Elizabeth A. Fassman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Elizabeth A. Fassman has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Chris C. Tanner
Earth Sciences New Zealand, Kirikiriroa-Hamilton 3216, New Zealand
4 shared publications - Robyn Simcock
Manaaki Whenua Landcare Research
4 shared publications Shaw L. Yu
Members, ASCE
4 shared publications- Suzanne Wilkinson
Faculty of Design & creative technologies, Auckland University of Technology, Auckland, New Zealand
3 shared publications - Danhui Xin
Southern California Coastal Water Research Project
2 shared publications Emily Voyde
2 shared publications
Latest Publications
- Open Access
- 30 May 2026
- Published by IWA Publishing in Blue-Green Systems
- Vol. 8 (1) , 173-187
Field monitoring of microplastics in biofilter media: insights into media characteristics and design
Graphical abstract illustrating the hypothesized filtration-based retention of MPs within biofilter media. MPs and other suspended particles in runoff enter the ponding zone and are retained within pore spaces in the biofilter media when pore sizes are smaller than the particles. The figure highlights the relationships among media particle size, pore size, and MP retention, and illustrates that media gradation metrics such as curvature coefficient may correlate with MP retention. Stormwater biofilters are widely implemented best management practices for treating urban runoff. Microplastics (MPs) are emerging contaminants in runoff and, because they are particulate in nature, are hypothesized to be removed primarily through physical filtration, with pores created by biofilter media playing a key role in retention. This study presents a field-based evaluation of MP accumulation in biofilter media and examines relationships between retained MPs and measurable media particle- and pore-size characteristics. Twelve media samples were collected from four full-scale biofilters (4–6 years in service) in Southern California. MPs were quantified across five size fractions (20–5,000 μm) and characterized by morphology, color, and polymer type. Media particle size distributions and gradation indices were determined, and pore-size distributions were derived from in situ water retention measurements. MP concentrations ranged from tens to >1,000 particles/g, with fragments in the smallest size fraction (20–63 μm) dominating accumulation. The proportion of pore volume associated with pores <20 μm exhibited the strongest correlation with MP accumulation (r = 0.93, p < 0.001, n = 9), supporting physical straining as the dominant removal mechanism. The curvature coefficient derived from particle size analysis was also associated with MP retention, highlighting its potential as a practical design-relevant factor.
- 30 May 2026
- Published by IWA Publishing in Blue-Green Systems
- Vol. 8 (1) , 173-187
Open AccessField monitoring of microplastics in biofilter media: insights into media characteristics and design
Graphical abstract illustrating the hypothesized filtration-based retention of MPs within biofilter media. MPs and other suspended particles in runoff enter the ponding zone and are retained within pore spaces in the biofilter media when pore sizes are smaller than the particles. The figure highlights the relationships among media particle size, pore size, and MP retention, and illustrates that media gradation metrics such as curvature coefficient may correlate with MP retention. Stormwater biofilters are widely implemented best management practices for treating urban runoff. Microplastics (MPs) are emerging contaminants in runoff and, because they are particulate in nature, are hypothesized to be removed primarily through physical filtration, with pores created by biofilter media playing a key role in retention. This study presents a field-based evaluation of MP accumulation in biofilter media and examines relationships between retained MPs and measurable media particle- and pore-size characteristics. Twelve media samples were collected from four full-scale biofilters (4–6 years in service) in Southern California. MPs were quantified across five size fractions (20–5,000 μm) and characterized by morphology, color, and polymer type. Media particle size distributions and gradation indices were determined, and pore-size distributions were derived from in situ water retention measurements. MP concentrations ranged from tens to >1,000 particles/g, with fragments in the smallest size fraction (20–63 μm) dominating accumulation. The proportion of pore volume associated with pores <20 μm exhibited the strongest correlation with MP accumulation (r = 0.93, p < 0.001, n = 9), supporting physical straining as the dominant removal mechanism. The curvature coefficient derived from particle size analysis was also associated with MP retention, highlighting its potential as a practical design-relevant factor.
