Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ranjan Vepa has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Operational Modal Analysis for Active Flutter Suppression Using Subspace Identification Methods

    by Denis Kuropatkin, Sam Al-Jaboby, Jigarjot Natt, Arrin Fernandes, Raima Rahman, Ranjan Vepa, Eldad Avital

    This paper investigates the application of Operational Modal Analysis (OMA) techniques to a simplified two degree of freedom aeroelastic system representing coupled plunge and pitch flutter dynamics under stochastic turbulence excitation. Synthetic response data were generated using Dryden, Von Kármán and white noise excitation applied to a reduced order aeroelastic state space model. Four identification methods were evaluated: Frequency Domain Decomposition (FDD), covariance driven Stochastic Subspace Identification (SSI COV), data driven Stochastic Subspace Identification (SSI DATA), and Numerical Subspace State Space System Identification (N4SID). The results demonstrate that all investigated methods successfully identified the dominant aeroelastic frequencies from output only response data. The FDD method produced particularly accurate frequency predictions due to its spectral decomposition approach. However, larger discrepancies were observed in damping estimation, especially for the second aeroelastic mode. The second mode damping ratio proved more difficult to identify accurately because of lower response energy, closer modal spacing and greater sensitivity to spectral leakage and noise contamination. Overall, the subspace based methods, particularly SSI COV and SSI DATA, produced the most robust and consistent damping predictions under turbulence excitation and additional measurement noise. The results indicate that stochastic subspace identification methods are well suited for operational aeroelastic monitoring and future active flutter suppression applications.

  • Enhancing the Flight Endurance and Autonomy of Multirotor UAVs Using Solar Power

    by Stephen A. Agha, Aly Abidali, Ranjan Vepa, M. Hasan Shaheed

    This paper is focused on improving the flight endurance of a multirotor unmanned aerial vehicle (UAV) by utilizing a solar-battery hybrid energy system. This arrangement imparts energy autonomy to the system and in this study, an increase in endurance is achieved in real-world conditions. To achieve this result, an integrated design framework is introduced with the aim of sequencing the subsystem design with consideration for the interplay between the subsystems such that predefined performance specifications can be attained. This systematic approach was implemented in this study to realize a prototype solar-powered quadrotor which was subsequently tested outdoors successfully. The significant increase in the flight endurance of the multirotor solar-powered UAV achieved in this article, presents an opportunity for increased scope for commercial and industrial applications.

  • Open Access

    Modelling and forward motion of vibro-impact capsules using magnetic actuation: Application of optimal & adaptive sliding mode control

    by Afsoon F. Abdollahi, Mohammad Hasan Shaheed, Mohamed A. Thaha, Ranjan Vepa

    Purpose: Capsule endoscopy offers a minimally invasive approach to gastrointestinal (GI) diagnostics but is limited by passive propulsion, which restricts controllability and risks suboptimal visualisation in complex anatomical regions. This study aims to develop and validate advanced control strategies for the CAPSUBOT, a vibro-impact robotic active capsule endoscope, enabling precise navigation and sustained motion within the GI tract. Methods: A two-degree-of-freedom (2-DOF) navigation system is implemented to control the relative motion of the inner mass with respect to the outer mass of the capsule. The capsule dynamics are mathematically modelled and formulated in the state-space domain. Linear Quadratic Regulator (LQR) and various Sliding Mode Controllers (SMC), including first-order SMC, second-order SMC, Integral SMC (ISMC), and Terminal SMC (TSMC), are designed and simulated using MATLAB/Simulink. Frictional forces and interaction effects are incorporated to emulate realistic operational conditions. The controllers’ performance in tracking desired trajectories is systematically evaluated, and the potential for optimisation of LQR weighting matrices using computational techniques such as artificial bee colony, genetic algorithm, particle swarm optimisation, and reinforcement learning is discussed. Results: Simulation results demonstrate that both LQR and SMC controllers can effectively guide the CAPSUBOT along commanded trajectories. First-order SMC, ISMC, and TSMC exhibit particularly strong performance in achieving steady-state tracking of the inner mass position and velocity, whereas LQR offers improved trajectory tracking under nominal conditions. The SMC controllers show robustness against disturbances and system uncertainties, supporting their use for sustained in vivo motion. Some time delays are observed in the SMC responses, highlighting areas for further improvement. Conclusion: This work establishes a framework for actively controlling a vibro-impact robotic capsule endoscope using LQR and SMC strategies, providing unified principles for the interaction of inner and outer capsule masses under feedback-controlled actuation. While the controllers demonstrate feasibility and robustness, limitations remain: SMC time delays and computational complexity in real-time implementation warrant further investigation. Future work will focus on integrating artificial intelligence-based reinforcement learning, neural networks, and fuzzy logic to develop faster, adaptive controllers. Overall, the study contributes both practical guidance for CAPSUBOT navigation and generalized control principles that may inform the design of other active capsule endoscopy systems.

  • Open Access

    Explaining the discrepancy in the Chandler period and the prediction of the changes in the Earths rotation dynamics

    by Ranjan Vepa

    In this paper, in the first instance the attitude dynamics of the Earth is modelled based on physical principles so as to correctly predict the Chandler wobble and its features such as its period. To this end not only the steady state and dynamic gravity gradient torques were included, but also the effects of centrifugal acceleration on the deformable viscoelastic model of the planet. After validating the Chandler wobble response, the paper seeks to go beyond and predict the attitude response of the Earth not just over a few years but over much longer term. This requires modelling of the energy balance effects of the entire planet as a whole and not just the redistribution of mass and inertia but also the changes in the inertial properties. To this end simpler physical model of the energy balance process was included to demonstrate the sustained changes in the length of day response of the Earth over a long term. The over aim of the paper is to bring into focus the key physical processes responsible for the changes to the attitude dynamics of the Earth over a reasonable longer time frame. The overall responses of the attitude dynamics over, the short and medium terms are presented.

