Francesca Tinti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Francesca Tinti has a total of 87 co-authors. Here are the top co-authors by number of shared publications:
- Nadia Camaioni
Istituto per la Sintesi Organica e la Fotoreattività, Consiglio Nazionale delle Ricerche, Via P. Gobetti 101, I-40129 Bologna, Italy
16 shared publications Riccardo Po
Istituto per la Sintesi Organica e la Fotoreattività, Consiglio Nazionale delle Ricerche, Via P. Gobetti 101, I-40129 Bologna, Italy
6 shared publicationsSiraye E. Debebe
Department of Chemistry, Addis Ababa University, P.O. Box 1176 3 , Addis Ababa, Ethiopia
6 shared publicationsTeketel Yohannes
Department of Chemistry Addis Ababa University P.O. Box 1176 Addis Ababa Ethiopia
6 shared publications- Luca Dore
Dipartimento di Chimica “Giacomo Ciamician”, Università di Bologna, Via F. Selmi 2, 40126 Bologna, Italy
5 shared publications Sara Righi
Laboratorio di Micro e Submicro Tecnologie Abilitanti per l’Emilia Romagna (MIST E-R S.C.R.L.), via P. Gobetti 101, I-40129 Bologna, Italy
5 shared publications
Latest Publications
- Open Access
- 13 May 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (26) , 10304-10317
Fine color-tuning of Ir(iii) tetrazolato complexes: synthesis, photophysical properties and OLED device fabrication
The modulation, to both lower and higher energies, of the emission output of a new family of Ir(iii)-tetrazole-based complexes was achieved by combining the ligand design of both cyclometalated and ancillary ligands.
- 13 May 2025
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 54 (26) , 10304-10317
Open AccessFine color-tuning of Ir(iii) tetrazolato complexes: synthesis, photophysical properties and OLED device fabrication
The modulation, to both lower and higher energies, of the emission output of a new family of Ir(iii)-tetrazole-based complexes was achieved by combining the ligand design of both cyclometalated and ancillary ligands.
- 23 March 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (13) , 6909-6919
Pyrene–Fullerene Interaction and Its Effect on the Behavior of Photovoltaic Blends
- 23 March 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (13) , 6909-6919
Pyrene–Fullerene Interaction and Its Effect on the Behavior of Photovoltaic Blends
- 27 October 2014
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 6 (23) , 21416-21425
Neat C70-Based Bulk-Heterojunction Polymer Solar Cells with Excellent Acceptor Dispersion
The replacement of common fullerene derivatives with neat-C70 could be an effective approach to restrain the costs of organic photovoltaics and increase their sustainability. In this study, bulk-heterojunction solar cells made of neat-C70 and low energy-gap conjugated polymers, PTB7 and PCDTBT, are thoroughly investigated and compared. Upon replacing PC70BM with C70, the mobility of positive carriers in the donor phase is roughly reduced by 1 order of magnitude, while that of electrons is only slightly modified. It is shown that the main loss mechanism of the investigated neat-C70 solar cells is a low mobility-lifetime product. Nevertheless, PCDTBT:C70 devices undergo a limited loss of 7.5%, compared to the reference PCDTBT:PC70BM cells, reaching a record efficiency (4.44%) for polymer solar cells with unfunctionalized fullerenes. The moderate efficiency loss of PCDTBT:C70 devices, due to an unexpected excellent miscibility of PCDTBT:C70 blends, demonstrates that efficient solar cells made of neat-fullerene are possible. The efficient dispersion of C70 in the PCDTBT matrix is attributed to an interaction between fullerene and the carbazole unit of the polymer.
