Martin Uhlig
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Martin Uhlig has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Regine von Klitzing
Soft Matter at Interfaces, Department of Physics, Technische Universität Darmstadt, Darmstadt, Germany
3 shared publications Regine von Klitzing
TU Darmstadt, Center of Smart Interfaces, Department of Physics, Alarich-Weiss-Str. 10, D-64287 Darmstadt, Germany
2 shared publications- Reinhard Miller
Institute for Condensed Matter Physics, Technical University of Darmstadt, 64289 Darmstadt, Germany
2 shared publications - Richard A. Campbell
Division of Pharmacy and Optometry, Faculty of Biology, Medicine and Health, University of Manchester, Oxford Road, Manchester M13 9PT, U.K.
2 shared publications A. Ebraheme
1 shared publicationAndreas B. Fall
Department of Fibre and Polymer Technology, and Wallenberg Wood Science Centre, KTH Royal Institute of Technology, School of Chemical Science and Engineering , Teknikringen 56, 10044 Stockholm, Sweden
1 shared publication
Latest Publications
- Open Access
- 20 December 2019
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (6) , 952-955
New structural approach to rationalize the foam film stability of oppositely charged polyelectrolyte/surfactant mixtures
The foam film stability of polyelectrolyte/surfactant mixtures is rationalized using structural data from neutron reflectometry for the first time.
- 20 December 2019
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (6) , 952-955
Open AccessNew structural approach to rationalize the foam film stability of oppositely charged polyelectrolyte/surfactant mixtures
The foam film stability of polyelectrolyte/surfactant mixtures is rationalized using structural data from neutron reflectometry for the first time.
- 1 November 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 188, 451-457
Biopolymers for dye removal via foam separation
- 1 November 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 188, 451-457
Biopolymers for dye removal via foam separation
- 1 September 2017
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 247, 130-148
Polymers and surfactants at fluid interfaces studied with specular neutron reflectometry
- 1 September 2017
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 247, 130-148
Polymers and surfactants at fluid interfaces studied with specular neutron reflectometry
- 17 June 2016
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 18 (27) , 18414-18423
Surface adsorption of sulfonated poly(phenylene sulfone)/C 14 TAB mixtures and its correlation with foam film stability
Polyelectrolyte/surfactant mixtures of rigid monosulfonated poly(phenylene sulfone) (sPSO 2 -220) and tetradecyl trimethylammonium bromide (C 14 TAB) were investigated by surface tension, surface elasticity and foam film stability measurements.
- 17 June 2016
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 18 (27) , 18414-18423
Surface adsorption of sulfonated poly(phenylene sulfone)/C 14 TAB mixtures and its correlation with foam film stability
Polyelectrolyte/surfactant mixtures of rigid monosulfonated poly(phenylene sulfone) (sPSO 2 -220) and tetradecyl trimethylammonium bromide (C 14 TAB) were investigated by surface tension, surface elasticity and foam film stability measurements.
- 4 January 2016
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 32 (2) , 442-450
Two-Dimensional Aggregation and Semidilute Ordering in Cellulose Nanocrystals
The structural properties and aggregation behavior of carboxymethylated cellulose nanocrystals (CNC-COOH), was analyzed with small angle neutron scattering (SANS), transmission electron microscopy (TEM), atomic force microscopy (AFM) and dynamic light scattering (DLS) and compared to sulfuric acid hydrolyzed cellulose nanocrystals (CNC-SO3H). The CNC-COOH system, prepared from single carboxymethylated cellulose nanofibrils, was shown to laterally aggregate into 2D-stacks that were stable both in bulk solution and when adsorbed to surfaces. CNC-SO3H also showed a 2D aggregate structure with similar cross sectional dimensions (a width to height ratio of 8) as CNC-COOH, but a factor of 2 shorter length. SANS and DLS revealed a reversible ordering of the 2D aggregates under semi-dilute conditions and a structure peak was observed for both systems. This indicates an early stage of liquid crystalline arrangement of the crystal aggregates, at concentrations below those assessed using birefringence or polarized microscopy.
