CHCarl Hopkins

Carl Hopkins

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Carl Hopkins has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impacts of Substrate-Borne Vibration and Chemical Stressors on the Embryonic Development and Hatching of Marine Invertebrates

    by Thomas Williamson, Nova Mieszkowska, Jack Thomson, Carl Hopkins, Ambrosine Clark, Louise Roberts

  • Open Access

    Sound power of speech between 63Hz and 20kHz at a normal vocal effort level

    by Carl Hopkins, Simone Graetzer, Gary Seiffert

    This paper reports anechoic measurements of speech (720 IEEE sentences) produced at a normal vocal effort by 12 native British English speakers (six male, six female) over a hemispherical region (1m radius) on one side of the talker to allow calculation of the sound power as well as an assessment of the on-axis sound pressure level. One-third octave bands were measured from 63Hz to 20kHz to include the Extended High Frequency (EHF) range above 7kHz. In the low-frequency range (below 200Hz), male talkers had higher levels than female talkers in the 100Hz and 125Hz one-third octave bands, and only male talkers had measurable levels in the 63Hz and 80Hz bands. In the mid-frequency range (200Hz – 4kHz) there was a difference between male and female talkers in the 800Hz one-third octave band where females were ≈ 3dB higher than males for the on-axis sound pressure level and ≈ 2dB higher for the sound power level. In the high-frequency range (5kHz – 20kHz), no statistically significant differences were found between male and female talkers; although there were large variations between talkers and between sentences that did, and did not contain the fricatives /s, z, S, Z, f, v, T, D/ and the unvoiced affricate /tS/. The results show that the definition of a unisex talker spectrum (average of male and female talkers) for the on-axis sound pressure level or sound power level is reasonable between the 160Hz and 20kHz one-third octave bands, and between the 125Hz and 16kHz octave bands.

  • Open Access

    History of the Acoustics Research Unit at the University of Liverpool

    by Carl Hopkins, Pyoung Jik Lee, Barry Gibbs, Gary Seiffert

    Acoustics research was established at the University of Liverpool in the middle of the 20th century in the department of physics which led to the formation of the Acoustics Research Unit (ARU) in the mid-1970s as part of the department of building engineering and then architecture. This article reviews the history and legacy of the research group that has worked on airborne and structure-borne sound over a 70 year period.


  • Open Access

    Prediction of rainfall noise radiated by sandwich panels using the Finite Transfer Matrix Method

    by Yicheng Yu, Carl Hopkins

    Multilayer elements, such as sandwich panels, are often used to form the roof of a building or car; hence validated prediction models are needed to determine the sound radiated by them during rainfall. To calculate the radiation efficiency of a sandwich panel formed from two plates and a porous material, the Finite Transfer Matrix Method (FTMM) has been used with an order-reduced integral equation and an additional term to account for nearfield radiation because, in comparison with homogeneous plates, sandwich panels tend to have high damping. Transfer mobility measurements on the sandwich panel showed that vibrational energy was concentrated near the point of excitation due to the panel being highly damped, and confirmed the validity of the limp porous material model for the foam that was used as the porous material. Experimental validation of the prediction models used artificial rain with drops impacting at approximately terminal velocity. This demonstrated that it was necessary to include the effect of nearfield radiation in the overall radiation efficiency. An assessment of existing empirical and semi-empirical models for the time-dependent force applied by liquid water drops showed that for this application of artificial rain in the laboratory it was reasonable to assume a dry surface when predicting the structure-borne sound power input.

  • Open Access

    Book review on “Engineering acoustics: noise and vibration control” by Malcolm J. Crocker and Jorge P. Arenas

    by Carl Hopkins

    'Engineering Acoustics: Noise and Vibration Control' aims to provide the reader with background theory and understanding that can be applied to solve engineering problems concerning sound and vibration. On this topic, the authors, Malcolm Crocker and Jorge Arenas, have considerable experience in academic research, industrial applications, teaching and consultancy


  • Open Access

    Vibration Transmission across Seismically Damaged Beam-to-Column Junctions of Reinforced Concrete Using Statistical Energy Analysis

    by Marios Filippoupolitis, Carl Hopkins

    To detect human survivors trapped in buildings after earthquakes by using structure-borne sound it is necessary to have knowledge of vibration transmission in collapsed and fragmented reinforced-concrete buildings. In this paper, statistical energy analysis (SEA) is considered for modelling vibration transmission in seismically damaged, reinforced concrete, beam-to-column junctions where the connection between the beam and the column is made only via the steel reinforcement. An ensemble of 30 randomly damaged beam-to-column junctions was generated using a Monte Carlo simulation with FEM. Experimental SEA (ESEA) is then considered with two or three subsystems to determine the coupling loss factors (CLFs) between the beam and the column with either bending modes or the combination of all mode types. It is shown that bending modes dominate the dynamic response and that the uncertainty of predicting the CLFs using FEM with ESEA is sufficiently low that it should be feasible to estimate the coupling even when the exact angle between the beam and the column is unknown. In addition, the use of two rather than three subsystems for the junction significantly decreases the number of negative coupling loss factors with ESEA. An initial analysis of the results in this paper was presented at the 50th International Congress and Exposition on Noise Control Engineering.


