EKElena Leonidovna Kossovich

Elena Leonidovna Kossovich

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Elena Leonidovna Kossovich has a total of 102 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Structural Features of Coals and Their Proneness to Spontaneous Combustion

    by E. L. Kossovich, S. A. Epshtein, N. N. Kondratev, V. G. Nesterova, N. N. Dobryakova

    The paper presents the results of an assessment of the influence of coals’ structural features on their proneness to spontaneous combustion. Fifteen


  • Open Access

    Coals’ proneness to airborne respirable dust formation

    by Svetlana A. Epshtein, Elena L. Kossovich, Nadezhda N. Dobryakova, Jie Hao, Yulia E. Andreeva, Vera A. Krasilova

    The paper contains the results of investigation of interconnections between coals’ vitrinite structural features, mode of its crushing under the cyclic nanoindentation with increasing peak load and coals’ proneness to formation of airborne respirable dust (ARD) with particles sized < 10 μm (PM10). A specific value of PM10 contents in coals normalized on a fines fraction (with particles sizes of less than 200 μm) was used as a measure of proneness to ARD formation. It has been shown that the aforementioned parameter is predefined by the ratio of amorphous and crystalline carbon compounds in vitrinite and the mode of its crushing. Some preliminary investigation have been done in order to characterize the involvement of inertinite in ARD formation. It was proposed that the inertinite is not as actively involved in the processes of ARD formation of coals as vitrinite, having a more diverse structural features in terms of amorphous to crystalline carbon compounds ratio.


  • Methodological and instrumental support for the quantitative assessment of the contents of airborne dust in coals

    by S. A. Epshtein, E. L. Kossovich, V. A. Krasilova, A. S. Smirnov

    The processes of mining, processing, transportation and transshipment of coal are accompanied by the release of dust. In accordance with sanitary rules (SanPiN 1.2.3685), coal dust, airborne particles and airborne PM2.5 and PM10 are classified as air pollutants. To calculate emissions of pollutants, including coal dust, from stationary fugitive sources, different methods are used, based on considering of such factors as the characteristics of various equipment used, its productivity, operating time, meteorological conditions, size and dispersion of materials, etc. The coefficients introduced into the calculation, which take into account the fineness of the material, are fixed (constant) for all the coals. This approach does not allow ranking coals according to their “dust capacity”. This is primary due to the lack of reliable methods for quantifying the content of airborne dust in coals and the proportion of PM2.5 and PM10 in it. This paper presents the methodological and instrumental support for the quantitative assessment of the contents of airborne dust in specific coals and its granulometric composition. It is shown that the contents of airborne dust in coals and proportion of PM10 and PM2.5 in t he latter are individual and, in general, do not depend on coal type, rank and petrographic composition. It is shown that the proposed methodological and instrumental support for the quantitative assessment of the contents of airborne dust in coals makes it possible to calculate the coefficients of dispersion of the material that are a part of evaluation of emissions of pollutants into the atmospheric air.The work was supported by the Russian Science Foundation (grant no. 18-77-10052).

  • Open Access

    Effects of coals microscale structural features on their mechanical properties, propensity to crushing and fine dust formation

    by Elena Kossovich, Svetlana Epshtein, Vera Krasilova, Jie Hao, Maxim Minin

    The work is dedicated to revealing the structural features of coals with different ranks, such as anthracites, metaanthracite and graphite, that determine their ability to crush and form fine dust. For this purpose, a combination of various nanoindentation techniques and Raman spectroscopy was used. The mechanical behavior of the selected coals was investigated by cyclic nanoindentation with increasing peak load and quasi-static loading. The alteration of the mechanical properties was studied by analysis of elastic moduli and damage indices Rw. Three groups of coals were identified based on their propensity to crushing during cyclic nanoindentation. Coals assigned to the first and second groups are characterized by local destruction in the contact zone with the indenter and the formation of a core of crushed material. Coals assigned to the third group are characterized by bulk destruction (outside the zone of contact with the indenter). In general, the ability of coals to fracture under mechanical loading decreases in the series of metamorphism due to microscale compaction of vitrinite matter. In the series of anthracite, metaanthracite and graphite, it is established that the coal matter compaction takes place for the anthracite and metaanthracite, whereas graphite reveals rather different behavior due to abrupt change of its structure. The ratios between the amorphous and crystalline phases of carbon (S) were determined by deconvolution of coals Raman spectra. The propensity of coals to crushing (a damage index Rw) increases with growth of the proportion of amorphous carbon in the coal matter. For the considered coals and metaanthracite, it is established that the proneness to destruction outside the contact zone with the indenter is determined by the ratio of amorphous and crystalline carbon of 1 and higher. When S parameter is lower than 1, the coals are being crushed only in the zone of contact with the indenter.