- 1 November 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Sustainable Water in the Built Environment
- Vol. 11 (4)
Assessment of PFOA and PFOS Sorption to Engineered Media in Biofiltration Columns
- 1 November 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Sustainable Water in the Built Environment
- Vol. 11 (4)
Assessment of PFOA and PFOS Sorption to Engineered Media in Biofiltration Columns
- Open Access
- 2 May 2025
- Published by Elsevier in Water Research
- Vol. 282, 123769
A data-driven index for evaluating BMP water quality performance
- 2 May 2025
- Published by Elsevier in Water Research
- Vol. 282, 123769
Open AccessA data-driven index for evaluating BMP water quality performance
- 1 August 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Sustainable Water in the Built Environment
- Vol. 7 (3) , 04021006
Sources and Impacts of Uncertainty in Uncalibrated Bioretention Models Using SWMM 5.1.012
Using the USEPA’s Storm Water Management Model version 5.1.012 (SWMM), a case study of a street right-of-way bioretention system (ROWB) configured as a storage node is compared against SWMM’s Low Impact Development (LID) Controls for urban runoff retention, detention, and the timing of discharge. Through 12,000 one-year continuous simulations, single parameter perturbations and Monte-Carlo simulation of the uncalibrated models result in predicted annual runoff coefficients (representing stormwater retention) of 0.19–0.55 for an exfiltrating ROWB compared to 0.61 and 0.72 for a storage node with low and high assumed exfiltration capacity, respectively. Stormwater detention was represented by the frequency of event peak discharges exceeding an arbitrary low threshold value. The storage node simulations predicted peak discharges near or exceeding the upper values for the LID Control simulations. The dynamic representation of flow through porous media in the LID Control predicts greater retention and detention compared to the storage node over the range of uncalibrated models investigated. Sensitivity analysis of the LID Control parameterization indicates that the relative difference between the engineered media’s porosity and field capacity have the most significant influence on predicted performance. Poor runoff retention results in scenarios where the engineered media exhibits a high field capacity relative to its porosity, whereas high field capacity is a desirable trait that should lead to superior performance. The model’s calculation procedures and neglect of unsaturated flow or preferential pathways bias model output toward more frequent runoff bypass. The sensitivity analysis also demonstrates that the timing and duration of the discharge hydrograph are highly variable depending on parameterization. The wide range of potential performance generated from uncalibrated model parameterization leads to significant concerns for infrastructure planning and implementation, leading potentially to underperforming infrastructure, or excessive cost. Allocating resources to collect field performance data that enables robust model development, calibration, and verification at the green infrastructure (GI) stormwater control measure (SCM) scale offers the opportunity to reduce uncertainty in model predictions.
- 1 August 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Sustainable Water in the Built Environment
- Vol. 7 (3) , 04021006
Sources and Impacts of Uncertainty in Uncalibrated Bioretention Models Using SWMM 5.1.012
Using the USEPA’s Storm Water Management Model version 5.1.012 (SWMM), a case study of a street right-of-way bioretention system (ROWB) configured as a storage node is compared against SWMM’s Low Impact Development (LID) Controls for urban runoff retention, detention, and the timing of discharge. Through 12,000 one-year continuous simulations, single parameter perturbations and Monte-Carlo simulation of the uncalibrated models result in predicted annual runoff coefficients (representing stormwater retention) of 0.19–0.55 for an exfiltrating ROWB compared to 0.61 and 0.72 for a storage node with low and high assumed exfiltration capacity, respectively. Stormwater detention was represented by the frequency of event peak discharges exceeding an arbitrary low threshold value. The storage node simulations predicted peak discharges near or exceeding the upper values for the LID Control simulations. The dynamic representation of flow through porous media in the LID Control predicts greater retention and detention compared to the storage node over the range of uncalibrated models investigated. Sensitivity analysis of the LID Control parameterization indicates that the relative difference between the engineered media’s porosity and field capacity have the most significant influence on predicted performance. Poor runoff retention results in scenarios where the engineered media exhibits a high field capacity relative to its porosity, whereas high field capacity is a desirable trait that should lead to superior performance. The model’s calculation procedures and neglect of unsaturated flow or preferential pathways bias model output toward more frequent runoff bypass. The sensitivity analysis also demonstrates that the timing and duration of the discharge hydrograph are highly variable depending on parameterization. The wide range of potential performance generated from uncalibrated model parameterization leads to significant concerns for infrastructure planning and implementation, leading potentially to underperforming infrastructure, or excessive cost. Allocating resources to collect field performance data that enables robust model development, calibration, and verification at the green infrastructure (GI) stormwater control measure (SCM) scale offers the opportunity to reduce uncertainty in model predictions.
- 1 November 2014
- Published by Elsevier in Journal of Hydrology
- Vol. 519, 2571-2583
A comprehensive typology for mainstreaming urban green infrastructure
- 1 November 2014
- Published by Elsevier in Journal of Hydrology
- Vol. 519, 2571-2583
A comprehensive typology for mainstreaming urban green infrastructure
- 1 January 2014
- Published by Elsevier in Water Research
- Vol. 48, 430-442
Floating Treatment Wetland influences on the fate of metals in road runoff retention ponds
- 1 January 2014
- Published by Elsevier in Water Research
- Vol. 48, 430-442
Floating Treatment Wetland influences on the fate of metals in road runoff retention ponds
- 12 November 2013
- Published by Taylor & Francis in Architectural Engineering and Design Management
- Vol. 10 (1-2) , 25-39
Management practice to achieve energy-efficient performance of green buildings in New Zealand
- 12 November 2013
- Published by Taylor & Francis in Architectural Engineering and Design Management
- Vol. 10 (1-2) , 25-39
Management practice to achieve energy-efficient performance of green buildings in New Zealand