanagat Kishibayev, Luca Fiori

    The essential oil (EO) of Mentha spicata L. (spearmint) exhibits pronounced biological activity, making it valuable for applications in agrochemistry as an insecticidal agent, in perfumery and cosmetics, and as a natural preservative in the food industry. However, maintaining the integrity and yield of EO during post-harvest processing and extraction remains a key technological challenge. This study aimed to enhance the vacuum-drying (VD) process of spearmint using calcium chloride as a desiccant and to optimize the conditions of supercritical CO2 extraction (SC-CO2), including EO separation and the evaluation of its solubility under dynamic extraction conditions. The incorporation of calcium chloride into the VD process reduced drying duration by 21.1% and processing costs by 31.0%, while increasing EO yield by 11%. A decrease in separator pressure from 70 to 10 bar during SC-CO2 extraction resulted in nearly a threefold increase in EO yield by minimizing the loss of volatile constituents. The solubility of spearmint EO in supercritical CO2 was successfully described by the Chrastil model and correlated with carvone solubility. The maximum total phenolic content (72.3 ± 2.2 mg gallic acid equivalent per gram) was observed at a CO2 density of 353.91 kg/m3. The solubility of EO was studied directly using the plant matrix under dynamic conditions.


  • Open Access

    Investigation and Kinetic Analysis of Rare Earth Elements Leaching: Case Study of the Weathering Crust of the Kundybay Deposit (Northern Kazakhstan)

    by Rustam Tokpayev, Tamina Khavaza, Zair Ibraimov, Bagashar Zhaksybay, Alexandra Ciorita, Kanagat Kishibayev, Elena Zlobina, Mikhail Nauryzbayev

    The study investigates the process of intensifying rare earth elements (REEs) group uncovering from the Kundybay deposit (Northern Kazakhstan). Currently, there is no interest in extracting REEs because the ore lying beneath is significantly richer in both rare elements and REEs. However, this type of raw material is a potential source of REEs. The total content of all REEs in the weathering crust is 372.7 ppm; of these, 82.6% are Sc, Y, La, Ce, and Nd, which are present in the form of complex salts and native minerals. In order to find the optimal REE group leaching mode, the influence of the L/S ratio, temperature, acid concentration in the leaching solution, leaching kinetics, and the influence of adding HF and Na2S2O5 on process efficiency were studied. The optimal conditions for REE leaching are as follows: L/S-20, T = 70 °C, t = 180 min. The maximum REE extraction yields, %: Sc-70.84; Y-90.2; La-99.8; Ce-99.24; Nd-97.98. The leaching process kinetic study results show that the process is managed by two steps. The activation energy differences for Sc, Y, La, Ce, and Nd, kJ/mol: 26.19, 23.83, 29.18, 11.15, and 15.13 allow to conclude that REEs in the Kundybay deposit weathering crust are in different forms.


  • Open Access

    Functional Activated Biocarbons Based on Biomass Waste for CO2 Capture and Heavy Metal Sorption

    by Jarosław Serafin, Kanagat Kishibayev, Rustam Tokpayev, Tamina Khavaza, Azhar Atchabarova, Zair Ibraimov, Mikhail Nauryzbayev, Joanna Sreńscek Nazzal, Liliana Giraldo, Juan Carlos Moreno-Piraján

    Inexpensive porous activated biocarbons were prepared from biomass and agriculture waste following the method of thermal and hydrothermal carbonization and activation with superheated water vapor. The activated biocarbons were characterized by nitrogen adsorption-desorption at 77 K, SEM, XRD, Raman spectrometry, FTIR spectroscopy, determination of particle size, and elemental composition by XRF. The specific surface area was in the range of 240-709 m2/g, and the total pore volume was from 0.12 to 0.43 cm3/g. The percentage of microporosity in activated biocarbons was 89-92%. These activated biocarbons have been used for CO2 and heavy metal sorption. Activated biocarbons based on pine cones and birch prepared by thermal carbonization and activation with superheated water vapor had the highest ability to capture CO2 and amounted to 6.43 and 6.00 mmol/g at 273 K, as well as 4.57 and 4.22 mmol/g at 298 K, respectively. The best activated biocarbon was characterized by unchanged stability after 30 adsorption and desorption cycles. It was proved that the adsorption of CO2 depends on narrow micropores (2+, Zn2+, Fe2+, Ni2+, Co2+, and Pb2+ ions from aqueous solutions. Activated biocarbons are effective adsorbents for the removal of lead and zinc ions from aqueous solutions.


