Susumu Takabayashi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Susumu Takabayashi has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
Yuji Takakuwa
Micro System Integration Center, Tohoku University
10 shared publicationsKeishi Okamoto
Department of Quantum Matter, Graduate School of Advanced Sciences of Matter Hiroshima University 1‐3‐1 Kagamiyama, Higashihiroshima Hiroshima 739‐8530 Japan
9 shared publicationsTatsuyuki Nakatani
Toyo Advanced Technologies Co., Ltd. 5‐3‐38 Ujina‐Higashi, Minami‐ku Hiroshima 734‐8501 Japan
9 shared publications- Shuichi Ogawa
Nihon University 8 , Narashino, Chiba 275-8576
8 shared publications Takayuki Takahagi
Department of Quantum Matter, Graduate School of Advanced Sciences of Matter Hiroshima University 1‐3‐1 Kagamiyama, Higashihiroshima Hiroshima 739‐8530 Japan
8 shared publicationsHiroyuki Hayashi
Tohoku Univ, Inst Multidisciplinary Res Adv Mat, Aoba Ku, 2-1-1 Katahira, Sendai, Miyagi 9808577, Japan
6 shared publications
Latest Publications
- 22 April 2024
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 42 (3)
Plasma confinement by an optoelectronic system
Plasma confinement was succeeded by an optoelectronic system with the aid of a vacuum ultraviolet (VUV) light source, called the photoemission-assisted plasma system. The photoemission-assisted plasma was generated by utilizing photoelectrons from the substrate cathode. The photoelectrons were emitted from the substrate by external VUV irradiation via the photoelectric effect and then worked as initial electrons triggering the plasma generation. The photoemission-assisted plasma was confined with bright luminescence in an argon atmosphere by controlling the flow rate and pressure. The plasma confinement survived at up to 6400 Pa, which was much higher than the pressure estimated from the current–voltage characteristics. These results suggested that the area exhibiting luminescence dominated by the γ regime becomes small as the argon flow rate increases; however, the area does not vanish because the VUV-excited photoelectrons are sufficiently supplied. The residual area is dominated by the α regime without luminescence. Thus, the photoemission-assisted plasma seems to be confined on the balance between α and γ regimes. Because the current in the α-regime area is one hundredth in magnitude compared with that in the γ-regime area, the actual current density results in over 40 times with strong luminescence. This confined plasma with certain voltage and current condition may be expected for developing a new plasma reaction system and for application in semiconductor engineering.
- 22 April 2024
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 42 (3)
Plasma confinement by an optoelectronic system
Plasma confinement was succeeded by an optoelectronic system with the aid of a vacuum ultraviolet (VUV) light source, called the photoemission-assisted plasma system. The photoemission-assisted plasma was generated by utilizing photoelectrons from the substrate cathode. The photoelectrons were emitted from the substrate by external VUV irradiation via the photoelectric effect and then worked as initial electrons triggering the plasma generation. The photoemission-assisted plasma was confined with bright luminescence in an argon atmosphere by controlling the flow rate and pressure. The plasma confinement survived at up to 6400 Pa, which was much higher than the pressure estimated from the current–voltage characteristics. These results suggested that the area exhibiting luminescence dominated by the γ regime becomes small as the argon flow rate increases; however, the area does not vanish because the VUV-excited photoelectrons are sufficiently supplied. The residual area is dominated by the α regime without luminescence. Thus, the photoemission-assisted plasma seems to be confined on the balance between α and γ regimes. Because the current in the α-regime area is one hundredth in magnitude compared with that in the γ-regime area, the actual current density results in over 40 times with strong luminescence. This confined plasma with certain voltage and current condition may be expected for developing a new plasma reaction system and for application in semiconductor engineering.
- Open Access
- 10 February 2024
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 67 (2) , 59-64
Precise Deposition and Application of Diamond-like Carbon by Photo-excited Plasma
A new plasma-enhanced chemical vapor deposition (PECVD) system using photo-excited plasma, photoemission-assisted PECVD (PA-PECVD), is explained. PA-PECVD gives certain voltage and current density during its plasma reactions, controlling plasma reactions precisely. The voltage is a thermodynamic factor to determine how a chemical reaction occurs. The current density is a kinetics factor to determine how fast the reaction occurs. Its Townsend discharge, photoemission-assisted Townsend discharge (PATD), gives current approximately 10000 times larger than conventional Townsend discharge. PATD can be used for precise deposition of diamond-like carbon (DLC) films without damage by accelerated ions and the films can be optimized for carbon electronics. Investigation of the characteristics of the DLC films precisely synthesized by PA-PECVD leads to elucidate its growth model and will contribute to the tailor-made synthesis of DLC suitable to every industrial purpose.
