THTaro Hitosugi

Taro Hitosugi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Taro Hitosugi has a total of 285 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Performance of a 5 V-Class Thin-Film Li Battery at a High Current Density of ∼30 mA cm–2

    by Asuka Oi, Kazunori Nishio, Kurei Edamura, Yuki Takeda, Shigeru Kobayashi, Ryo Nakayama, Ryota Shimizu, Taro Hitosugi

    All-solid-state Li batteries operating at high current densities exceeding 10 mA cm–2 are desired for high-power and rapid-charging batteries. Therefore, battery development needs to focus on reducing the electrolyte–electrode interface resistance at high current density, which is a major contributor to internal resistance. However, methods for reducing the electrolyte–electrode interfacial resistance at high current densities remain unexplored. Here, we demonstrate charge–discharge operation at 30 mA cm–2 using Li3PS4, LiNi0.5Mn1.5O4, and Li metal as a solid electrolyte, 5 V-class positive electrode, and negative electrode, respectively. The introduction of Li3PO4 buffer layers at both Li–Li3PS4 and Li3PS4–LiNi0.5Mn1.5O4 interfaces reduced the interfacial resistance 45,000-fold. Furthermore, the introduction of a 5 nm-thick Pt layer instead of Li3PO4 at the Li–Li3PS4 interface enabled charge–discharge operation under high-current-density conditions. This quantitative study highlights the importance of designing electrochemically robust negative electrode and electrolyte interfaces for high-power 5 V-class all-solid-state Li batteries.

  • Inverted-Pyramidal Microcrystals Embedded in an Amorphous Matrix through High-Pressure Reactive Epitaxy

    by Yuki Sasahara, Masaki Kudo, Takaaki Toriyama, Masayuki Fukuda, Ryota Shimizu, Norimasa Nishiyama, Masaki Azuma, Taro Hitosugi

    High-pressure phases are often unstable at ambient pressure and amorphize during decompression, making their direct recovery as crystalline materials difficult. Here, we demonstrate a route for synthesizing crystalline particles embedded in an amorphous matrix using an unstable high-pressure phase as a transient reaction medium. An amorphous CaSiO3 film deposited on a YAlO3 single-crystal substrate was treated at 15.6 GPa and 1200 °C. After recovery to ambient pressure and temperature, faceted (Ca,Y)(Si,Al)O3 perovskite-related particles were observed at the interface between the film and substrate. Structural and compositional analyses showed that the particles formed through reactive interdiffusion between the film and substrate and grew downward into the substrate while maintaining a crystallographic relationship with the YAlO3 substrate. The particles retained crystallinity at ambient pressure, whereas the surrounding CaSiO3-rich region became amorphous. These results indicate that transient high-pressure phase formation, interfacial reaction, and selective amorphization during decompression can be combined to produce faceted crystalline particles embedded in an amorphous matrix, a structure that is difficult to obtain by conventional crystal-growth methods.

  • Low Interfacial Contact Resistance between Carbon-Based Gas Diffusion Layer and Sputter-Deposited Anatase TiO2

    by Tomohito Sudare, Reiichi Ueda, Yumie Miura, Ayaka Nakamura, Han Xu, Ryo Nakayama, Kazunori Nishio, Ryota Shimizu, Naoomi Yamada, Taro Hitosugi

    Reducing the interfacial contact resistance between separators and gas diffusion layers is critical for achieving high-power polymer-electrolyte membrane fuel cells. Stringent targets for contact resistance below 3.0 mΩ cm2 have been proposed; however, achieving such values using practical separator materials remains challenging. Here, we demonstrate that electrically conductive anatase Nb-doped TiO2 (TNO) thin films deposited onto stainless steel separators by RF magnetron sputtering exhibit a low contact resistance of 2.6 mΩ cm2 against carbon-based gas diffusion layers. Postdeposition vacuum annealing at 500 °C, suitable for practical stainless steel, reduces contact resistance. X-ray diffraction, electron backscattering diffraction, and Raman spectroscopy mapping reveal that a high carrier density (∼1021 cm–3) in Nb-doped TiO2 thin films plays a key role in reducing interfacial contact resistance. These findings highlight TNO as a promising inorganic coating material for next-generation high-power fuel cells.

  • (Invited) Autonomous Experiments for Solid Materials: From Thin Films to Bulk Synthesis

    by Taro Hitosugi

    Autonomous experiments that integrate machine learning and robotics are reshaping materials research. By automating experimental workflows and efficiently searching high-dimensional parameter spaces, these approaches markedly accelerate materials discovery and process optimization.

