Álisson Franco Do Couto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Álisson Franco Do Couto has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Nicole Schwantes-Cezario
State University of Londrina
3 shared publications - Berenice Martins Toralles
Universidade Estadual de Londrina
2 shared publications - Geovana Souza Ferreira Nogueira
Universidade Estadual de Londrina
2 shared publications - Gersson Fernando Barreto Sandoval
Universidad Pedagógica y Tecnológica de Colombia, Sede Tunja, Boyacá 150003, Colombia
2 shared publications - Gilson Morales
Universidade Estadual de Londrina - UEL
2 shared publications - M. F. Porto
State University of Londrina, Brazil
1 shared publication
Latest Publications
- Open Access
- 1 February 2019
- Published by FapUNIFESP (SciELO) in Revista IBRACON de Estruturas e Materiais
- Vol. 12 (1) , 31-38
Effects of Bacillus subtilis biocementation on the mechanical properties of mortars
This study aims to evaluate the influence of B. subtilis AP91 spores addition on the mechanical properties of mortars. B. subtilis strain AP91, isolated from rice leaves of the needle variety, which has an early cycle of production, was used at the concentration of 105 spores/mL in mortars with cement-to-sand ratio of 1:3 (by weight) and water-to-cement ratio (w/c) of 0.63. These spores were added in two different ways: in the mixing water and by immersion in a solution containing bacterial spores. Scanning Electron Microscope (SEM) analysis showed crystals with calcium peaks on the EDS, which possibly indicates the presence of bioprecipitated calcium carbonate. The results obtained in the mechanical analysis showed that the bioprecipitation of CaCO3 by B. subtilis strain AP91 was satisfactory, particularly when the spores were added in the mixing water, increasing the compressive strength up to 31%. Thus, it was concluded that the addition of B. subtilis AP91 spores in the mixing water of cement mortars induced biocementation, which increased the compressive strength. This bioprecipitation of calcium carbonate may very well have other advantageous consequences, such as the closure of pores and cracks in cementitious materials that could improve durability properties, although more research is still needed on this matter.
- 1 February 2019
- Published by FapUNIFESP (SciELO) in Revista IBRACON de Estruturas e Materiais
- Vol. 12 (1) , 31-38
Open AccessEffects of Bacillus subtilis biocementation on the mechanical properties of mortars
This study aims to evaluate the influence of B. subtilis AP91 spores addition on the mechanical properties of mortars. B. subtilis strain AP91, isolated from rice leaves of the needle variety, which has an early cycle of production, was used at the concentration of 105 spores/mL in mortars with cement-to-sand ratio of 1:3 (by weight) and water-to-cement ratio (w/c) of 0.63. These spores were added in two different ways: in the mixing water and by immersion in a solution containing bacterial spores. Scanning Electron Microscope (SEM) analysis showed crystals with calcium peaks on the EDS, which possibly indicates the presence of bioprecipitated calcium carbonate. The results obtained in the mechanical analysis showed that the bioprecipitation of CaCO3 by B. subtilis strain AP91 was satisfactory, particularly when the spores were added in the mixing water, increasing the compressive strength up to 31%. Thus, it was concluded that the addition of B. subtilis AP91 spores in the mixing water of cement mortars induced biocementation, which increased the compressive strength. This bioprecipitation of calcium carbonate may very well have other advantageous consequences, such as the closure of pores and cracks in cementitious materials that could improve durability properties, although more research is still needed on this matter.
- Open Access
- 1 January 2019
- Published by Universidad Nacional de Colombia in DYNA
- Vol. 86 (208) , 264-270
Initial study of Eucalyptus Wood Ash (EWA) as a mineral admixture in concrete
This study evaluated the possibility of using in natura Eucalyptus Wood Ash (EWA) from aviary furnaces as a mineral admixture in concrete. The ash was 100 mesh-sieved and added to the mix in 5, 10, 15 and 20% of the cement bulk. Physical analysis unveiled that EWA has a specific gravity higher than other organic originated residues, whereas its BET specific surface area is not enough to enhance its filler and/or pozzolanic effects. Chemically, the residue presented a low organic matter rate and a SAI below the minimum required by the Brazilian standards. EWA interfered in the times of cement set, increasing them, while FTIR unveiled mainly the presence of calcium carbonate bonds. The admixture compromised the concretes mechanical performance, leading to the conclusion that the sieving procedure of EWA alone is not enough do admit its usage as a mineral admixture.
