Jeffrey Lindemuth
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jeffrey Lindemuth has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Brad C. Dodrill
Lake Shore Cryotronics 3 , 575 McCorkle Blvd., Westerville, Ohio 43082, USA
2 shared publications Alexander J. E. Rettie
The University of Texas at Austin 1 McKetta Department of Chemical Engineering Austin, Texas 78712, USA
1 shared publicationC. Buddie Mullins
The University of Texas at Austin 1 McKetta Department of Chemical Engineering Austin, Texas 78712, USA
1 shared publication- Cosmin Radu
Lake Shore Cryotronics Inc. Westerville OH 43082 USA
1 shared publication David Emin
The University of New Mexico 7 Department of Physics and Astronomy Albuquerque, New Mexico 87131, USA
1 shared publication- David R. Daughton
Department of Applications, Lake Shore Cryotronics, Westerville, OH, USA
1 shared publication
Latest Publications
- 1 December 2024
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 95 (12)
Hybrid filter for lock-in amplifiers
Lock-in amplifiers are instrumental in the precise measurement of extremely small AC signals within high-noise environments. Traditionally, noise reduction in these instruments relies on infinite impulse response (IIR) filters, which can necessitate prolonged settling times to ensure the acquisition of accurate, statistically independent data. While moving average filters offer faster settling times, their non-monotonic frequency response may not be optimal for noise reduction. Conversely, IIR filters frequently realized as N-pole RC filters exhibit a monotonic frequency response conducive to effective noise reduction. This study presents a hybrid filter architecture that combines a short IIR filter with a longer moving average finite impulse response filter. The objective is to enhance noise reduction as quantified by the filter’s equivalent noise bandwidth (ENBW). Theoretical analysis is provided to derive the step response, settling time, frequency response, and ENBW of the hybrid filter configuration. Design methodologies are outlined for hybrid filters that either match the settling time of an N-pole RC filter while achieving a lower ENBW or maintain the ENBW of an N-pole RC filter but with significantly faster settling time. The performance of the hybrid filter is validated through noise measurements of low-value resistors and thermal noise of larger resistors, with results compared to theoretical predictions.
- 1 December 2024
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 95 (12)
Hybrid filter for lock-in amplifiers
Lock-in amplifiers are instrumental in the precise measurement of extremely small AC signals within high-noise environments. Traditionally, noise reduction in these instruments relies on infinite impulse response (IIR) filters, which can necessitate prolonged settling times to ensure the acquisition of accurate, statistically independent data. While moving average filters offer faster settling times, their non-monotonic frequency response may not be optimal for noise reduction. Conversely, IIR filters frequently realized as N-pole RC filters exhibit a monotonic frequency response conducive to effective noise reduction. This study presents a hybrid filter architecture that combines a short IIR filter with a longer moving average finite impulse response filter. The objective is to enhance noise reduction as quantified by the filter’s equivalent noise bandwidth (ENBW). Theoretical analysis is provided to derive the step response, settling time, frequency response, and ENBW of the hybrid filter configuration. Design methodologies are outlined for hybrid filters that either match the settling time of an N-pole RC filter while achieving a lower ENBW or maintain the ENBW of an N-pole RC filter but with significantly faster settling time. The performance of the hybrid filter is validated through noise measurements of low-value resistors and thermal noise of larger resistors, with results compared to theoretical predictions.
- Open Access
- 9 November 2015
- Published by Springer Nature in MRS Bulletin
- Vol. 40 (11) , 903-905
White Paper: High-temperature FORC study of single- and multi-phase permanent magnets
- 9 November 2015
- Published by Springer Nature in MRS Bulletin
- Vol. 40 (11) , 903-905
Open AccessWhite Paper: High-temperature FORC study of single- and multi-phase permanent magnets
- 12 January 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (2) , 022106
Anisotropic small-polaron hopping in W:BiVO4 single crystals
DC electrical conductivity, Seebeck and Hall coefficients are measured between 300 and 450 K on single crystals of monoclinic bismuth vanadate that are doped n-type with 0.3% tungsten donors (W:BiVO4). Strongly activated small-polaron hopping is implied by the activation energies of the Arrhenius conductivities (about 300 meV) greatly exceeding the energies characterizing the falls of the Seebeck coefficients' magnitudes with increasing temperature (about 50 meV). Small-polaron hopping is further evidenced by the measured Hall mobility in the ab-plane (10−1 cm2 V−1 s−1 at 300 K) being larger and much less strongly activated than the deduced drift mobility (about 5 × 10−5 cm2 V−1 s−1 at 300 K). The conductivity and n-type Seebeck coefficient is found to be anisotropic with the conductivity larger and the Seebeck coefficient's magnitude smaller and less temperature dependent for motion within the ab-plane than that in the c-direction. These anisotropies are addressed by considering highly anisotropic next-nearest-neighbor (≈5 Å) transfers in addition to the somewhat shorter (≈4 Å), nearly isotropic nearest-neighbor transfers.
- 12 January 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (2) , 022106
Anisotropic small-polaron hopping in W:BiVO4 single crystals
DC electrical conductivity, Seebeck and Hall coefficients are measured between 300 and 450 K on single crystals of monoclinic bismuth vanadate that are doped n-type with 0.3% tungsten donors (W:BiVO4). Strongly activated small-polaron hopping is implied by the activation energies of the Arrhenius conductivities (about 300 meV) greatly exceeding the energies characterizing the falls of the Seebeck coefficients' magnitudes with increasing temperature (about 50 meV). Small-polaron hopping is further evidenced by the measured Hall mobility in the ab-plane (10−1 cm2 V−1 s−1 at 300 K) being larger and much less strongly activated than the deduced drift mobility (about 5 × 10−5 cm2 V−1 s−1 at 300 K). The conductivity and n-type Seebeck coefficient is found to be anisotropic with the conductivity larger and the Seebeck coefficient's magnitude smaller and less temperature dependent for motion within the ab-plane than that in the c-direction. These anisotropies are addressed by considering highly anisotropic next-nearest-neighbor (≈5 Å) transfers in addition to the somewhat shorter (≈4 Å), nearly isotropic nearest-neighbor transfers.
- 28 February 2002
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 41 (Part 1, No) , 1055-1058
Characterizing Multi-Carrier Devices with Quantitative Mobility Spectrum Analysis and Variable Field Hall Measurements
Single magnetic field Hall measurements are inadequate for characterizing multicarrier mixed conduction in heterostructure devices, since the resultant mobility and density parameters are averaged over all carriers. We demonstrate an optimized quantitative mobility spectrum analysis (QMSA) technique for resolving individual carrier mobilities and densities in multi-carrier devices such as pHEMTs from field dependent Hall measurement data. The reliability and sensitivity of this technique suggests that it is a suitable standard tool for routine characterization of multi-carrier semiconductor devices.
- 28 February 2002
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 41 (Part 1, No) , 1055-1058
Characterizing Multi-Carrier Devices with Quantitative Mobility Spectrum Analysis and Variable Field Hall Measurements
Single magnetic field Hall measurements are inadequate for characterizing multicarrier mixed conduction in heterostructure devices, since the resultant mobility and density parameters are averaged over all carriers. We demonstrate an optimized quantitative mobility spectrum analysis (QMSA) technique for resolving individual carrier mobilities and densities in multi-carrier devices such as pHEMTs from field dependent Hall measurement data. The reliability and sensitivity of this technique suggests that it is a suitable standard tool for routine characterization of multi-carrier semiconductor devices.