Kai Ren
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kai Ren has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Robert J. Burkholder
The Ohio State University
7 shared publications - Nader Behdad
Department of Electrical and Computer Engineering, University of WisconsinMadison, Madison, WI, USA
3 shared publications - Mohammad Ranjbar Nikkhah
Department of Electrical and Computer Engineering, University of Wisconsin-Madison, Madison, WI, 53706 USA
2 shared publications Ahmed Hassebo
Wentworth Institute of Technology
1 shared publicationAllan Estuardo Rodas
Raytheon Company
1 shared publicationAnna White
Wentworth Institute of Technology
1 shared publication
Latest Publications
- 8 February 2024
- Published by American Society for Engineering Education
A Wideband Vivaldi Antenna for Drone-Based Microwave Imaging System
- 8 February 2024
- Published by American Society for Engineering Education
A Wideband Vivaldi Antenna for Drone-Based Microwave Imaging System
- 8 February 2024
- Published by American Society for Engineering Education
Direction Finding Using a Single Cellphone Antenna
- 8 February 2024
- Published by American Society for Engineering Education
Direction Finding Using a Single Cellphone Antenna
- 8 February 2024
- Published by American Society for Engineering Education
Deployable Log-Periodic Dipole Array Antenna for CubeSats
- 8 February 2024
- Published by American Society for Engineering Education
Deployable Log-Periodic Dipole Array Antenna for CubeSats
- 8 February 2024
- Published by American Society for Engineering Education
Detection of Red Palm Weevil Infestation in Palm Trees
- 8 February 2024
- Published by American Society for Engineering Education
Detection of Red Palm Weevil Infestation in Palm Trees
- 6 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 22 (7) , 1597-1601
Helicopter-Mounted HF Direction-Finding Antenna With Rotor-Blade Modulation Using the Characteristic Mode Theory
A single helicopter-based high frequency (HF) antenna is proposed for direction finding (DF) using rotor-blade modulation. Without integrating additional antenna structures, a landing gear is utilized as a coupling element to excite a combination of significant characteristic modes of the helicopter through characteristic mode (CM) analysis. Different from traditional DF systems where multiple antennas required, incoming signal receptions are achieved by a single radiator in this work. The diversity in antenna radiation patterns is realized by incorporating main rotor-blade rotations. The incident signals can be measured as the blade rotates from 0° to 75°, where the helicopter-mounted antenna with each rotation angle is equivalent to one antenna element in a conventional DF antenna array. Correlation coefficients of complex CM and excited radiation patterns between the antenna with different blade rotation angles are calculated to demonstrate pattern diversity. Both Cramer-Rao bound (CRB) and multiple signal classification (MUSIC) algorithm are investigated using the complex CM and excited radiation patterns to validate the azimuthal DF capability of the helicopter-integrated single antenna.
- 6 March 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 22 (7) , 1597-1601
Helicopter-Mounted HF Direction-Finding Antenna With Rotor-Blade Modulation Using the Characteristic Mode Theory
A single helicopter-based high frequency (HF) antenna is proposed for direction finding (DF) using rotor-blade modulation. Without integrating additional antenna structures, a landing gear is utilized as a coupling element to excite a combination of significant characteristic modes of the helicopter through characteristic mode (CM) analysis. Different from traditional DF systems where multiple antennas required, incoming signal receptions are achieved by a single radiator in this work. The diversity in antenna radiation patterns is realized by incorporating main rotor-blade rotations. The incident signals can be measured as the blade rotates from 0° to 75°, where the helicopter-mounted antenna with each rotation angle is equivalent to one antenna element in a conventional DF antenna array. Correlation coefficients of complex CM and excited radiation patterns between the antenna with different blade rotation angles are calculated to demonstrate pattern diversity. Both Cramer-Rao bound (CRB) and multiple signal classification (MUSIC) algorithm are investigated using the complex CM and excited radiation patterns to validate the azimuthal DF capability of the helicopter-integrated single antenna.
