ASAlberto Sottile

Alberto Sottile

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Alberto Sottile has a total of 52 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Diode-pumped solid-state laser platform for compact and long-lasting strontium-based optical clocks

    by Alberto Sottile, Eugenio Damiano, Alberto Di Lieto, Mauro Tonelli

    Optical clocks based on strontium (Sr) atoms and ions are currently used to provide precise standards for measuring time. These devices require several narrow-band visible laser sources at specific wavelengths to operate. We report on the diode-pumped continuous-wave laser operation at 674, 688, 689, 698, and 707 nm of a single crystal of Pr3+:LiGdF4 (Pr:GLF). To the best of our knowledge, Pr:GLF is the only active medium suitable for solid-state laser operation at all the wavelengths of interest for Sr-based clocks in the deep-red region. We also investigated the spectral tunability of this source, achieving an uninterrupted tuning range of 17 nm, between 697 and 714 nm.


  • Widely tunable, efficient 2 μm laser in monocrystalline Tm3+:SrF2

    by Alberto Sottile, Eugenio Damiano, Martina Rabe, Rainer Bertram, Detlef Klimm, Mauro Tonelli

    We report on the growth, spectroscopy, and laser operation of monocrystalline Tm3+:SrF2. Spectroscopic investigations confirmed the presence of broad absorption and emission bands caused by inequivalent doped sites, introduced by charge compensation effects which also caused the clusterization of doping ions in the lattice. We obtained continuous-wave laser emission at about 2 μm, with efficiencies comparable with other Tm-doped crystals. We also achieved an uninterrupted tuning range of 180 nm between 1.8 and 2 μm. This characterization indicates that SrF2 enhances the cooperative mechanisms between Tm ions, helping to obtain remarkable laser performances at low doping concentrations.


  • Crystal growth and optimization of Pr:CaGdAlO 4 by the flux-Czochralski method

    by Qiangqiang Hu, Zhitai Jia, Stefano Veronesi, Jian Zhang, Alberto Sottile, Mauro Tonelli, Enrico Cavalli, Xutang Tao

    This work reports on the flux-Cz growth and the thermal and spectroscopic characterization of Pr:CaGdAlO 4 crystals.


  • Open Access

    Growth by the μ-PD Method and Visible Laser Operation of a Single-Crystal Fiber of Pr3+:KY3F10

    by Jun Shu, Eugenio Damiano, Alberto Sottile, Zhonghan Zhang, Mauro Tonelli

    We report on the first growth, spectroscopy, and visible laser operation of a single-crystal fiber (SCF) of KY3F10 (KYF) grown by the micro-pulling-down (μ-PD) method, doped with Pr3+ ions. This material has a cubic lattice, which makes it appealing for use in the industry. However, KYF crystals are considered difficult to grow with high optical quality, even with well-established methods. Nevertheless, we grew a 50-mm-long SCF of Pr:KYF, which was transparent in its inner part. We studied the spectroscopic features of it in comparison with existing literature and with samples of the same crystal grown by the Czochralski method, and we did not notice any large differences. These characterizations confirmed that is indeed possible to grow high-quality crystals of Pr:KYF by the μ-PD method. Unfortunately, the crystal proved to be more brittle than typical KYF and especially difficult to polish, leading to rough and irregular facets, as evidenced by transmission measurements. Despite these issues, we obtained continuous-wave laser operation in the orange, red, and deep red regions, using a sample carved from the SCF as active medium and an InGaN-based laser diode as pump source, though with lower performances than in existing reports on this crystal.


  • Wavelength tuning in a diode-pumped Pr3+:Ba(Y0.8Lu0.2)2F8 laser

    by Alberto Sottile, Eugenio Damiano, Mauro Tonelli

    Summary form only given. Research on praseodymium-doped solid-state lasers is seeing a renovated interest in the last years. Among the best crystal hosts for these lasers, BaY 2 F 8 (BYF) shows some peculiarities, such as its monoclinic structure and its wide Stark splitting, which allow enhanced power scalability and broad tunability. However, BYF is considered troublesome to grow, and sometimes can crack during handling. To prevent these issues, Ba(Y 1-x Lu x ) 2 F 8 (BYLF) has been proposed as a new host material [1]. BYLF is isomorphic to BYF, keeping all the advantages of its structure. Thanks to the addition of lutetium, BYLF should have better thermo-mechanical properties and overall it has shown laser performances than BYF [2]. In this work, we report on the first spectral tuning of a continuous-wave laser based on monocrystalline Ba(Y 0.8 Lu 0.2 ) 2 F 8 (x = 0.2), doped with 1.25 at.% of praseodymium (Pr:BYLF). This crystal was grown, oriented, and polished in our laboratories. Further details on the growth and spectroscopic properties can be found in [2].