  • Open Access

    Active blade pitch control and stabilization of a wind turbine driven PMSG for power output regulation

    by Yingxue Chen, Mohammad Hasan Shaheed, Ranjan Vepa

    A common strategy in controlling a permanent magnet synchronous generator (PMSG) driven by a wind turbine is the maximization of output power of the wind turbine itself. A control strategy must be adopted, is to deliver a desired reduced amount of power whenever it is required. In order to realize the direct control of wind turbine output power across a wide range of wind speeds, a linearized parameter varying dynamic model of the nonlinear wind turbine system including wind disturbances is developed and used in this paper. The stability of the wind turbine system is analyzed and a blade pitch controller is designed, based on the linearized, parameter-varying, model-predictive control and is validated. Thus, the wind turbine is regulated in a way that the generator delivers the demanded power output to the load. Moreover, the blade pitch control system also performs the key function of augmenting the stability of the wind turbine, for the right choice of the gains.


  • Open Access

    Transonic small disturbance unsteady potential flow over very high aspect ratio wings

    by J. R. Kwon, R. Vepa

    In this paper, the prediction of the unsteady flow field over typical high aspect ratio (AR) wings in the transonic flow regime but below the sonic Mach number is of interest. The methodology adopted is a computational approach based on the transonic small disturbance unsteady potential equation. It is shown that the higher AR wings generally have a higher lift coefficient as well as a higher lift-to-drag ratio. With NASA’s common research model (CRM) wing, there is an increase in maximum lift with increasing AR while the induced drag is almost the same. There is also an optimum sweep angle, which is different for each angle-of-attack so that variable sweep lifting surfaces may be designed to provide optimum solutions. The computed flutter speeds indicate an expected reduction with increasing AR.

  • Feedback control of limit cycle oscillations and transonic buzz, using the nonlinear transonic small disturbance aerodynamics

    by Jae R Kwon, Ranjan Vepa

    In this paper, a systematic method to suppress transonic buzz with feedback is presented. A trailing edge control surface in the form of part-span flap was used only to modify and control the unsteady aerodynamic loading on the wing. The flap rotation was used to provide feedback, which consisted of a weighted linear combination of the amplitudes of the principal modes of the structure, referred to as the control law. A linear, optimal feedback control law, that is synthesized systematically based on pseudo-spectral time domain analysis, may be used in principle, to assess its capacity to actively suppress the buzz in the transonic flow domain by using a servo-controlled control surface to modify the unsteady, nonlinear aerodynamic loads on the wing. Thus, it is essential that a set of feasible control laws are first constructed. In this paper, this is done by applying the doublet-lattice method. Restrictions, such as near-zero structural damping in the flap mode, were imposed on the aeroelastic model to facilitate the occurrence of transonic buzz. The feasible set of control laws were then assessed using the nonlinear transonic small disturbance theory and an optimum control is selected to suppress the buzz. The essential differences of the behaviour of the closed-loop system in nonlinear transonic flow, when compared to the applications of linear optimal control in linear potential flow, are presented and discussed.


  • Open Access

    Optimal Trajectory Synthesis for Spacecraft Asteroid Rendezvous

    by Ranjan Vepa, M. Hasan Shaheed

    Several researchers are considering the plausibility of being able to rapidly launch a mission to an asteroid, which would fly in close proximity of the asteroid to deliver an impulse in a particular direction so as to deflect the asteroid from its current orbit. Planetary motion, in general, and the motion of asteroids, in particular, are subject to planetary influences that are characterised by a kind of natural symmetry, which results in an asteroid orbiting in a stable and periodic or almost periodic orbit exhibiting a number of natural orbital symmetries. Tracking and following an asteroid, in close proximity, is the subject of this paper. In this paper, the problem of synthesizing an optimal trajectory to a NEO such as an asteroid is considered. A particular strategy involving the optimization of a co-planar trajectory segment that permits the satellite to approach and fly alongside the asteroid is chosen. Two different state space representations of the Hill–Clohessy–Wiltshire (HCW) linearized equations of relative motion are used to obtain optimal trajectories for a spacecraft approaching an asteroid. It is shown that by using a state space representation of HCW equations where the secular states are explicitly represented, the optimal trajectories are not only synthesized rapidly but also result in lower magnitudes of control inputs which must be applied continuously over extended periods of time. Thus, the solutions obtained are particularly suitable for low thrust control of the satellites orbit which can be realized by electric thrusters.


  • Synthesis of an active flutter suppression system in the transonic domain using a computational model

    by R. Vepa, J.R. Kwon

    Control laws for implementing active flutter suppression are generally derived from linear aeroelastic models. In this paper, families of control laws for implementing an active flutter suppression system were initially designed using linearised aeroelastic models based on the doublet lattice method after ignoring the aerodynamic loads associated with relatively faster time scales. Using these preliminary sets of control laws and the nonlinear transonic small disturbance theory, near-optimum control laws were chosen in the transonic domain to maximally increase the flutter speed of a typical aircraft wing by at least 16% or more. Thus it is shown that it is feasible to systematically design near-optimal control laws for active flutter suppression using computational models in transonic flow. The doublet lattice method coupled with the zeroth-order matrix Padé approximant provided the fastest method for synthesising a large number of preliminary control laws. The methodology was successfully demonstrated by applying it to two benchmarking examples.