DZDongxiao Zhang

Dongxiao Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dongxiao Zhang has a total of 25 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Numerical Investigation of the Multiphase Flow Originating from the Muzzle of Submerged Parallel Guns

    by Dongxiao Zhang, Lin Lu, Xiaobin Qi, Xuepu Yan, Cisong Gao, Yanxiao Hu

    A two-dimensional model, employing a dynamic mesh technology, is used to simulate numerically the transient multiphase flow field produced by two submerged parallel guns. After a grid refinement study ensuring grid independence, five different conditions are considered to assess the evolution of cavitation occurring in proximity to the gun muzzle. The simulation results show that flow interference is enabled when the distance between the parallel barrels is relatively small; accordingly, the generation and evolution of the vapor cavity becomes more complex. By means of the Q criterion for vorticity detection, it is shown that cavitation causes the generation of vorticity and the evolution of the vapor cavity can result in an asymmetric distribution of vorticity for a certain distance of the barrels. In particular, the evolution of the vapor cavity can hinder the expansion of the gas and force it to flow outward, while an asymmetric distribution of vorticity can lead to a gas jet flowing outward and rotating simultaneously.

  • Top Cited Papers

    Investigation on Falling and Damage Mechanisms of UAV Illuminated by HPM Pulses

    by Min Zhao, Yazhou Chen, Xing Zhou, Dongxiao Zhang, Yaning Nie

    Unmanned aerial vehicle (UAV), when illuminated by high-power microwave (HPM), is vulnerable to losing control and even falling to the ground with damage. To explore the mechanism of the UAV's falling and its damage caused by HPM, the HPM radiation experiments on a certain kind of UAV are carried out. It is concluded that the UAV's cable is the main energy coupling path from HPM according to the analysis of the cable connection relationships among the flight control system (FCS), the electronic speed control (ESC) board, and the motors based on the experiment. Furthermore, the coupled voltages of the cable's termination load are obtained when the UAV is radiated by HPM with different carrier frequencies or incident directions using numerical calculation and typical test verification. To facilitate the analysis of circuit level, the equivalence of radiation and injection test is analyzed, so the waveform of the control signal related to the UAV's flight is recorded by the injection test. According to the experimental results and the principle of the UAV's flight dynamics, the effect mechanisms of the UAV's falling and its damage are clarified. The experimental results show that the carrier frequency of the HPM leading to the falling and damage of the UAV mainly depends on the length of the internal cable inside the UAV. The pulsewidth and the repetition frequency of HPM resulting in the UAV's falling are related to the pulsewidth and the period of the control signal of FCS. In addition, the coupled voltages induced on the twisted three-wire cables due to the illumination of HPM are verified to enter into the control signal port through parasitic capacitance and, finally, to damage the vulnerable components, including the metal–oxide–semiconductor field-effect transistor inside the ESC and the motor of the UAV. The damage mechanism is determined to be the high-voltage breakdown and large current burning.


  • Prediction on EMS of UAV's Data Link Based on SSA-Optimized Dual-Channel CNN

    by Tong Xu, Yuming Wang, Dongxiao Zhang, Min Zhao, Yazhou Chen

    In this article, a novel method is presented for electromagnetic interference (EMI) perception and electromagnetic susceptibility (EMS) assessment of an unmanned aerial vehicle (UAV) against interference. A large number of in-phase and quadrature data of the UAV's data link and their corresponding critical EMI signal were collected by the equivalent injection test method. After visualization and preprocessing of the in-phase and quadrature data, the obtained time–frequency spectrum and the data-link state parameter histogram were joined to further preprocess as the input of the model. A dual-channel convolutional neural network optimized by a sparrow search algorithm (SSA-DCNN) was proposed to predict the EMS of the data link of the UAV. The proposed method can not only avoid manual extraction of data features but also improve the intelligence level of EMI perception and safety evaluation on UAVs. The performance of the dual-channel convolutional neural network is compared with that of the SSA-DCNN method under different optimization algorithms. The results show that the SSA-DCNN model can significantly enhance the convergence speed and prediction accuracy of the training process compared with the dual-channel convolutional neural network. Besides, among the optimization algorithms, the stochastic gradient descent with momentum applied to the SSA-DCNN model shows a better performance.


