Mohamed Abbes
Mohamed Abbes has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Jamel Belhadj
Université de Tunis EL Manar, ENIT, L.S.E., LR 11 ES 15, B.P.37, 1002 Tunis Tunisia
4 shared publications- Afef Bennani-Ben Abdelghani
Electrical Systems Laboratory, University of Tunis El Manar, Tunis 1068, Tunisia
1 shared publication - Jamel Belhadj
LR 11 ES 15, Ecole Nationale d’Ingénieurs de Tunis, Laboratoire Des Systèmes Electriques, Université de Tunis El Manar, Le Belvédère, Tunisia
1 shared publication Mehdi Allagui
Universit de Tunis,Laboratory LaTICE, ENSIT,Tunis,Tunisia
1 shared publication
Latest Publications
- 16 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Comparative Analysis of Droop Control Techniques for Voltage Stability in DC Microgrids
The main control objective in stand-alone DC microgrids is to keep constant the DC bus voltage. When droop control is adopted, several generation units participate in DC voltage control. The objective of this work is to evaluate the control performances of droop control techniques. A comparative analysis is performed for two mode of droop control; the voltage droop mode (V-I) and the current/voltage mode (I-V). The micro-grid operation with the two control techniques was simulated considering rapid variation of the loads in order to investigate voltage stability. The Voltage Deviation Index (VDI) and the Load sharing equilibrium were used to measure the control performances with the two control methods.
- 16 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Comparative Analysis of Droop Control Techniques for Voltage Stability in DC Microgrids
The main control objective in stand-alone DC microgrids is to keep constant the DC bus voltage. When droop control is adopted, several generation units participate in DC voltage control. The objective of this work is to evaluate the control performances of droop control techniques. A comparative analysis is performed for two mode of droop control; the voltage droop mode (V-I) and the current/voltage mode (I-V). The micro-grid operation with the two control techniques was simulated considering rapid variation of the loads in order to investigate voltage stability. The Voltage Deviation Index (VDI) and the Load sharing equilibrium were used to measure the control performances with the two control methods.
- Open Access
- 1 March 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Supervisory control strategy for optimal integration of direct drive wind turbine to the grid
The main attention of this paper is to improve the integration of wind energy systems to the grid. Therefore, a new supervision scheme for a 2MW direct drive wind turbine is proposed. It aims to satisfy the new Grid Connection Requirements (GCR), where the lowest voltage dip that wind farms must withstand can reach 0% of nominal voltage. The power electronics interface of the investigated wind turbine consists of a back-to-back voltage source converter. The three-level, Neutral Point Clamped topology is used since multi-level converters are suitable for high power applications. Power limitation is achieved by pitch control. Supervision algorithm adapts the control strategy according to the different operating conditions. Thus, wind turbine safety during faults is guaranteed and it can provide ancillary services, necessary for power system stability. Performances are evaluated in terms of accordance with GCR including, low voltage ride-through capabilities, power limitation and reactive power control.
- 1 March 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Open AccessSupervisory control strategy for optimal integration of direct drive wind turbine to the grid
The main attention of this paper is to improve the integration of wind energy systems to the grid. Therefore, a new supervision scheme for a 2MW direct drive wind turbine is proposed. It aims to satisfy the new Grid Connection Requirements (GCR), where the lowest voltage dip that wind farms must withstand can reach 0% of nominal voltage. The power electronics interface of the investigated wind turbine consists of a back-to-back voltage source converter. The three-level, Neutral Point Clamped topology is used since multi-level converters are suitable for high power applications. Power limitation is achieved by pitch control. Supervision algorithm adapts the control strategy according to the different operating conditions. Thus, wind turbine safety during faults is guaranteed and it can provide ancillary services, necessary for power system stability. Performances are evaluated in terms of accordance with GCR including, low voltage ride-through capabilities, power limitation and reactive power control.
- 1 July 2012
- Published by Elsevier in Electric Power Systems Research
- Vol. 88, 52-63
New control method of a robust NPC converter for renewable energy sources grid connection
- 1 July 2012
- Published by Elsevier in Electric Power Systems Research
- Vol. 88, 52-63
New control method of a robust NPC converter for renewable energy sources grid connection
- 1 March 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-10
Investigation of wind characteristics and wind power potential in El-Kef region, Tunisia
This paper gives an estimation of the wind power that potentially could be generated by wind farms in the El-Kef governorate, a north-western region of Tunisia. The results of this investigation are based on wind speed measurements carried out by the local cement factory Oum ELKelil Cement (CIOK), one of the first plants in Tunisia which intends to set up its own wind farm. According to the collected data, the local values of Wind Shear Coefficient (WSC) and Turbulence Intensity (TI) are analysed and their hourly and monthly variations are assessed. The wind speed distribution is characterized using the Weibull probability density function. Average wind power density was calculated using Weibull distribution parameters. Based on wind characteristics study, a power production estimate is performed for different configurations of low wind speed turbines. The effect of hub-height on the annual energy yield was also investigated. The results presented in this paper indicate that El-Kef region has an encouraging wind potential to exploit.
- 1 March 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-10
Investigation of wind characteristics and wind power potential in El-Kef region, Tunisia
This paper gives an estimation of the wind power that potentially could be generated by wind farms in the El-Kef governorate, a north-western region of Tunisia. The results of this investigation are based on wind speed measurements carried out by the local cement factory Oum ELKelil Cement (CIOK), one of the first plants in Tunisia which intends to set up its own wind farm. According to the collected data, the local values of Wind Shear Coefficient (WSC) and Turbulence Intensity (TI) are analysed and their hourly and monthly variations are assessed. The wind speed distribution is characterized using the Weibull probability density function. Average wind power density was calculated using Weibull distribution parameters. Based on wind characteristics study, a power production estimate is performed for different configurations of low wind speed turbines. The effect of hub-height on the annual energy yield was also investigated. The results presented in this paper indicate that El-Kef region has an encouraging wind potential to exploit.
- 1 May 2010
- Published by Elsevier in Renewable Energy
- Vol. 35 (5) , 936-945
Design and control of a direct drive wind turbine equipped with multilevel converters
- 1 May 2010
- Published by Elsevier in Renewable Energy
- Vol. 35 (5) , 936-945
Design and control of a direct drive wind turbine equipped with multilevel converters