Sven Holger Behrens
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Sven Holger Behrens has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
Michal Borkovec
Department of Inorganic and Analytical Chemistry, University of Geneva , Sciences II, 30 Quai Ernest-Ansermet, 1205 Geneva, Switzerland
12 shared publications- J. Carson Meredith
School of Chemical & Biomolecular Engineering, Georgia Institute of Technology, Atlanta, GA 30332-0100, USA
10 shared publications Yi Zhang
School of Chemical & Biomolecular Engineering, Georgia Institute of Technology, Atlanta, Georgia 30332-0100, USA.
7 shared publications- Adriana San-Miguel
North Carolina State University
6 shared publications Jonathan Rubin
School of Chemical & Biomolecular Engineering, Georgia Institute of Technology , Atlanta, Georgia 30332-0100, United States
6 shared publicationsJoohyung Lee
School of Chemical and Biomolecular Engineering, Georgia Institute of Technology , 311 Ferst Drive Northwest, Atlanta, Georgia 30332, United States
5 shared publications
Latest Publications
- Open Access
Oil-Coated Bubble Flotation for Separating Hydrophilic Particles from Water
Froth flotation is a widely used method for the selective separation of particulates from aqueous dispersions or slurries. This technology is based on the attachment of sufficiently hydrophobic particles to the air–water interface of gas bubbles. However, when the target particles are strongly hydrophilic, the requirement of hydrophobicity limits the effectiveness of conventional froth flotation. A prominent example is the deinking step in paper recycling, where modern hydrophilic inkjet inks are difficult to remove by flotation. In this study, we evaluated oil-coated bubble flotation as an alternative to conventional air flotation for removing inkjet ink from pulped newsprint. We examined the effects of oil type, salt type and concentration, and pH on deinking efficiency. Compared with traditional air flotation, oil-coated bubble flotation produced substantial improvements in standard performance metrics, including ISO brightness, effective residual ink concentration (ERIC), and the fiber retention of recycled paper pads.
Open AccessOil-Coated Bubble Flotation for Separating Hydrophilic Particles from Water
Froth flotation is a widely used method for the selective separation of particulates from aqueous dispersions or slurries. This technology is based on the attachment of sufficiently hydrophobic particles to the air–water interface of gas bubbles. However, when the target particles are strongly hydrophilic, the requirement of hydrophobicity limits the effectiveness of conventional froth flotation. A prominent example is the deinking step in paper recycling, where modern hydrophilic inkjet inks are difficult to remove by flotation. In this study, we evaluated oil-coated bubble flotation as an alternative to conventional air flotation for removing inkjet ink from pulped newsprint. We examined the effects of oil type, salt type and concentration, and pH on deinking efficiency. Compared with traditional air flotation, oil-coated bubble flotation produced substantial improvements in standard performance metrics, including ISO brightness, effective residual ink concentration (ERIC), and the fiber retention of recycled paper pads.
- 14 September 2023
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 23 (20) , 4434-4444
Bubble-particle dynamics in multiphase flow of capillary foams in a porous micromodel
Surfactant-free capillary foams (CFs) are known to be remarkably tolerant to oil, and possess unique stability and flow properties, studied here for the first time in poros media.
- 14 September 2023
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 23 (20) , 4434-4444
Bubble-particle dynamics in multiphase flow of capillary foams in a porous micromodel
Surfactant-free capillary foams (CFs) are known to be remarkably tolerant to oil, and possess unique stability and flow properties, studied here for the first time in poros media.
- Open Access
- 1 May 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (18) , 7031-7039
Effect of Shear on Pumped Capillary Foams
- 1 May 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (18) , 7031-7039
Open AccessEffect of Shear on Pumped Capillary Foams
- 6 January 2022
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 22 (2) , 554-560
Programming Semiconductor Nanowire Composition with Sub-100 nm Resolution via the Geode Process
We demonstrate the vapor–liquid–solid growth of single-crystalline i-Si, i-Si/n-Si, and SixGe1–x/SiyGe1–y nanowires via the Geode process. By enabling nanowire growth on the large internal surface area of a microcapsule powder, the Geode process improves the scalability of semiconductor nanowire manufacturing while maintaining nanoscale programmability. Here, we show that heat and mass transport limitations introduced by the microcapsule wall are negligible, enabling the same degree of compositional control for nanowires grown inside microcapsules and on conventional flat substrates. Efficient heat and mass transport also minimize the structural variations of nanowires grown in microcapsules with different diameters and wall thicknesses. Nanowires containing at least 16 segments and segment lengths below 75 nm are demonstrated.
