VVVincent Vanel

Vincent Vanel

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Vincent Vanel has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • PSO-Based Adaptive NMPC for Uranium Extraction-Scrubbing Operation in Spent Nuclear Fuel Treatment Process

    by Duc-Tri Vo, Ionela Prodan, Laurent Lefévre, Vincent Vanel, Sylvain Costenoble, Binh Dinh

  • Americium Recovery from Highly Active PUREX Raffinate by Solvent Extraction: The EXAm Process. A Review of 10 Years of R&D

    by Manuel Miguirditchian, Vincent Vanel, Cécile Marie, Vincent Pacary, Marie-Christine Charbonnel, Laurence Berthon, Xavier Hérès, Marc Montuir, Christian Sorel, Marie-Jordane Bollesteros, et al.

    In the framework of the R&D program conducted in France on partitioning and transmutation of minor actinides, a solvent extraction process was developed for separating americium from a PUREX raffinate arising from the dissolution of spent nuclear fuels in nitric acid. The so-called EXAm process uses a mixture of a malonamide (DMDOHEMA, N,N’-dimethyl-N,N’-dioctyl-hexyloxyethyl-malonamide) and HDEHP (di-2-ethylhexylphosphoric acid) in organic phase in combination with a water-soluble complexing agent TEDGA (N,N,N’,N’-tetraethyldiglycolamide) in aqueous phase to enhance Am/Cm separation. Am/Ln separation is then obtained by selective Am stripping with polyaminocarboxylic acids (HEDTA or DTPA) buffered by citric or malonic acid at low acidity. Started in 2008, an important R&D program was conducted at CEA to optimize and model the process. The feasibility of the direct recovery of Am from a genuine PUREX raffinate by solvent extraction was demonstrated in 2010 and reported, for the first time in the literature. R&D was then conducted to adapt the process for a future scale-up and for application from concentrated PUREX raffinates. The results of the final EXAm process performed on a highly active PUREX concentrate are presented after a summary of 10 years of R&D on this process development.


  • Development of a Selective Americium Separation Process Using H4TPAEN as Water-Soluble Stripping Agent

    by Cécile Marie, Peter Kaufholz, Vincent Vanel, Marie-Thérèse Duchesne, Emilie Russello, Federica Faroldi, Laura Baldini, Alessandro Casnati, Andreas Wilden, Giuseppe Modolo, et al.

    Recycling americium from spent nuclear fuel is considered as an important option for a future sustainable nuclear fuel cycle. The PUREX solvent extraction process allows to separate uranium and plutonium from a solution of spent fuel dissolved in nitric acid. In a second step, it would be desirable to separate americium from fission products, and especially lanthanides, but also from curium in order to further transmute americium in future fast neutron reactors. For this purpose, we report the investigation of a new solvent extraction process based on the use of TODGA as an extractant in the organic phase and H4TPAEN as a selective Am(III) stripping agent in the aqueous phase. With this promising system it is possible to co-extract Am, Cm and lanthanides at high acidity and then selectively strip americium from the loaded organic phase at pH around 1 with H4TPAEN. Batch extraction data were acquired to evaluate best conditions to develop a liquid-liquid extraction flow sheet. The influence of several parameters like concentration of ligand, cations and temperature on Am(III)/Cm(III) and Am/lanthanides separation was evaluated. Especially, the ability of H4TPAEN complexing agent to strip macro-concentrations of Am was demonstrated.


  • Behavior of Molybdenum (VI) in {DMDOHEMA–HDEHP/nitric acid} Liquid–Liquid Extraction Systems

    by Cécile Marie, Vincent Vanel, Sou Watanabe, Marie-Thérèse Duchesne, Nicole Zorz, Laurence Berthon

    The EXAm (extraction of americium) process was developed for americium recycling in future nuclear fuel cycles. In this solvent extraction system, a combination of two extractants, N,N′-dimethyl-N,N′-dioctyl-hexylethoxy malonamide (DMDOHEMA) and di-2-ethylhexyl phosphoric acid (HDEHP), in TPH (hydrogenated tetrapropylene) is used to extract americium in the first step of the process at high acidity (HNO3 5–6 M). Americium is co-extracted with light lanthanides and other fission products like molybdenum, iron, ruthenium, etc.. Molybdenum is selectively scrubbed during the second step at low acidity using citric or glycolic acid as a buffer and complexing agent. The speciation of Mo(VI) in aqueous solutions is highly dependent on acidity and Mo concentration. In this article, a simple thermodynamical model is proposed for Mo(VI) scrubbing based on batch extraction experiments (with pH and cation concentration variations) and stoichiometries of complexes formed in the organic phase according to electrospray ionization mass spectrometry (ESI-MS) experiments and published data on Mo(VI) speciation. At high acidity ([HNO3] > 1 M), the MoO22+ species is strongly extracted by the solvent DMDOHEMA–HDEHP according to a solvate mechanism. At lower acidity ([HNO3] < 1 M), cation exchange mechanisms become predominant and DMDOHEMA does not participate to the extraction Mo(VI) anymore. During Mo scrubbing at pH higher than 1, the extraction of Mo as neutral species (like MoO3) and anionic species (like MoO42–) has to be taken into account in the model to predict the “bell-shape” of Mo distribution ratio evolution as a function of pH. This model was then implemented in the PAREX simulation code developed by the CEA to build the flowsheet for the “Mo scrubbing” section of EXAm process and predict Mo concentrations profiles in batteries of mixer-settlers during pilot-scale tests.


  • Open Access

    Consolidation of the EXAm Process: Towards the Reprocessing of a Concentrated PUREX Raffinate

    by V. Vanel, M.-J. Bollesteros, C. Marie, M. Montuir, V. Pacary, F. Antégnard, S. Costenoble, V. Boyer-Deslys


  • Open Access

    Modeling and Flowsheet Design of an Am Separation Process Using TODGA and H4TPAEN

    by V. Vanel, C. Marie, P. Kaufholz, M. Montuir, N. Boubals, A. Wilden, G. Modolo, A. Geist, C. Sorel


  • Open Access

    Modelling of Americium Stripping in the EXAm Process

    by Vincent Vanel, Laurence Berthon, Julie Muller Manuel Miguirditchian, Fabien Burdet