Ashish Kumar Singh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ashish Kumar Singh has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Seong-Ook Park
School of Electrical Engineering, Korea Advanced Institute of Science and Technology, Daejeon, South Korea
2 shared publications - Yong-Hoon Kim
Sensor System Laboratory, Department of Mechatronics, Gwangju Institute of Science and Technology (GIST)
2 shared publications - Chulki Kim
Department of Electronic Engineering, Soongsil University, Seoul 06978, Republic of Korea
1 shared publication Kyung-Bin Bae
School of Electrical Engineering, KAIST, Daejeon, Republic of Korea
1 shared publication- Muhammad Tayyab Azim
School of Electrical Engineering, Korea Advanced Institute of Science and Technology, Daejeon, South Korea
1 shared publication
Latest Publications
- 10 November 2020
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 35 (3) , 416-429
NLFM pulse radar for drone detection using predistortion technique
The development of radar technology for the detection of small drones is getting attention of researchers. In this work, the detection of drones using Ku-band radar system has been discussed. We have utilized the advantage of nonlinear frequency modulation (NLFM) waveform for the suppression of range sidelobes. The performance and sensitivity of a radar system can be related with the linearity of system response. Here, we have made an effort to minimize non-linearity in the radar system response by using digital predistortion method. In this method, amplitude weighting coefficients have been calculated based on the received data. We have used FPGA-based transceiver for intermediate frequency (IF) signal generation and data acquisition, along with Ku-band up-down converters. The radar system was first calibrated for desired frequency band using amplitude predistortion method. In this article, experiment results for the detection of single drone and two drones using NLFM pulse signal are presented.
- 10 November 2020
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 35 (3) , 416-429
NLFM pulse radar for drone detection using predistortion technique
The development of radar technology for the detection of small drones is getting attention of researchers. In this work, the detection of drones using Ku-band radar system has been discussed. We have utilized the advantage of nonlinear frequency modulation (NLFM) waveform for the suppression of range sidelobes. The performance and sensitivity of a radar system can be related with the linearity of system response. Here, we have made an effort to minimize non-linearity in the radar system response by using digital predistortion method. In this method, amplitude weighting coefficients have been calculated based on the received data. We have used FPGA-based transceiver for intermediate frequency (IF) signal generation and data acquisition, along with Ku-band up-down converters. The radar system was first calibrated for desired frequency band using amplitude predistortion method. In this article, experiment results for the detection of single drone and two drones using NLFM pulse signal are presented.
- 2 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 68 (1053587X) , 3990-4001
Doppler Shifting Technique for Generating Multi-Frames of Video SAR via Sub-Aperture Signal Processing
The signal processing technologies of synthetic aperture radar (SAR) have been vastly studied as diverse measurement modes for various applications. One of the technologies is Video-SAR (ViSAR). It is a land-imaging mode where a sequence of images is continuously formed on the spotlight mode. We propose a new signal processing method to generate the multi-frames of ViSAR using Doppler shifting technique via sub-aperture processing. The method is based on our designed wide-angle antenna, which is a corrugated horn shape with low side lobe and Gaussian beam pattern. This wide-angle antenna receives a wide Doppler band along the azimuth direction. Based on the characteristics of the antenna, we separate the wide Doppler band into each chirp pulse signal. Each of these separated signals has a different center time. Through each chirp pulse signal in Doppler domain, the proposed method generates each frame of video at a high frame rate. The proposed ViSAR processing can show high efficiency with low computation and without a fixed coordinate system. Moreover, it can also visualize a wider area on stripmap mode than the conventional ViSAR mode, and can derive the video results based on Range Doppler Algorithm (RDA). These advantages can lead to reduce economic costs and simplify the operating ViSAR system. We have performed the practical experiments using X-band chirp pulse SAR system mounted on an airplane to verify the proposed method.
