Jianjun Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jianjun Liu has a total of 105 co-authors. Here are the top co-authors by number of shared publications:
Shengli Zuo
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, 15 North Third Ring Road East, Chaoyang District, Beijing, People's Republic of China
32 shared publicationsYingchun Yu
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, 15 North Third Ring Road East, Chaoyang District, Beijing, People's Republic of China
29 shared publicationsBaoshan Li
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, Beijing, 100029, PR China
18 shared publicationsHecheng Ma
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, 15 North Third Ring Road East, Chaoyang District, Beijing, People's Republic of China
13 shared publicationsYimeng Wang
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, 15 North Third Ring Road East, Chaoyang District, Beijing, People's Republic of China
7 shared publicationsJinbo Pan
6 shared publications
Latest Publications
- 25 March 2024
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 665, 655-680
Broad-spectrum hybrid-driven triple-interface Z-Scheme 1T/2H phase sailboat-like molybdenum disulfide (MoS2)/protonated N-defect nanoporous graphitic carbon nitride (g-C3N4) nanosheets piezo-photocatalyst: Superior degradation and hydrogen evolution
- 25 March 2024
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 665, 655-680
Broad-spectrum hybrid-driven triple-interface Z-Scheme 1T/2H phase sailboat-like molybdenum disulfide (MoS2)/protonated N-defect nanoporous graphitic carbon nitride (g-C3N4) nanosheets piezo-photocatalyst: Superior degradation and hydrogen evolution
- 29 March 2023
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 642, 304-320
Enhanced non-layer-dependent piezo-response in sailboat-like vertical molybdenum disulfide nanosheets for piezo-catalytic hydrogen evolution and dye degradation: Effect of microstructure and phase composition
- 29 March 2023
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 642, 304-320
Enhanced non-layer-dependent piezo-response in sailboat-like vertical molybdenum disulfide nanosheets for piezo-catalytic hydrogen evolution and dye degradation: Effect of microstructure and phase composition
- 7 March 2023
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 49 (8) , 3327-3362
Development of TiO2 decorated Fe2O3QDs/g-C3N4 Ternary Z-scheme photocatalyst involving the investigation of phase analysis via strain mapping and its photocatalytic performance under visible light illumination
- 7 March 2023
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 49 (8) , 3327-3362
Development of TiO2 decorated Fe2O3QDs/g-C3N4 Ternary Z-scheme photocatalyst involving the investigation of phase analysis via strain mapping and its photocatalytic performance under visible light illumination
- Open Access
- 26 December 2022
- Published by MDPI AG in Nanomaterials
- Vol. 13 (1) , 109
Synthesis of N-Doped Few-Layer Graphene through Shock-Induced Carbon Fixation from CO2
In this study, graphene and N-doped graphene nanosheets were synthesized through the shock-induced reduction of CO2 using a cylindrical shock-loading apparatus. The mixture of solid CO2 and Mg powder was filled in the pre-cooled sample tube and then impacted by a shock-driven cylindrical flyer tube. The impact generated a shockwave that propagated into the mixed precursor, inducing a chemical reaction between CO2 and Mg at a high shock pressure and high shock temperature. The recovered black powders were characterized via various techniques, confirming the presences of few-layer graphene. The mechanism is carefully shown to be that CO2 was reduced by Mg to form few-layer graphene under shock-induced high pressure and high temperature. By adding carbamide as an N source, this synthetic route was also applied to synthesize N-doped graphene nanosheets. Moreover, the yield and mass of the graphene materials in this study are up to 40% and 0.5 g, respectively. This study showed an efficient and easy-to-scale-up route to prepare few-layer graphene and N-doped few-layer graphene through shock synthesis.
- 26 December 2022
- Published by MDPI AG in Nanomaterials
- Vol. 13 (1) , 109
Open AccessSynthesis of N-Doped Few-Layer Graphene through Shock-Induced Carbon Fixation from CO2
In this study, graphene and N-doped graphene nanosheets were synthesized through the shock-induced reduction of CO2 using a cylindrical shock-loading apparatus. The mixture of solid CO2 and Mg powder was filled in the pre-cooled sample tube and then impacted by a shock-driven cylindrical flyer tube. The impact generated a shockwave that propagated into the mixed precursor, inducing a chemical reaction between CO2 and Mg at a high shock pressure and high shock temperature. The recovered black powders were characterized via various techniques, confirming the presences of few-layer graphene. The mechanism is carefully shown to be that CO2 was reduced by Mg to form few-layer graphene under shock-induced high pressure and high temperature. By adding carbamide as an N source, this synthetic route was also applied to synthesize N-doped graphene nanosheets. Moreover, the yield and mass of the graphene materials in this study are up to 40% and 0.5 g, respectively. This study showed an efficient and easy-to-scale-up route to prepare few-layer graphene and N-doped few-layer graphene through shock synthesis.
