Concha Batanero
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Concha Batanero has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Salvador Otón
Computer Science Department, University of Alcalá, 28871 Madrid, Spain
5 shared publications Jaana Holvikivi
Information and Communications Technology Department, Metropolia University of Applied Sciences, 02650 Espoo, Finland
3 shared publications- Héctor Roderico Amado-Salvatierra
Universidad Galileo
2 shared publications - Luis De-Marcos
Universidad de Alcalà
2 shared publications - Luis Felipe Rivera-Galicia
Universidad de Alcalà
2 shared publications - Luis Fernández-Sanz
University of Alcalá, Alcalá de Henares, Spain
2 shared publications
Latest Publications
- Open Access
- 5 October 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (19) , 10978
Estimation of Interaction Time for Students with Vision and Motor Problems when Using Computers and E-Learning Technology
Students with disabilities can attend online education using virtual learning platforms and assistive technology adapted to their personal needs. However, access is not enough to avoid difficulties as they tend to require more time for interaction with learning resources. Analysis of the literature suggests that there is relevant interest among researchers in exploring the interaction time required by students with disabilities. The aim of this paper is to explore the average time required by students with disabilities for interaction with questionnaires, the most typical e-learning resource, in comparison to students without disabilities. This is especially relevant for computer and telecommunication engineering students since all of their teaching activities are computer-related. The average time required for interaction is estimated through empirical testing with 60 students filling out a questionnaire while attending two courses on digital technology in a total of four editions. The sample included students with three types of disability as well as non-disabled students as a control group, with ages ranging from 22 to 58. Results showed time ratios of 2.92, 1.88, and 1.58 times, respectively, for blind, partially sighted, and reduced motor capability students, compared to students without disabilities. Although the results are robust, the small sample of the reduced motor capability students and the variability of capabilities for this group recommend further research with additional samples for this type of disability. It is also recommended to continue experimentation with additional types of e-learning resources.
- 5 October 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (19) , 10978
Open AccessEstimation of Interaction Time for Students with Vision and Motor Problems when Using Computers and E-Learning Technology
Students with disabilities can attend online education using virtual learning platforms and assistive technology adapted to their personal needs. However, access is not enough to avoid difficulties as they tend to require more time for interaction with learning resources. Analysis of the literature suggests that there is relevant interest among researchers in exploring the interaction time required by students with disabilities. The aim of this paper is to explore the average time required by students with disabilities for interaction with questionnaires, the most typical e-learning resource, in comparison to students without disabilities. This is especially relevant for computer and telecommunication engineering students since all of their teaching activities are computer-related. The average time required for interaction is estimated through empirical testing with 60 students filling out a questionnaire while attending two courses on digital technology in a total of four editions. The sample included students with three types of disability as well as non-disabled students as a control group, with ages ranging from 22 to 58. Results showed time ratios of 2.92, 1.88, and 1.58 times, respectively, for blind, partially sighted, and reduced motor capability students, compared to students without disabilities. Although the results are robust, the small sample of the reduced motor capability students and the variability of capabilities for this group recommend further research with additional samples for this type of disability. It is also recommended to continue experimentation with additional types of e-learning resources.
- Open Access
- 6 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 99968-99982
Improving Accessibility in Online Education: Comparative Analysis of Attitudes of Blind and Deaf Students Toward an Adapted Learning Platform
People with different capacities, such as the deaf and blind, have problems accessing educational content due to lack of accessible technology. Accessibility and usability are closely related concepts that share the goals for a satisfactory user experience. Existing literature establishes a direct relation between accessibility and usability, and reports that there are problems with both in learning platforms, and more generally with most websites. The objective of this paper is to evaluate the accessibility and usability of a learning platform by interrogating its participants. Three groups of students with different capacities (blind, deaf and deaf-blind) used an accessible learning platform prototype to assess the accessibility and usability of the platform and its contents. This article presents a comparative study of the perception and attitude of blind and deaf students towards the use of a learning platform adapted to their personal needs. Results showed that their attitude to the adaptation was very positive but there were differences in the perception of the ease of use of the application and with the level of difficulty to access the learning content. This work contributes to the body of knowledge by showing the effects that adaptations have on learning contents for blind and deaf students in terms of accessibility and ease of use through the analysis of the perceptions of participants. Future work may consider increasing the sample of students, as well as developing and testing new technologies and approaches that address other forms of functional diversity.
- 6 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 99968-99982
Open AccessImproving Accessibility in Online Education: Comparative Analysis of Attitudes of Blind and Deaf Students Toward an Adapted Learning Platform
People with different capacities, such as the deaf and blind, have problems accessing educational content due to lack of accessible technology. Accessibility and usability are closely related concepts that share the goals for a satisfactory user experience. Existing literature establishes a direct relation between accessibility and usability, and reports that there are problems with both in learning platforms, and more generally with most websites. The objective of this paper is to evaluate the accessibility and usability of a learning platform by interrogating its participants. Three groups of students with different capacities (blind, deaf and deaf-blind) used an accessible learning platform prototype to assess the accessibility and usability of the platform and its contents. This article presents a comparative study of the perception and attitude of blind and deaf students towards the use of a learning platform adapted to their personal needs. Results showed that their attitude to the adaptation was very positive but there were differences in the perception of the ease of use of the application and with the level of difficulty to access the learning content. This work contributes to the body of knowledge by showing the effects that adaptations have on learning contents for blind and deaf students in terms of accessibility and ease of use through the analysis of the perceptions of participants. Future work may consider increasing the sample of students, as well as developing and testing new technologies and approaches that address other forms of functional diversity.
