KJKjell Jeppson

Kjell Jeppson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kjell Jeppson has a total of 46 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Parameter Extraction Methodology for Graphene Field-Effect Transistors

    by Kjell Jeppson

    Graphene field-effect transistors (GFETs) have now been around for more than a decade and their transfer characteristics extensively used for device characterization. Model parameters, such as low-field charge-carrier mobility and device contact/series resistance, have often been the main interest. However, not until recently have the methods for device characterization themselves been the focus of research publications. In this article, I report on a structured methodology for extracting and validating the extracted GFET model parameter values based on the physics of FETs in general and of GFETs in particular. During the extraction process, the GFET resistance is divided into two parts, a constant part and a gate-voltage-dependent part, where the constant part often has been believed to represent the series/contact resistance. However, part of it depends on the channel length and contains first-order information about mobility degradation. Finally, I show that the main influence of the quantum capacitance can be captured by an equivalent oxide thickness (EOT) replacing the insulator thickness.


  • Graphene FET on Diamond for High-Frequency Electronics

    by M. Asad, S. Majdi, A. Vorobiev, K. Jeppson, J. Isberg, J. Stake

    Transistors operating at high frequencies are the basic building blocks of millimeter-wave communication and sensor systems. The high charge-carrier mobility and saturation velocity in graphene can open way for ultra-fast field-effect transistors with a performance even better than what can be achieved with III-V-based semiconductors. However, the progress of high-speed graphene transistors has been hampered by fabrication issues, influence of adjacent materials, and self-heating effects. Here, we report on the improved performance of graphene field-effect transistors (GFETs) obtained by using a diamond substrate. An extrinsic maximum frequency of oscillation ${f}_{{\mathrm {max}}}$ of up to 54 GHz was obtained for a gate length of 500 nm. Furthermore, the high thermal conductivity of diamond provides an efficient heat-sink, and the relatively high optical phonon energy of diamond contributes to an increased charge-carrier saturation velocity in the graphene channel. Moreover, we show that GFETs on diamond exhibit excellent scaling behavior for different gate lengths. These results promise that the GFET-on-diamond technology has the potential of reaching sub-terahertz frequency performance.


  • Mobility Degradation and Series Resistance in Graphene Field-Effect Transistors

    by Kjell Jeppson, Muhammad Asad, Jan Stake

    Accurate device models and parameter extraction methods are of utmost importance for characterizing graphene FETs (GFETs) and for predicting their performance in circuit applications. For dc characterization, accurate extraction of mobility and series resistance is of particular concern. In this article, we show how a first-order mobility degradation model can be used to separate information about mobility degradation and series resistance for a set of GFETs of different channel lengths. Data from a large set of top-gated GFETs based on chemical vapor deposited (CVD) graphene was analyzed to validate the proposed model and extraction procedures. For removing any uncertainties caused by the observed device-to-device data variations due to the uneven quality of CVD graphene, the same methods were applied to a set of closely located bottom-gated GFETs found in literature. Those GFETs were designed for transfer length methods and fabricated on exfoliated graphene of homogeneous quality. Similar mobility degradation behavior was observed for both sets of devices with the mobility being reduced to half for a voltage-induced charge carrier density of 10 13 cm -2 .


  • Enhanced High-Frequency Performance of Top-Gated Graphene FETs Due to Substrate- Induced Improvements in Charge Carrier Saturation Velocity

    by Muhammad Asad, Kjell O. Jeppson, Andrei Vorobiev, Marlene Bonmann, Jan Stake

    The high-frequency performance of top-gated graphene field-effect transistors (GFETs) depends to a large extent on the saturation velocity of the charge carriers, a velocity limited by inelastic scattering by surface optical phonons from the dielectrics surrounding the channel. In this work, we show that, by simply changing the graphene channel surrounding dielectric with a material having higher optical phonon energy, one could improve the transit frequency and maximum frequency of oscillation of GFETs. We fabricated GFETs on conventional SiO 2 /Si substrates by adding a thin Al 2 O 3 interfacial buffer layer on top of SiO 2 /Si substrates, a material with about 30% higher optical phonon energy than that of SiO 2 , and compared performance with that of GFETs fabricated without adding the interfacial layer. From S-parameter measurements, a transit frequency and a maximum frequency of oscillation of 43 and 46 GHz, respectively, were obtained for GFETs on Al 2 O 3 with 0.5- $\mu \text{m}$ gate length. These values are approximately 30% higher than those for state-of-the-art GFETs of the same gate length on SiO 2 . For relating the improvement of GFET high-frequency performance to improvements in the charge carrier saturation velocity, we used standard methods to extract the charge carrier velocity from the channel transit time. A comparison between two sets of GFETs with and without the interfacial Al 2 O 3 layer showed that the charge carrier saturation velocity had increased from $1.5\cdot 10^{{7}}$ to $2\cdot 10^{{7}}$ cm/s.


  • Open Access

    A Linear-Array of 300-GHz Antenna Integrated GFET Detectors on a Flexible Substrate

    by Xinxin Yang, Andrei Vorobiev, Jian Yang, Kjell Jeppson, Jan Stake

    Terahertz imaging has potential in a variety of applications, such as non-invasive inspection, medical examination, and security. Many of these applications call for flexible focal-plane arrays with large fields of view. Here, we demonstrate the implementation of a flexible, 300 GHz, 1x6 linear detector array based on graphene field-effect transistors and integrated bowtie antennas. Conservative estimates based on room temperature measurements at 300 GHz show element voltage responsivities in the range from 20 V/W to 70 V/W, and noise equivalent powers in the range from 0.06 nW/ $\sqrt Hz$ to 0.2 nW/ $\sqrt Hz$ . Measured radiation patterns, showing good agreement with simulations, reveal half-power beamwidths of 45 ° and 60° for H- and E-planes, respectively. Characterization of the antenna array in a curved configuration shows that the voltage response is reduced up to 3 dB compared to the flat configuration due to a decrease of the antenna directivity. We believe that our preliminary results could serve as an enabling platform for the future development of flexible antenna arrays based on GFETs for curved focal plane imaging, important for wearable sensors and many other applications.


