Ali Akbar Maghsoudi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ali Akbar Maghsoudi has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Habib Akbarzadeh Bengar
Department of Civil Engineering, Faculty of Engineering and Technology, University of Mazandaran, Babolsar 47416-13534, Iran
7 shared publications - Mohammad Maghsoudi
Department of Civil Engineering, University of Jiroft, Jiroft, Iran
3 shared publications - Hamid Reza Ronagh
The University of Queensland
2 shared publications Reza Rahgozar
2 shared publications- Seyed Hamid Hashemi
Arak University
2 shared publications - Yasser Sharifi
Department of Civil Engineering, Vali-e-Asr University of Rafsanjan, Rafsanjan, Iran
2 shared publications
Latest Publications
- 19 February 2018
- Published by Springer Nature in International Journal of Civil Engineering
- Vol. 17 (5) , 541-553
Finite Element and Experimental Investigation on the Flexural Response of Pre-tensioned T-Girders
- 19 February 2018
- Published by Springer Nature in International Journal of Civil Engineering
- Vol. 17 (5) , 541-553
Finite Element and Experimental Investigation on the Flexural Response of Pre-tensioned T-Girders
- 1 July 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 22 (7)
Experimental and Theoretical Serviceability of Strengthened and Nonstrengthened Unbonded Posttensioned Indeterminate I-Beams
The serviceability response of ultrahigh strength self-consolidating concrete (UHSSCC) in strengthened and nonstrengthened unbonded posttensioned indeterminate members is crucial, because little research has been conducted on such continuous members composed of this relatively new type of concrete. Moreover, most studies on continuous beams mainly focused on ultimate response prediction, because the results are not applicable to the serviceability response, and the design of these members is mostly governed by the serviceability limit state. Therefore, for evaluation of the serviceability response, flexural testing of unbonded posttensioned UHSSCC continuous nonstrengthened and strengthened I-beams, reinforced with one unbonded tendon of variable eccentricity and different area of tensile and compressive reinforcement bars, was conducted. One layer of unidirectional carbon-fiber-reinforced polymer sheet (CFRP) (ply) at sagging and hogging regions was externally applied to strengthened beams. To determine the service loads, materials stress and strain (tendon, concrete, steel rebar, and CFRP sheets), the flexural crack width and deflection of test beams were monitored at different stages of loading. Different standards were used to specify the permissible stress and strain of materials and flexural crack widths (0.1 and 0.2 mm) under the serviceability limit state. The end of the serviceability level was determined for beams with a new flexural crack width limitation of 0.3 mm. Considering this aspect, it was found that for the test beams, an average load capacity enhancement of 20% was pronounced at the serviceability state. An increase in propagation length and number of cracks with a decrease in crack spacing was monitored for strengthened beams compared with nonstrengthened ones. This was primarily caused by lower values of effective prestressing stress ( ) and strengthening technique. Maximum flexural crack width equations were proposed and compared with experimental and theoretical values. The performances of the proposed equations were as good as that for the American Concrete Institute (ACI), but were superior to those recommended by the Eurocode 2 and Canadian Prestressed Concrete Institute standards. The ACI equation was more versatile because it was applicable to both nonstrengthened and strengthened beams. The predicted values for immediate deflection of the beams at the service limit state based on the simplified method were compared with the experimental deflection values, and the results showed good agreement up to the yielding of nonprestressed steel. The discrepancies between the predicted and experimental deflections were within ±20%.- 1 July 2017
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 22 (7)
Experimental and Theoretical Serviceability of Strengthened and Nonstrengthened Unbonded Posttensioned Indeterminate I-Beams
The serviceability response of ultrahigh strength self-consolidating concrete (UHSSCC) in strengthened and nonstrengthened unbonded posttensioned indeterminate members is crucial, because little research has been conducted on such continuous members composed of this relatively new type of concrete. Moreover, most studies on continuous beams mainly focused on ultimate response prediction, because the results are not applicable to the serviceability response, and the design of these members is mostly governed by the serviceability limit state. Therefore, for evaluation of the serviceability response, flexural testing of unbonded posttensioned UHSSCC continuous nonstrengthened and strengthened I-beams, reinforced with one unbonded tendon of variable eccentricity and different area of tensile and compressive reinforcement bars, was conducted. One layer of unidirectional carbon-fiber-reinforced polymer sheet (CFRP) (ply) at sagging and hogging regions was externally applied to strengthened beams. To determine the service loads, materials stress and strain (tendon, concrete, steel rebar, and CFRP sheets), the flexural crack width and deflection of test beams were monitored at different stages of loading. Different standards were used to specify the permissible stress and strain of materials and flexural crack widths (0.1 and 0.2 mm) under the serviceability limit state. The end of the serviceability level was determined for beams with a new flexural crack width limitation of 0.3 mm. Considering this aspect, it was found that for the test beams, an average load capacity enhancement of 20% was pronounced at the serviceability state. An increase