- 2 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 68 (1053587X) , 3990-4001
Doppler Shifting Technique for Generating Multi-Frames of Video SAR via Sub-Aperture Signal Processing
The signal processing technologies of synthetic aperture radar (SAR) have been vastly studied as diverse measurement modes for various applications. One of the technologies is Video-SAR (ViSAR). It is a land-imaging mode where a sequence of images is continuously formed on the spotlight mode. We propose a new signal processing method to generate the multi-frames of ViSAR using Doppler shifting technique via sub-aperture processing. The method is based on our designed wide-angle antenna, which is a corrugated horn shape with low side lobe and Gaussian beam pattern. This wide-angle antenna receives a wide Doppler band along the azimuth direction. Based on the characteristics of the antenna, we separate the wide Doppler band into each chirp pulse signal. Each of these separated signals has a different center time. Through each chirp pulse signal in Doppler domain, the proposed method generates each frame of video at a high frame rate. The proposed ViSAR processing can show high efficiency with low computation and without a fixed coordinate system. Moreover, it can also visualize a wider area on stripmap mode than the conventional ViSAR mode, and can derive the video results based on Range Doppler Algorithm (RDA). These advantages can lead to reduce economic costs and simplify the operating ViSAR system. We have performed the practical experiments using X-band chirp pulse SAR system mounted on an airplane to verify the proposed method.
- Open Access
- 1 April 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (8) , 523-525
Accurate measurement of drone's blade length and rotation rate using pattern analysis with W‐band radar
Characteristics of a target are essential for the classification purpose. Input parameters such as blade length, rotation rate and a number of rotors can be used for classification of drone. An algorithm for accurate measurement of blade length and rotation rate using pattern analysis has been proposed. The time–frequency domain image is used for calculation of maximum Doppler frequency and the rotational speed of the blade. Accuracy and precision of the proposed technique are validated by experimental data using W‐band radar system.
- 1 April 2018
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 54 (8) , 523-525
Open AccessAccurate measurement of drone's blade length and rotation rate using pattern analysis with W‐band radar
Characteristics of a target are essential for the classification purpose. Input parameters such as blade length, rotation rate and a number of rotors can be used for classification of drone. An algorithm for accurate measurement of blade length and rotation rate using pattern analysis has been proposed. The time–frequency domain image is used for calculation of maximum Doppler frequency and the rotational speed of the blade. Accuracy and precision of the proposed technique are validated by experimental data using W‐band radar system.
- 19 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 18 (5) , 1895-1902
Automatic Measurement of Blade Length and Rotation Rate of Drone Using W-Band Micro-Doppler Radar
For the classification of target, one should utilize different features of target that others do not have. In case of drone as a target, classification requires input parameters such as number of blades, blade length, frame size and rotations per second (RPS). In this work, we have introduced an algorithm for automatic calculation of blade length and RPS using micro-Doppler signature. We used time-frequency domain for the analysis of received signal and the variation in micro-Doppler frequency with time gives relationship with blade length and RPS. For experimental purpose, W-band homodyne micro-Doppler radar is developed using designed low loss high gain modules of transmitter, low noise front-end and down converter. The transmitter output power is 25 dBm, front-end gain is 51 dB over 4 GHz bandwidth, and conversion loss of down converter is -12 dB. Validation of the proposed algorithm has been done by analyzing experimental data for single rotor, double rotors and quad rotors cases, measurement results achieve average error of 1.3% (with maximum 6.1% error) in estimation of blade length using W-band Doppler radar.
- 19 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 18 (5) , 1895-1902
Automatic Measurement of Blade Length and Rotation Rate of Drone Using W-Band Micro-Doppler Radar
For the classification of target, one should utilize different features of target that others do not have. In case of drone as a target, classification requires input parameters such as number of blades, blade length, frame size and rotations per second (RPS). In this work, we have introduced an algorithm for automatic calculation of blade length and RPS using micro-Doppler signature. We used time-frequency domain for the analysis of received signal and the variation in micro-Doppler frequency with time gives relationship with blade length and RPS. For experimental purpose, W-band homodyne micro-Doppler radar is developed using designed low loss high gain modules of transmitter, low noise front-end and down converter. The transmitter output power is 25 dBm, front-end gain is 51 dB over 4 GHz bandwidth, and conversion loss of down converter is -12 dB. Validation of the proposed algorithm has been done by analyzing experimental data for single rotor, double rotors and quad rotors cases, measurement results achieve average error of 1.3% (with maximum 6.1% error) in estimation of blade length using W-band Doppler radar.