  • EFFECTS OF NATURAL OXIDATION OF HARD COALS AT THE CONTENTS OF MACRO- AND MICROELEMENTS

    by Svetlana Abramovna Epshtein, Vera Alekseevna Krasilova, Nadezhda Nikolaevna Dobryakova, Hao Jie, Elena Leonidovna Kossovich


  • Problems of carbon dioxide leakage from geological storage

    by E.L. Kossovich, Y.E. Andreeva, D.I. Gavrilova, S.A. Epshtein, N.N. Dobryakova

  • Development of method for coal dust particle size distribution characterization by laser diffraction

    by V.A. Krasilova, S.A. Epshtein, E.L. Kossovich, M.M. Kozyrev, A.A. Ionin

    В настоящее время актуальной экологической проблемой является выделение угольной пыли при добыче, хранении, транспортировке углей, а также при их перевалке на угольных терминалах и в морских портах. Наибольший интерес представляет тонкодисперсная угольная пыль с размерами частиц менее 10 мкм, способная длительное время находиться во взвешенном состоянии и переноситься с воздушными потоками на значительные расстояния. Для контроля технологических процессов добычи, обогащения, переработки, транспортировки углей и мониторинга состояния окружающей среды необходима надежная информация не только о содержании тонкодисперсной угольной пыли, но и о ее гранулометрическом составе. На сегодняшний день метод лазерной дифракции является одним из востребованных и надежных методов определения гранулометрического состава тонкодисперсных материалов. В данной статье представлен подход к разработке методики измерений гранулометрического состава угольной пыли методом лазерной дифракции. Рассмотрены вопросы подготовки проб для анализа, приведены экспериментальные результаты исследований влияния условий проведения испытаний на результаты измерений гранулометрического состава пыли. На основании полученных результатов была разработана методика измерения гранулометрического состава тонко-дисперсной угольной пыли. Она включает в себя способы подготовки проб для анализа, подбор оптимального режима измерений, результаты измерений, анализ полученных результатов и их метрологическую оценку. Показано, что разработанная методика может использоваться для оценки гранулометрического состава угольной пыли разного происхождения (отобранной с различных поверхностей, выделенной из суспензий, отобранной из рудничной или воздушной атмосферы, из аспирационных...


  • Laboratory installation for collection and concentration of airborne coal dust

    by V.A. Krasilova, E.L. Kossovich, D.I. Gavrilova, M.M. Kozyrev

    Пыление углей является одной из актуальных проблем в угольной промышленности, так как угольная пыль может загрязнять атмосферный воздух, почвы и водные объекты. В соответствии с СанПиН 1.2.3685-21 пыль каменного угля внесена в перечень загрязняющих атмосферный воздух веществ. Отмечено, что для почв и водных объектов отсутствуют маркерные вещества, указывающие на то, что причиной загрязнения этих объектов является именно угольная пыль. Наличие информации о содержании в углях взвешенной пыли, ее гранулометрическом составе и концентрации потенциально опасных элементов позволит выявить перечень маркерных веществ - потенциальных загрязнителей почв и водных объектов. Дано описание новой лабораторной установки, предназначенной для улавливания и концентрирования тонкодисперсной пыли, содержащейся в рядовых углях или товарной продукции и способной находиться во взвешенном состоянии. Приведены результаты экспериментальных исследований на лабораторной установке по улавливанию взвешенной угольной пыли из товарных углей. Определено количественное содержание взвешенной пыли в углях разных марок, проведен анализ ее гранулометрического состава. Установлено, что по сравнению с исходными углями угольная пыль характеризуется большей зольностью, а содержание в ней серы практически не...


  • Development of micro- and nanoindentation methods for assessing the mechanical properties of coals and their propensity to destruction

    by E. L. Kossovich

    The destruction of coals in the processes of mining, storage, transportation and processing is associated, among other, with their mechanical properties. As a rule, the mechanical properties of coals are evaluated by the resul ts of measurements of such characteristics as tensile and compressive strength, stiffness (elastic modulus) and Poisson’s ratio, etc. For this, experiments are carried out on specially prepared samples in tensile testing machines and mechanical presses. Such integral indicators characterize the mechanical behavior of coals at the macro scale and do not allow assessing the influence of structural features on the initiation of defects leading to destruction. In this regard, the characteristics of the mechanical properties of coals, obtained in areas comparable to the levels of microcracks initiation, are of interest. Micro- and nanoindentation techniques are quite simple to implement for obtaining the reliable information on various mechanical properties of materials at the appropriate scale levels. This paper is dedicated to an overview of the current state of research on the use of these methods to assess the mechanical properties of coals and their individual macerals, as well as their ability to crush with the formation of dust particles. The use of micro- and nanoindentation techniques made it possible to establish the differences in the mechanical properties of individual macerals of coals, as well as to characterize the heterogeneity of the distribution of various indicators characterizing mechanical properties within the individual macerals. Based on experimental data on nanoindentation and Raman spectroscopy, it was shown that the change in the mechanical properties (values of the modulus of elasticity and hardness) of vitrinite in the series of coal metamorphism is associated with an increase in the proportion of graphitized components in organic matter. Nanoindentation methods, combined with an analytical mathematical apparatus, made it possible to obtain data on the ability of coals to crush under mechanical effects with the formation of particles with sizes comparable to those of hazardous aerosol dust (class PM 2.5). The method of cyclic nanoindentation with an increasing maximum load was proposed as a method for determining the degree of coal tendency to fracture with the formation of dust. Its application made it possible to reveal the characteristics of irreversible changes occurring in the structure of coals during destruction. They are expressed in a change in their mechanical properties (stiffness and fracturing ability) with an increase in the applied load. The use of the cyclic nanoindentation method is a promising method for the qualitative and quantitative analysis of the degree of coal propensity to crushing with the formation of dust. This work was carried out with the financial support of the Russian Science Foundation (Grant No. 18-77-10052).