TCTommaso Cassese

Tommaso Cassese

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Tommaso Cassese has a total of 66 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Optimized low-frequency PECVD diamond-like carbon hard masks for high-selectivity thin-film lithium niobate etching

    by M. L. Savchenko, D. Solonenko, S. M. Azeem, N. A. Andrianov, T. Cassese

    Low-frequency plasma-enhanced chemical vapor deposition (LF PECVD) was developed for growing diamond-like carbon (DLC) films intended as hard masks for photonic nanofabrication. DLC offers high hardness and physical etch selectivity, enabling effective etching of such ferroelectric materials as lithium niobate (LNO), lithium tantalate, and barium titanate that possess high intrinsic electro-optic coefficient. We systematically studied the influence of deposition power, chamber pressure, and substrate temperature on DLC film properties, finding that LF growth produces denser films with higher ion beam etch selectivity compared to RF deposition. A linear correlation was observed between refractive index, density, stress, and etch selectivity, enabling quality assessment by ellipsometry. Optimized PECVD deposition conditions yielded DLC films with 2.8 etch selectivity over LNO, deposition rates near 10 nm/min, and thickness uniformity of about 2% across 4-in. wafers. High compressive stress, up to 1.5 GPa, limited DLC adhesion on non-silicon substrates, which was overcome by introducing a thin, low-temperature SiNx adhesion layer between DLC and LNO. Raman spectroscopy confirmed that etch selectivity is enhanced by sp2-rich clustering in a-C:H films.

  • Two dimensional beam forming and steering based on silicon nitride 1 × 32 optical phased array

    by Saeed Nazemosadat Arsanjani, Muhammad S. Khan, Jochen Bardong, Albert Frank, Lars Zimmermann, Tommaso Cassese, Muhammad Bardong, Tommaso Frank

    Optical phased arrays (OPAs) offer a promising solution for integrating beam focusing and steering functionalities on a chip. In this work, we present a 32-antenna OPA fully integrated on a commercially available silicon nitride (SiN) platform, operating in the wavelength range of 1500 nm to 1630 nm. We detail the design of the circuit and its components, emphasizing the development of a highly efficient phase shifter that requires 130 mW for a 2π phase shift. Testing the fabricated and assembled chip demonstrates a field of view of 24.28∘× 9.4∘ and a beam resolution of 0.66∘ × 0.082∘. To the best of our knowledge, these values are the highest reported for a fully SiN-based OPA at 1550 nm.


  • Ultraviolet to mid-infrared optical properties of sputtered Al(Sc)N-on-SiO2 thin films and experimental demonstration of AlN integrated photonic devices in the telecom C-band

    by Jasmin Spettel, Nikolai Andrianov, Florian Dubois, Munir Azeem, Hernán Furci, Tommaso Cassese, Niels Quack, Guillermo Villanueva, Mohssen Moridi, Thang Duy Dao, et al.

    Thin film aluminum nitride (AlN) stands out as a promising material for integrated photonics due to its wide bandgap of 6.1 eV, facilitating efficient operation across diverse spectral ranges. Its inherent electro-optic and nonlinear optical properties make it exceptionally well suited for active photonic components. Compatibility with CMOS technology further strengthens its appeal. Doping AlN with scandium (Sc) in non-centrosymmetric configurations significantly enhances its nonlinear and piezoelectric characteristics. This study explores Al(Sc)N thin films on silicon dioxide (SiO2), investigating optical properties in a broad wavelength range from 0.19 µm to 25 µm. Comprehensive material analysis of sputtered Al(Sc)N films and fabrication techniques for AlN integrated photonic devices demonstrated here highlight AlScN's potential in integrated photonic applications.


  • Open Access

    Photonic Integrated Fully Tunable Comb Generator Cascading Optical Modulators

    by Nicola Andriolli, Tommaso Cassese, Marco Chiesa, Cristina de Dios, Giampiero Contestabile

    We report the first monolithic InP photonic integrated comb generator made by cascading optical modulators. The device is extremely compact and tunable both in repetition frequency and wavelength, making real world applications possible. A DBR laser, a Mach-Zehnder intensity modulator and two phase modulators are monolithically integrated on a 4.5×2.5 mm $^2$ chip that also includes a booster SOA at the output. Modulators integrated on the circuit have a 3-dB bandwidth of 7 GHz and can generate up to 28 comb lines within a 5 dB power range when properly electrically driven (here demonstrated in the range 4-5 GHz). Operation up to 10 GHz is also reported.


