Stefano Vidoli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Stefano Vidoli has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Corrado Maurini
Sorbonne Universite
9 shared publications - Antonino Favata
Department of Structural and Geotechnical Engineering, Sapienza University of Rome, Rome, Italy
6 shared publications - Francesco Dell’isola
University of L’Aquila, L’Aquila, Italy
6 shared publications - Jean-Jacques Marigo
Laboratoire de Mécanique des Solides, Ecole Polytechnique, Route de Saclay, 91120 Palaiseau, France
4 shared publications Matteo Brunetti
Polytechnic Department of Engineering and Architecture, University of Udine, Udine, Italy
4 shared publications- Achille Paolone
Sapienza University of Rome
3 shared publications
Latest Publications
- Open Access
- 13 November 2026
- Published by Elsevier in European Journal of Mechanics - A/Solids
- Vol. 122
From advancing to locked fronts: The rank-one limit of a family of strain-gradient plasticity models
- 13 November 2026
- Published by Elsevier in European Journal of Mechanics - A/Solids
- Vol. 122
Open AccessFrom advancing to locked fronts: The rank-one limit of a family of strain-gradient plasticity models
- Open Access
- 20 May 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 214
Nucleation in rank-one gradient plasticity: Exact solutions and geometry-dependent regimes
- 20 May 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 214
Open AccessNucleation in rank-one gradient plasticity: Exact solutions and geometry-dependent regimes
- Open Access
- 7 February 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 211
Sharp-interface cohesive fracture models with consistent bulk energies: Numerical investigations
- 7 February 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 211
Open AccessSharp-interface cohesive fracture models with consistent bulk energies: Numerical investigations
- 16 December 2025
- Published by SAGE Publications in Mathematics and Mechanics of Solids
- Vol. 31 (5) , 1022-1037
Gaussian curvature-induced localization in tape springs: A one-dimensional nonlinear model
A one-dimensional model for tape springs is proposed to capture their essential mechanical behavior, including membrane and bending effects. A key feature of the model is the incorporation of Gaussian curvature, for which a one-dimensional estimate is provided. The bending energy is derived from shell theory using a suitable kinematic Ansatz. Equilibrium configurations with uniform curvature are analyzed under prescribed end rotations, and critical rotations are determined through analytical estimates of the stability conditions. An inextensible version of the model is also considered, allowing for the prediction of the post-localization bending moment and the explanation of the linear energy growth observed at large rotations. Numerical results are presented and compared with both experimental data and existing numerical predictions from the literature, confirming the model’s capability to accurately capture curvature localization phenomena.
- 16 December 2025
- Published by SAGE Publications in Mathematics and Mechanics of Solids
- Vol. 31 (5) , 1022-1037
Gaussian curvature-induced localization in tape springs: A one-dimensional nonlinear model
A one-dimensional model for tape springs is proposed to capture their essential mechanical behavior, including membrane and bending effects. A key feature of the model is the incorporation of Gaussian curvature, for which a one-dimensional estimate is provided. The bending energy is derived from shell theory using a suitable kinematic Ansatz. Equilibrium configurations with uniform curvature are analyzed under prescribed end rotations, and critical rotations are determined through analytical estimates of the stability conditions. An inextensible version of the model is also considered, allowing for the prediction of the post-localization bending moment and the explanation of the linear energy growth observed at large rotations. Numerical results are presented and compared with both experimental data and existing numerical predictions from the literature, confirming the model’s capability to accurately capture curvature localization phenomena.
- Open Access
- 7 August 2024
- Published by Springer Nature in Meccanica
- Vol. 59 (8) , 1315-1326
A variational model for finger-driven cell diffusion in the extracellular matrix
We present a simple chemo-mechanical variational model for a fibrous material that describes (i) the emergence of the anisotropy due to microscopic buckling instabilities (ii) a diffusion in the substrate of the cell phase driven by the new created macroscopic bands characterized by intense compressive deformation. The model is applicable for simulating the spreading of cells within tissues and their interaction with tissue remodeling during mesenchymal migration.
- 7 August 2024
- Published by Springer Nature in Meccanica
- Vol. 59 (8) , 1315-1326
Open AccessA variational model for finger-driven cell diffusion in the extracellular matrix
We present a simple chemo-mechanical variational model for a fibrous material that describes (i) the emergence of the anisotropy due to microscopic buckling instabilities (ii) a diffusion in the substrate of the cell phase driven by the new created macroscopic bands characterized by intense compressive deformation. The model is applicable for simulating the spreading of cells within tissues and their interaction with tissue remodeling during mesenchymal migration.
