Mortaza Aliasghary
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mortaza Aliasghary has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Hamed Mobki
Electrical Engineering Department, Faculty of Industrial Technologies, Urmia University of Technology (UUT), Urmia, Iran
2 shared publications Amin Zarrin
Urmia University of Technology
1 shared publication- Hadi Madinei
Swansea University
1 shared publication - Hamed Haddad Khodaparast
Swansea University, Swansea, UK
1 shared publication - Hassen M. Ouakad
Renewable Energy Engineering Department, Mediterranean Institute of Technology, South Mediterranean University, Tunis, Tunisia
1 shared publication Hojjat Aminnejhad
1 shared publication
Latest Publications
- 11 December 2023
- Published by Springer Nature in International Journal of Information Technology
- Vol. 16 (1) , 237-243
Effective machine learning pull-in instability estimation of an electrostatically nano actuator under the influences of intermolecular forces
- 11 December 2023
- Published by Springer Nature in International Journal of Information Technology
- Vol. 16 (1) , 237-243
Effective machine learning pull-in instability estimation of an electrostatically nano actuator under the influences of intermolecular forces
- Open Access
On the Efficiency Enhancement of an Actively Tunable MEMS Energy Harvesting Device
In this paper, we propose an active control method to adjust the resonance frequency of a capacitive energy harvester. To this end, the resonance frequency of the harvester is tuned using an electrostatic force, which is actively controlled by a voltage source. The spring softening effect of the electrostatic force is used to accommodate the dominant frequency of the ambient mechanical vibration within the bandwidth of the resonance region. A single degree of freedom is considered, and the nonlinear equation of motion is numerically integrated over time. Using a conventional proportional–integral–derivative (PID) control mechanism, the results demonstrated that our controller could shift the resonance frequency leftward on the frequency domain and, as a result, improve the efficiency of the energy harvester, provided that the excitation frequency is lower than the resonance frequency of the energy harvester. Application of the PID controller in the resonance zone resulted in pull-in instability, adversely affecting the harvester’s performance. To tackle this problem, we embedded a saturation mechanism in the path of the control signal to prevent a sudden change in motion amplitude. Outside the pull-in band, the saturation of the control signal resulted in the reduction of harvested power compared to the non-saturated signal; this is a promising improvement in the design and analysis of energy harvesting devices.
Open AccessOn the Efficiency Enhancement of an Actively Tunable MEMS Energy Harvesting Device
In this paper, we propose an active control method to adjust the resonance frequency of a capacitive energy harvester. To this end, the resonance frequency of the harvester is tuned using an electrostatic force, which is actively controlled by a voltage source. The spring softening effect of the electrostatic force is used to accommodate the dominant frequency of the ambient mechanical vibration within the bandwidth of the resonance region. A single degree of freedom is considered, and the nonlinear equation of motion is numerically integrated over time. Using a conventional proportional–integral–derivative (PID) control mechanism, the results demonstrated that our controller could shift the resonance frequency leftward on the frequency domain and, as a result, improve the efficiency of the energy harvester, provided that the excitation frequency is lower than the resonance frequency of the energy harvester. Application of the PID controller in the resonance zone resulted in pull-in instability, adversely affecting the harvester’s performance. To tackle this problem, we embedded a saturation mechanism in the path of the control signal to prevent a sudden change in motion amplitude. Outside the pull-in band, the saturation of the control signal resulted in the reduction of harvested power compared to the non-saturated signal; this is a promising improvement in the design and analysis of energy harvesting devices.
- 20 November 2021
- Published by Springer Nature in Soft Computing
- Vol. 26 (10) , 4961-4977
A novel single-input interval type-2 fractional-order fuzzy controller for systems with parameter uncertainty
- 20 November 2021
- Published by Springer Nature in Soft Computing
- Vol. 26 (10) , 4961-4977
A novel single-input interval type-2 fractional-order fuzzy controller for systems with parameter uncertainty
- 13 July 2021
- Published by Springer Nature in Energy Efficiency
- Vol. 14 (6) , 1-12
Design and fabrication of an intelligent management and control system to optimize energy consumption in indoor swimming pools
- 13 July 2021
- Published by Springer Nature in Energy Efficiency
- Vol. 14 (6) , 1-12
Design and fabrication of an intelligent management and control system to optimize energy consumption in indoor swimming pools
- 25 June 2019
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 8 (2) , 604-614
A novel inverse kinematics scheme for the design and fabrication of a five degree of freedom arm robot
- 25 June 2019
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 8 (2) , 604-614
A novel inverse kinematics scheme for the design and fabrication of a five degree of freedom arm robot
- 3 October 2018
- Published by Wiley in International Transactions on Electrical Energy Systems
- Vol. 29 (2) , e2735
A fractional order fuzzy PID for load frequency control of four-area interconnected power system using biogeography-based optimization
- 3 October 2018
- Published by Wiley in International Transactions on Electrical Energy Systems
- Vol. 29 (2) , e2735
A fractional order fuzzy PID for load frequency control of four-area interconnected power system using biogeography-based optimization
- 12 June 2018
- Published by Wiley in Fuel Cells
- Vol. 18 (4) , 449-456
Control of PEM Fuel Cell Systems Using Interval Type‐2 Fuzzy PID Approach
In this study, an interval type‐2 fuzzy proportional–integral–derivative (IT2FPID) controller is designed to be used in the air flow regulation of polymer electrolyte membrane fuel cell (PEMFC) systems. The proposed controller is able to handle the effect of external disturbances and fix the oxygen excess ratio at an appropriate set‐point. Three crisp singletons for the output and two interval type‐2 membership functions for the inputs are defined for the suggested controller. Two conventional controllers including type‐1 fuzzy PID (T1FPID) and ordinary proportional–integral–derivative (PID) are also investigated to evaluate the performance and efficiency of this technique. The results of various simulations indicate that the IT2FPID controller has a better performance and transient response compared to the other approaches.
- 12 June 2018
- Published by Wiley in Fuel Cells
- Vol. 18 (4) , 449-456
Control of PEM Fuel Cell Systems Using Interval Type‐2 Fuzzy PID Approach
In this study, an interval type‐2 fuzzy proportional–integral–derivative (IT2FPID) controller is designed to be used in the air flow regulation of polymer electrolyte membrane fuel cell (PEMFC) systems. The proposed controller is able to handle the effect of external disturbances and fix the oxygen excess ratio at an appropriate set‐point. Three crisp singletons for the output and two interval type‐2 membership functions for the inputs are defined for the suggested controller. Two conventional controllers including type‐1 fuzzy PID (T1FPID) and ordinary proportional–integral–derivative (PID) are also investigated to evaluate the performance and efficiency of this technique. The results of various simulations indicate that the IT2FPID controller has a better performance and transient response compared to the other approaches.
- 3 July 2014
- Published by Springer Nature in Soft Computing
- Vol. 19 (5) , 1283-1293
General derivation and analysis for input–output relations in interval type-2 fuzzy logic systems
- 3 July 2014
- Published by Springer Nature in Soft Computing
- Vol. 19 (5) , 1283-1293
General derivation and analysis for input–output relations in interval type-2 fuzzy logic systems