Jose M Zamanillo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jose M Zamanillo has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
A. Mediavilla
Departamento de Ingeniería de Comunicaciones (DICOM), Universidad de Cantabria, Plaza de la Ciencia s/n 39005 Santander SPAIN
8 shared publicationsC. Perez-Vega
Departamento de Ingeniería de Comunicaciones (DICOM), Universidad de Cantabria, Plaza de la Ciencia s/n 39005 Santander SPAIN
5 shared publicationsC. Navarro
Communications Engineering Department, ETSII y Telecomunicación, University of Cantabria, Avda. Los Castros s/n., 39005 Santander, Spain
4 shared publicationsA. Tazon
2 shared publicationsC. Pérez-Vega
Communications Engineering Department, ETSII y Telecomunicación, University of Cantabria, Avda. Los Castros s/n., 39005 Santander, Spain
2 shared publicationsT. Fernandez
2 shared publications
Latest Publications
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Sidescan sonar imagery processing software for underwater research
Detailed submarine digital analysis of side scan sonar images significantly enhances the ability to assess seafloor features and artifacts digital images. These images are usually poor in their resolution if they are compared with optical images. There are commercial solutions that could solve this trouble, such as: the use of high resolution multibeam sidescan sonar, or the use of bathymetric sonar. Present work shows an economical solution to avoid this kind of problem by using digital image processing techniques under MATLAB environment. The application presented here is easy to use and has been developed under user friendly philosophy and could be operated for users at any level. Two types of sonar surveys, seafloor mapping and submerged target searches (buried or not), each require different processing methods for data analysis. Results are comparable in quality with commercial hardware solutions. Present work is the first step of a new general purpose tool that will be used in submerged objects recognition.
- 1 June 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Sidescan sonar imagery processing software for underwater research
Detailed submarine digital analysis of side scan sonar images significantly enhances the ability to assess seafloor features and artifacts digital images. These images are usually poor in their resolution if they are compared with optical images. There are commercial solutions that could solve this trouble, such as: the use of high resolution multibeam sidescan sonar, or the use of bathymetric sonar. Present work shows an economical solution to avoid this kind of problem by using digital image processing techniques under MATLAB environment. The application presented here is easy to use and has been developed under user friendly philosophy and could be operated for users at any level. Two types of sonar surveys, seafloor mapping and submerged target searches (buried or not), each require different processing methods for data analysis. Results are comparable in quality with commercial hardware solutions. Present work is the first step of a new general purpose tool that will be used in submerged objects recognition.
- 1 November 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 153-156
The versatility of verilog-A based models on commercial microwave simulators
Verilog-A Hardware Description Language (VHDL) is a behavioral description language for analog systems. It is derived from the IEEE 1364 Verilog HDL specification and it is intended to let designers of analog and integrated circuits to create and use modules described mathematically in terms of its terminals and external parameters applied to the module. This paper shows the simplicity and versatility technique of modeling active microwave devices using Verilog-A language. We have made several comparisons under two different commercial simulators: Agilent ADS and GENESYS.
- 1 November 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 153-156
The versatility of verilog-A based models on commercial microwave simulators
Verilog-A Hardware Description Language (VHDL) is a behavioral description language for analog systems. It is derived from the IEEE 1364 Verilog HDL specification and it is intended to let designers of analog and integrated circuits to create and use modules described mathematically in terms of its terminals and external parameters applied to the module. This paper shows the simplicity and versatility technique of modeling active microwave devices using Verilog-A language. We have made several comparisons under two different commercial simulators: Agilent ADS and GENESYS.