- Open Access
- 11 May 2024
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 427
A phase-field model for the brittle fracture of Euler–Bernoulli beams coupling stretching and bending
- 11 May 2024
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 427
Open AccessA phase-field model for the brittle fracture of Euler–Bernoulli beams coupling stretching and bending
- Open Access
- 28 February 2024
- Published by Springer Nature in Acta Mechanica
- Vol. 235 (5) , 3059-3071
Effect of realistic distributed loads on the bi-stable behavior of a pre-stressed aileron
We study both experimentally and numerically the aeroelastic response of a pre-stressed curved aileron in a high Reynolds number flow undisturbed at infinity. The structure is designed to have a peculiar nonlinear behavior. Specifically, the aileron has only one stable equilibrium when the external forces are vanishing, but it is bistable when distributed aerodynamic loads are applied. Hence, for sufficiently high fluid velocities, another equilibrium branch is possible. We test a prototype of such an aileron in a wind tunnel. A sudden change (snap) of the shell configuration is observed when the fluid velocity exceeds a critical threshold: the snapped configuration is characterized by sensibly lower drag. However, when the velocity is reduced to zero, the structure recovers its initial shape. A similar nonlinear behavior can have important applications for drag-reduction strategies since the transition between a bluff body-like and a slender body-like behavior is controlled by the free-stream fluid velocity and does not require any external actuation.
- 28 February 2024
- Published by Springer Nature in Acta Mechanica
- Vol. 235 (5) , 3059-3071
Open AccessEffect of realistic distributed loads on the bi-stable behavior of a pre-stressed aileron
We study both experimentally and numerically the aeroelastic response of a pre-stressed curved aileron in a high Reynolds number flow undisturbed at infinity. The structure is designed to have a peculiar nonlinear behavior. Specifically, the aileron has only one stable equilibrium when the external forces are vanishing, but it is bistable when distributed aerodynamic loads are applied. Hence, for sufficiently high fluid velocities, another equilibrium branch is possible. We test a prototype of such an aileron in a wind tunnel. A sudden change (snap) of the shell configuration is observed when the fluid velocity exceeds a critical threshold: the snapped configuration is characterized by sensibly lower drag. However, when the velocity is reduced to zero, the structure recovers its initial shape. A similar nonlinear behavior can have important applications for drag-reduction strategies since the transition between a bluff body-like and a slender body-like behavior is controlled by the free-stream fluid velocity and does not require any external actuation.
- Open Access
- 27 March 2023
- Published by Elsevier in International Journal of Solids and Structures
- Vol. 269
A coarse-grained constitutive law for fracturing beams based on a sharp interface crack representation
- 27 March 2023
- Published by Elsevier in International Journal of Solids and Structures
- Vol. 269
Open AccessA coarse-grained constitutive law for fracturing beams based on a sharp interface crack representation
- 27 April 2022
- Published by Elsevier in Extreme Mechanics Letters
- Vol. 54, 101755
Chaotic and regular dynamics of a morphing shell with a vanishing-stiffness mode
- 27 April 2022
- Published by Elsevier in Extreme Mechanics Letters
- Vol. 54, 101755
Chaotic and regular dynamics of a morphing shell with a vanishing-stiffness mode
- Open Access
- 21 October 2020
- Published by The Royal Society in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 476 (2242) , 20200455
Enhanced models for the nonlinear bending of planar rods: localization phenomena and multistability
We deduce a one-dimensional model of elastic planar rods starting from the Föppl–von Kármán model of thin shells. Such model is enhanced by additional kinematical descriptors that keep explicit track of the compatibility condition requested in the two-dimensional parent continuum, that in the standard rods models are identically satisfied after the dimensional reduction. An inextensible model is also proposed, starting from the nonlinear Koiter model of inextensible shells. These enhanced models describe the nonlinear planar bending of rods and allow to account for some phenomena of preeminent importance even in one-dimensional bodies, such as formation of singularities and localization (d-cones), otherwise inaccessible by the classical one-dimensional models. Moreover, the effects of the compatibility translate into the possibility to obtain multiple stable equilibrium configurations.
- 21 October 2020
- Published by The Royal Society in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 476 (2242) , 20200455
Open AccessEnhanced models for the nonlinear bending of planar rods: localization phenomena and multistability
We deduce a one-dimensional model of elastic planar rods starting from the Föppl–von Kármán model of thin shells. Such model is enhanced by additional kinematical descriptors that keep explicit track of the compatibility condition requested in the two-dimensional parent continuum, that in the standard rods models are identically satisfied after the dimensional reduction. An inextensible model is also proposed, starting from the nonlinear Koiter model of inextensible shells. These enhanced models describe the nonlinear planar bending of rods and allow to account for some phenomena of preeminent importance even in one-dimensional bodies, such as formation of singularities and localization (d-cones), otherwise inaccessible by the classical one-dimensional models. Moreover, the effects of the compatibility translate into the possibility to obtain multiple stable equilibrium configurations.