in propagation length and number of cracks with a decrease in crack spacing was monitored for strengthened beams compared with nonstrengthened ones. This was primarily caused by lower values of effective prestressing stress ( ) and strengthening technique. Maximum flexural crack width equations were proposed and compared with experimental and theoretical values. The performances of the proposed equations were as good as that for the American Concrete Institute (ACI), but were superior to those recommended by the Eurocode 2 and Canadian Prestressed Concrete Institute standards. The ACI equation was more versatile because it was applicable to both nonstrengthened and strengthened beams. The predicted values for immediate deflection of the beams at the service limit state based on the simplified method were compared with the experimental deflection values, and the results showed good agreement up to the yielding of nonprestressed steel. The discrepancies between the predicted and experimental deflections were within ±20%.- Open Access
- 1 July 2016
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 20 (5) , 1863-1869
Properties assessment of concrete containing Sirjan Pozzolan
- 1 July 2016
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 20 (5) , 1863-1869
Open AccessProperties assessment of concrete containing Sirjan Pozzolan
- 11 April 2016
- Published by Wiley in Structural Concrete
- Vol. 17 (5) , 883-895
The monitored and theoretical ultimate moment and ductility of pre-tensioned HSSCC bridge girders
- 11 April 2016
- Published by Wiley in Structural Concrete
- Vol. 17 (5) , 883-895
The monitored and theoretical ultimate moment and ductility of pre-tensioned HSSCC bridge girders
- 1 April 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 20 (2)
Sagging and Hogging Strengthening of Continuous Unbonded Posttensioned HSC Beams by NSM and EBR
Continuous unbonded posttensioned concrete beams might require strengthening to cope with higher demands. Strengthening with carbon-fiber-reinforced plastics (CFRP) is a viable option; however, because of the limited number of studies in this area and lack of experimental data, the guidelines covered only bonded prestressed concrete members, in particular when these are made from high-strength concrete (HSC). This paper reports on the results of an experimental investigation on the flexural behavior of continuous unbonded posttensioned HSC beams strengthened using CFRP. In this application, the CFRP is either externally bonded reinforcement (EBR) or internally near-surface mounted (NSM) in both hogging and sagging regions. The results show that both service and ultimate states of continuous unbonded posttensioned concrete beams were considerably improved by CFRP strengthening, and also that the efficiency of the NSM method is greater than that of the EBR method, especially in crack propagation and...
- 1 April 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 20 (2)
Sagging and Hogging Strengthening of Continuous Unbonded Posttensioned HSC Beams by NSM and EBR
Continuous unbonded posttensioned concrete beams might require strengthening to cope with higher demands. Strengthening with carbon-fiber-reinforced plastics (CFRP) is a viable option; however, because of the limited number of studies in this area and lack of experimental data, the guidelines covered only bonded prestressed concrete members, in particular when these are made from high-strength concrete (HSC). This paper reports on the results of an experimental investigation on the flexural behavior of continuous unbonded posttensioned HSC beams strengthened using CFRP. In this application, the CFRP is either externally bonded reinforcement (EBR) or internally near-surface mounted (NSM) in both hogging and sagging regions. The results show that both service and ultimate states of continuous unbonded posttensioned concrete beams were considerably improved by CFRP strengthening, and also that the efficiency of the NSM method is greater than that of the EBR method, especially in crack propagation and...
- Open Access
- 1 July 2015
- Vol. 3 (2) , 16-29
Serviceability Response of Rehabilitated Unbounded Post-tensioned Indeterminate I-Beams Consisting UHSSCC
- 1 July 2015
- Vol. 3 (2) , 16-29
Open AccessServiceability Response of Rehabilitated Unbounded Post-tensioned Indeterminate I-Beams Consisting UHSSCC
- 25 March 2015
- Published by Techno-Press in STRUCTURAL ENGINEERING AND MECHANICS
- Vol. 53 (6) , 1083-1104
Flexural strengthening of continuous unbonded post-tensioned concrete beams with end-anchored CFRP laminates
- 25 March 2015
- Published by Techno-Press in STRUCTURAL ENGINEERING AND MECHANICS
- Vol. 53 (6) , 1083-1104
Flexural strengthening of continuous unbonded post-tensioned concrete beams with end-anchored CFRP laminates
- Open Access
- 1 February 2014
- Vol. 2 (1) , 35-45
Ultimate Tendon Stress in CFRP Strengthened Unbounded HSC Post-Tensioned Continuous I-Beams
- 1 February 2014
- Vol. 2 (1) , 35-45
Open AccessUltimate Tendon Stress in CFRP Strengthened Unbounded HSC Post-Tensioned Continuous I-Beams
- 29 January 2014
- Published by Springer Nature in Frontiers of Structural and Civil Engineering
- Vol. 8 (1) , 46-56
An experimental study on the flexural behavior of heavily steel reinforced beams with high-strength concrete
- 29 January 2014
- Published by Springer Nature in Frontiers of Structural and Civil Engineering
- Vol. 8 (1) , 46-56
An experimental study on the flexural behavior of heavily steel reinforced beams with high-strength concrete
- 25 July 2011
- Published by Techno-Press in STRUCTURAL ENGINEERING AND MECHANICS
- Vol. 39 (2) , 241-266
Theoretical and experimental serviceability performance of SCCs connections
- 25 July 2011
- Published by Techno-Press in STRUCTURAL ENGINEERING AND MECHANICS
- Vol. 39 (2) , 241-266
Theoretical and experimental serviceability performance of SCCs connections