- 10 February 2024
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 67 (2) , 59-64
Open AccessPrecise Deposition and Application of Diamond-like Carbon by Photo-excited Plasma
A new plasma-enhanced chemical vapor deposition (PECVD) system using photo-excited plasma, photoemission-assisted PECVD (PA-PECVD), is explained. PA-PECVD gives certain voltage and current density during its plasma reactions, controlling plasma reactions precisely. The voltage is a thermodynamic factor to determine how a chemical reaction occurs. The current density is a kinetics factor to determine how fast the reaction occurs. Its Townsend discharge, photoemission-assisted Townsend discharge (PATD), gives current approximately 10000 times larger than conventional Townsend discharge. PATD can be used for precise deposition of diamond-like carbon (DLC) films without damage by accelerated ions and the films can be optimized for carbon electronics. Investigation of the characteristics of the DLC films precisely synthesized by PA-PECVD leads to elucidate its growth model and will contribute to the tailor-made synthesis of DLC suitable to every industrial purpose.
- Open Access
Time of Flight Size Control of Carbon Nanoparticles Using Ar+CH4 Multi-Hollow Discharge Plasma Chemical Vapor Deposition Method
As the application of nanotechnology increases continuously, the need for controlled size nanoparticles also increases. Therefore, in this work, we discussed the growth mechanism of carbon nanoparticles generated in Ar+CH4 multi-hollow discharge plasmas. Using the plasmas, we succeeded in continuous generation of hydrogenated amorphous carbon nanoparticles with controlled size (25–220 nm) by the gas flow. Among the nanoparticle growth processes in plasmas, we confirmed the deposition of carbon-related radicals was the dominant process for the method. The size of nanoparticles was proportional to the gas residence time in holes of the discharge electrode. The radical deposition developed the nucleated nanoparticles during their transport in discharges, and the time of flight in discharges controlled the size of nanoparticles.
Open AccessTime of Flight Size Control of Carbon Nanoparticles Using Ar+CH4 Multi-Hollow Discharge Plasma Chemical Vapor Deposition Method
As the application of nanotechnology increases continuously, the need for controlled size nanoparticles also increases. Therefore, in this work, we discussed the growth mechanism of carbon nanoparticles generated in Ar+CH4 multi-hollow discharge plasmas. Using the plasmas, we succeeded in continuous generation of hydrogenated amorphous carbon nanoparticles with controlled size (25–220 nm) by the gas flow. Among the nanoparticle growth processes in plasmas, we confirmed the deposition of carbon-related radicals was the dominant process for the method. The size of nanoparticles was proportional to the gas residence time in holes of the discharge electrode. The radical deposition developed the nucleated nanoparticles during their transport in discharges, and the time of flight in discharges controlled the size of nanoparticles.
- 2 March 2018
- Published by Wiley in Surface and Interface Analysis
- Vol. 50 (4) , 441-447
Influence of post‐annealing on a diamondlike carbon film analyzed by Raman spectroscopy
The influence of a post‐annealing treatment on the chemical structure of a diamondlike carbon (DLC) film was clarified by Raman spectroscopy. The DLC films were synthesized by ionized deposition. The structures were elucidated via Raman analysis in conjunction with the sp 2 cluster model. The as‐prepared DLC film consisted of a dielectric matrix including sp 3 carbon, where sp 2 clusters were floating. When the post‐annealing treatment commenced, especially between 450 and 600°C, carbon─hydrogen bonds were cleaved, and the hydrogen atoms were desorbed from the film, creating defects or dangling bonds. The defects were reactive in growing sp 2 clusters that were strained with numerous defects because of the restricted degrees of freedom in the solid. As the post‐annealing temperature further increased, the clusters became dominant and the strain was gradually dissolved.
