Yuanjian Xu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yuanjian Xu has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
Hongzhen Chen
Key Laboratory of Reservoir Aquatic Environment, Chongqing Institute of Green and Intelligent Technology, Chinese Academy of Sciences, Chongqing, 400714, China
5 shared publicationsYee-Hing Lai
Department of Chemistry, National University of Singapore, 10 Kent Ridge Crescent, Singapore 119260, Forest Research Centre, Sepilok, Sandakan, Sabah, Malaysia, and Forest Research Institute of Malaysia, Kepong, Malaysia
4 shared publicationsDongyuan Li
School of Petroleum Engineering, Southwest Petroleum University, Chengdu, 610500, China
3 shared publications- Fengjun Yin
Chongqing Institute of Green and Intelligent Technology, Chinese Academy of Sciences, Chongqing 400714, China
3 shared publications Shu Yang
3 shared publicationsSwee-Hock Goh
Department of Chemistry, National University of Singapore, 10 Kent Ridge Crescent, Singapore 119260, Forest Research Centre, Sepilok, Sandakan, Sabah, Malaysia, and Forest Research Institute of Malaysia, Kepong, Malaysia
3 shared publications
Latest Publications
- 1 February 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 384, 121225
Continuous supercritical water oxidation treatment of oil-based drill cuttings using municipal sewage sludge as diluent
- 1 February 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 384, 121225
Continuous supercritical water oxidation treatment of oil-based drill cuttings using municipal sewage sludge as diluent
- 17 January 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (7) , 7216-7227
Static decontamination of oil-based drill cuttings with pressurized hot water using response surface methodology
Separating organic pollutants from oil-based drill cuttings (OBDC) is the current trend for its safe disposal. In this study, pressurized hot water extraction (PHWE) was adapted to decontaminate OBDC for the first time. Two typical OBDC samples, i.e., diesel-based drill cuttings (OBDC-A) and white oil-based drill cuttings (OBDC-B), were statically extracted in a homemade batch autoclave. Response surface methodology (RSM) with a central composite design (CCD) was applied to investigate the effects and interactive effects of three independent operating parameters (temperature, extraction time, and water volume) and to ultimately optimize the PHWE process. The results suggested that temperature is the dominant parameter, followed by water volume and extraction time. Interactive effects among the three parameters are present in the PHWE of OBDC-A but absent in the PHWE of OBDC-B. The suitable conditions for the effective PHWE of OBDC-A were found to be a temperature of 284–300 °C, water volume of 15–35 ml, and extraction time of 20–60 min. The corresponding conditions were 237–300 °C, 15–35 ml, and 20–60 min for the PHWE of OBDC-B. These different phenomena are caused by the different characteristics of the two OBDC samples. All of the polynomial models obtained from the RSM experiments are very valid and can adequately describe the relationship among the three independent operating parameters and responses. The experimental results also confirmed that PHWE is a more efficient separation technique for decontaminating OBDC than single organic solvent extraction or low-temperature thermal desorption because PHWE integrates the advantages of both these processes.
- 17 January 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 26 (7) , 7216-7227
Static decontamination of oil-based drill cuttings with pressurized hot water using response surface methodology
Separating organic pollutants from oil-based drill cuttings (OBDC) is the current trend for its safe disposal. In this study, pressurized hot water extraction (PHWE) was adapted to decontaminate OBDC for the first time. Two typical OBDC samples, i.e., diesel-based drill cuttings (OBDC-A) and white oil-based drill cuttings (OBDC-B), were statically extracted in a homemade batch autoclave. Response surface methodology (RSM) with a central composite design (CCD) was applied to investigate the effects and interactive effects of three independent operating parameters (temperature, extraction time, and water volume) and to ultimately optimize the PHWE process. The results suggested that temperature is the dominant parameter, followed by water volume and extraction time. Interactive effects among the three parameters are present in the PHWE of OBDC-A but absent in the PHWE of OBDC-B. The suitable conditions for the effective PHWE of OBDC-A were found to be a temperature of 284–300 °C, water volume of 15–35 ml, and extraction time of 20–60 min. The corresponding conditions were 237–300 °C, 15–35 ml, and 20–60 min for the PHWE of OBDC-B. These different phenomena are caused by the different characteristics of the two OBDC samples. All of the polynomial models obtained from the RSM experiments are very valid and can adequately describe the relationship among the three independent operating parameters and responses. The experimental results also confirmed that PHWE is a more efficient separation technique for decontaminating OBDC than single organic solvent extraction or low-temperature thermal desorption because PHWE integrates the advantages of both these processes.
- 5 March 2018
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 229 (3) , 102
Behaviors of Organic and Heavy Metallic Pollutants during Supercritical Water Oxidation of Oil-Based Drill Cuttings
- 5 March 2018
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 229 (3) , 102
Behaviors of Organic and Heavy Metallic Pollutants during Supercritical Water Oxidation of Oil-Based Drill Cuttings
- 1 June 2017
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 332, 205-213
Supercritical water oxidation of oil-based drill cuttings
- 1 June 2017
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 332, 205-213
Supercritical water oxidation of oil-based drill cuttings
- 1 December 2015
- Published by Elsevier in Bioresource Technology
- Vol. 198, 351-357
A detailed kinetic model for the hydrothermal decomposition process of sewage sludge
- 1 December 2015
- Published by Elsevier in Bioresource Technology
- Vol. 198, 351-357
A detailed kinetic model for the hydrothermal decomposition process of sewage sludge
- 1 March 2015
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 23, 307-315
Removal of Cu2+ from aqueous solution by adsorption onto mercapto functionalized palygorskite
- 1 March 2015
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 23, 307-315
Removal of Cu2+ from aqueous solution by adsorption onto mercapto functionalized palygorskite
- 15 January 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (17) , 12624-12637
Development and application of a novel screening method and experimental use of the mutant bacterial strain Clostridium beijerinckii NCIMB 8052 for production of butanol via fermentation of fresh cassava
Classic chemical mutagenesis has a demonstrated potential to create a strain ofClostridiumwith improved fermentation performance for obtaining high butanol yield.
- 15 January 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (17) , 12624-12637
Development and application of a novel screening method and experimental use of the mutant bacterial strain Clostridium beijerinckii NCIMB 8052 for production of butanol via fermentation of fresh cassava
Classic chemical mutagenesis has a demonstrated potential to create a strain ofClostridiumwith improved fermentation performance for obtaining high butanol yield.
- 30 September 2014
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 225 (10) , 1-13
Sorption Stability and Mechanism Exploration of Palygorskite as Immobilization Agent for Cd in Polluted Soil
- 30 September 2014
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 225 (10) , 1-13
Sorption Stability and Mechanism Exploration of Palygorskite as Immobilization Agent for Cd in Polluted Soil
- 1 April 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 88, 117-125
Study of transpiring fluid dynamics in supercritical water oxidation using a transparent reactor
- 1 April 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 88, 117-125
Study of transpiring fluid dynamics in supercritical water oxidation using a transparent reactor