  • Spectroscopy and visible laser operations of a μ -PD grown Pr 3+ :LiYF 4 single-crystal fiber

    by Eugenio Damiano, Jun Shu, Alberto Sottile, Mauro Tonelli

    We report on the growth and visible laser operations of a single-crystal fiber of Pr 3+ :LiYF 4 (Pr:YLF), grown by the micro-pulling-down method ( μ -PD). We performed spectroscopic analyses on the crystal and compared the results with a Czochralski-grown sample of the same material. These analyses proved the high optical quality of the fiber. Using a hemispherical cavity and pumping the crystal with an InGaN-based laser diode, we achieved laser emission in the orange, red and deep red regions. We measured the slope efficiencies of three transitions and studied the propagation of output beams. To the best of our knowledge, these are the first laser operations in a Pr:YLF single-crystal fiber grown by this method.


  • Diode-pumped laser operation of Pr^3+:Ba(Y_08Lu_02)_2F_8 in the visible region

    by Alberto Sottile, Eugenio Damiano, Mauro Tonelli

    We report on, to the best of our knowledge, the first growth, spectroscopy, and laser operation of monocrystalline Ba(Y0.8Lu0.2)2F8 doped with 1.25 at.% of Pr3+ ions (Pr:BYLF). We studied the spectroscopic properties of this material, particularly in comparison with its isomorph Pr3+: BaY2F8 (Pr:BYF). Under diode-pumped excitation, we achieved continuous-wave laser operation in the orange, red, and deep red regions in the three possible crystal orientations. We obtained considerably improved laser performances and remarkably low passive losses, in comparison with Pr:BYF crystals and other fluorides, indicating that Pr:BYLF is an excellent host material in the visible region.


  • The Advanced LIGO photon calibrators

    by S. Karki, D. Tuyenbayev, S. Kandhasamy, B. P. Abbott, T. D. Abbott, E. H. Anders, J. Berliner, J. Betzwieser, C. Cahillane, L. Canete, et al.

    The two interferometers of the Laser Interferometry Gravitational-wave Observatory (LIGO) recently detected gravitational waves from the mergers of binary black hole systems. Accurate calibration of the output of these detectors was crucial for the observation of these events and the extraction of parameters of the sources. The principal tools used to calibrate the responses of the second-generation (Advanced) LIGO detectors to gravitational waves are systems based on radiation pressure and referred to as photon calibrators. These systems, which were completely redesigned for Advanced LIGO, include several significant upgrades that enable them to meet the calibration requirements of second-generation gravitational wave detectors in the new era of gravitational-wave astronomy. We report on the design, implementation, and operation of these Advanced LIGO photon calibrators that are currently providing fiducial displacements on the order of 10−18m/Hz with accuracy and precision of better than 1%.


  • Open Access

    Visible laser operation in a Pr^3+:LiLuF_4 monocrystalline fiber grown by the micro-pulling-down method

    by Alberto Sottile, Zhonghan Zhang, Stefano Veronesi, Daniela Parisi, Alberto Di Lieto, Mauro Tonelli

    We report on the growth and laser operation of a fiber-shaped single crystal of Pr3+:LiLuF4 (Pr:LLF) grown by the micro-pulling-down (µ-PD) method. We checked the optical quality of the crystal by measuring its spectroscopic features, and by observing the profile of a laser beam transmitted through it. Using an InGaN laser diode as pump source, we achieved continuous-wave laser emission in the orange, red, and deep red regions, with slope efficiencies comparable with or exceeding previous reports on this material. To the best of our knowledge, this work represents the first observation of visible laser emissions from a crystal grown by the µ-PD technique.


  • Deep red diode-pumped Pr^3+:KY_3F_10 continuous-wave laser

    by Alberto Sottile, Philip W. Metz

    We report the first observation of continuous-wave laser emission at 720 nm, in the deep red region, of a Pr3+:KY3F10 (Pr:KYF) single crystal, pumped with a blue InGaN-based laser diode at 446 nm. We employed a hemispherical cavity with three different output coupling mirrors transmitting 0.7%, 1.4%, and 2.7% of laser radiation. We obtained a maximum output power of 207 mW with a slope efficiency of 24.3%, comparable for the first time to what has been reported for other praseodymium-doped fluoride crystals. The round-trip cavity losses for our sample were estimated to be between 0.3% and 0.6%, a remarkably small value for this material.