Samuel Saada
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Samuel Saada has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Philippe Bergonzo
Electronic and Electrical Engineering Department, University College London, London WC1E 7JE, UK
6 shared publications - Jean-Charles Arnault
Commissariat à l'Energie Atomique et aux Energies Alternatives
3 shared publications J. C. Arnault
CEA, LIST, Diamond Sensor Laboratory, 91191 Gif sur Yvette, France
2 shared publications- Luciana Intiso
CEA Saclay, DSM/DRECAM/SPCSI, bâtiment 462, Gif sur Yvette, 91191, France
2 shared publications A. Bongrain
CEA, LIST, Diamond Sensors Laboratory, 91191 Gif-sur-Yvette, France
1 shared publication- Alain Lusson
CNRS, GEMaC, Meudon, France
1 shared publication
Latest Publications
- 8 February 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (6) , 061901
Dislocation density reduction using overgrowth on hole arrays made in heteroepitaxial diamond substrates
The growth of large-area diamond films with low dislocation density is a landmark in the fabrication of diamond-based power electronic devices or high-energy particle detectors. Here, we report the development of a growth strategy based on the use of micrometric laser-pierced hole arrays to reduce dislocation densities in heteroepitaxial chemical vapor deposition diamond. We show that, under optimal growth conditions, this strategy leads to a reduction in dislocation density by two orders of magnitude to reach an average value of 6 × 105 cm−2 in the region where lateral growth occurred, which is equivalent to that typically measured for commercial type Ib single crystal diamonds.
- 8 February 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (6) , 061901
Dislocation density reduction using overgrowth on hole arrays made in heteroepitaxial diamond substrates
The growth of large-area diamond films with low dislocation density is a landmark in the fabrication of diamond-based power electronic devices or high-energy particle detectors. Here, we report the development of a growth strategy based on the use of micrometric laser-pierced hole arrays to reduce dislocation densities in heteroepitaxial chemical vapor deposition diamond. We show that, under optimal growth conditions, this strategy leads to a reduction in dislocation density by two orders of magnitude to reach an average value of 6 × 105 cm−2 in the region where lateral growth occurred, which is equivalent to that typically measured for commercial type Ib single crystal diamonds.
- Open Access
- 11 August 2017
- Published by MDPI AG in Proceedings
- Vol. 1 (4) , 623
Estimation of the Number of Volatile Compounds in Simple Mixtures
In this paper, we address the problem of simple mixtures identification using a SAW sensor based e-nose. First, we propose a linearized form of the SAW sensor’s response to mixtures. This equation is then used to set up a linear least squares problem whose residuals are suitable to identify the number of compounds present in a mixture thanks to a supervised learning algorithm.
- 11 August 2017
- Published by MDPI AG in Proceedings
- Vol. 1 (4) , 623
Open AccessEstimation of the Number of Volatile Compounds in Simple Mixtures
In this paper, we address the problem of simple mixtures identification using a SAW sensor based e-nose. First, we propose a linearized form of the SAW sensor’s response to mixtures. This equation is then used to set up a linear least squares problem whose residuals are suitable to identify the number of compounds present in a mixture thanks to a supervised learning algorithm.
- 30 August 2010
- Published by Wiley in Physica Status Solidi (a)
- Vol. 207 (9) , 2078-2083
Measurement of DNA denaturation on B‐NCD coated diamond micro‐cantilevers
We report the detection of DNA denaturation using diamond micro‐cantilevers operating in dynamic mode in liquid environment. Intrinsic diamond cantilevers were fabricated using a bottom up approach which consists of a selective growth of diamond patterns in micro‐machined silicon moulds. They were then coated with a thin layer of boron doped diamond to allow electrochemical immobilization of DNA on their surface. DNA was attached onto the measuring cantilever using a four‐step electrochemical process involving diazonium salt grafting on diamond surface. The DNA immobilization was validated by cyclic voltammetry and fluorescence imaging. DNA denaturation was detected by comparing the resonance frequency shift of the measuring diamond cantilever against that of a reference cantilever when adding the denaturing agent in the solution. A frequency shift was measured and was attributed to surface stress modification upon denaturation.
