Fan Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fan Zhou has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Søren Juhl Andreasen
Aalborg University
5 shared publications - Søren Knudsen Kær
Department of Energy Technology, Aalborg University, DK-9220 Aalborg, Denmark
5 shared publications - Samuel Simon Araya
Luxembourg Institute of Science and Technology,Materials Research and Technology Development,Luxembourg
4 shared publications - Vincenzo Liso
Aalborg University
4 shared publications - Na Li
Aalborg University
2 shared publications - Raghunandan Sharma
University of Southern Denmark
2 shared publications
Latest Publications
- Open Access
- 10 June 2026
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 173 (11) , 114507
Protocol for the Ex-Situ Electrochemical Performance Evaluation of the High-Temperature PEMFC Electrodes: Activity, Durability and Wettability Inter-Relations
The effect of pre-wetting on the catalyst utilization and durability of high-temperature proton exchange membrane fuel cell (HT-PEMFC) gas diffusion electrodes (GDEs) was investigated in a three-electrode configuration. Pre-wetting protocols included treatment in ethanol-water mixture (0, 10, 50, and 100% v/v ethanol), ethanol-water vapor, and concentrated orthophosphoric acid (14.85 M) at 150 °C. All pre-wetting approaches significantly enhanced electrode wettability by reducing hydrophobicity and surface tension, thereby improving initial catalyst utilization. However, accelerated stress test (AST) revealed a trade-off between utilization and durability, with wetted electrodes exhibiting lower electrochemically active surface area and Pt retention than untreated electrodes. Changes in Pt crystallite and particle sizes during the AST were estimated through X-ray diffraction analysis and transmission electron microscopy. All three wetting procedures have similar effects on catalyst utilization and durability without compromising the structural integrity. Single-cell measurements showed that while pre-wetting is effective for rapid screening and improving the initial performance, its benefits are not directly transferable to practical operation without further optimization. These findings highlight the trade-off between catalyst utilization and durability in HT-PEMFC GDEs.
- 10 June 2026
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 173 (11) , 114507
Open AccessProtocol for the Ex-Situ Electrochemical Performance Evaluation of the High-Temperature PEMFC Electrodes: Activity, Durability and Wettability Inter-Relations
The effect of pre-wetting on the catalyst utilization and durability of high-temperature proton exchange membrane fuel cell (HT-PEMFC) gas diffusion electrodes (GDEs) was investigated in a three-electrode configuration. Pre-wetting protocols included treatment in ethanol-water mixture (0, 10, 50, and 100% v/v ethanol), ethanol-water vapor, and concentrated orthophosphoric acid (14.85 M) at 150 °C. All pre-wetting approaches significantly enhanced electrode wettability by reducing hydrophobicity and surface tension, thereby improving initial catalyst utilization. However, accelerated stress test (AST) revealed a trade-off between utilization and durability, with wetted electrodes exhibiting lower electrochemically active surface area and Pt retention than untreated electrodes. Changes in Pt crystallite and particle sizes during the AST were estimated through X-ray diffraction analysis and transmission electron microscopy. All three wetting procedures have similar effects on catalyst utilization and durability without compromising the structural integrity. Single-cell measurements showed that while pre-wetting is effective for rapid screening and improving the initial performance, its benefits are not directly transferable to practical operation without further optimization. These findings highlight the trade-off between catalyst utilization and durability in HT-PEMFC GDEs.
- Open Access
- 6 December 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 665
Validation on electrocatalyst closed-loop circularity for high temperature PEMFC electrodes: Pt recovery, electrocatalyst synthesis, and performance evaluation
- 6 December 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 665
Open AccessValidation on electrocatalyst closed-loop circularity for high temperature PEMFC electrodes: Pt recovery, electrocatalyst synthesis, and performance evaluation
- Open Access
- 3 March 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 639
A novel method of EIS application in online fault diagnosis of high-temperature PEMFC with CNN
- 3 March 2025
- Published by Elsevier in Journal of Power Sources
- Vol. 639
Open AccessA novel method of EIS application in online fault diagnosis of high-temperature PEMFC with CNN
- 1 December 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (46) , 21310-21344
A comprehensive review of PBI-based high temperature PEM fuel cells
- 1 December 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (46) , 21310-21344
A comprehensive review of PBI-based high temperature PEM fuel cells
- 1 November 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (43) , 14932-14941
Experimental investigation of carbon monoxide poisoning effect on a PBI/H3PO4 high temperature polymer electrolyte membrane fuel cell: Influence of anode humidification and carbon dioxide
- 1 November 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (43) , 14932-14941
Experimental investigation of carbon monoxide poisoning effect on a PBI/H3PO4 high temperature polymer electrolyte membrane fuel cell: Influence of anode humidification and carbon dioxide
- 1 June 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (20) , 6672-6680
Experimental study of cell reversal of a high temperature polymer electrolyte membrane fuel cell caused by H2 starvation
- 1 June 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (20) , 6672-6680
Experimental study of cell reversal of a high temperature polymer electrolyte membrane fuel cell caused by H2 starvation
- 1 February 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (6) , 2833-2839
Analysis of accelerated degradation of a HT-PEM fuel cell caused by cell reversal in fuel starvation condition
- 1 February 2015
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 40 (6) , 2833-2839
Analysis of accelerated degradation of a HT-PEM fuel cell caused by cell reversal in fuel starvation condition
- 1 October 2014
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 39 (32) , 18343-18350
Performance and endurance of a high temperature PEM fuel cell operated on methanol reformate
- 1 October 2014
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 39 (32) , 18343-18350
Performance and endurance of a high temperature PEM fuel cell operated on methanol reformate