- 5 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Education
- Vol. 62 (4) , 270-277
Effects of New Supportive Technologies for Blind and Deaf Engineering Students in Online Learning
Contribution: A redesign of the Moodle platform to adapt digital educational content [learning objects (LOs)] to the specific needs of students with disabilities. The approach, extendable to a range of disciplines, was empirically tested with blind and deaf engineering students. Background: Previous studies identified difficulties that blind and deaf students face in accessing digital content for learning. General guidelines and specific tools are available to help educators adapt digital content and existing learning platforms for access by students with varying abilities/capacities. Such tools are usually for a specific disability rather than a range of capacities, and few provide empirical evidence of effectiveness. Intended Outcomes: The engineering-related digital content adapted using the techniques described in this paper should enable blind and/or deaf students to use an oscilloscope, understand communication channels, and distinguish the different types of telecommunication networks. Application Design: The Moodle learning platform was adapted using existing e-learning accessibility standards so that digital LOs could be automatically presented in formats accessible to blind and/or deaf students. This model is extendable for other types of disabilities, helping educators adapt existing content for access by students with differing capacities. The teacher adds content (in non-auditory and non-visual formats to describe content otherwise inaccessible to deaf or blind students) and students upload reusable profiles/metadata describing their specific accessibility needs to connect to suitably adjusted content. Findings: Learning improvement with the adjusted platform was evaluated via multiple choice pre- and post-tests. Students' learning performance improved significantly across all groups: blind (45%), deaf (46.25%) and deaf-blind (87.5%).
- 5 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Education
- Vol. 62 (4) , 270-277
Effects of New Supportive Technologies for Blind and Deaf Engineering Students in Online Learning
Contribution: A redesign of the Moodle platform to adapt digital educational content [learning objects (LOs)] to the specific needs of students with disabilities. The approach, extendable to a range of disciplines, was empirically tested with blind and deaf engineering students. Background: Previous studies identified difficulties that blind and deaf students face in accessing digital content for learning. General guidelines and specific tools are available to help educators adapt digital content and existing learning platforms for access by students with varying abilities/capacities. Such tools are usually for a specific disability rather than a range of capacities, and few provide empirical evidence of effectiveness. Intended Outcomes: The engineering-related digital content adapted using the techniques described in this paper should enable blind and/or deaf students to use an oscilloscope, understand communication channels, and distinguish the different types of telecommunication networks. Application Design: The Moodle learning platform was adapted using existing e-learning accessibility standards so that digital LOs could be automatically presented in formats accessible to blind and/or deaf students. This model is extendable for other types of disabilities, helping educators adapt existing content for access by students with differing capacities. The teacher adds content (in non-auditory and non-visual formats to describe content otherwise inaccessible to deaf or blind students) and students upload reusable profiles/metadata describing their specific accessibility needs to connect to suitably adjusted content. Findings: Learning improvement with the adjusted platform was evaluated via multiple choice pre- and post-tests. Students' learning performance improved significantly across all groups: blind (45%), deaf (46.25%) and deaf-blind (87.5%).
- 18 July 2017
- Published by Wiley in Computer Applications in Engineering Education
- Vol. 25 (6) , 1018-1037
Accessible platforms for e‐learning: A case study
This paper presents a technical solution to improve accessibility in e‐learning platforms. The guidelines for the solution were concluded from the analysis of literature with the goal of achieving scalable, reusable, and easily manageable platforms. The method has been tested through a case study conducted on Moodle where a sample of the target population experimented it through several Engineering Education courses resulting in a high degree of perceived usefulness. We also found out that deaf students encountered less problems accessing the information than blind students due to different reasons.
- 18 July 2017
- Published by Wiley in Computer Applications in Engineering Education
- Vol. 25 (6) , 1018-1037
Accessible platforms for e‐learning: A case study
This paper presents a technical solution to improve accessibility in e‐learning platforms. The guidelines for the solution were concluded from the analysis of literature with the goal of achieving scalable, reusable, and easily manageable platforms. The method has been tested through a case study conducted on Moodle where a sample of the target population experimented it through several Engineering Education courses resulting in a high degree of perceived usefulness. We also found out that deaf students encountered less problems accessing the information than blind students due to different reasons.
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 556-560
A Method to Evaluate Accessibility in E-learning Education Systems
This paper explores the relationship between accessible learning objects and accessible Web content. On the one hand it takes into consideration the standard ISO/IEC 24751 to describe the process of using an accessible on-line educational system, which takes into account the needs and preferences of the student and contains accessibility metadata of the learning objects. On the other hand it takes into consideration the standard ISO/IEC 40500 to describe the accessibility guidelines of the Web content underlying those concepts that can be applied to the learning objects. Based on the idea that a learning object is also a web content, a study has been carried out to discover the mandatory accessibility metadata that must necessarily be included into a learning object to meet accessibility levels A, AA and AAA.
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 556-560
A Method to Evaluate Accessibility in E-learning Education Systems
This paper explores the relationship between accessible learning objects and accessible Web content. On the one hand it takes into consideration the standard ISO/IEC 24751 to describe the process of using an accessible on-line educational system, which takes into account the needs and preferences of the student and contains accessibility metadata of the learning objects. On the other hand it takes into consideration the standard ISO/IEC 40500 to describe the accessibility guidelines of the Web content underlying those concepts that can be applied to the learning objects. Based on the idea that a learning object is also a web content, a study has been carried out to discover the mandatory accessibility metadata that must necessarily be included into a learning object to meet accessibility levels A, AA and AAA.
- 1 January 2014
- Published by Springer Nature
- p. 338-341
Towards a Methodology for Curriculum Development within an Accessible Virtual Campus
- 1 January 2014
- Published by Springer Nature
- p. 338-341
Towards a Methodology for Curriculum Development within an Accessible Virtual Campus