Ateeq J. Suria
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ateeq J. Suria has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Debbie G. Senesky
Department of Aeronautics and Astronautics, Stanford University 5 , Stanford, California 94305
3 shared publications Caitlin A. Chapin
Stanford University 1 Department of Mechanical Engineering Stanford, California 94305, USA
2 shared publicationsHongyun So
Stanford University 4 Department of Aeronautics and Astronautics Stanford, California 94305, USA
2 shared publicationsAlexandra Bruefach
Temple University 3 College of Science and Technology Philadelphia, Pennsylvania 19122, USA
1 shared publicationAnanth Saran Yalamarthy
Stanford University 1 Department of Mechanical Engineering Stanford, California 94305, USA
1 shared publicationHeather C. Chiamori
Department of Aeronautics and Astronautics, Stanford University, Stanford, California 94305, USA
1 shared publication
Latest Publications
- 17 November 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 122 (19)
Degradation of 2DEG transport properties in GaN-capped AlGaN/GaN heterostructures at 600 °C in oxidizing and inert environments
In this paper, the electron mobility and sheet density of the two-dimensional electron gas (2DEG) in both air and argon environments at 600 °C were measured intermittently over a 5 h duration using unpassivated and Al2O3-passivated AlGaN/GaN (with 3 nm GaN cap) van der Pauw test structures. The unpassivated AlGaN/GaN heterostructures annealed in air showed the smallest decrease (∼8%) in 2DEG electron mobility while Al2O3-passivated samples annealed in argon displayed the largest drop (∼70%) based on the Hall measurements. Photoluminescence and atomic force microscopy showed that minimal strain relaxation and surface roughness changes have occurred in the unpassivated samples annealed in air, while those with Al2O3 passivation annealed in argon showed significant microstructural degradations. This suggests that cracks developed in the samples annealed in air were healed by oxidation reactions. To further confirm this, Auger electron spectroscopy was conducted on the unpassivated samples after the anneal in air and results showed that extra surface oxides have been generated, which could act as a dislocation pinning layer to suppress the strain relaxation in AlGaN. On the other hand, similar 2DEG sheet densities were observed in passivated and unpassivated AlGaN/GaN samples at the end of the 5-h anneal in air or argon due to the combined impact of strain relaxation and changes in the ionized electronic states. The results support the use of unpassivated GaN-capped AlGaN/GaN heterostructures as the material platform for high-temperature electronics and sensors used in oxidizing environmental conditions.
- 17 November 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 122 (19)
Degradation of 2DEG transport properties in GaN-capped AlGaN/GaN heterostructures at 600 °C in oxidizing and inert environments
In this paper, the electron mobility and sheet density of the two-dimensional electron gas (2DEG) in both air and argon environments at 600 °C were measured intermittently over a 5 h duration using unpassivated and Al2O3-passivated AlGaN/GaN (with 3 nm GaN cap) van der Pauw test structures. The unpassivated AlGaN/GaN heterostructures annealed in air showed the smallest decrease (∼8%) in 2DEG electron mobility while Al2O3-passivated samples annealed in argon displayed the largest drop (∼70%) based on the Hall measurements. Photoluminescence and atomic force microscopy showed that minimal strain relaxation and surface roughness changes have occurred in the unpassivated samples annealed in air, while those with Al2O3 passivation annealed in argon showed significant microstructural degradations. This suggests that cracks developed in the samples annealed in air were healed by oxidation reactions. To further confirm this, Auger electron spectroscopy was conducted on the unpassivated samples after the anneal in air and results showed that extra surface oxides have been generated, which could act as a dislocation pinning layer to suppress the strain relaxation in AlGaN. On the other hand, similar 2DEG sheet densities were observed in passivated and unpassivated AlGaN/GaN samples at the end of the 5-h anneal in air or argon due to the combined impact of strain relaxation and changes in the ionized electronic states. The results support the use of unpassivated GaN-capped AlGaN/GaN heterostructures as the material platform for high-temperature electronics and sensors used in oxidizing environmental conditions.
