Nataša Stipanelov Vrandečić
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Nataša Stipanelov Vrandečić has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Matko Erceg
Kemijsko-tehnološki fakultet, Zavod za organsku tehnologiju
6 shared publications Ivka Klarić
5 shared publicationsI. Klarić
University of Split
4 shared publicationsMiće Jakić
University of Split
4 shared publicationsBranka Andričić
Department of Organic Chemical Technology, Faculty of Chemistry and Technology, University of Split, Split, Croatia
3 shared publicationsTonka Kovačić
3 shared publications
Latest Publications
- 2 July 2026
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 198 (8)
Floating microplastics in semi-enclosed Boka Kotorska Bay (southern Adriatic Sea)
Sampling and analysis of microplastics (MPs) were conducted along five transects in the Boka Kotorska Bay (southern Adriatic Sea) in October 2023. The transects were strategically selected to capture the influence of one of the most significant cruise ship ports in the Adriatic (the Port of Kotor), an area with substantial freshwater inflows, and the impact of open sea waters. Surface water samples were collected using a Manta trawl. The number and types of polymers were identified using optical microscopy and FTIR spectroscopy. MPs were present in all samples. There was statistical significant difference in the distribution of plastic polymers between the transects (χ2 = 16.87, p < 0.05). Higher MP concentrations were observed near municipal wastewater outlets and in the vicinity of the port. Floating MP abundance ranged from 0.03291 to 0.25126 items/m2, with an average value of 0.116847 items/m2. The collected MPs were predominantly filaments and fragments, primarily composed of polyethylene and polypropylene. The data obtained in this study are crucial for evaluating the extent of MPs pollution and assessing the environmental risks posed by plastic particles. The results indicate substantial MPs contamination, ranging from 0.7 to 5.6 times above baseline values and between 38 to 210 times higher than the threshold levels recommended for the Mediterranean Sea.
- 2 July 2026
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 198 (8)
Floating microplastics in semi-enclosed Boka Kotorska Bay (southern Adriatic Sea)
Sampling and analysis of microplastics (MPs) were conducted along five transects in the Boka Kotorska Bay (southern Adriatic Sea) in October 2023. The transects were strategically selected to capture the influence of one of the most significant cruise ship ports in the Adriatic (the Port of Kotor), an area with substantial freshwater inflows, and the impact of open sea waters. Surface water samples were collected using a Manta trawl. The number and types of polymers were identified using optical microscopy and FTIR spectroscopy. MPs were present in all samples. There was statistical significant difference in the distribution of plastic polymers between the transects (χ2 = 16.87, p < 0.05). Higher MP concentrations were observed near municipal wastewater outlets and in the vicinity of the port. Floating MP abundance ranged from 0.03291 to 0.25126 items/m2, with an average value of 0.116847 items/m2. The collected MPs were predominantly filaments and fragments, primarily composed of polyethylene and polypropylene. The data obtained in this study are crucial for evaluating the extent of MPs pollution and assessing the environmental risks posed by plastic particles. The results indicate substantial MPs contamination, ranging from 0.7 to 5.6 times above baseline values and between 38 to 210 times higher than the threshold levels recommended for the Mediterranean Sea.
- Open Access
- 19 July 2021
- Published by University of Split in St open
- Vol. 2, 1-13
Influence of poly(ethylene oxide) sample preparation on the results of thermogravimetric analysis
Aim: To investigate whether the sample preparation process of poly(ethylene oxide) (PEO) affects kinetic analysis of the thermal degradation process. Kinetic analysis was performed to describe the course of a chemical reaction regardless of the reaction conditions and the reaction system complexity. One differential method, the Friedman method, and one integral Kissinger-Akahira-Sunose method (KAS), were applied in this work. Methods: The PEO sample was prepared in 4 different ways. Thermogravimetric analysis was performed to determine the thermal degradation of prepared samples. Infrared spectroscopic analysis was performed during the preparation of the PEO film obtained by casting from the solution. Results: Dynamic thermal decomposition of PEO, regardless of the method of preparation, takes place through a single decomposition stage, which is manifested by the appearance of one peak on derivative thermogravimetric (DTG) curve. During the preparation of the PEO film, the procedure was carried out at a temperature higher than its melting temperature (Tm=65°C). After the cooling, the obtained sample didn’t solidify and it had an intense odor of acetic acid, which was confirmed by infrared spectroscopic analysis. Samples III and IV were re-prepared at a temperature lower than the melting point of PEO, obtaining samples of satisfactory quality. Conclusion: In order to prepare poly(ethylene oxide) films by solution casting technique, drying should be carried out at temperatures below the melting point of PEO. If TG analysis of pure PEO powder is compared with the results of hot pressed samples and solution cast samples, it can be concluded that the preparation of the sample doesn’t affect the thermal stability of the PEO. The dependence of activation energy calculated by the differential Friedman and integral KAS method on conversion is constant for all samples in a broad conversion range, regardless of how the samples were prepared. The hot pressed samples and solution cast samples have lower activation energy than the commercial PEO powder.