  • Open Access

    An Iterative Phase Autofocus Approach for ISAR Imaging of Maneuvering Targets

    by Binbin Wang, Hao Cha, Zibo Zhou, Huatao Tang, Lidong Sun, Baozhou Du, Lei Zuo

    Translational motion compensation and azimuth compression are two essential processes in inverse synthetic aperture radar (ISAR) imaging. The anterior process recovers coherence between pulses, during which the phase autofocus algorithm is usually used. For ISAR imaging of maneuvering targets, conventional phase autofocus methods cannot effectively eliminate the phase error due to the adverse influence of the quadratic phase terms caused by the target’s maneuvering motion, which leads to the blurring of ISAR images. To address this problem, an iterative phase autofocus approach for ISAR imaging of maneuvering targets is proposed in this paper. Considering the coupling between translational phase errors and quadratic phase terms, minimum entropy-based autofocus (MEA) method and adaptive modified Fourier transform (MFT) are performed iteratively to realize better imaging results. In this way, both the translational phase error and quadratic phase terms induced by target’s maneuvering motion can be compensated effectively, and the globally optimal ISAR image is obtained. Comparison ISAR imaging results indicates that the new approach achieves stable and better ISAR image under a simple procedure. Experimental results show that the image entropy of the proposed approach is 0.2 smaller than the MEA method, which validates the effectiveness of the new approach.


  • GPR-Based EMI Prediction for UAV's Dynamic Datalink

    by Dongxiao Zhang, Min Zhao, Erwei Cheng, Yazhou Chen

    The datalink of an unmanned aerial vehicle (UAV) is vulnerable to external electromagnetic interference (EMI). The characteristic parameters of the EMI signal can be definitively detected by a developed monitoring platform mounted on the UAV, but it is impossible to determine the lost-link thresholds of the datalink in any state by experiment because the state of the datalink varies dynamically with the flight distance and the UAV's attitudes. In this case, whether a certain state of the UAV's datalink will be interrupted or not by the EMI cannot be evaluated. In this article, a method of EMI prediction for the UAV's dynamic datalink based on the Gaussian process regression (GPR) is proposed, two indicators, including the interfering frequency and the operation signal power of the datalink, are taken as the training inputs, and the lost-link thresholds of the datalink obtained by the EMI injection test are taken as the training targets. The results show that this method can effectively fit the training samples and determine a 95% confidence interval of the predictive outputs, which has a low predictive error, less than 2.2 dB. Compared with the methods of the layer recurrent neural network and support vector machine, the GPR method has higher predictive accuracy and a stronger generalization ability. Therefore, the detected EMI characteristic parameters can be used as new input samples to predict the lost-link thresholds in any condition. On this basis, the EMI margin can be calculated to evaluate the degree of the anti-EMI redundancy of the UAV's datalink, which can be used for the active adaptation of the UAV's datalink to EMI in the future.


  • Investigation on Effects of HPM Pulse on UAV's Datalink

    by Dongxiao Zhang, Xing Zhou, Erwei Cheng, Haojiang Wan, Yazhou Chen

    Unmanned aerial vehicle (UAV) is likely to be interfered by high-power microwave (HPM) pulse, especially its datalink. To investigate the effects of HPM pulse on the datalink of a UAV in a dynamic flight scenario, a tracking interference model for an HPM source toward a UAV is proposed, as well a dynamic flight model is also built to determine the HPM reception of the UAV's datalink. In order to predict the possible effects of HPM on the datalink, the tests on a certain type of UAV's datalink are carried out in the presence of HPM with its carrier frequency in L-, S- and C-band, respectively. The results show that the electromagnetic interference (EMI) can easily enter the receiver via front-door when the carrier frequency of the HPM falls into the operating frequency band of the datalink, which will lead to a permanent physical damage. However, when the carrier frequency deviates from the operating frequency band of the datalink, the EMI couples into the incomplete shielded power line via back-door and generates a high-voltage signal at the power port, resulting in a transient lost-link effect or even a functional failure of the datalink due to its abnormal electric power supply. Finally, some suggestions are put forward to improve the UAV's adaptability in the HPM environment.


  • Prediction of Electromagnetic Compatibility for Dynamic Datalink of UAV

    by Dongxiao Zhang, Erwei Cheng, Haojiang Wan, Xing Zhou, Yazhou Chen

    The operation signal of an unmanned aerial vehicle's (UAV's) datalink will change with the flight radius and attitude, which leads to a dynamic variation of the electromagnetic susceptibility (EMS) of the datalink against the external electromagnetic interference. In order to predict the electromagnetic compatibility (EMC) for the dynamic datalink of a UAV, the operation signal of the UAV's datalink and the received interference by the UAV need to be quantified and the EMS is also necessary to be tested. In this paper, a new model of the UAV's datalink in different flight states is presented. The relationship among the airborne operation signal, the interference and the flight parameters is presented and compared in three typical flight states, i.e., the fixed angle state, dive state, and hover state. To increase the repeatability and accuracy of the test and avoid risks in a flight test, a novel EMS test method using a static test instead of a dynamic flight test is proposed. On the basis of the operation state and its corresponding EMS threshold, the EMC prediction is performed to determine the moment when the datalink will be interrupted. The new method can be used to improve the security of UAV in the severe electromagnetic environment.


  • Research on the temperature effect characteristics of SERS enhancement factor

    by Cheng Xiao, Zhibing Chen, Dongxiao Zhang, Wenjian Xiao, Mengze Qing, Xianhong Liu