  • Open Access

    INVESTIGATION OF THE FUNCTIONAL LAYER FORMATION ON THE SURFACE OF CARBON MATERIAL

    by Saken Abdimomyn, Azhar Atchabarova, Dinara Abduakhytova, Rustam Tokpayev, Kanagat Kishibayev, Tamina Khavaza, Andrey Kurbatov, Graziella Liana Turdean, Mikhail Nauryzbayev

    In this study, a comparison of walnut-based carbon materials (CM) obtained by hydrothermal carbonization (HTC) and HTC in combination with steam gas activation (SGA) was carried out. In order to study the effect of steam activation on the functional layer formation, the obtained materials were studied by SEM, nitrogen adsorption/desorption by Brunauer-Emmett-Teller (BET) method, Raman spectroscopy, X-ray diffraction spectroscopy (XRD), X-ray fluorescence elemental analysis (XRF). Functional groups (FG) were evaluated qualitatively and quantitatively by Fourier transform infrared spectroscopy (FTIR), acetone extract analysis of CM by gas chromatography-mass spectrometry (GC-MS), and potentiometrically Boehm titration. The described mechanism of the influence of the base nature on the surface functionality correlates well with the results of the powder addition method. The HTC or HTC+SGA treatment provides a wide range of possibilities for further controlled modification of the carbon sorbent surface for specific adsorption purposes.

  • Open Access

    Optimization of the preparation method of a mechanically strong carbon electrode

    by Saken Abdimomyn, Dinara Abduakhytova, Аzhar Atchabarova, Graziella Liana Turdean, Rustam Tokpayev, Kanagat Kishibayev, Andrey Kurbatov, Mikhail Nauryzbayev

    Nowadays, a strategy for the utilization of secondary resources to obtain valuable components is actual. It will lead to the most rational use of natural resources and environmental protection. Electrochemical methods are perfectly applicable to solve this problem. Electrochemical methods allow concentrating of the target components without preliminary preparation of the raw material. Carbon materials (CM) based on plant and carbon-mineral raw materials are an excellent option as a matrix for obtaining the electrodes, due to their availability, low cost, high specific surface area, and the presence of different functional groups. The lack of theoretical substantiation of the adsorption phenomena on carbon electrodes served as an incentive for the study and development of a method for obtaining a mechanically strong electrode based on modified carbon and polyethylene. The design and mechanical strength of carbon electrodes (CE) are of great importance for the efficiency of purification and extraction of valuable components. In this article, we obtained carbon mate- rial from walnut shells by hydrothermal carbonization with further steam-gas activation (the specific surface area is 754.0 m2/g). The structural, physicochemical characteristics of the carbon material, binder, and carrier material were studied by the following methods: scanning electron microscope (SEM), Brunauer–Emmett–Teller (BET), thermogravimetric analysis and differential scanning calorymetry (TGA-DSC). The method of hot-pressing is applied for obtaining the carbon electrodes. Using the method of full-factor experiment and steepest ascent, the values of pressure and temperature during pressing and the ratio of carbon material: binder was optimized: P = 226 atm; T = 90.8 °C; carbon material: binder ratio = 67.5:32.5 %, respectively

  • STUDY OF SORPTION OF Ni AND Cd IONS ON NEW CARBON SORBENTS FROM KAZAKHSTAN RAW MATERIALS

    by A.Zh. Yerman, Center for Physicochemical Methods of Research and Analysis at Al-Farabi KazNU, A.A. Atchabarovа, K.K. Kishibaev

