Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shahar Weksler has a total of 10 co-authors. Here are the top co-authors by number of shared publications:

  • Eyal Ben-Dor

    Porter School of the Environment and Earth Sciences, Faculty of Exact Sciences, Tel Aviv University, Tel Aviv 6997801, Israel

    6 shared publications
  • Offer Rozenstein

    Institute of Soil, Water and Environmental Sciences, Agricultural Research Organization—Volcani Institute, HaMaccabim Road 68, Rishon LeZion 75359, Israel

    4 shared publications
  • Menachem Moshelion

    Institute of Plant Sciences and Genetics in Agriculture, The Robert H. Smith Faculty of Agriculture, Food and Environment, The Hebrew University of Jerusalem, Rehovot 76100, Israel

    3 shared publications
  • Nadav Haish

    The Robert H Smith Institute of Plant Sciences and Genetics in Agriculture, The Hebrew University of Jerusalem, Rehovot 7610001, Israel

    3 shared publications
  • Rony Wallach

    Department of Soil and Water Sciences, The Robert H. Smith Faculty of Agriculture, Food and Environment, The Hebrew University of Jerusalem, Rehovot 76100, Israel

    3 shared publications
  • Gila Notesco

    Porter School of the Environment and Earth Sciences, Faculty of Exact Sciences, Tel Aviv University, Tel Aviv 6997801, Israel

    2 shared publications

Latest Publications

  • Continuous seasonal monitoring of nitrogen and water content in lettuce using a dual phenomics system

    by Shahar Weksler, Offer Rozenstein, Eyal Ben Dor

    The collection and analysis of large amounts of information on a plant-by-plant basis contributes to the development of precision fertigation and may be achieved by combining remote-sensing technology with high-throughput phenotyping methods. Here, lettuce plants (Lactuca sativa) were grown under optimal and suboptimal nitrogen and irrigation treatments from seedlings to harvest. A Plantarray system was used to calculate and log weights, daily transpiration, and momentary transpiration rates throughout the experiment. From 15 d after planting until experiment termination, the entire array of plants was imaged hourly (from 09.00 h to 14.00 h) using a hyperspectral moving camera. Three vegetation indices were calculated from the plants’ reflectance signal: red-edge chlorophyll index (RECI), photochemical reflectance index (PRI), and water index (WI), and combined treatments, physiological measurements, and vegetation indices were compared. RECI values differed significantly between nitrogen treatments from the first day of imaging, and WI values distinguished well-irrigated from drought-treated groups before detecting significant differences in daily transpiration rate. The PRI, calculated hourly during the drought-treatment phase, changed with the momentary transpiration rate. Thus, hyperspectral imaging might be used in growing facilities to detect nitrogen or water shortages in plants before their physiological response affects yields.


  • Open Access

    Pepper Plants Leaf Spectral Reflectance Changes as a Result of Root Rot Damage

    by Shahar Weksler, Offer Rozenstein, Nadav Haish, Menachem Moshelion, Rony Wallach, Eyal Ben-Dor

    Symptoms of root stress are hard to detect using non-invasive tools. This study reveals proof of concept for vegetation indices’ ability, usually used to sense canopy status, to detect root stress, and performance status. Pepper plants were grown under controlled greenhouse conditions under different potassium and salinity treatments. The plants’ spectral reflectance was measured on the last day of the experiment when more than half of the plants were already naturally infected by root disease. Vegetation indices were calculated for testing the capability to distinguish between healthy and root-damaged plants using spectral measurements. While no visible symptoms were observed in the leaves, the vegetation indices and red-edge position showed clear differences between the healthy and the root-infected plants. These results were achieved after a growth period of 32 days, indicating the ability to monitor root damage at an early growing stage using leaf spectral reflectance.


  • Open Access

    Detection of Potassium Deficiency and Momentary Transpiration Rate Estimation at Early Growth Stages Using Proximal Hyperspectral Imaging and Extreme Gradient Boosting

    by Shahar Weksler, Offer Rozenstein, Nadav Haish, Menachem Moshelion, Rony Wallach, Eyal Ben-Dor

    Potassium is a macro element in plants that is typically supplied to crops in excess throughout the season to avoid a deficit leading to reduced crop yield. Transpiration rate is a momentary physiological attribute that is indicative of soil water content, the plant’s water requirements, and abiotic stress factors. In this study, two systems were combined to create a hyperspectral–physiological plant database for classification of potassium treatments (low, medium, and high) and estimation of momentary transpiration rate from hyperspectral images. PlantArray 3.0 was used to control fertigation, log ambient conditions, and calculate transpiration rates. In addition, a semi-automated platform carrying a hyperspectral camera was triggered every hour to capture images of a large array of pepper plants. The combined attributes and spectral information on an hourly basis were used to classify plants into their given potassium treatments (average accuracy = 80%) and to estimate transpiration rate (RMSE = 0.025 g/min, R2 = 0.75) using the advanced ensemble learning algorithm XGBoost (extreme gradient boosting algorithm). Although potassium has no direct spectral absorption features, the classification results demonstrated the ability to label plants according to potassium treatments based on a remotely measured hyperspectral signal. The ability to estimate transpiration rates for different potassium applications using spectral information can aid in irrigation management and crop yield optimization. These combined results are important for decision-making during the growing season, and particularly at the early stages when potassium levels can still be corrected to prevent yield loss.