  • Capacitive actuation and switching of add–drop graphene-silicon micro-ring filters

    by Tommaso Cassese, Marco Angelo Giambra, Vito Sorianello, Gabriele De Angelis, Michele Midrio, Marianna Pantouvaki, Joris Van Campenhout, Inge Asselberghs, Cedric Huyghebaert, Antonio D’eRrico, et al.

    We propose and experimentally demonstrate capacitive actuation of a graphene–silicon micro-ring add/drop filter. The mechanism is based on a silicon–SiO2–graphene capacitor on top of the ring waveguide. We show the capacitive actuation of the add/drop functionality by a voltage-driven change of the graphene optical absorption. The proposed capacitive solution overcomes the need for continuous heating to keep tuned the filter’s in/out resonance and therefore eliminates “in operation” energy consumption.


  • Integration of III-V light sources on a silicon photonics circuit by transfer printing

    by Joan Juvert, Tommaso Cassese, Sarah Uvin, Andreas De Groote, Brad Snyder, Peter De Heyn, Peter Verheyen, Antonio Jose Trindade, Christopher Bower, Marco Romagnoli, et al.

    We report on the integration by transfer printing of III-V Fabry-Perot cavities on a silicon photonic circuit. We pre-process the III-V coupons on their native substrate, transfer print onto the target SOI, and post-process the printed coupons. We report light coupling into the photonic circuit.


  • Open Access

    Complex effective index in graphene-silicon waveguides

    by V. Sorianello, G. De Angelis, T. Cassese, M. Midrio, M. Romagnoli, M. Mohsin, M. Otto, D. Neumaier, I. Asselberghs, J. Van Campenhout, et al.

    We report for the first time and characterize experimentally the complex optical conductivity of graphene on silicon photonic waveguides. This permits us to predict accurately the behavior of photonic integrated devices encompassing graphene layers. Exploiting a Si microring add/drop resonator, we show the effect of electrical gating of graphene on the complex effective index of the waveguide by measuring both the wavelength shift of the resonance and the change in the drop peak transmission. Due to electro-refractive effect of graphene a giant (>10−3) change in the effective index is demonstrated for the first time on Si photonics waveguides and this large effect will crucially impact performances and consumption of Si photonics devices. We confirmed the results by two independent experiments involving two different gating schemes: Si gating through the ridge waveguide, and polymer-electrolyte gating. Both the experiments demonstrate a very large phase effect in good agreement with numerical calculations. The reported results validate the Kubo model for the case of graphene-Si photonics interfaces and for propagation in this type of waveguide. This is fundamental for the next design and fabrication of future graphene-silicon photonics devices.


  • Polarization insensitive silicon photonic ROADM with selectable communication direction for radio access networks

    by Vito Sorianello, Gabriele De Angelis, Tommaso Cassese, Massimo Valerio Preite, Philippe Velha, Alberto Bianchi, Marco Romagnoli, Francesco Testa

    We report on an experimental prototype of a low-cost silicon photonic reconfigurable optical add/drop multiplexer (ROADM). The device is able to operate with up to 12 wavelength division multiplexing channels. In order to control the polarization of the multi-wavelength signal at the input of the device, an integrated polarization controller is investigated as an alternative to the polarization diversity device architecture. The integrated ROADM is equipped with optical switches for the selection of the path direction and variable optical attenuators for optical power control. We demonstrate the polarization insensitive routing of 10 Gb/s channels between two ROADM nodes with error-free transmission.


  • Wide-band polarization controller for Si photonic integrated circuits

    by P. Velha, V. Sorianello, M. V. Preite, G. De Angelis, T. Cassese, A. Bianchi, F. Testa, M. Romagnoli

    A circuit for the management of any arbitrary polarization state of light is demonstrated on an integrated silicon (Si) photonics platform. This circuit allows us to adapt any polarization into the standard fundamental TE mode of a Si waveguide and, conversely, to control the polarization and set it to any arbitrary polarization state. In addition, the integrated thermal tuning allows kilohertz speed which can be used to perform a polarization scrambler. The circuit was used in a WDM link and successfully used to adapt four channels into a standard Si photonic integrated circuit.


  • Si photonic active controller for polarization independent coupling

    by T. Cassese, G. De Angelis, P. Velha, V. Sorianello, M. V. Preite, A. Bianchi, F. Testa, G. Contestabile, M. Romagnoli

    A photonic integrated circuit capable of recombining any incoming state of polarization into a single TE Silicon waveguide was demonstrated, allowing optical communication systems to be transparent to polarization issues.