Matteo Veneri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Matteo Veneri has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Matteo Massaro
University of Padova
3 shared publications - Stefano Lovato
University of Padova
1 shared publication
Latest Publications
- 14 February 2023
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 62 (2) , 448-462
An optimal control approach to the computation of g-g diagrams
The so-called g-g diagram is widely employed to assess the performance of road vehicles since it provides the maximum longitudinal and lateral accelerations that can be extracted from the selected vehicle. The different points of the g-g diagram are usually computed independently from one another, e.g. the maximum longitudinal accelerations corresponding to given lateral accelerations are computed sequentially. In this work, the problem of computing the points of the g-g diagram is transformed into an optimal control problem, which allows to avoid one of the most annoying practical problems often encountered when deriving such diagrams, namely the ‘jumps’ between different solutions (i.e. large slip vs. small slip solutions at similar lateral acceleration) in adjacent points along the g-g envelope. In the proposed method, the objective is to maximise the area enclosed within the g-g diagram, which has a polar representation. The rate of change of the radial coordinate is the control input. Additional constraints are included to enforce the continuity between the states of the vehicle model in adjacent points along the envelope. These conditions can hardly be enforced using standard methods based on sequential and independent computation of the g-g points. An example of the application of the method is demonstrated on the classic double-track car model with nonlinear tyres.
- 14 February 2023
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 62 (2) , 448-462
An optimal control approach to the computation of g-g diagrams
The so-called g-g diagram is widely employed to assess the performance of road vehicles since it provides the maximum longitudinal and lateral accelerations that can be extracted from the selected vehicle. The different points of the g-g diagram are usually computed independently from one another, e.g. the maximum longitudinal accelerations corresponding to given lateral accelerations are computed sequentially. In this work, the problem of computing the points of the g-g diagram is transformed into an optimal control problem, which allows to avoid one of the most annoying practical problems often encountered when deriving such diagrams, namely the ‘jumps’ between different solutions (i.e. large slip vs. small slip solutions at similar lateral acceleration) in adjacent points along the g-g envelope. In the proposed method, the objective is to maximise the area enclosed within the g-g diagram, which has a polar representation. The rate of change of the radial coordinate is the control input. Additional constraints are included to enforce the continuity between the states of the vehicle model in adjacent points along the envelope. These conditions can hardly be enforced using standard methods based on sequential and independent computation of the g-g points. An example of the application of the method is demonstrated on the classic double-track car model with nonlinear tyres.
- 20 February 2020
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 59 (6) , 907-927
The effect of Ackermann steering on the performance of race cars
While several papers dealing with the kinematic of mechanisms that approximate the well-known Ackermann steering are available, apparently there are no contributions related to the effect of Ackermann steering on vehicle performance. This work focuses on the effect of Ackermann steering and parallel steering on the performance of a racing car, after a discussion on the different definitions of Ackermann steering ratio available in the literature. Three scenarios are considered: steady turning, slalom and a circuit lap. Nonlinear optimal control techniques are employed to assess the maximum performance. A Formula SAE car model is used and validated against experimental data in acceleration, steady turning and slalom. Then the same model is employed to investigate the effect of different steering layouts.
- 20 February 2020
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 59 (6) , 907-927
The effect of Ackermann steering on the performance of race cars
While several papers dealing with the kinematic of mechanisms that approximate the well-known Ackermann steering are available, apparently there are no contributions related to the effect of Ackermann steering on vehicle performance. This work focuses on the effect of Ackermann steering and parallel steering on the performance of a racing car, after a discussion on the different definitions of Ackermann steering ratio available in the literature. Three scenarios are considered: steady turning, slalom and a circuit lap. Nonlinear optimal control techniques are employed to assess the maximum performance. A Formula SAE car model is used and validated against experimental data in acceleration, steady turning and slalom. Then the same model is employed to investigate the effect of different steering layouts.
- 24 April 2019
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 58 (6) , 933-954
A free-trajectory quasi-steady-state optimal-control method for minimum lap-time of race vehicles
Minimum lap time problems are usually solved employing quasi-steady-state models on a predetermined (fixed) trajectory or employing dynamic models on a free (i.e. not predetermined) trajectory. This work describes a third approach, where the minimum-lap-time problem is solved using quasi-steady-state models and free trajectory. The method builds upon g-g maps that can either be derived numerically or experimentally. Such g-g-speed surfaces can either represent the performance of a car or a motorcycle. Both a double-track car model and a motorcycle model are employed as examples of applications. The effect of the free-trajectory vs. fixed-trajectory assumption is also discussed.
- 24 April 2019
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 58 (6) , 933-954
A free-trajectory quasi-steady-state optimal-control method for minimum lap-time of race vehicles
Minimum lap time problems are usually solved employing quasi-steady-state models on a predetermined (fixed) trajectory or employing dynamic models on a free (i.e. not predetermined) trajectory. This work describes a third approach, where the minimum-lap-time problem is solved using quasi-steady-state models and free trajectory. The method builds upon g-g maps that can either be derived numerically or experimentally. Such g-g-speed surfaces can either represent the performance of a car or a motorcycle. Both a double-track car model and a motorcycle model are employed as examples of applications. The effect of the free-trajectory vs. fixed-trajectory assumption is also discussed.