- 30 August 2010
- Published by Wiley in Physica Status Solidi (a)
- Vol. 207 (9) , 2078-2083
Measurement of DNA denaturation on B‐NCD coated diamond micro‐cantilevers
We report the detection of DNA denaturation using diamond micro‐cantilevers operating in dynamic mode in liquid environment. Intrinsic diamond cantilevers were fabricated using a bottom up approach which consists of a selective growth of diamond patterns in micro‐machined silicon moulds. They were then coated with a thin layer of boron doped diamond to allow electrochemical immobilization of DNA on their surface. DNA was attached onto the measuring cantilever using a four‐step electrochemical process involving diazonium salt grafting on diamond surface. The DNA immobilization was validated by cyclic voltammetry and fluorescence imaging. DNA denaturation was detected by comparing the resonance frequency shift of the measuring diamond cantilever against that of a reference cantilever when adding the denaturing agent in the solution. A frequency shift was measured and was attributed to surface stress modification upon denaturation.
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1203
Hydrogen Incorporation in MPCVD Nanocrystalline Diamond Films During the Deposition Process
- 1 January 2009
- Published by Springer Nature in MRS Proceedings
- Vol. 1203
Hydrogen Incorporation in MPCVD Nanocrystalline Diamond Films During the Deposition Process
- 4 September 2008
- Published by Wiley in Physica Status Solidi (a)
- Vol. 205 (9) , 2121-2125
Synthesis and characterisation of NCD films on 10 × 10 mm2and deposition on 2 inch wafer using rotating substrate-holder set-up
- 4 September 2008
- Published by Wiley in Physica Status Solidi (a)
- Vol. 205 (9) , 2121-2125
Synthesis and characterisation of NCD films on 10 × 10 mm2and deposition on 2 inch wafer using rotating substrate-holder set-up
- 30 August 2007
- Published by Wiley in Physica Status Solidi (a)
- Vol. 204 (9) , 2854-2859
Study of the CVD process sequences for an improved control of the Bias Enhanced Nucleation step on silicon
Diamond epitaxy is of great interest for electronic applications. Most of the time, heteroepitaxial diamond films have been obtained using the Bias Enhanced Nucleation (BEN) step. To investigate the transition between the first CVD plasma exposure and the BEN steps, we studied the residence time distribution (RTD) to monitor the methane concentration in the gas mixture. We showed that the stabilisation time of the methane concentration is not negligible when compared to the biasing duration currently used to obtain high nucleation density and induces effects on the current variation during the first stages of nucleation. We proposed a modelisation of the CVD reactor from experimental data to optimise and reduce this stabilisation time. Then, we showed that the nucleation phenomena are strongly dependent of the used protocol. To conclude, we propose a new approach for an improved control of the Bias Enhanced Nucleation parameters towards a greater reproducibility.
- 30 August 2007
- Published by Wiley in Physica Status Solidi (a)
- Vol. 204 (9) , 2854-2859
Study of the CVD process sequences for an improved control of the Bias Enhanced Nucleation step on silicon
Diamond epitaxy is of great interest for electronic applications. Most of the time, heteroepitaxial diamond films have been obtained using the Bias Enhanced Nucleation (BEN) step. To investigate the transition between the first CVD plasma exposure and the BEN steps, we studied the residence time distribution (RTD) to monitor the methane concentration in the gas mixture. We showed that the stabilisation time of the methane concentration is not negligible when compared to the biasing duration currently used to obtain high nucleation density and induces effects on the current variation during the first stages of nucleation. We proposed a modelisation of the CVD reactor from experimental data to optimise and reduce this stabilisation time. Then, we showed that the nucleation phenomena are strongly dependent of the used protocol. To conclude, we propose a new approach for an improved control of the Bias Enhanced Nucleation parameters towards a greater reproducibility.
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1039
Surface behavior of heterosubstrates during BEN-MPCVD: a key for diamond heteroepitaxy
- 1 January 2007
- Published by Springer Nature in MRS Proceedings
- Vol. 1039
Surface behavior of heterosubstrates during BEN-MPCVD: a key for diamond heteroepitaxy
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 956
The effects of Methane Concentration on diamond nucleation and growth during bias enhanced nucleation on 3C-SiC(100) surfaces
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 956
The effects of Methane Concentration on diamond nucleation and growth during bias enhanced nucleation on 3C-SiC(100) surfaces
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 956
Synthesis of sub-micron diamond films on Si(100) for thermal applications by BEN-MPCVD
- 1 January 2006
- Published by Springer Nature in MRS Proceedings
- Vol. 956
Synthesis of sub-micron diamond films on Si(100) for thermal applications by BEN-MPCVD