- 19 July 2021
- Published by University of Split in St open
- Vol. 2, 1-13
Open AccessInfluence of poly(ethylene oxide) sample preparation on the results of thermogravimetric analysis
Aim: To investigate whether the sample preparation process of poly(ethylene oxide) (PEO) affects kinetic analysis of the thermal degradation process. Kinetic analysis was performed to describe the course of a chemical reaction regardless of the reaction conditions and the reaction system complexity. One differential method, the Friedman method, and one integral Kissinger-Akahira-Sunose method (KAS), were applied in this work. Methods: The PEO sample was prepared in 4 different ways. Thermogravimetric analysis was performed to determine the thermal degradation of prepared samples. Infrared spectroscopic analysis was performed during the preparation of the PEO film obtained by casting from the solution. Results: Dynamic thermal decomposition of PEO, regardless of the method of preparation, takes place through a single decomposition stage, which is manifested by the appearance of one peak on derivative thermogravimetric (DTG) curve. During the preparation of the PEO film, the procedure was carried out at a temperature higher than its melting temperature (Tm=65°C). After the cooling, the obtained sample didn’t solidify and it had an intense odor of acetic acid, which was confirmed by infrared spectroscopic analysis. Samples III and IV were re-prepared at a temperature lower than the melting point of PEO, obtaining samples of satisfactory quality. Conclusion: In order to prepare poly(ethylene oxide) films by solution casting technique, drying should be carried out at temperatures below the melting point of PEO. If TG analysis of pure PEO powder is compared with the results of hot pressed samples and solution cast samples, it can be concluded that the preparation of the sample doesn’t affect the thermal stability of the PEO. The dependence of activation energy calculated by the differential Friedman and integral KAS method on conversion is constant for all samples in a broad conversion range, regardless of how the samples were prepared. The hot pressed samples and solution cast samples have lower activation energy than the commercial PEO powder.
- 3 August 2020
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 142 (5) , 1863-1875
Characterization of poly(ethylene oxide) modified with different phenyl hepta isobutyl polyhedral oligomeric silsesquioxanes
- 3 August 2020
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 142 (5) , 1863-1875
Characterization of poly(ethylene oxide) modified with different phenyl hepta isobutyl polyhedral oligomeric silsesquioxanes
- Open Access
- 19 May 2020
- Published by Croatian Society of Chemical Engineers/HDKI in Kemija u industriji
- Vol. 69 (5-6) , 261-268
Kinetička analiza izotermne razgradnje poli(etilen-oksida) modificiranog fenil hepta izobutil poliedarskim oligomernim silseskvioksanima
- 19 May 2020
- Published by Croatian Society of Chemical Engineers/HDKI in Kemija u industriji
- Vol. 69 (5-6) , 261-268
Open AccessKinetička analiza izotermne razgradnje poli(etilen-oksida) modificiranog fenil hepta izobutil poliedarskim oligomernim silseskvioksanima
- 4 April 2017
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 131 (1) , 325-334
Different approaches to the kinetic analysis of thermal degradation of poly(ethylene oxide)
- 4 April 2017
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 131 (1) , 325-334
Different approaches to the kinetic analysis of thermal degradation of poly(ethylene oxide)
- 19 August 2016
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 127 (1) , 663-674
The influence of poly(ethylene glycol) on thermal properties of poly(vinyl chloride)/poly(ethylene oxide) blends
- 19 August 2016
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 127 (1) , 663-674
The influence of poly(ethylene glycol) on thermal properties of poly(vinyl chloride)/poly(ethylene oxide) blends
- 1 August 2016
- Published by Elsevier in European Polymer Journal
- Vol. 81, 376-385
Thermal degradation of poly(3-hydroxybutyrate)/poly(ethylene oxide) blends: Thermogravimetric and kinetic analysis
- 1 August 2016
- Published by Elsevier in European Polymer Journal
- Vol. 81, 376-385
Thermal degradation of poly(3-hydroxybutyrate)/poly(ethylene oxide) blends: Thermogravimetric and kinetic analysis
- 20 October 2015
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 123 (2) , 1513-1522
Kinetic analysis of the non-isothermal degradation of poly(vinyl chloride)/poly(ethylene oxide) blends
- 20 October 2015
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 123 (2) , 1513-1522
Kinetic analysis of the non-isothermal degradation of poly(vinyl chloride)/poly(ethylene oxide) blends
- 1 September 2013
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 98 (9) , 1738-1743
Thermal degradation of poly(vinyl chloride)/poly(ethylene oxide) blends: Thermogravimetric analysis
- 1 September 2013
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 98 (9) , 1738-1743
Thermal degradation of poly(vinyl chloride)/poly(ethylene oxide) blends: Thermogravimetric analysis
- 1 January 2010
- Published by Elsevier in Thermochimica Acta
- Vol. 498 (1-2) , 71-80
Kinetic analysis of thermal degradation of poly(ethylene glycol) and poly(ethylene oxide)s of different molecular weight
- 1 January 2010
- Published by Elsevier in Thermochimica Acta
- Vol. 498 (1-2) , 71-80
Kinetic analysis of thermal degradation of poly(ethylene glycol) and poly(ethylene oxide)s of different molecular weight