MGManuel Gensler

Manuel Gensler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Manuel Gensler has a total of 93 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Luminescence Behavior of Di(pyridine-2-yl)methyl-substituted Phosphine Oxides

    by Jonathan Gutenthaler-Tietze, Richard Einsele, Jiyong Kim, Christian Wangnick, Yohan Kim, Jens Petersen, Manuel Gensler, Armin Wedel, Roland Mitrić, Konstantin Karaghiosoff

    Two new di(pyridine-2-yl)methyl-substituted phosphine oxides, (dpym) 2 PhPO and (dpym) 2 PyPO , were synthesized, both exhibiting blue luminescence in the solid state. Suitable single crystals for X-ray diffraction experiments could be obtained to investigate the solid-state structure. Based on the geometry in the crystalline state, TD-DFT and GW/BSE calculations were performed to gain better insight into the photophysical properties. Time-resolved photoluminescence measurements reveal that the emission is dominated by phosphorescence, with lifetimes of 116 µs upon 251 nm excitation and biexponential microsecond-scale decays upon lower-energy excitation. In solution, luminescence is observed only at high concentrations (22 mm), indicating aggregation-mediated excitation. Excitation–emission spectroscopy of the powders shows two emission bands: one near 390 nm upon excitation at 250 nm and a second band at 500–540 nm upon excitation above 300 nm, the latter also appearing in concentrated solution. The theoretical and spectroscopic data point toward a complex photoluminescence mechanism in which direct triplet excitation, aggregation-mediated low-energy states, and efficient intersystem crossing all contribute to the observed emission.

  • Open Access

    High‐Resolution Patterning via Electrohydrodynamic (EHD)‐Jet Printing for Quantum Dot Light‐Emitting Diodes

    by Yohan Kim, Manuel Gensler, Jiyong Kim, Christine Boeffel, Benjamin Heyne, Chul Jong Han, Kyoungwon Park, Min Suk Oh, Simon Ogier, Dan Sharkey, et al.

    High‐resolution printing technology is crucial for electroluminescent (EL) quantum dot light‐emitting diodes (QD‐LEDs) to be used in high‐end display applications such as AR/VR displays. This study successfully demonstrates the patterning of PEDOT:PSS, ZnO nanoparticles (NPs), and InP‐based QD/organic nanohybrids using electrohydrodynamic (EHD)‐jet printing, fabricating top‐emitting green conventional or inverted QD‐LEDs on a PEN flexible substrate. The integration of a hydrophobic pixel defining layer and continuous‐jet modes in the EHD‐jet printing system enhances the patterning processability, showcasing the EL of patterned conventional and inverted QD‐LEDs. Especially, the EL spectrum of an inverted QD‐LED exhibits a sharp green emission at a peak wavelength of 542 nm, with a full width at half maximum (FWHM) of 46 nm. This indicates that the uniform layers were achieved through EHD‐jet printing and balanced charge carriers in the device, despite the active layer consisting of not only InP‐based QDs but also n‐type and/or p‐type organic transport materials. This research opens up new possibilities for the utilization of EHD‐jet printing in various QD‐LED structures for commercially viable printed display applications.


  • Open Access

    Blue cadmium-free and air-fabricated quantum dot light-emitting diodes

    by Paul Hänsch, Selen Solak, Hyung Seok Choi, Yohan Kim, Giovanni Ligorio, Manuel Gensler, Jiyong Kim, Christine Boeffel, Emil J. W. List-Kratochvil, Felix Hermerschmidt