- 14 December 2022
- Published by Elsevier in Chemosphere
- Vol. 313, 137482
Photocatalytic degradation and electrochemical energy storage properties of CuO/SnO2 nanocomposites via the wet-chemical method
- 14 December 2022
- Published by Elsevier in Chemosphere
- Vol. 313, 137482
Photocatalytic degradation and electrochemical energy storage properties of CuO/SnO2 nanocomposites via the wet-chemical method
- Open Access
- 10 October 2022
- Published by Beilstein Institut in Beilstein Journal of Organic Chemistry
- Vol. 18 (1) , 1416-1423
Mechanochemical synthesis of unsymmetrical salens for the preparation of Co–salen complexes and their evaluation as catalysts for the synthesis of α-aryloxy alcohols via asymmetric phenolic kinetic resolution of terminal epoxides
In this paper, we report the mechanochemical synthesis of unsymmetrical salens using grinding and ball milling technologies, respectively, both of which were afforded in good yield. The chelating effect of the unsymmetrical salens with zinc, copper, and cobalt was studied and the chiral Co–salen complex 2f was obtained in 98% yield. Hydrolytic kinetic resolution (HKR) of epichlorohydrin with water catalyzed by complex 2f (0.5 mol %) was explored and resulted in 98% ee, suggesting complex 2f could serve as an enantioselective catalyst for the asymmetric ring opening of terminal epoxides by phenols. A library of α-aryloxy alcohols 3 was thereafter synthesized in good yield and high ee using 2f via the phenolic KR of epichlorohydrin.
- 10 October 2022
- Published by Beilstein Institut in Beilstein Journal of Organic Chemistry
- Vol. 18 (1) , 1416-1423
Open AccessMechanochemical synthesis of unsymmetrical salens for the preparation of Co–salen complexes and their evaluation as catalysts for the synthesis of α-aryloxy alcohols via asymmetric phenolic kinetic resolution of terminal epoxides
In this paper, we report the mechanochemical synthesis of unsymmetrical salens using grinding and ball milling technologies, respectively, both of which were afforded in good yield. The chelating effect of the unsymmetrical salens with zinc, copper, and cobalt was studied and the chiral Co–salen complex 2f was obtained in 98% yield. Hydrolytic kinetic resolution (HKR) of epichlorohydrin with water catalyzed by complex 2f (0.5 mol %) was explored and resulted in 98% ee, suggesting complex 2f could serve as an enantioselective catalyst for the asymmetric ring opening of terminal epoxides by phenols. A library of α-aryloxy alcohols 3 was thereafter synthesized in good yield and high ee using 2f via the phenolic KR of epichlorohydrin.
- Open Access
- 26 July 2022
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 3 (20) , 7546-7558
Construction of novel flower-like functionalized black phosphorus nanosheets/P-doped BiOCl S-scheme photocatalysts with improved photocatalytic activity in RhB and Cr(vi) degradation
A flower-like S-scheme BP/BiOCl photocatalyst has been successfully prepared via a simple co-precipitation method, which shows high photocatalytic activity and good stability.
- 26 July 2022
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 3 (20) , 7546-7558
Open AccessConstruction of novel flower-like functionalized black phosphorus nanosheets/P-doped BiOCl S-scheme photocatalysts with improved photocatalytic activity in RhB and Cr(vi) degradation
A flower-like S-scheme BP/BiOCl photocatalyst has been successfully prepared via a simple co-precipitation method, which shows high photocatalytic activity and good stability.
- 4 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (14) , 141902
Formation of black phosphorus quantum dots via shock-induced phase transformation
Black phosphorus quantum dots (BPQDs) have recently obtained great attention owing to their outstanding properties, such as high hole mobility, quantum confinement effect, and edge effect. At present, several methods have been applied to prepare BPQDs using black phosphorus as precursor. In this study, BPQDs are obtained via shock-induced phase transformation using ball-milled red phosphorus nanopowder as precursor. The red phosphorus powder was ball-milled and shocked to induce phase transformation at transient high pressure and temperature. Multiple techniques are applied to characterize the recovered samples, including x-ray diffraction, Raman spectroscopy, transmission electron microscopy, and atomic force microscope. The characterization results demonstrate that the majority of recovered sample is BPQDs with a lateral size of 2–10 nm and a thickness of 0.9–2 nm. In addition, the formation mechanism of BPQDs under shock treatment was carefully analyzed, consisting of phase transformation induced by shock loading and exfoliation by tensile and shear effects. Furthermore, this study also confirms that the micromorphology of precursor is critical to the formation of BPQDs. This research provides an efficient one-step path to prepare BPQDs using ball-milled red phosphorus nanopowder as precursor.
- 4 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (14) , 141902
Formation of black phosphorus quantum dots via shock-induced phase transformation
Black phosphorus quantum dots (BPQDs) have recently obtained great attention owing to their outstanding properties, such as high hole mobility, quantum confinement effect, and edge effect. At present, several methods have been applied to prepare BPQDs using black phosphorus as precursor. In this study, BPQDs are obtained via shock-induced phase transformation using ball-milled red phosphorus nanopowder as precursor. The red phosphorus powder was ball-milled and shocked to induce phase transformation at transient high pressure and temperature. Multiple techniques are applied to characterize the recovered samples, including x-ray diffraction, Raman spectroscopy, transmission electron microscopy, and atomic force microscope. The characterization results demonstrate that the majority of recovered sample is BPQDs with a lateral size of 2–10 nm and a thickness of 0.9–2 nm. In addition, the formation mechanism of BPQDs under shock treatment was carefully analyzed, consisting of phase transformation induced by shock loading and exfoliation by tensile and shear effects. Furthermore, this study also confirms that the micromorphology of precursor is critical to the formation of BPQDs. This research provides an efficient one-step path to prepare BPQDs using ball-milled red phosphorus nanopowder as precursor.