  • Unified Description for Redshift of C=O and Blueshift of C≡N Vibrations Observed in Li-Ion Battery Electrolytes

    by Ryoma Sasaki, Riku Kitano, Rikiya Mizobuchi, Dan Ito, Shigeru Kobayashi, Taro Hitosugi, Makoto Moriya, Yoshitaka Tateyama

    Li-ion batteries are key to sustainable energy storage, with performance governed by Li-ion solvation among anions, solvents, and additives. The solvation structure determines ion transport and interfacial reactivity, motivating molecular-level investigation. Vibrational spectroscopy (FT-IR, Raman) sensitively captures solvation effects through shifts in characteristic C=O and C≡N stretching modes. Interestingly, Li⁺ induces opposite spectral responses: a red shift for carbonyl and a blue shift for nitrile solvents. Although these phenomena have been recognized for decades, previous studies lacked a unified mechanistic explanation connecting the two opposite trends. In this study, we address to establish a unified orbital-based explanation of the vibrational shifts using neural network potential molecular dynamics (NNP-MD) and DFT-based orbital analysis. NNP-MD simulations relate the solvation structures to the vibrational properties. We then carried out quantum chemical investigation using natural bond orbital (NBO) analysis of the simplified model systems to obtain the unified quantitative description of the vibrational shift based on the electronic structure.

  • Open Access

    Materials science in the era of AI: recent trends in autonomous experimental systems and the changing role of scientists

    by Naoya Miyawaki, Taro Hitosugi

    Self-driving laboratories (SDLs) bring a paradigm shift to materials science by accelerating material development through autonomous exploration. This review explores recent SDL advances, including the evolution of search algorithms, hardware improvements, and expanded autonomy via LLM-based artificial intelligence (AI) agents. Research process transformations are discussed based on a data-acquisition "small loop" and a hypothesis-generation "large loop." As AI increasingly controls experimentation and optimization (the "small loop"), researchers need to collaborate with AI, focusing on generating overarching hypotheses and strategies (the "large loop"). Finally, from the perspective of the patent system, we argue that the conception of and responsibility for inventions ultimately remain with researchers.


  • Transparent Conductive Anatase Nb-Doped TiO 2 Obtained via Annealing in Ambient Air

    by Yumie Miura, Ryota Shimizu, Tomohito Sudare, Reiichi Ueda, Shigeru Kobayashi, Shoichiro Nakao, Tetsuya Hasegawa, Naoomi Yamada, Taro Hitosugi


  • Open Access

    Observation of proton tunneling correlated with phonons and electrons in Pd

    by Takahiro Ozawa, Ryota Shimizu, Isao Harayama, Taro Hitosugi, Daiichiro Sekiba, Katsuyuki Fukutani

    Quantum-mechanical properties substantially affect the dynamics of light particles, including hydrogen. The temperature dependence of the tunneling rate provides a clue to understanding the quantum effects. Important physics behind quantum tunneling involves the correlation with surrounding environment, such as phonons and electrons. However, this correlation is not yet well understood due to the difficulty of directly probing hydrogen hopping. Taking advantage of nuclear reaction analysis and resistance measurements, we successfully observed hydrogen hopping from tetrahedral to octahedral sites in palladium. The hydrogen hopping is observed even at low temperatures owing to the quantum tunneling. The tunneling rate reveals a slightly positive and negative temperature dependence above and below 20 kelvin, respectively. The former is explained by the phonon effects. The latter is attributed to the nonadiabatic effects of conduction electrons, whose coupling constant K was derived to be 0.41 ± 0.03 from its temperature ( T ) dependence described as T 2 K –1 .


  • Lyotropic Polymer Liquid Crystal Coating: Enabling Lamellar Ion-Conduction Pathways for Superior C-Rate Performance in NCM523 Cathodes

    by Mayeesha Marium, Kentaro Aoki, Yang He, Katsuhiro Yamamoto, Athchaya Suwansoontorn, Seiya Ikuta, Mitsuo Hara, Shusaku Nagano, Yuki Nagao, Kei Nishikawa, et al.


  • Open Access

    Space Charge Layer Evolution in All-Solid-State Batteries Probed via Operando Kelvin Probe Force Microscopy and Nuclear Reaction Analysis

    by Chao Zhu, Shigeru Kobayashi, Yuki Sugisawa, Franjo Weber, Kun-Han Lin, Miho Kitamura, Koji Horiba, Hiroshi Kumigashira, Kazunori Nishio, Ryota Shimizu, et al.

    The current controversies about the role of space charge layers hinder the development of better solid-solid interfaces and, thus, the improvement of solid-state batteries (ASSBs). To overcome this, we have combined high spatial resolution and nondestructive techniques, operando heterodyne Kelvin probe force microscopy (KPFM), and operando nuclear reaction analysis (NRA) to conduct a study of space charge layers in ASSBs. A model thin-film ASSB was fabricated from lithium (Li)|Li3PO4 (LPO)|LiCoO2 (LCO) for this study. This battery excels due to negligible interfacial defects and side reactions. For a working battery voltage range from 3.0 to 4.3 V vs Li/Li+, a space charge layer mainly exists at the LPO|LCO interface. This space charge layer with a width 2 at 4.3 V vs Li/Li+. The absolute value of interfacial resistance from space charge layer formation is much smaller compared with the bulk solid electrolyte resistance in the fabricated thin-film ASSB. By employing KPFM and NRA techniques in ASSB research, our knowledge of space charge layer evolution at the solid electrolyte electrode interface is more comprehensive, even beyond the investigation of space charge layers.