    Quantum dot (QD) materials have found increasing use in display applications because of their high color purity and fluorescence quantum yield, enabling devices with higher brightness and efficiency. However, to access large-area printing and coating methods that are carried out in ambient conditions, it is necessary to, first, move away from toxic cadmium, and second, to target materials that can be air-processed. Herein, we synthesize zinc selenide-based blue QD material and air-fabricate light-emitting diodes (LEDs) and single-carrier devices. The encapsulated devices were also measured under ambient conditions. Multi-shell-structured ZnSeTe/ZnSe/ZnS (core/shell/shell) QDs show pure deep blue/purple fluorescence emission with a high photoluminescence quantum yield of 78%. The blue QD-LED devices are fabricated in a conventional structure with bottom light emission with two electron transport materials (ZnO and ZnMgO). The QD-LED devices with ZnO electron transport layer show a maximum luminance of ∼6200 cd m−2 at 9 V with a turn-on voltage of 3.5 V and current efficacy of 0.38 cd A−1, while with ZnMgO electron transport layer, the devices show a maximum luminance of 3000 cd m−2 at 7 V with a turn-on voltage of 3 V and current efficacy of 0.6 cd A−1. Electron-only and hole-only devices were fabricated to show and confirm the underlying charge transport mechanisms. To our knowledge, these results show for the first-time air-fabricated ZnSe-based QD-LEDs, paving the way for scaling up display applications and moving toward high-performance printed electronics.


  • Open Access

    Aggregation‐Induced Emission in a Flexible Phosphine Oxide and its Zn(II) Complexes—A Simple Approach to Blue Luminescent Materials

    by Christin Kirst, Fabian Knechtel, Manuel Gensler, David Fischermeier, Jens Petersen, Nader A. Danaf, Jonathan Tietze, Armin Wedel, Don C. Lamb, Roland Mitrić, et al.

    Easily accessible blue‐emitting materials are in the focus of ongoing research, as they still lack the efficiency and lifetime of their red and green counterparts. The new multidentate phosphine oxide ligands and two respective ZnCl2 complexes presented here combine a straightforward synthesis with high yields and show interesting luminescent properties. The free ligand exhibits blue luminescence in the crystalline state, but not in amorphous films or diluted solution. In contrast, the Zn(II) complexes shows intense blue luminescence in the crystalline state as well as in amorphous thin films and in solution. Fluorescence lifetime imaging microscopy measurements show luminescence lifetimes of 3–6 ns indicative of fluorescence. By combining the experimental data with quantum chemical calculations, we propose a model where the conformation of the molecule is restricted, either via the crystal environment, aggregation, or the steric fixation by the coordinating central atom, blocking the nonradiative relaxation from the excited into the ground electronic state. However, this nonradiative relaxation is still possible in the gas phase via elongation of a PC bond. These results may provide a general mechanism to explain the luminescence properties in a whole class of organic phosphine oxides.


  • 82‐5: Late-News Paper: High‐Resolution Printing for Future Processing of RGB OLED Displays

    by Manuel Gensler, Christine Boeffel, Stefan Kröpke, Auke Jisk Kronemeijer, Tung Huei Ke, Nikolas Papadopoulos, Jian Yao, John Stark, Pufinji Obene

    High resolution ESJET printing is presented for processing of OLED devices. With appropriate nozzle geometry and driving schemes pixel structures of 10 µm and below are achievable with the final goal of printing a 310 ppi RGB AMOLED display.


  • Hydration Effects Turn a Highly Stretched Polymer from an Entropic into an Energetic Spring

    by Susanne Liese, Manuel Gensler, Stefanie Krysiak, Richard Schwarzl, Andreas Achazi, Beate Paulus, Thorsten Hugel, Jürgen P. Rabe, Roland R. Netz

    Polyethylene glycol (PEG) is a structurally simple and nontoxic water-soluble polymer that is widely used in medical and pharmaceutical applications as molecular linker and spacer. In such applications, PEG’s elastic response against conformational deformations is key to its function. According to text-book knowledge, a polymer reacts to the stretching of its end-to-end separation by a decrease in entropy that is due to the reduction of available conformations, which is why polymers are commonly called entropic springs. By a combination of single-molecule force spectroscopy experiments with molecular dynamics simulations in explicit water, we show that entropic hydration effects almost exactly compensate the chain conformational entropy loss at high stretching. Our simulations reveal that this entropic compensation is due to the stretching-induced release of water molecules that in the relaxed state form double hydrogen bonds with PEG. As a consequence, the stretching response of PEG is predominantly of energetic, not of entropic, origin at high forces and caused by hydration effects, while PEG backbone deformations only play a minor role. These findings demonstrate the importance of hydration for the mechanics of macromolecules and constitute a case example that sheds light on the antagonistic interplay of conformational and hydration degrees of freedom.


