Mohamed Gibigaye
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mohamed Gibigaye has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Crespin Prudence Yabi
Laboratory of Studies and Tests in Civil Engineering (L2EGC), National University of Sciences, Technologies, Engineering and Mathematics, Abomey BP 486, Benin
3 shared publications Gerard Degan
Technologies, Engineering and Mathematics of Abomey National University of Sciences Abomey Benin
3 shared publications- Ahouefa Reine Katte1 shared publication
- Bio Chéissou Koto Tamou
Laboratory of Studies and Tests in Civil Engineering (L2EGC), National University of Sciences, Technologies, Engineering and Mathematics, Abomey BP 486, Benin
1 shared publication C. Akowanou
Ecole Polytechnique d’Abomey-Calavi, LEMA
1 shared publicationDamien Agagbe
1 shared publication
Latest Publications
- Open Access
- 29 April 2025
- Published by MDPI AG in Infrastructures
- Vol. 10 (5) , 111
Analysis and Classification of Distress on Flexible Pavements Using Convolutional Neural Networks: A Case Study in Benin Republic
Roads are critical infrastructure in multi-sectoral development. Any country that aims to expand and stabilize its activities must have a network of paved roads in good condition. However, that is not the case in many countries. The usual methods of recording and classifying pavement distress on the roads require a lot of equipment, technicians, and time to obtain the nature and indices of the damage to estimate the roadway’s quality level. This study proposes the use of pavement distress detection and classification models based on Convolutional Neural Networks, starting from videos taken of any asphalt road. To carry out this work, various routes were filmed to list the degradations concerned. Images were extracted from these videos and then resized and annotated. Then, these images were used to constitute several databases of road damage, such as longitudinal cracks, alligator cracks, small potholes, and patching. Within an appropriate development environment, three Convolutional Neural Networks were developed and trained on the databases. The accuracy achieved by the different models varies from 94.6% to 97.3%. This accuracy is promising compared to the literature models. This method would make it possible to considerably reduce the financial resources used for each road data campaign.
- 29 April 2025
- Published by MDPI AG in Infrastructures
- Vol. 10 (5) , 111
Open AccessAnalysis and Classification of Distress on Flexible Pavements Using Convolutional Neural Networks: A Case Study in Benin Republic
Roads are critical infrastructure in multi-sectoral development. Any country that aims to expand and stabilize its activities must have a network of paved roads in good condition. However, that is not the case in many countries. The usual methods of recording and classifying pavement distress on the roads require a lot of equipment, technicians, and time to obtain the nature and indices of the damage to estimate the roadway’s quality level. This study proposes the use of pavement distress detection and classification models based on Convolutional Neural Networks, starting from videos taken of any asphalt road. To carry out this work, various routes were filmed to list the degradations concerned. Images were extracted from these videos and then resized and annotated. Then, these images were used to constitute several databases of road damage, such as longitudinal cracks, alligator cracks, small potholes, and patching. Within an appropriate development environment, three Convolutional Neural Networks were developed and trained on the databases. The accuracy achieved by the different models varies from 94.6% to 97.3%. This accuracy is promising compared to the literature models. This method would make it possible to considerably reduce the financial resources used for each road data campaign.
- 23 May 2023
- Published by Elsevier in Materials Today: Proceedings
- Vol. 120, 165-172
Physical and mechanical characterization of mallotus oppositifolius wood for use as reinforcement in bent parts
- 23 May 2023
- Published by Elsevier in Materials Today: Proceedings
- Vol. 120, 165-172
Physical and mechanical characterization of mallotus oppositifolius wood for use as reinforcement in bent parts
- Open Access
- 1 January 2019
- Published by Wiley in Advances in Civil Engineering
- Vol. 2019 (1)
Estimation of Elastic Properties of Oil Palm Kernel Shell Concrete by Semianalytical Methods of Homogenisation
Despite its importance as one of the key parameters in the design of structural elements, the modulus of elasticity (MoE) is one of the least researched areas in oil palm kernel shell (OPKS) concrete. In the present study, we determined the MoE of OPKS concrete, using micromechanical models based on the classic approaches of homogenisation of Hashin–Shtrikman (HS) and Mori–Tanaka (MT). The MoE values for OPKSC (fcu < 35 MPa and OPKS volume fraction < 42%) estimated using the HS and MT models in the literature showed a good correlation with the experimental values. An empirical linear correlation between the volume fraction of inclusions and the MoE was proposed. The results obtained can enable better control of the mix design of structural concrete based on the proportion of OPKS coarse aggregate in tropical countries producing palm oil.
