Marco Poloni
Research Subjects
Research Interests
Marco Poloni has a total of 262 co-authors. Here are the top co-authors by number of shared publications:
- Jader Monari
I.N.A.F. -I.R.A Via Fiorentina 3508/B 40059 Medicina Italy
16 shared publications - Sergio Poppi
INAF - Osservatorio Astronomico di Cagliari (Italy)
13 shared publications - Renzo Nesti
INAF, Osservatorio Astrofisico di Arcetri, Firenze, Italy
10 shared publications - Alessandro Orfei
INAF - Institute of Radio Astronomy, via P. Gobetti 101, 40129 Bologna, Italy
8 shared publications - Andrea Maccaferri
INAF - Institute of Radio Astronomy, via P. Gobetti 101, 40129 Bologna, Italy
8 shared publications - Ettore Carretti
INAF – Istituto di Radioastronomia
8 shared publications
Latest Publications
- Open Access
- 28 October 2021
- Published by EDP Sciences in Astronomy & Astrophysics
- Vol. 655, A5
The Aperture Array Verification System 1: System overview and early commissioning results
The design and development process for the Square Kilometre Array (SKA) radio telescope’s Low Frequency Aperture Array component was progressed during the SKA pre-construction phase by an international consortium, with the goal of meeting requirements for a critical design review. As part of the development process a full-sized prototype SKA Low ‘station’ was deployed – the Aperture Array Verification System 1 (AAVS1). We provide a system overview and describe the commissioning results of AAVS1, which is a low frequency radio telescope with 256 dual-polarisation log-periodic dipole antennas working as a phased array. A detailed system description is provided, including an in-depth overview of relevant sub-systems, ranging from hardware, firmware, software, calibration, and control sub-systems. Early commissioning results cover initial bootstrapping, array calibration, stability testing, beam-forming, and on-sky sensitivity validation. Lessons learned are presented, along with future developments.
- 28 October 2021
- Published by EDP Sciences in Astronomy & Astrophysics
- Vol. 655, A5
Open AccessThe Aperture Array Verification System 1: System overview and early commissioning results
The design and development process for the Square Kilometre Array (SKA) radio telescope’s Low Frequency Aperture Array component was progressed during the SKA pre-construction phase by an international consortium, with the goal of meeting requirements for a critical design review. As part of the development process a full-sized prototype SKA Low ‘station’ was deployed – the Aperture Array Verification System 1 (AAVS1). We provide a system overview and describe the commissioning results of AAVS1, which is a low frequency radio telescope with 256 dual-polarisation log-periodic dipole antennas working as a phased array. A detailed system description is provided, including an in-depth overview of relevant sub-systems, ranging from hardware, firmware, software, calibration, and control sub-systems. Early commissioning results cover initial bootstrapping, array calibration, stability testing, beam-forming, and on-sky sensitivity validation. Lessons learned are presented, along with future developments.
- 1 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Design of PHAROS2 Phased Array Feed
- 1 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Design of PHAROS2 Phased Array Feed
- 19 March 2017
- Published by World Scientific Pub Co Pte Ltd in Journal of Astronomical Instrumentation
- Vol. 06 (01)
The Signal Processing Firmware for the Low Frequency Aperture Array
The signal processing firmware that has been developed for the Low Frequency Aperture Array component of the Square Kilometre Array (SKA) is described. The firmware is implemented on a dual FPGA board, that is capable of processing the streams from 16 dual polarization antennas. Data processing includes channelization of the sampled data for each antenna, correction for instrumental response and for geometric delays and formation of one or more beams by combining the aligned streams. The channelizer uses an oversampling polyphase filterbank architecture, allowing a frequency continuous processing of the input signal without discontinuities between spectral channels. Each board processes the streams from 16 antennas, as part of larger beamforming system, linked by standard Ethernet interconnections. These are envisaged to be 8192 of these signal processing platforms in the first phase of the SKA so particular attention has been devoted to ensure the design is low cost and low power.
- 19 March 2017
- Published by World Scientific Pub Co Pte Ltd in Journal of Astronomical Instrumentation
- Vol. 06 (01)
The Signal Processing Firmware for the Low Frequency Aperture Array
The signal processing firmware that has been developed for the Low Frequency Aperture Array component of the Square Kilometre Array (SKA) is described. The firmware is implemented on a dual FPGA board, that is capable of processing the streams from 16 dual polarization antennas. Data processing includes channelization of the sampled data for each antenna, correction for instrumental response and for geometric delays and formation of one or more beams by combining the aligned streams. The channelizer uses an oversampling polyphase filterbank architecture, allowing a frequency continuous processing of the input signal without discontinuities between spectral channels. Each board processes the streams from 16 antennas, as part of larger beamforming system, linked by standard Ethernet interconnections. These are envisaged to be 8192 of these signal processing platforms in the first phase of the SKA so particular attention has been devoted to ensure the design is low cost and low power.