  • Open Access

    Cooperative Switching in Nanofibers of Azobenzene Oligomers

    by Christopher Weber, Tobias Liebig, Manuel Gensler, Anton Zykov, Linus Pithan, Jürgen P. Rabe, Stefan Hecht, David Bléger, Stefan Kowarik

    Next-generation molecular devices and machines demand the integration of molecular switches into hierarchical assemblies to amplify the response of the system from the molecular level to the meso- or macro-scale. Here, we demonstrate that multi-azobenzene oligomers can assemble to form robust supramolecular nanofibers in which they can be switched repeatedly between the E- and Z-configuration. While in isolated oligomers the azobenzene units undergo reversible photoisomerization independently, in the nanofibers they are coupled via intermolecular interactions and switch cooperatively as evidenced by unusual thermal and kinetic behavior. We find that the photoisomerization rate from the Z-isomer to the E-isomer depends on the fraction of Z-azobenzene in the nanofibers and is increased by more than a factor of 4 in Z-rich fibers when compared to E-rich fibers. This demonstrates the great potential of coupling individual photochromic units for increasing their quantum efficiency in the solid state with potential relevance for actuation and sensing.


  • Open Access

    Aβ42-oligomer Interacting Peptide (AIP) neutralizes toxic amyloid-β42 species and protects synaptic structure and function

    by Christian Barucker, Heiko J. Bittner, Philip K.-Y. Chang, Scott Cameron, Mark A. Hancock, Filip Liebsch, Shireen Hossain, Anja Harmeier, Hunter Shaw, François M. Charron, et al.

    The amyloid-β42 (Aβ42) peptide is believed to be the main culprit in the pathogenesis of Alzheimer disease (AD), impairing synaptic function and initiating neuronal degeneration. Soluble Aβ42 oligomers are highly toxic and contribute to progressive neuronal dysfunction, loss of synaptic spine density and affect long-term potentiation (LTP). We have characterized a short, L-amino acid Aβ-oligomer Interacting Peptide (AIP) that targets a relatively well-defined population of low-n Aβ42 oligomers, rather than simply inhibiting the aggregation of Aβ monomers into oligomers. Our data show that AIP diminishes the loss of Aβ42-induced synaptic spine density and rescues LTP in organotypic hippocampal slice cultures. Notably, the AIP enantiomer (comprised of D-amino acids) attenuated the rough-eye phenotype in a transgenic Aβ42 fly model and significantly improved the function of photoreceptors of these flies in electroretinography tests. Overall, our results indicate that specifically “trapping” low-n oligomers provides a novel strategy for toxic Aβ42-oligomer recognition and removal.


  • Open Access

    Mechanical stability of bivalent transition metal complexes analyzed by single-molecule force spectroscopy

    by Manuel Gensler, Christian Eidamshaus, Maurice Taszarek, Hans-Ulrich Reissig, Jürgen P. Rabe

    Multivalent biomolecular interactions allow for a balanced interplay of mechanical stability and malleability, and nature makes widely use of it. For instance, systems of similar thermal stability may have very different rupture forces. Thus it is of paramount interest to study and understand the mechanical properties of multivalent systems through well-characterized model systems. We analyzed the rupture behavior of three different bivalent pyridine coordination complexes with Cu2+ in aqueous environment by single-molecule force spectroscopy. Those complexes share the same supramolecular interaction leading to similar thermal off-rates in the range of 0.09 and 0.36 s−1, compared to 1.7 s−1 for the monovalent complex. On the other hand, the backbones exhibit different flexibility, and we determined a broad range of rupture lengths between 0.3 and 1.1 nm, with higher most-probable rupture forces for the stiffer backbones. Interestingly, the medium-flexible connection has the highest rupture forces, whereas the ligands with highest and lowest rigidity seem to be prone to consecutive bond rupture. The presented approach allows separating bond and backbone effects in multivalent model systems.


  • Light-Controlled “Molecular Zippers” Based on Azobenzene Main Chain Polymers

    by Christopher Weber, Tobias Liebig, Manuel Gensler, Linus Pithan, Sebastian Bommel, David Bléger, Jürgen P. Rabe, Stefan Hecht, Stefan Kowarik