- 1 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21654727,p. 1-4
A user-friendly CAD tool for the Rigorous and Efficient Analysis of Finline Waveguiding Structures for Millimetre Applications
In this paper we present the computation of the finline parameters using the transverse resonance method and spectral domain analysis suitable for the design of microwave and millimeter-wave integrated circuits. However, this powerful method has one drawback when many hybrid modes are required because the above technique is used to yield a homogeneous system of equations to determine the propagation constants. In this work and in order to avoid this difficulty, once the equations are written in terms of the transverse components of the fields in the spectral domain, Galerkin's method is used to yield a homogeneous system of equations to determine the propagation constants, but due to the new approach formulation the equations can be rewritten as a linear matrix eigenvalue system for the propagation constant when the eigenvectors of an auxiliary problem are used to expand the modes of the original problem. The key issue of the present study is to use an expanding set of modes at cutoff as auxiliary eigenvectors First, we have obtained the hybrid and complex spectrum of various finlines configurations. This analysis includes the characteristic impedance, attenuation due to dielectric and conductor losses, and the effect of finite metallization thickness. Secondly, configurations of the field components were also studied. We also present a software package; all examples are developed for numerical computation using MATLAB. Comparison with previously accurate published data was performed to confirm the accuracy of our procedure.
- 1 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21654727,p. 1-4
A user-friendly CAD tool for the Rigorous and Efficient Analysis of Finline Waveguiding Structures for Millimetre Applications
In this paper we present the computation of the finline parameters using the transverse resonance method and spectral domain analysis suitable for the design of microwave and millimeter-wave integrated circuits. However, this powerful method has one drawback when many hybrid modes are required because the above technique is used to yield a homogeneous system of equations to determine the propagation constants. In this work and in order to avoid this difficulty, once the equations are written in terms of the transverse components of the fields in the spectral domain, Galerkin's method is used to yield a homogeneous system of equations to determine the propagation constants, but due to the new approach formulation the equations can be rewritten as a linear matrix eigenvalue system for the propagation constant when the eigenvectors of an auxiliary problem are used to expand the modes of the original problem. The key issue of the present study is to use an expanding set of modes at cutoff as auxiliary eigenvectors First, we have obtained the hybrid and complex spectrum of various finlines configurations. This analysis includes the characteristic impedance, attenuation due to dielectric and conductor losses, and the effect of finite metallization thickness. Secondly, configurations of the field components were also studied. We also present a software package; all examples are developed for numerical computation using MATLAB. Comparison with previously accurate published data was performed to confirm the accuracy of our procedure.
- 2 August 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21588473,p. 157-160
Straightforward Method to Extract Electrical Microwave Packages Models
This paper shows an, accurate-straightforward electrical small signal modeling technique for radiofrequency and microwave packaged devices, developed by us. This method called DICOMPAK can be used for ceramic packaged and low cost plastic encapsulated devices. The technique employs analytically derived expressions and it is based on analysis of the measured scattering parameters over an adequate frequency range. Very good agreement between measured and simulated scattering parameters for different ceramic and plastic packaged devices from several foundries is shown
- 2 August 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21588473,p. 157-160
Straightforward Method to Extract Electrical Microwave Packages Models
This paper shows an, accurate-straightforward electrical small signal modeling technique for radiofrequency and microwave packaged devices, developed by us. This method called DICOMPAK can be used for ceramic packaged and low cost plastic encapsulated devices. The technique employs analytically derived expressions and it is based on analysis of the measured scattering parameters over an adequate frequency range. Very good agreement between measured and simulated scattering parameters for different ceramic and plastic packaged devices from several foundries is shown
- 28 April 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 225-228
Measurements of Non-Ionizing Radiation Levels in an Urban Environment
In this paper, we resume the results of electromagnetic radiation measurements performed in the urban environment of the city of Santander, in Spain from radioelectric systems that operate in the area of the city of Santander, in the North of Spain. They include mobile telephony, radio and television broadcasting, police and private communications in the VHF and UHF bands. Four different measuring equipments were used, two of them wideband with isotropic probes and two, narrowband with dipole antennas. Special attention was put in places such as schools and geriatric residences. Furthermore, a wide survey through the urban area of the city was carried out, collecting more than 20,000 samples at street level which were statistically analyzed
- 28 April 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 225-228
Measurements of Non-Ionizing Radiation Levels in an Urban Environment
In this paper, we resume the results of electromagnetic radiation measurements performed in the urban environment of the city of Santander, in Spain from radioelectric systems that operate in the area of the city of Santander, in the North of Spain. They include mobile telephony, radio and television broadcasting, police and private communications in the VHF and UHF bands. Four different measuring equipments were used, two of them wideband with isotropic probes and two, narrowband with dipole antennas. Special attention was put in places such as schools and geriatric residences. Furthermore, a wide survey through the urban area of the city was carried out, collecting more than 20,000 samples at street level which were statistically analyzed
- 1 January 2005
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 16 (1) , 95-101
Large-signal model for microwave FETs under CW laser stimulation
This article presents the results of research on the large‐signal dynamic behavior (pulsed I/V curves) of PHEMT devices, in the overall I/V plane, when the incident optical‐input‐power level is changed. A complete bias and the optical‐power dependency of the parameters used in the large‐signal model for a PHEMT device are determined from the experimental scattering parameters and the DC and pulsed measurements. All the derivatives of the model shown here are continuous in order to provide a realistic description of the circuit distortion and intermodulation phenomena. The model is also valid for GaAs MESFETs. The results obtained for the model exhibit very good agreement with the measurements. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.