- 20 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9914, 991425-991425-13
Status of the radio receiver system of the Sardina Radio Telescope
- 20 July 2016
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9914, 991425-991425-13
Status of the radio receiver system of the Sardina Radio Telescope
- Open Access
- 1 December 2015
- Published by World Scientific Pub Co Pte Ltd in Journal of Astronomical Instrumentation
- Vol. 04 (03n04)
Sardinia Radio Telescope: General Description, Technical Commissioning and First Light
- 1 December 2015
- Published by World Scientific Pub Co Pte Ltd in Journal of Astronomical Instrumentation
- Vol. 04 (03n04)
Open AccessSardinia Radio Telescope: General Description, Technical Commissioning and First Light
- 29 April 2015
- Published by Springer Nature in Experimental Astronomy
- Vol. 39 (2) , 405-421
Medicina array demonstrator: calibration and radiation pattern characterization using a UAV-mounted radio-frequency source
- 29 April 2015
- Published by Springer Nature in Experimental Astronomy
- Vol. 39 (2) , 405-421
Medicina array demonstrator: calibration and radiation pattern characterization using a UAV-mounted radio-frequency source
- 1 August 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Commissioning of the Sardinia Radio Telescope in Italy: Results and perspectives
On 30 September 2013, the opening ceremony of SRT has signed the contractual ending of the instrumental commissioning of the Sardinia Radio Telescope. In February 2014 it has been completed also the “fine tuning process” aimed at defining the first optimizations parameters needed to make calibrated radio astronomical observations. Since then, the final Astronomical Validation, that was just started in parallel with the previous activities, has taken the lead of the user's allocated time. At the time of the real presentation in August we expect to be able to present the experimental quantitative results of the commissioning that at the time of this writing are still under analysis.
- 1 August 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1
Commissioning of the Sardinia Radio Telescope in Italy: Results and perspectives
On 30 September 2013, the opening ceremony of SRT has signed the contractual ending of the instrumental commissioning of the Sardinia Radio Telescope. In February 2014 it has been completed also the “fine tuning process” aimed at defining the first optimizations parameters needed to make calibrated radio astronomical observations. Since then, the final Astronomical Validation, that was just started in parallel with the previous activities, has taken the lead of the user's allocated time. At the time of the real presentation in August we expect to be able to present the experimental quantitative results of the commissioning that at the time of this writing are still under analysis.
- 1 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 82-85
The sardinia radio telescope: Overview and status
The Sardinia Radio Telescope is approaching to its official inauguration. Nowadays, the technical staff is accomplishing the last remaining activities to set up and integrate the microwave receivers, the digital processing systems and all the equipment necessary to reach a top level in the international scenario of large radio telescopes. Even if the radio telescope is still along the technical commissioning, SRT has already performed its first astronomical detection. This early scientific result opens exciting perspectives for the time when SRT will be in the full operational phase.
- 1 September 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 82-85
The sardinia radio telescope: Overview and status
The Sardinia Radio Telescope is approaching to its official inauguration. Nowadays, the technical staff is accomplishing the last remaining activities to set up and integrate the microwave receivers, the digital processing systems and all the equipment necessary to reach a top level in the international scenario of large radio telescopes. Even if the radio telescope is still along the technical commissioning, SRT has already performed its first astronomical detection. This early scientific result opens exciting perspectives for the time when SRT will be in the full operational phase.
- 15 November 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Propagation Magazine
- Vol. 52 (4) , 62-72
A Multi-Feed Receiver in the 18 to 26.5 GHz Band for Radio Astronomy
A large-bandwidth, state-of-the-art multi-feed receiver has been constructed to be used on the new 64 m Sardinia Radio Telescope (SRT) (http://www.srt.inaf.itl), an antenna aiming to work from 300 MHz to 100 GHz with an almost continuous frequency coverage. The goal of this new receiver is to speed up the survey of the sky with high sensitivity in a frequency band that is very interesting to radio astronomers. In the meantime, the antenna erection has been finalized, and the receiver has been mounted on the Medicina 32 m antenna to be tested (http://www.med.ira.inaf.itl). We present a complete description of the system, including a dedicated backend, and the results of the tests.
- 15 November 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Propagation Magazine
- Vol. 52 (4) , 62-72
A Multi-Feed Receiver in the 18 to 26.5 GHz Band for Radio Astronomy
A large-bandwidth, state-of-the-art multi-feed receiver has been constructed to be used on the new 64 m Sardinia Radio Telescope (SRT) (http://www.srt.inaf.itl), an antenna aiming to work from 300 MHz to 100 GHz with an almost continuous frequency coverage. The goal of this new receiver is to speed up the survey of the sky with high sensitivity in a frequency band that is very interesting to radio astronomers. In the meantime, the antenna erection has been finalized, and the receiver has been mounted on the Medicina 32 m antenna to be tested (http://www.med.ira.inaf.itl). We present a complete description of the system, including a dedicated backend, and the results of the tests.