- 4 January 2016
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 32 (2) , 442-450
Two-Dimensional Aggregation and Semidilute Ordering in Cellulose Nanocrystals
The structural properties and aggregation behavior of carboxymethylated cellulose nanocrystals (CNC-COOH), was analyzed with small angle neutron scattering (SANS), transmission electron microscopy (TEM), atomic force microscopy (AFM) and dynamic light scattering (DLS) and compared to sulfuric acid hydrolyzed cellulose nanocrystals (CNC-SO3H). The CNC-COOH system, prepared from single carboxymethylated cellulose nanofibrils, was shown to laterally aggregate into 2D-stacks that were stable both in bulk solution and when adsorbed to surfaces. CNC-SO3H also showed a 2D aggregate structure with similar cross sectional dimensions (a width to height ratio of 8) as CNC-COOH, but a factor of 2 shorter length. SANS and DLS revealed a reversible ordering of the 2D aggregates under semi-dilute conditions and a structure peak was observed for both systems. This indicates an early stage of liquid crystalline arrangement of the crystal aggregates, at concentrations below those assessed using birefringence or polarized microscopy.
- 24 September 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 119 (40) , 12877-12886
Surface Adsorption of Oppositely Charged SDS:C12TAB Mixtures and the Relation to Foam Film Formation and Stability
The complexation, surface adsorption, and foam film stabiliztation of the oppositely charged surfactants, sodium dodecyl sulfate (SDS) and dodecyl trimethylammonium bromide (C12TAB), is analyzed. The SDS:C12TAB mixing ratio is systematically varied to investigate whether the adsorption of equimolar or irregular catanionic surfactant complexes, and thus a variation in surface charge (i.e., surface excess of either SDS or C12TAB), governs foam film properties. Surface tension measurements indicate that SDS and C12TAB interact electrostatically in order to form stoichometric catanionic surfactant complexes and enhance surface adsorption. On the other hand it can be demonstrated that the SDS:C12TAB mixing ratio and, thus, a change in surface charge and composition plays a decisive role in foam film stabilization. The present study demonstrates that varying the mixing ratio between SDS and C12TAB offers a tool for tailoring surface composition and foam film properties, which are therefore not exclusively mediated by the presence of equimolar catanionic surfactant complexes. The SDS:C12TAB net amount and mixing ratio determine the type, stability, and thinning behavior of the corresponding foam film. These observations indicate the formation of a mixed surface layer, composed of the catanionic surfactant species surrounded by either free SDS or C12TAB molecules in excess. Furthermore, a systematic variation in CBF–NBF transition kinetics is rationalized on the basis of a microscopic phase transition within the foam films. Fundamental knowlegde gained from this research gives insight into the surface adsorption and foam film formation of catanionic surfactant mixtures. The study helps researchers to understand basic mechanisms of foam film stabilization and to use resources more efficiently.
- 24 September 2015
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 119 (40) , 12877-12886
Surface Adsorption of Oppositely Charged SDS:C12TAB Mixtures and the Relation to Foam Film Formation and Stability
The complexation, surface adsorption, and foam film stabiliztation of the oppositely charged surfactants, sodium dodecyl sulfate (SDS) and dodecyl trimethylammonium bromide (C12TAB), is analyzed. The SDS:C12TAB mixing ratio is systematically varied to investigate whether the adsorption of equimolar or irregular catanionic surfactant complexes, and thus a variation in surface charge (i.e., surface excess of either SDS or C12TAB), governs foam film properties. Surface tension measurements indicate that SDS and C12TAB interact electrostatically in order to form stoichometric catanionic surfactant complexes and enhance surface adsorption. On the other hand it can be demonstrated that the SDS:C12TAB mixing ratio and, thus, a change in surface charge and composition plays a decisive role in foam film stabilization. The present study demonstrates that varying the mixing ratio between SDS and C12TAB offers a tool for tailoring surface composition and foam film properties, which are therefore not exclusively mediated by the presence of equimolar catanionic surfactant complexes. The SDS:C12TAB net amount and mixing ratio determine the type, stability, and thinning behavior of the corresponding foam film. These observations indicate the formation of a mixed surface layer, composed of the catanionic surfactant species surrounded by either free SDS or C12TAB molecules in excess. Furthermore, a systematic variation in CBF–NBF transition kinetics is rationalized on the basis of a microscopic phase transition within the foam films. Fundamental knowlegde gained from this research gives insight into the surface adsorption and foam film formation of catanionic surfactant mixtures. The study helps researchers to understand basic mechanisms of foam film stabilization and to use resources more efficiently.