- 1 January 2005
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 16 (1) , 95-101
Large-signal model for microwave FETs under CW laser stimulation
This article presents the results of research on the large‐signal dynamic behavior (pulsed I/V curves) of PHEMT devices, in the overall I/V plane, when the incident optical‐input‐power level is changed. A complete bias and the optical‐power dependency of the parameters used in the large‐signal model for a PHEMT device are determined from the experimental scattering parameters and the DC and pulsed measurements. All the derivatives of the model shown here are continuous in order to provide a realistic description of the circuit distortion and intermodulation phenomena. The model is also valid for GaAs MESFETs. The results obtained for the model exhibit very good agreement with the measurements. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.
- 1 January 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 4 pp.-1394
Optical ports: next generation of MMIC control devices?
The results of our research on the electro-optical control of MMICs are shown in this paper. Two different devices have been investigated: a GaAs chip monolithic amplifier at S band, and an AlGaAs chip MMIC voltage controlled oscillator at Ku. The possibilities of optical control of the amplifier are evidenced as follows: if the amplifier operates with the same biasing, the gain can be optically controlled from a condition of almost isolation,, up to an active condition, which gives a range of optical control of about 15 dB and provides an improvement of the input and output matching in a range of 12dB and 6dB, respectively. The possibilities of optical control of the VCO by illumination of the PHEMT transistor are demonstrated through measurements of the oscillation output power and frequency. An optical control range of 8dB of oscillation output power and up to 400MHz of oscillation frequency has been obtained. This optical control suggests an interesting control of gain and matching for other microwave FET based active devices.
- 1 January 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 4 pp.-1394
Optical ports: next generation of MMIC control devices?
The results of our research on the electro-optical control of MMICs are shown in this paper. Two different devices have been investigated: a GaAs chip monolithic amplifier at S band, and an AlGaAs chip MMIC voltage controlled oscillator at Ku. The possibilities of optical control of the amplifier are evidenced as follows: if the amplifier operates with the same biasing, the gain can be optically controlled from a condition of almost isolation,, up to an active condition, which gives a range of optical control of about 15 dB and provides an improvement of the input and output matching in a range of 12dB and 6dB, respectively. The possibilities of optical control of the VCO by illumination of the PHEMT transistor are demonstrated through measurements of the oscillation output power and frequency. An optical control range of 8dB of oscillation output power and up to 400MHz of oscillation frequency has been obtained. This optical control suggests an interesting control of gain and matching for other microwave FET based active devices.
- 23 February 2001
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 29 (1) , 25-31
Large-signal model predicts dynamic behavior of GaAs MESFET model under optical illumination
- 23 February 2001
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 29 (1) , 25-31
Large-signal model predicts dynamic behavior of GaAs MESFET model under optical illumination
- 15 May 2000
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 26 (1) , 16-21
New optical capacitance model for GaAs MESFETs
- 15 May 2000
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 26 (1) , 16-21
New optical capacitance model for GaAs MESFETs