- 19 June 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 110 (25) , 253505
Thickness engineering of atomic layer deposited Al2O3 films to suppress interfacial reaction and diffusion of Ni/Au gate metal in AlGaN/GaN HEMTs up to 600 °C in air
In this paper, we describe the use of 50 nm atomic layer deposited (ALD) Al2O3 to suppress the interfacial reaction and inter-diffusion between the gate metal and semiconductor interface, to extend the operation limit up to 600 °C in air. Suppression of diffusion is verified through Auger electron spectroscopy (AES) depth profiling and X-ray diffraction (XRD) and is further supported with electrical characterization. An ALD Al2O3 thin film (10 nm and 50 nm), which functions as a dielectric layer, was inserted between the gate metal (Ni/Au) and heterostructure-based semiconductor material (AlGaN/GaN) to form a metal-insulator-semiconductor high electron mobility transistor (MIS-HEMT). This extended the 50 nm ALD Al2O3 MIS-HEMT (50-MIS) current-voltage (Ids-Vds) and gate leakage (Ig,leakage) characteristics up to 600 °C. Both, the 10 nm ALD Al2O3 MIS-HEMT (10-MIS) and HEMT, failed above 350 °C, as evidenced by a sudden increase of approximately 50 times and 5.3 × 106 times in Ig,leakage, respectively. AES on the HEMT revealed the formation of a Ni-Au alloy and Ni present in the active region. Additionally, XRD showed existence of metal gallides in the HEMT. The 50-MIS enables the operation of AlGaN/GaN based electronics in oxidizing high-temperature environments, by suppressing interfacial reaction and inter-diffusion of the gate metal with the semiconductor.
- 19 June 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 110 (25) , 253505
Thickness engineering of atomic layer deposited Al2O3 films to suppress interfacial reaction and diffusion of Ni/Au gate metal in AlGaN/GaN HEMTs up to 600 °C in air
In this paper, we describe the use of 50 nm atomic layer deposited (ALD) Al2O3 to suppress the interfacial reaction and inter-diffusion between the gate metal and semiconductor interface, to extend the operation limit up to 600 °C in air. Suppression of diffusion is verified through Auger electron spectroscopy (AES) depth profiling and X-ray diffraction (XRD) and is further supported with electrical characterization. An ALD Al2O3 thin film (10 nm and 50 nm), which functions as a dielectric layer, was inserted between the gate metal (Ni/Au) and heterostructure-based semiconductor material (AlGaN/GaN) to form a metal-insulator-semiconductor high electron mobility transistor (MIS-HEMT). This extended the 50 nm ALD Al2O3 MIS-HEMT (50-MIS) current-voltage (Ids-Vds) and gate leakage (Ig,leakage) characteristics up to 600 °C. Both, the 10 nm ALD Al2O3 MIS-HEMT (10-MIS) and HEMT, failed above 350 °C, as evidenced by a sudden increase of approximately 50 times and 5.3 × 106 times in Ig,leakage, respectively. AES on the HEMT revealed the formation of a Ni-Au alloy and Ni present in the active region. Additionally, XRD showed existence of metal gallides in the HEMT. The 50-MIS enables the operation of AlGaN/GaN based electronics in oxidizing high-temperature environments, by suppressing interfacial reaction and inter-diffusion of the gate metal with the semiconductor.
- 1 September 2016
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 87 (9) , 095003
A microfabricated sun sensor using GaN-on-sapphire ultraviolet photodetector arrays
A miniature sensor for detecting the orientation of incident ultraviolet light was microfabricated using gallium nitride (GaN)-on-sapphire substrates and semi-transparent interdigitated gold electrodes for sun sensing applications. The individual metal-semiconductor-metal photodetector elements were shown to have a stable and repeatable response with a high sensitivity (photocurrent-to-dark current ratio (PDCR) = 2.4 at −1 V bias) and a high responsivity (3200 A/W at −1 V bias) under ultraviolet (365 nm) illumination. The 3 × 3 GaN-on-sapphire ultraviolet photodetector array was integrated with a gold aperture to realize a miniature sun sensor (1.35 mm × 1.35 mm) capable of determining incident light angles with a ±45° field of view. Using a simple comparative figure of merit algorithm, measurement of incident light angles of 0° and 45° was quantitatively and qualitatively (visually) demonstrated by the sun sensor, supporting the use of GaN-based sun sensors for orientation, navigation, and tracking of the sun within the harsh environment of space.
- 1 September 2016
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 87 (9) , 095003
A microfabricated sun sensor using GaN-on-sapphire ultraviolet photodetector arrays
A miniature sensor for detecting the orientation of incident ultraviolet light was microfabricated using gallium nitride (GaN)-on-sapphire substrates and semi-transparent interdigitated gold electrodes for sun sensing applications. The individual metal-semiconductor-metal photodetector elements were shown to have a stable and repeatable response with a high sensitivity (photocurrent-to-dark current ratio (PDCR) = 2.4 at −1 V bias) and a high responsivity (3200 A/W at −1 V bias) under ultraviolet (365 nm) illumination. The 3 × 3 GaN-on-sapphire ultraviolet photodetector array was integrated with a gold aperture to realize a miniature sun sensor (1.35 mm × 1.35 mm) capable of determining incident light angles with a ±45° field of view. Using a simple comparative figure of merit algorithm, measurement of incident light angles of 0° and 45° was quantitatively and qualitatively (visually) demonstrated by the sun sensor, supporting the use of GaN-based sun sensors for orientation, navigation, and tracking of the sun within the harsh environment of space.