  • Open Access

    Properties of Undoped Few-Layer Graphene-Based Transparent Heaters

    by Yong Zhang, Hao Liu, Longwang Tan, Yan Zhang, Kjell Jeppson, Bin Wei, Johan Liu

    In many applications like sensors, displays, and defoggers, there is a need for transparent and efficient heater elements produced at low cost. For this reason, we evaluated the performance of graphene-based heaters with from one to five layers of graphene on flexible and transparent polyethylene terephthalate (PET) substrates in terms of their electrothermal properties like heating/cooling rates and steady-state temperatures as a function of the input power density. We found that the heating/cooling rates followed an exponential time dependence with a time constant of just below 6 s for monolayer heaters. From the relationship between the steady-state temperatures and the input power density, a convective heat-transfer coefficient of 60 W·m−2·°C−1 was found, indicating a performance much better than that of many other types of heaters like metal thin-film-based heaters and carbon nanotube-based heaters.


  • Open Access

    Describing Broadband Terahertz Response of Graphene FET Detectors by a Classical Model

    by Xinxin Yang, Andrei Vorobiev, Kjell Jeppson, Jan Stake

    Direct power detectors based on field-effect transistors are becoming widely used for terahertz applications. However, accurate characterization at terahertz frequencies of such detectors is a challenging task. The high-frequency response is dominated by parasitic coupling and loss associated with contacts and overall layout of the component. Moreover, the performance of such detectors is complicated to predict since many different physical models are used to explain the high sensitivity at terahertz frequencies. This makes it hard to draw important conclusions about the underlying device physics for these detectors. For the first time, we demonstrate accurate and comprehensive characterization of graphene field-effect transistors from 1 GHz to 1.1 THz, simultaneously accessing the bias dependence, the scattering parameters, and the detector voltage responsivity. Within a frequency range of more than 1 THz, and over a wide bias range, we have shown that the voltage responsivity can be accurately described using a combination of a small-signal equivalent circuit model, and the second-order series expansion terms of the nonlinear dc I - V characteristic. Without bias, the measured low-frequency responsivity was 0.3 kV/W with the input signal applied to the gate, and 2 kV/W with the input signal applied to the drain. The corresponding cut-off frequencies for the two cases were 140 GHz and 50 GHz, respectively. With a 300-GHz signal applied to the gate, a voltage responsivity of 1.8 kV/W was achieved at a drain-source current of 0.2 mA. The minimum noise equivalent power was below $30 \text{pW}/\sqrt{Hz}$ in cold mode. Our results show that detection of terahertz signals in graphene field-effect transistors can be described over a wide frequency range by the nonlinear carrier transport characteristic obtained at static electrical fields. This finding is important for explaining the mechanism of detection and for further development of terahertz detectors.


  • Open Access

    Wide bandwidth terahertz mixers based on graphene FETs

    by Xinxin Yang, Andrei Vorobiev, Kjell Jeppson, Jan Stake, Luca Banszerus, Christoph Stampfer, Martin Otto, Daniel Neumaier

    In this work, we demonstrate wide RF and IF bandwidth resistive fundamental terahertz mixers based on graphene field-effect transistors. In the RF frequency range of 220-487 GHz, the 3-dB IF bandwidth is 32 GHz and 56 GHz for the mixers based on graphene field-effect transistors with the gate length of 1.2 μm and 0.6 μm, respectively. The highest conversion efficiency is estimated to be -28 dB at local oscillator power of 13 dBm. This shows that resistive fundamental terahertz mixers based on graphene field-effect transistors are promising for ultrawide band-width applications.


  • Open Access

    Thermal Characterization of Low-Dimensional Materials by Resistance Thermometers

    by Yifeng Fu, Guofeng Cui, Kjell Jeppson

    The design, fabrication, and use of a hotspot-producing and temperature-sensing resistance thermometer for evaluating the thermal properties of low-dimensional materials are described in this paper. The materials that are characterized include one-dimensional (1D) carbon nanotubes, and two-dimensional (2D) graphene and boron nitride films. The excellent thermal performance of these materials shows great potential for cooling electronic devices and systems such as in three-dimensional (3D) integrated chip-stacks, power amplifiers, and light-emitting diodes. The thermometers are designed to be serpentine-shaped platinum resistors serving both as hotspots and temperature sensors. By using these thermometers, the thermal performance of the abovementioned emerging low-dimensional materials was evaluated with high accuracy.


  • Low-frequency Noise Characterization of Graphene FET THz Detectors

    by Xinxin Yang, Andrei Vorobiev, Kjell Jeppson, Jan Stake, Luca Banszerus, Christoph Stampfer, Martin Otto, Daniel Neumaier

    Graphene field-effect transistors are promising for direct detection of THz signals at room temperature. The sensitivity of such detectors can be in part limited by the low-frequency noise. Here, we report on the characterization of the low-frequency noise of graphene field-effect transistor THz detectors in the frequency range from 1 Hz to 1 MHz. The room-temperature Hooge parameter is extracted to be around 2×10 -3 . The voltage responsivity at room-temperature and the corresponding minimum noise equivalent power at 0.3 THz are estimated to be 11 V/W and 0.2 nW/H z o.5, respectively, at a modulation frequency of 333 Hz, which shows comparable results with other detector technologies.