- 6 January 2022
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 22 (2) , 554-560
Programming Semiconductor Nanowire Composition with Sub-100 nm Resolution via the Geode Process
We demonstrate the vapor–liquid–solid growth of single-crystalline i-Si, i-Si/n-Si, and SixGe1–x/SiyGe1–y nanowires via the Geode process. By enabling nanowire growth on the large internal surface area of a microcapsule powder, the Geode process improves the scalability of semiconductor nanowire manufacturing while maintaining nanoscale programmability. Here, we show that heat and mass transport limitations introduced by the microcapsule wall are negligible, enabling the same degree of compositional control for nanowires grown inside microcapsules and on conventional flat substrates. Efficient heat and mass transport also minimize the structural variations of nanowires grown in microcapsules with different diameters and wall thicknesses. Nanowires containing at least 16 segments and segment lengths below 75 nm are demonstrated.
- 26 August 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (35) , 10510-10520
Structure–Property Relationship in Capillary Foams
The recently discovered capillary foams are aqueous foams stabilized by the synergistic action of colloidal particles and a small amount of oil. Characteristically, their gas bubbles are coated by a particle-stabilized layer of oil and embedded in a gel network of oil-bridged particles. This unique foam architecture offers opportunities for engineering new foam-related materials and processes, but the necessary understanding of its structure–property relations is still in its infancy. Here, we study the effects of particle wettability, particle volume fraction, and oil-to-particle ratio on the structure and selected properties of capillary foams and use our findings to relate measured foamability, foam stability, and rheological key parameters to the observed foam microstructure. We see that particle wettability not only determines the type of gel network formed but also influences the prevalence of oil droplets included within the foam. Our results further show that the stability and rheology of capillary foams are mainly a function of the particle volume fraction whereas the foamability and observed microstructure are sensitive also to the oil-to-particle ratio. These insights expand our fundamental understanding of capillary foams and will greatly facilitate future work on new foam formulations.
- 26 August 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (35) , 10510-10520
Structure–Property Relationship in Capillary Foams
The recently discovered capillary foams are aqueous foams stabilized by the synergistic action of colloidal particles and a small amount of oil. Characteristically, their gas bubbles are coated by a particle-stabilized layer of oil and embedded in a gel network of oil-bridged particles. This unique foam architecture offers opportunities for engineering new foam-related materials and processes, but the necessary understanding of its structure–property relations is still in its infancy. Here, we study the effects of particle wettability, particle volume fraction, and oil-to-particle ratio on the structure and selected properties of capillary foams and use our findings to relate measured foamability, foam stability, and rheological key parameters to the observed foam microstructure. We see that particle wettability not only determines the type of gel network formed but also influences the prevalence of oil droplets included within the foam. Our results further show that the stability and rheology of capillary foams are mainly a function of the particle volume fraction whereas the foamability and observed microstructure are sensitive also to the oil-to-particle ratio. These insights expand our fundamental understanding of capillary foams and will greatly facilitate future work on new foam formulations.
- 1 December 2020
- Published by Elsevier in Current Opinion in Colloid & Interface Science
- Vol. 50, 101384
Oil-coated bubbles in particle suspensions, capillary foams, and related opportunities in colloidal multiphase systems
- 1 December 2020
- Published by Elsevier in Current Opinion in Colloid & Interface Science
- Vol. 50, 101384
Oil-coated bubbles in particle suspensions, capillary foams, and related opportunities in colloidal multiphase systems
- 10 June 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (29) , 6725-6732
Rheology of capillary foams
Capillary foams display some rheological features characteristic of classical surfactant stabilized foams, although their architecture more closely resembles that of colloidal gel foams.