- 9 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 21 (5) , 873-877
Direction Finding Using a Single Antenna With Blade Modulation
A single top-hat antenna using blade modulation is presented for direction finding (DF). Unlike conventional DF techniques requiring an antenna array with multiple elements, the fixed single antenna is utilized to receive incoming signals. To enhance radiation pattern diversity and perform direction of arrival (DOA) estimation, four rotating blades are placed around four corners of the antenna. The antenna is designed to operate at the frequency where the incoming wave is in resonance with the metallic blades. The incoming signals are recorded as blades rotating with an angle from 0 to 180. To validate the radiation pattern diversity at the resonant frequency and out of the operational frequency band, correlation coefficients of amplitude and phase of complex radiation patterns between the antenna with different blade rotation angles are investigated. DF accuracy in azimuth directions of the proposed single antenna with blade modulation is demonstrated by Cramer-Rao bound (CRB) using the complex radiation patterns at different frequencies.
- 9 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 21 (5) , 873-877
Direction Finding Using a Single Antenna With Blade Modulation
A single top-hat antenna using blade modulation is presented for direction finding (DF). Unlike conventional DF techniques requiring an antenna array with multiple elements, the fixed single antenna is utilized to receive incoming signals. To enhance radiation pattern diversity and perform direction of arrival (DOA) estimation, four rotating blades are placed around four corners of the antenna. The antenna is designed to operate at the frequency where the incoming wave is in resonance with the metallic blades. The incoming signals are recorded as blades rotating with an angle from 0 to 180. To validate the radiation pattern diversity at the resonant frequency and out of the operational frequency band, correlation coefficients of amplitude and phase of complex radiation patterns between the antenna with different blade rotation angles are investigated. DF accuracy in azimuth directions of the proposed single antenna with blade modulation is demonstrated by Cramer-Rao bound (CRB) using the complex radiation patterns at different frequencies.
- Open Access
- 6 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 2, 793-806
Performance-Enhancement of Platform-Based, HF Direction-Finding Systems Using Dynamic Mode Selection
We present a method to enhance the accuracy of platform-based, high-frequency (HF) direction-finding (DF) systems using dynamic mode selection. To improve bandwidth and efficiency, the metallic platform supporting the DF array is used as the primary radiator by employing electrically small antennas to excite linearly independent combinations of its characteristic modes (CMs). However, the radiation characteristics of these modes vary dramatically over the HF band, making it difficult to achieve consistently good DF accuracy with a fixed system. To alleviate this, we propose a dynamic mode selection strategy to achieve enhanced DF accuracy. This strategy is based on the assumption that the number of available CMs of the platform is greater than the number of available coherent receive channels. Thus, dynamic mode selection allows for choosing the optimal antenna combination to obtain the best DF accuracy at each frequency. This strategy is demonstrated for an airborne DF system employing five electrically small antennas and up to four coherent receive channels. We demonstrate the efficacy of the proposed approach using computer simulations and scaled-model experiments. Simulation and measurement results show that dynamic mode selection can significantly enhance the DF accuracy of platform-based HF DF systems using a limited number of coherent receive channels.
- 6 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Antennas and Propagation
- Vol. 2, 793-806
Open AccessPerformance-Enhancement of Platform-Based, HF Direction-Finding Systems Using Dynamic Mode Selection
We present a method to enhance the accuracy of platform-based, high-frequency (HF) direction-finding (DF) systems using dynamic mode selection. To improve bandwidth and efficiency, the metallic platform supporting the DF array is used as the primary radiator by employing electrically small antennas to excite linearly independent combinations of its characteristic modes (CMs). However, the radiation characteristics of these modes vary dramatically over the HF band, making it difficult to achieve consistently good DF accuracy with a fixed system. To alleviate this, we propose a dynamic mode selection strategy to achieve enhanced DF accuracy. This strategy is based on the assumption that the number of available CMs of the platform is greater than the number of available coherent receive channels. Thus, dynamic mode selection allows for choosing the optimal antenna combination to obtain the best DF accuracy at each frequency. This strategy is demonstrated for an airborne DF system employing five electrically small antennas and up to four coherent receive channels. We demonstrate the efficacy of the proposed approach using computer simulations and scaled-model experiments. Simulation and measurement results show that dynamic mode selection can significantly enhance the DF accuracy of platform-based HF DF systems using a limited number of coherent receive channels.