- 2 March 2018
- Published by Wiley in Surface and Interface Analysis
- Vol. 50 (4) , 441-447
Influence of post‐annealing on a diamondlike carbon film analyzed by Raman spectroscopy
The influence of a post‐annealing treatment on the chemical structure of a diamondlike carbon (DLC) film was clarified by Raman spectroscopy. The DLC films were synthesized by ionized deposition. The structures were elucidated via Raman analysis in conjunction with the sp 2 cluster model. The as‐prepared DLC film consisted of a dielectric matrix including sp 3 carbon, where sp 2 clusters were floating. When the post‐annealing treatment commenced, especially between 450 and 600°C, carbon─hydrogen bonds were cleaved, and the hydrogen atoms were desorbed from the film, creating defects or dangling bonds. The defects were reactive in growing sp 2 clusters that were strained with numerous defects because of the restricted degrees of freedom in the solid. As the post‐annealing temperature further increased, the clusters became dominant and the strain was gradually dissolved.
- 1 February 2018
- Published by Elsevier in Surface Science
- Vol. 668, 29-35
Chemical structural analysis of diamondlike carbon films: I. Surface growth model
- 1 February 2018
- Published by Elsevier in Surface Science
- Vol. 668, 29-35
Chemical structural analysis of diamondlike carbon films: I. Surface growth model
- 1 February 2018
- Published by Elsevier in Surface Science
- Vol. 668, 36-41
Chemical structural analysis of diamondlike carbon films: II. Raman analysis
- 1 February 2018
- Published by Elsevier in Surface Science
- Vol. 668, 36-41
Chemical structural analysis of diamondlike carbon films: II. Raman analysis
- 1 January 2018
- Published by Elsevier in Diamond and Related Materials
- Vol. 81, 16-26
Chemical structure and electrical characteristics of diamondlike carbon films
- 1 January 2018
- Published by Elsevier in Diamond and Related Materials
- Vol. 81, 16-26
Chemical structure and electrical characteristics of diamondlike carbon films
- 1 December 2017
- Published by Elsevier in Surface and Coatings Technology
- Vol. 330, 26-33
Dependence of the features of diamondlike carbon films on their synthesis methods, as analyzed by Raman spectroscopy
- 1 December 2017
- Published by Elsevier in Surface and Coatings Technology
- Vol. 330, 26-33
Dependence of the features of diamondlike carbon films on their synthesis methods, as analyzed by Raman spectroscopy
- 17 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 44 (12) , 3107-3111
Infrared Spectroscopic Study of Hydrogenation Process of Si(100) Surface During Hydrogen Plasma Exposure
We used infrared spectroscopy to investigate the hydrogenation process of Si(100) surface by hydrogen plasma exposure with the substrate bias of -150 V at different temperatures between room temperature and 200 °C. An amorphous layer is generated by exposure at room temperature, following the generation of both hydrogen insertion states and hydrogen terminated vacancies. By increasing the substrate temperature during exposure, generation of SiH2 in the amorphous layer is suppressed. Si vacancy terminated with three hydrogen atoms (VH 3 ) is prominently generated by the plasma exposure at more than 150 °C, following generation of two hydrogen insertions into the Si-Si bonds (IH 2 ).
- 17 August 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 44 (12) , 3107-3111
Infrared Spectroscopic Study of Hydrogenation Process of Si(100) Surface During Hydrogen Plasma Exposure
We used infrared spectroscopy to investigate the hydrogenation process of Si(100) surface by hydrogen plasma exposure with the substrate bias of -150 V at different temperatures between room temperature and 200 °C. An amorphous layer is generated by exposure at room temperature, following the generation of both hydrogen insertion states and hydrogen terminated vacancies. By increasing the substrate temperature during exposure, generation of SiH2 in the amorphous layer is suppressed. Si vacancy terminated with three hydrogen atoms (VH 3 ) is prominently generated by the plasma exposure at more than 150 °C, following generation of two hydrogen insertions into the Si-Si bonds (IH 2 ).
- 1 March 2015
- Published by Elsevier in Diamond and Related Materials
- Vol. 53, 11-17
Controlled oxygen-doped diamond-like carbon film synthesized by photoemission-assisted plasma
- 1 March 2015
- Published by Elsevier in Diamond and Related Materials
- Vol. 53, 11-17
Controlled oxygen-doped diamond-like carbon film synthesized by photoemission-assisted plasma