- 1 January 2019
- Published by Universidad Nacional de Colombia in DYNA
- Vol. 86 (208) , 264-270
Open AccessInitial study of Eucalyptus Wood Ash (EWA) as a mineral admixture in concrete
This study evaluated the possibility of using in natura Eucalyptus Wood Ash (EWA) from aviary furnaces as a mineral admixture in concrete. The ash was 100 mesh-sieved and added to the mix in 5, 10, 15 and 20% of the cement bulk. Physical analysis unveiled that EWA has a specific gravity higher than other organic originated residues, whereas its BET specific surface area is not enough to enhance its filler and/or pozzolanic effects. Chemically, the residue presented a low organic matter rate and a SAI below the minimum required by the Brazilian standards. EWA interfered in the times of cement set, increasing them, while FTIR unveiled mainly the presence of calcium carbonate bonds. The admixture compromised the concretes mechanical performance, leading to the conclusion that the sieving procedure of EWA alone is not enough do admit its usage as a mineral admixture.
- Open Access
- 10 December 2018
- Published by Complexo de Ensino Superior Meridional S.A. in Revista de Engenharia Civil IMED
- Vol. 5 (2) , 84-98
Efeitos da substituição parcial do agregado miúdo por cinza de madeira de eucalipto nas propriedades das argamassas
O desenvolvimento da avicultura de corte no Brasil tem causado um considerável aumento na demanda pelos combustíveis utilizados para aquecimento do ambiente interno das granjas. Dentre esses, destaca-se a lenha de eucalipto, que ao ser queimada produz cinzas residuais que muitas vezes não recebem destinação adequada. Nesse contexto, o uso da cinza de madeira de eucalipto (CME) em substituição parcial à areia natural em argamassas foi investigado. As areias utilizadas foram separadas em três frações granulométricas da areia normal, avaliando-se a massa específica, massa unitária, superfície específica e teor de matéria orgânica. As argamassas foram produzidas com traço 1:3, em volume, com índice de consistência fixado em 250 ± 10mm e teores de substituição de 0, 10 e 20% da areia natural por CME. No estado fresco, as argamassas foram avaliadas quanto à massa específica e, em estado endurecido, quanto à absorção de água, massa específica, índice de vazios e resistência à compressão axial. Os ensaios realizados indicaram a viabilidade técnica da substituição da areia natural por CME em teores de até 10% de seu volume, sem prejuízo significativo às propriedades avaliadas.
- 10 December 2018
- Published by Complexo de Ensino Superior Meridional S.A. in Revista de Engenharia Civil IMED
- Vol. 5 (2) , 84-98
Open AccessEfeitos da substituição parcial do agregado miúdo por cinza de madeira de eucalipto nas propriedades das argamassas
O desenvolvimento da avicultura de corte no Brasil tem causado um considerável aumento na demanda pelos combustíveis utilizados para aquecimento do ambiente interno das granjas. Dentre esses, destaca-se a lenha de eucalipto, que ao ser queimada produz cinzas residuais que muitas vezes não recebem destinação adequada. Nesse contexto, o uso da cinza de madeira de eucalipto (CME) em substituição parcial à areia natural em argamassas foi investigado. As areias utilizadas foram separadas em três frações granulométricas da areia normal, avaliando-se a massa específica, massa unitária, superfície específica e teor de matéria orgânica. As argamassas foram produzidas com traço 1:3, em volume, com índice de consistência fixado em 250 ± 10mm e teores de substituição de 0, 10 e 20% da areia natural por CME. No estado fresco, as argamassas foram avaliadas quanto à massa específica e, em estado endurecido, quanto à absorção de água, massa específica, índice de vazios e resistência à compressão axial. Os ensaios realizados indicaram a viabilidade técnica da substituição da areia natural por CME em teores de até 10% de seu volume, sem prejuízo significativo às propriedades avaliadas.