- 1 January 2019
- Published by Wiley in Advances in Civil Engineering
- Vol. 2019 (1)
Open AccessEstimation of Elastic Properties of Oil Palm Kernel Shell Concrete by Semianalytical Methods of Homogenisation
Despite its importance as one of the key parameters in the design of structural elements, the modulus of elasticity (MoE) is one of the least researched areas in oil palm kernel shell (OPKS) concrete. In the present study, we determined the MoE of OPKS concrete, using micromechanical models based on the classic approaches of homogenisation of Hashin–Shtrikman (HS) and Mori–Tanaka (MT). The MoE values for OPKSC (fcu < 35 MPa and OPKS volume fraction < 42%) estimated using the HS and MT models in the literature showed a good correlation with the experimental values. An empirical linear correlation between the volume fraction of inclusions and the MoE was proposed. The results obtained can enable better control of the mix design of structural concrete based on the proportion of OPKS coarse aggregate in tropical countries producing palm oil.
- 1 September 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 61, 618-633
Free vibration analysis of dowelled rectangular isotropic thin plate on a Modified Vlasov soil type by using discrete singular convolution method
- 1 September 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 61, 618-633
Free vibration analysis of dowelled rectangular isotropic thin plate on a Modified Vlasov soil type by using discrete singular convolution method
- Open Access
- 18 July 2018
- Published by IntechOpen
Mixture Proportioning for Oil Palm Kernel Shell
Oil palm kernel shell (OPKS) is an organic lightweight aggregate (LWA) used as coarse aggregate in tropical countries for concrete in low-cost buildings. Concrete mixture proportioning is used to calculate the quantities of different constituents required to achieve different properties. For LWA concrete with mineral aggregate, there exist mix design methods that follow rigorous sequence of steps that consider performance specifications. However, no such method exists for concrete using organic coarse aggregate, namely, OPKS. The methods that exist for OPKS concrete that satisfy technical specifications for structural lightweight concrete (LWC) are based on trial and error or empirical methods. With trial and error method, it is not always possible to predict the value of specific properties of the concrete; however, engineers are mainly concerned with obtaining specific properties when proportioning a concrete mixture. The present topic presents a structured method for trial mix proportioning of structural LWC using OPKS as coarse aggregate. Based on the principle of the absolute volume method in ACI 213, the method is presented, following the below headings: (1) properties of constituents of OPKS concrete; (2) mix design procedure; and (3) results and discussion. Technicians in tropical oil-palm-producing countries for low-cost buildings can use the presented method.
- 18 July 2018
- Published by IntechOpen
Open AccessMixture Proportioning for Oil Palm Kernel Shell
Oil palm kernel shell (OPKS) is an organic lightweight aggregate (LWA) used as coarse aggregate in tropical countries for concrete in low-cost buildings. Concrete mixture proportioning is used to calculate the quantities of different constituents required to achieve different properties. For LWA concrete with mineral aggregate, there exist mix design methods that follow rigorous sequence of steps that consider performance specifications. However, no such method exists for concrete using organic coarse aggregate, namely, OPKS. The methods that exist for OPKS concrete that satisfy technical specifications for structural lightweight concrete (LWC) are based on trial and error or empirical methods. With trial and error method, it is not always possible to predict the value of specific properties of the concrete; however, engineers are mainly concerned with obtaining specific properties when proportioning a concrete mixture. The present topic presents a structured method for trial mix proportioning of structural LWC using OPKS as coarse aggregate. Based on the principle of the absolute volume method in ACI 213, the method is presented, following the below headings: (1) properties of constituents of OPKS concrete; (2) mix design procedure; and (3) results and discussion. Technicians in tropical oil-palm-producing countries for low-cost buildings can use the presented method.
- Open Access
- 1 June 2017
- Published by Elsevier in Case Studies in Construction Materials
- Vol. 6, 219-224
Structured mixture proportioning for oil palm kernel shell concrete
- 1 June 2017
- Published by Elsevier in Case Studies in Construction Materials
- Vol. 6, 219-224
Open AccessStructured mixture proportioning for oil palm kernel shell concrete
- 15 January 2008
- Published by Springer Nature in Journal of Engineering Mathematics
- Vol. 62 (3) , 277-287
The similarity regime for natural convection in a vertical cylindrical well filled with an anisotropic porous medium
- 15 January 2008
- Published by Springer Nature in Journal of Engineering Mathematics
- Vol. 62 (3) , 277-287
The similarity regime for natural convection in a vertical cylindrical well filled with an anisotropic porous medium