  • Open Access

    Comparison of ideal mask-based speech enhancement algorithms for speech mixed with white noise at low mixture signal-to-noise ratios

    by Simone Graetzer, Carl Hopkins

    The literature shows that the intelligibility of noisy speech can be improved by applying an ideal binary or soft gain mask in the time-frequency domain for signal-to-noise ratios (SNRs) between –10 and +10 dB. In this study, two mask-based algorithms are compared when applied to speech mixed with white Gaussian noise (WGN) at lower SNRs, that is, SNRs from −29 to –5 dB. These comprise an Ideal Binary Mask (IBM) with a Local Criterion (LC) set to 0 dB and an Ideal Ratio Mask (IRM). The performance of three intrusive Short-Time Objective Intelligibility (STOI) variants—STOI, STOI+, and Extended Short-Time Objective Intelligibility (ESTOI)—is compared with that of other monaural intelligibility metrics that can be used before and after mask-based processing. The results show that IRMs can be used to obtain near maximal speech intelligibility (>90% for sentence material) even at very low mixture SNRs, while IBMs with LC = 0 provide limited intelligibility gains for SNR < −14 dB. It is also shown that, unlike STOI, STOI+ and ESTOI are suitable metrics for speech mixed with WGN at low SNRs and processed by IBMs with LC = 0 even when speech is high-pass filtered to flatten the spectral tilt before masking.


  • Open Access

    Experimental and numerical validation of Advanced Statistical Energy Analysis to incorporate tunneling mechanisms for vibration transmission across a grillage of beams

    by Xing Wang, Carl Hopkins

    Advanced Statistical Energy Analysis (ASEA) is used to predict vibrational response on a three-bay linear grillage of beams that supports multiple wave types when there is significant indirect coupling through tunneling mechanisms. For bending wave excitation where the component beams have identical material properties, there was agreement between measurements, ASEA and FEM (Finite Element Methods). The importance of indirect coupling was confirmed for bending-longitudinal and bending-torsional models due to ASEA predicting a higher response than SEA on beams that were distant from the source, and closer agreement between FEM and ASEA (rather than SEA) with only bending modes on all the beams or where beams supported longitudinal or torsional modes as well as bending modes. To investigate an imperfectly periodic, finite grillage that could exist due to engineering tolerances, numerical experiments with FEM were used to introduce uncertainty into the Young’s modulus for each beam. For beams modelled with Euler-Bernoulli or Timoshenko theory, the effect of this uncertainty was to reduce differences between FEM and ASEA to less than ≈3 dB. The results confirm the ability of ASEA to predict vibration transmission with significant indirect coupling across frameworks of beams that support local modes with multiple wave types.


  • Open Access

    Deafness And Music: Can Vibration Be Used When Playing Music Together?

    by Carl Hopkins, Saúl Maté-Cid, Robert Fulford, Gary Seiffert, Jane Ginsborg, Natalie Barker

    Performing music or singing together provides people with great pleasure. But if you are deaf (or hard of hearing) it is not always possible to listen to other musicians while trying to sing or play an instrument. It can be particularly difficult to perceive different musical pitches with a hearing aid or other hearing-assistance device. However, the human body can transmit musical sounds to the brain when vibrations are applied to the skin. In other words, we can feel music. Our research has identified a safe way for deaf people to hear musical notes through the skin of their hands and feet. We have shown that vibration allows people to safely feel music on the skin. This approach allows people to identify a musical note as being higher or lower in pitch than other notes, and it helps musicians to play music together.


  • Using Inverse Transient Statistical Energy Analysis to determine the transient power input from a heavy impact on floating floors

    by Susumu Hirakawa, Carl Hopkins

    To aid design decision concerning heavy impacts on heavyweight floors, it is necessary to be able to predict Fast-time weighted maximum sound pressure levels (Lp,Fmax) in the receiving room. For excitation directly on the heavyweight floor this can be carried out using Transient Statistical Energy Analysis (TSEA) in a predictive mode. However, the performance of floating floors is not always possible to accurately predict hence an inverse approach to TSEA, referred to as ITSEA, has been developed to determine the transient power. This paper compares the prediction of the Lp,Fmax using TSEA with normalized transient power input determined by ITSEA with measurements conducted in two test chambers with and without floor small floor toppings. For one-third octave bands, the maximum difference in Lp,Fmax between measurement and TSEA ranged from 5.3 to 8.3dB and 6 to 7dB when using W`in,ForcePlate and W`in,ITSEA respectively. For octave bands, the maximum difference in Lp,Fmax between measurement and TSEA ranged from 2.1 to 7.5dB and 2 to 7dB when using W`in,ForcePlate and W`in,ITSEA respectively