    This article presents the optimal results of new sorbents for the sorption separation of nickel and cadmium ions based on waste of plant raw materials of the Republic of Kazakhstan - pine sawdust. To obtain activated carbon, pine sawdust based on plant waste was subjected to thermal treatment by carbonization methods at a temperature of 600-800 ° C and hydrothermal 220-260 ° C. Further, to increase the specific surface area, the samples after heat treatment were activated with hot water vapor at a temperature of 800-850 ° C for 1 hour. As a result of steam-gas activation, combustion of unstructured carbon and an increase in pores on the surface of activated carbon occur. In addition, the main physicochemical characteristics, sorption properties of the obtained activated carbon (specific surface area, m2 /g, fraction of pore volume, cm3 /g, average pore size, nm, sorption capacity by the amount of iodine,%) are considered. Also, the obtained sorption materials were studied in the process of sorption of nickel and cadmium ions from model solutions in a static mode. The optimal parameters of the sorption process were determined, at which the highest degree of extraction of nickel and cadmium ions is achieved: pH, phase contact time, ratio of solid and liquid phases. The recovery rate of cadmium and nickel ions in the static regime was more than 95% for cadmium and nickel. Keywords: activated carbon, sorbent, sorption, plant waste, nickel ion, cadmium ion

  • Open Access

    PREPARATION AND STUDY OF GROWTH STIMULATING ACTIVITY OF 1-PROPYL-4-(3’-AMINO-1’, 2’, 4’-TRIAZOLO-3’- THIOPROPINYL) PIPERIDIN-4-OL

    by Kanagat Kazhmukhanovich Kishibayev, Vladimir Leonidovich Russinov, Sergey Nikolaevich Kalugin, Sergey Anatolievich Yefremov, Rustam Rishatovich Tokpayev, Azhar Aidarovna Atchabarova, Sergey Vitalievich Nechipurenko, Daria Bazarbekovna Markina, Zhanibek Serikovich Assylhanov, Kazhmukhan Orazovich Kishibayev

    Results on the obtaining and the study of a plant growth stimulator based on 1-propyl-4-(3'-amino-1’,2’,4'-triazolo-3'-thiopropinyl) piperidin-4-ol are presented in the article. 1-propylpiperidin-4-on and 3-mercaptopropinyl-5-amin-1,2,4- triazolo were obtained with the basic parameters of the synthesis for synthesizing of 1-propyl-4-(3'-amino-1', 2', 4'-triazolo-3'-thiopropinyl) piperidin-4-ol. The structures of the obtained organic compounds were proved using IR spectroscopy and 1H and 13C NMR spectrometry. The obtained 1-propyl-4-(3’-amino-1’2’4’-triazolo-3’-thiopropynyl)-piperidine-4-ol was tested for growth-stimulating activity on spring wheat grains compared with control (water) and has proved to be a domestic growth regulator «Akpinol-alpha» (KN-2).


  • Open Access

    Mechanism of the thermochemical transformation of wheat grain’s processing waste during heat treatment

    by Khaidar S. Tassibekov, Zhenis Zh. Bekishev, Rustam R. Tokpayev, Kanagat K. Kishibaev, Akmaral G. Ismailova, Sergey V. Nechipurenko, Sergey A. Efremov, Mikhail K. Nauryzbayev

    The thermal destruction of wheat grain’s processing wastes from Almaty and South Kazakhstan regions was studieв. The structure of the products obtained depending on the temperature of the carbonization process was formed, and the basic physico-chemical characteristics of the obtained carbon material based on the WGPW were studied using thermogravimetric analysis, differential scanning calorimetry, IR spectroscopy and EPR spectroscopy. The analysis of the elemental composition of the obtained samples of the sorption material showed that the carbon content in the composition of the obtained carbon material is 75.08 - 76.12%, which in turn can cause a sufficiently high degree of sorption capacity of this material, as well as its mechanical strength. The obtained carbon materials based on OIP were modified with ammonium nitrate (NH4NO3) to improve its physico-chemical characteristics, such as specific surface area, porosity and adsorption capacity by iodine. It is shown that structural transformations of the processing waste of wheat grain (bran) in the process of heat treatment irrespective of temperature (in the studied interval) proceed through the stage of formation of free radicals. The concentration of free radicals formed in this process, as well as the composition of the graphite-like component of the products obtained, are determined by the temperature indices of the process.

  • Preparation and investigation of active carbons based on furfural copolymer

    by S. A. Efremov, K. K. Kishibayev, A. T. Kabulov, R. R. Tokpayev, A. A. Atchabarov, S. V. Nechipurenko, M. K. Nauryzbayev, Kh. S. Tassibekov, K. O. Kishibayev, N. L. Voropaeva, et al.