- 27 October 2014
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 6 (23) , 21416-21425
Neat C70-Based Bulk-Heterojunction Polymer Solar Cells with Excellent Acceptor Dispersion
The replacement of common fullerene derivatives with neat-C70 could be an effective approach to restrain the costs of organic photovoltaics and increase their sustainability. In this study, bulk-heterojunction solar cells made of neat-C70 and low energy-gap conjugated polymers, PTB7 and PCDTBT, are thoroughly investigated and compared. Upon replacing PC70BM with C70, the mobility of positive carriers in the donor phase is roughly reduced by 1 order of magnitude, while that of electrons is only slightly modified. It is shown that the main loss mechanism of the investigated neat-C70 solar cells is a low mobility-lifetime product. Nevertheless, PCDTBT:C70 devices undergo a limited loss of 7.5%, compared to the reference PCDTBT:PC70BM cells, reaching a record efficiency (4.44%) for polymer solar cells with unfunctionalized fullerenes. The moderate efficiency loss of PCDTBT:C70 devices, due to an unexpected excellent miscibility of PCDTBT:C70 blends, demonstrates that efficient solar cells made of neat-fullerene are possible. The efficient dispersion of C70 in the PCDTBT matrix is attributed to an interaction between fullerene and the carbazole unit of the polymer.
- 1 September 2014
- Published by Elsevier in Tetrahedron
- Vol. 70 (36) , 6222-6228
Synthesis by MW-assisted direct arylation, side-arms driven self-assembly and functional properties of 9,10-dithienylanthracene orthogonal materials
- 1 September 2014
- Published by Elsevier in Tetrahedron
- Vol. 70 (36) , 6222-6228
Synthesis by MW-assisted direct arylation, side-arms driven self-assembly and functional properties of 9,10-dithienylanthracene orthogonal materials
- 3 February 2014
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 215 (5) , 452-457
Effect of Side Chains on Charge Transport of Anthracene‐Based PPE–PPV Copolymers
The variation of the drift mobility of positive and negative charge carriers in films of anthracene‐containing poly(p‐phenylene‐ethynylene)‐alt‐poly(p‐phenylene‐vinylene)s (AnE‐PVs), differently substituted, is investigated as a function of the applied electric field. Branched 2‐ethylhexyl and linear alkoxy side chains of different lengths are considered, as well as well‐defined and random distributions of lateral substituents. The same conditions are used both for the deposition of the polymer films and for their characterization, which allows for the establishment of a clear relationship between the chemical structure and the charge carrier mobility. image
- 3 February 2014
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 215 (5) , 452-457
Effect of Side Chains on Charge Transport of Anthracene‐Based PPE–PPV Copolymers
The variation of the drift mobility of positive and negative charge carriers in films of anthracene‐containing poly(p‐phenylene‐ethynylene)‐alt‐poly(p‐phenylene‐vinylene)s (AnE‐PVs), differently substituted, is investigated as a function of the applied electric field. Branched 2‐ethylhexyl and linear alkoxy side chains of different lengths are considered, as well as well‐defined and random distributions of lateral substituents. The same conditions are used both for the deposition of the polymer films and for their characterization, which allows for the establishment of a clear relationship between the chemical structure and the charge carrier mobility. image
- 28 November 2013
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 52 (4) , 338-346
Anthracene‐containing conjugated polymer showing four optical transitions upon doping: A spectroscopic study
An anthracene‐containing poly(arylene‐ethynylene)‐alt‐poly(arylene‐vinylene) (PAE‐PAV) of general constitutional unit (PhCCAnthrCCPhCHCHAnthrCHCH)nbearing two 2‐ethylhexyloxy solubilizing side chains on each phenylene (Ph) unit has been synthesized and characterized. The basic electrochemical characterization was done, showing the existence of two non‐reversible oxidation and one reversible reduction peaks. The optical properties, the real and imaginary part of the dielectric function, were probed using spectroscopic ellipsometry (SE). The vibrational structure of the undoped/doped polymer was investigated using Fourier transformed infrared spectroscopy. A strong change in the polaronic absorption was observed during the doping, which after modeling revealed the existence of two separated transitions. The optical changes upon doping were additionally recorded using the SE technique. Similar to the results from FT‐IR spectroscopy, two new in‐the‐gap absorptions were found. Moreover, the electrical conductivity as well as the mobility of positive carriers were measured. In the undoped state, the conductivity of the polymer was found to be below the detection limit (<μS cm−1), after doping the conductivity increased to 0.69 S cm−1. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys.2014,52, 338–346
- 28 November 2013
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 52 (4) , 338-346
Anthracene‐containing conjugated polymer showing four optical transitions upon doping: A spectroscopic study