  • Open Access

    A Hyperspectral-Physiological Phenomics System: Measuring Diurnal Transpiration Rates and Diurnal Reflectance

    by Shahar Weksler, Offer Rozenstein, Nadav Haish, Menachem Moshelion, Rony Walach, Eyal Ben-Dor

    A novel hyperspectral-physiological system that monitors plants dynamic response to abiotic alterations was developed. The system is a sensor-to-plant platform which can determine the optimal time of day during which physiological traits can be successfully identified via spectral means. The directly measured traits include momentary and daily transpiration rates throughout the daytime and daily and periodical plant weight loss and gain. The system monitored and evaluated pepper plants response to varying levels of potassium fertilization. Significant momentary transpiration rates differences were found between the treatments during 07:00–10:00 and 14:00–17:00. The simultaneous frequently measured high-resolution spectral data provided the means to correlate the two measured data sets. Significant correlation coefficients between the spectra and momentary transpiration rates resulted with a selection of three bands (ρ523, ρ697 and ρ818nm) that were used to capture transpiration rate differences using a normalized difference formula during the morning, noon and the afternoon. These differences also indicated that the best results are not always obtained when spectral (remote or proximal) measurements are typically preformed around noon (when solar illumination is the highest). Valuable information can be obtained when the spectral measurements are timed according to the plants’ dynamic physiological status throughout the day, which may vary among plant species and should be considered when planning remote sensing data acquisition.


  • Open Access

    Application of Hyperspectral Remote Sensing in the Longwave Infrared Region to Assess the Influence of Dust from the Desert on Soil Surface Mineralogy

    by Gila Notesco, Shahar Weksler, Eyal Ben-Dor

    Soil mineralogy can be used to study changes in the environment affecting the soil surface, such as dust from the desert through Aeolian processes, which is one of the sources that determine the mineral nature of the soil. Ground- and field-based hyperspectral longwave infrared images, acquired before and after dust dispersion on the soil surface, were processed and analyzed by applying a procedure for determining soil surface mineralogy from the emissivity spectrum, using two indices―SQCMI (the Soil Quartz Clay Mineral Index) and SCI (the Soil Carbonate Index)―to identify changes in the abundance of quartz, clay minerals and carbonates on the surface, caused by the settling dust particles. Mineralogical changes were identified, depending on the mineral composition of the dust compared to the soil surface mineralogy.


  • Open Access

    Mineral Classification of Soils Using Hyperspectral Longwave Infrared (LWIR) Ground-Based Data

    by Gila Notesco, Shahar Weksler, Eyal Ben-Dor

    Soil mineralogy is an important factor affecting chemical and physical processes in the soil. Most common minerals in soils—quartz, clay minerals and carbonates—present fundamental spectral features in the longwave infrared (LWIR) region. The current study presents a procedure for determining the soil mineralogy from the surface emissivity spectrum. Ground-based hyperspectral LWIR images of 90 Israeli soil samples were acquired with the Telops Hyper-Cam sensor, and the emissivity spectrum of each sample was calculated. Mineral-related emissivity features were identified and used to create indicants and indices to determine the content of quartz, clay minerals, and carbonates in the soil in a semi-quantitative manner—from more to less abundant minerals. The resultant mineral content was in good agreement with the mineralogy derived from chemical analyses.


  • Open Access

    Mapping Surface Quartz Content in Sand Dunes Covered by Biological Soil Crusts Using Airborne Hyperspectral Images in the Longwave Infrared Region

    by Shahar Weksler, Offer Rozenstein, Eyal Ben-Dor

    Biological soil crusts (BSCs), composed of cyanobacteria, algae, mosses, lichens, and fungi, are important ecosystem engineers that stabilize the quartz-rich dunes in the Nitzana study area near the Israel–Egypt border. The longwave infrared (LWIR) region of the electromagnetic spectrum is very useful for quartz identification since quartz reflectance in the visible, near infrared, and shortwave infrared (VIS-NIR-SWIR, 0.4–2.5 µm) spectral regions lacks identifying features, whereas in the LWIR region, the quartz emissivity spectrum presents a strong doublet feature. This emissivity feature can be used as a diagnostic tool for BSCs development in desert environments, because BSCs attenuate the quartz feature as a function of their successional development. A pair of day and night airborne hyperspectral images were acquired using the Specim AisaOWL LWIR sensor (7.7–12 µm) and processed using an innovative algorithm to reduce the atmospheric interference in this spectral domain. The resulting day and night apparent emissivity products were used to produce a surface quartz content map of the study area. The significant reduction in atmospheric interference resulted in a high correlation (R2 = 0.88) between quartz content in field samples determined by X-ray powder diffraction analysis and emissivity estimations from the airborne images. This, in turn, served as the ground truth to our quartz content map of the surface, and by proxy to the BSC.


  • An automated procedure for reducing atmospheric features and emphasizing surface emissivity in hyperspectral longwave infrared (LWIR) images

    by Shahar Weksler, Gila Notesco, Eyal Ben-Dor

    The at-sensor radiance of a pixel in a longwave infrared (LWIR) image represents the surface temperature, the surface emissivity, which is similar during the day and at night, and the atmospheric contribution, which is expressed differently during the day and at night. Based on this, an automated procedure, which locates pixels for which each absorption feature in their radiance during the day appears as an emission feature at night, indicative of atmospheric contribution, was developed. The average day or night spectrum of these indicative pixels was applied as a gain factor spectrum to the entire day or night image, respectively, reducing the atmospheric contribution and emphasizing the surface spectral features, represented by emissivity, of each pixel in the image. The procedure was examined on LWIR hyperspectral data cubes acquired over two different areas, and enabled effective reduction of the atmospheric features in both area data sets.