- 10 June 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (29) , 6725-6732
Rheology of capillary foams
Capillary foams display some rheological features characteristic of classical surfactant stabilized foams, although their architecture more closely resembles that of colloidal gel foams.
- 11 May 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 122 (22) , 6101-6106
Interfaces Charged by a Nonionic Surfactant
Highly hydrophobic, water-insoluble nonionic surfactants are often considered irrelevant to the ionization of interfaces at which they adsorb despite observations that suggest otherwise. In the present study, we provide unambiguous evidence for the participation of a water-insoluble surfactant in interfacial ionization by conducting electrophoresis experiments for surfactant-stabilized nonpolar oil droplets in aqueous continuous phase. It was found that the surfactant with amine headgroup positively charged the surface of oil suspended in aqueous continuous phase (oil/water interface), which is consistent to its chemically “basic” nature. In nonpolar oil continuous phase, the same surfactant positively charged the surface of solid silica (solid/oil interface) which is frequently considered chemically “acidic”. The latter observation is exactly opposite to what the traditional acid-base mechanism of surface charging would predict, most clearly suggesting the possibility for another charging mechanism.
- 11 May 2018
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 122 (22) , 6101-6106
Interfaces Charged by a Nonionic Surfactant
Highly hydrophobic, water-insoluble nonionic surfactants are often considered irrelevant to the ionization of interfaces at which they adsorb despite observations that suggest otherwise. In the present study, we provide unambiguous evidence for the participation of a water-insoluble surfactant in interfacial ionization by conducting electrophoresis experiments for surfactant-stabilized nonpolar oil droplets in aqueous continuous phase. It was found that the surfactant with amine headgroup positively charged the surface of oil suspended in aqueous continuous phase (oil/water interface), which is consistent to its chemically “basic” nature. In nonpolar oil continuous phase, the same surfactant positively charged the surface of solid silica (solid/oil interface) which is frequently considered chemically “acidic”. The latter observation is exactly opposite to what the traditional acid-base mechanism of surface charging would predict, most clearly suggesting the possibility for another charging mechanism.
- 14 March 2018
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 14 (14) , 2724-2734
The dynamics of rising oil-coated bubbles: experiments and simulations
Air bubbles rising through an aqueous medium have been studied extensively and are routinely used for the separation of particulates via froth flotation, a key step in many industrial processes. Oil-coated bubbles can be more effective for separating hydrophilic particles with low affinity for the air–water interface, but the rise dynamics of oil-coated bubbles has not yet been explored. In the present work, we report the first systematic study of the shape and rise trajectory of bubbles engulfed in a layer of oil. Results from direct observation of the coated bubbles with a high-speed camera are compared to computer simulations and confirm a pronounced effect of the oil coat on the bubble dynamics. We consistently find that the oil-coated bubbles display a more spherical shape and straighter trajectory, yet slower rise than uncoated bubbles of comparable size. These characteristics may provide practical benefits for flotation separations with oil-coated bubbles.
- 14 March 2018
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 14 (14) , 2724-2734
The dynamics of rising oil-coated bubbles: experiments and simulations
Air bubbles rising through an aqueous medium have been studied extensively and are routinely used for the separation of particulates via froth flotation, a key step in many industrial processes. Oil-coated bubbles can be more effective for separating hydrophilic particles with low affinity for the air–water interface, but the rise dynamics of oil-coated bubbles has not yet been explored. In the present work, we report the first systematic study of the shape and rise trajectory of bubbles engulfed in a layer of oil. Results from direct observation of the coated bubbles with a high-speed camera are compared to computer simulations and confirm a pronounced effect of the oil coat on the bubble dynamics. We consistently find that the oil-coated bubbles display a more spherical shape and straighter trajectory, yet slower rise than uncoated bubbles of comparable size. These characteristics may provide practical benefits for flotation separations with oil-coated bubbles.
- 15 August 2017
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 56 (34) , 9533-9540
Capillary Foams: Formation Stages and Effects of System Parameters
- 15 August 2017
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 56 (34) , 9533-9540
Capillary Foams: Formation Stages and Effects of System Parameters