An anthracene‐containing poly(arylene‐ethynylene)‐alt‐poly(arylene‐vinylene) (PAE‐PAV) of general constitutional unit (PhCCAnthrCCPhCHCHAnthrCHCH)nbearing two 2‐ethylhexyloxy solubilizing side chains on each phenylene (Ph) unit has been synthesized and characterized. The basic electrochemical characterization was done, showing the existence of two non‐reversible oxidation and one reversible reduction peaks. The optical properties, the real and imaginary part of the dielectric function, were probed using spectroscopic ellipsometry (SE). The vibrational structure of the undoped/doped polymer was investigated using Fourier transformed infrared spectroscopy. A strong change in the polaronic absorption was observed during the doping, which after modeling revealed the existence of two separated transitions. The optical changes upon doping were additionally recorded using the SE technique. Similar to the results from FT‐IR spectroscopy, two new in‐the‐gap absorptions were found. Moreover, the electrical conductivity as well as the mobility of positive carriers were measured. In the undoped state, the conductivity of the polymer was found to be below the detection limit (<μS cm−1), after doping the conductivity increased to 0.69 S cm−1. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys.2014,52, 338–346
- 19 February 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (19) , 6972-6980
Tuning the properties of an anthracene-based PPE-PPV copolymer by fine variation of its macromolecular parameters
The effects of a moderate variation of the molecular weight on the optical, structural, morphological and transport properties of an anthracene-containing PPE-PPV copolymer are investigated, as well as their overall implication on the photovoltaic parameters of bulk-heterojunction solar cells. Just a two-fold variation in the molecular weight is enough to induce appreciable changes in the properties of the investigated polymer films, indicating that a fine tuning of the macromolecular parameters is required for the optimization of the properties of polydispersed molecular systems. A remarkable role of the polydispersity index in the organization of polymer chains, thus reflecting in the electronic properties of the polymer films, is observed.
- 19 February 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (19) , 6972-6980
Tuning the properties of an anthracene-based PPE-PPV copolymer by fine variation of its macromolecular parameters
The effects of a moderate variation of the molecular weight on the optical, structural, morphological and transport properties of an anthracene-containing PPE-PPV copolymer are investigated, as well as their overall implication on the photovoltaic parameters of bulk-heterojunction solar cells. Just a two-fold variation in the molecular weight is enough to induce appreciable changes in the properties of the investigated polymer films, indicating that a fine tuning of the macromolecular parameters is required for the optimization of the properties of polydispersed molecular systems. A remarkable role of the polydispersity index in the organization of polymer chains, thus reflecting in the electronic properties of the polymer films, is observed.
- 30 July 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (5) , 053302
Electron and hole transport in an anthracene-based conjugated polymer
The bulk transport properties of an anthracene-containing poly(p-phenylene-ethynylene)-alt-poly(p-phenylene-vinylene) (AnE-PVstat) were investigated by small-signal time-of-flight. AnE-PVstat exhibited a very good ambipolar behaviour, consistent with the high delocalization of both frontier molecular orbitals. The transport of negative carriers was found to be even faster than that of positive carriers, with an electron drift mobility of about six times higher than that evaluated for holes, suggesting that conjugated polymers with carbon-carbon triple bonds could represent a promising platform toward high performance ambipolar materials for plastic electronics.
- 30 July 2012
- Published by AIP Publishing in Applied Physics Letters
- Vol. 101 (5) , 053302
Electron and hole transport in an anthracene-based conjugated polymer
The bulk transport properties of an anthracene-containing poly(p-phenylene-ethynylene)-alt-poly(p-phenylene-vinylene) (AnE-PVstat) were investigated by small-signal time-of-flight. AnE-PVstat exhibited a very good ambipolar behaviour, consistent with the high delocalization of both frontier molecular orbitals. The transport of negative carriers was found to be even faster than that of positive carriers, with an electron drift mobility of about six times higher than that evaluated for holes, suggesting that conjugated polymers with carbon-carbon triple bonds could represent a promising platform toward high performance ambipolar materials for plastic electronics.
- 1 May 2012
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 100, 97-114
Polymer- and carbon-based electrodes for polymer solar cells: Toward low-cost, continuous fabrication over large area
- 1 May 2012
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 100, 97-114
Polymer- and carbon-based electrodes for polymer solar cells: Toward low-cost, continuous fabrication over large area