- 21 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
A Multiscale Convolutional Neural Network With Color Vegetation Indices for Semantic Labeling of Point Cloud
This letter presents a multiscale convolutional neural network with color vegetation indices (MCCNN) for semantic labeling of point cloud directly in a 3-D model. First, color vegetation indices are calculated for each point with RGB information. Second, based on classic Point convolutional neural network (CNN), a new multiscale network is designed to incorporate multiscale information through the spatial contexts of different sizes around each point by setting different convolution of kernels $K$ , and then multiscale features produced by different convolutional layers are aggregated and unsampled. Finally, via Fully Connection layer and Softmax classifier, each point is labeled. Two different datasets, Semantic3D and Vaihingen3D, are used to evaluate the performance of the proposed method, and the results are compared with those produced by other existing approaches. Experimental results indicate that the proposed method achieves 84.5% in terms of overall accuracy on Semantic3D, and 85.2% on Vaihingen3D, which is the highest among the considered methods.
- 21 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
A Multiscale Convolutional Neural Network With Color Vegetation Indices for Semantic Labeling of Point Cloud
This letter presents a multiscale convolutional neural network with color vegetation indices (MCCNN) for semantic labeling of point cloud directly in a 3-D model. First, color vegetation indices are calculated for each point with RGB information. Second, based on classic Point convolutional neural network (CNN), a new multiscale network is designed to incorporate multiscale information through the spatial contexts of different sizes around each point by setting different convolution of kernels $K$ , and then multiscale features produced by different convolutional layers are aggregated and unsampled. Finally, via Fully Connection layer and Softmax classifier, each point is labeled. Two different datasets, Semantic3D and Vaihingen3D, are used to evaluate the performance of the proposed method, and the results are compared with those produced by other existing approaches. Experimental results indicate that the proposed method achieves 84.5% in terms of overall accuracy on Semantic3D, and 85.2% on Vaihingen3D, which is the highest among the considered methods.
- 17 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
Geometric Parameter Estimation of Buried Objects in Near-Field Microwave Images
We present a method to estimate and quantify geometric parameters of a buried object in near-field microwave images. These parameters are shape, location, size, and orientation. Unlike the parameter estimation based on a conventional ground-penetrating radar image, a 3-D well-focused coherent image is generated. Instead of choosing a z-slice of the 3-D image, both 2-D projection and shadow projection images are used to perform the parameter estimation. The shape of the buried object is determined based on both x- and y-polarized images. Other geometric parameters, such as location, size, and orientation, are estimated by the method of spatial moments. Both numerical and experimental data of an object buried in a dielectric slab are used to demonstrate the efficacy of the proposed geometric parameter estimation algorithm.
- 17 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
Geometric Parameter Estimation of Buried Objects in Near-Field Microwave Images
We present a method to estimate and quantify geometric parameters of a buried object in near-field microwave images. These parameters are shape, location, size, and orientation. Unlike the parameter estimation based on a conventional ground-penetrating radar image, a 3-D well-focused coherent image is generated. Instead of choosing a z-slice of the 3-D image, both 2-D projection and shadow projection images are used to perform the parameter estimation. The shape of the buried object is determined based on both x- and y-polarized images. Other geometric parameters, such as location, size, and orientation, are estimated by the method of spatial moments. Both numerical and experimental data of an object buried in a dielectric slab are used to demonstrate the efficacy of the proposed geometric parameter estimation algorithm.