Mamoon Rashid
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Mamoon Rashid has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Christoph H. Gierull
Department of National Defence, Defence Research and Development Canada, Ottawa, ON, Canada
3 shared publications Richard M. Dansereau
Carleton University, Ottawa, ON K1S 5B6, Canada
1 shared publication- Sreeraman Rajan
Carleton University
1 shared publication
Latest Publications
- 13 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 62 (01962892) , 1-13
Indicating Ambiguous False Positives to Improve Wide-Area SAR Vessel Detection
Automatic vessel detection based on wide-area Synthetic Aperture Radar (SAR) imagery is achieved via a statistical hypothesis test in which a ship is declared detected when the pixel intensity exceeds a pre-determined threshold. Inherent to the physical principle of SAR as a pulsed radar system, not only legitimate vessels are detected but commonly also ambiguous reflections caused by the periodic sampling of the scene. These ambiguous returns occur in both directions, azimuth and range, and can originate at land or ships. Depending on the chosen beam mode and system parameters, many also exceed the threshold and can severely degrade the overall performance quality. In the literature several elaborate technological and signal-processing techniques were proposed to either entirely avoid the emerging of ambiguities, or at least to suppress them significantly. While hardware based solutions are not readily available on existing spacecraft and potentially cost prohibitive on future ones, most processing algorithm are computationally too laborious for near real-time applications. This paper presents an alternative solution. As SAR-based ship detection is not about creating neat imagery, ambiguities may be tolerated as long as they can be reliably identified as such during a follow-on examination. This step is being proposed to be a novel additional statistical test that decides which hypothesis (vessel or ambiguity probability) was more likely to have generated the prior detected pixel-cluster. The effectiveness of the method is shown theoretically and corroborated with real RADARSAT Constellation Mission (RCM) data.
- 13 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 62 (01962892) , 1-13
Indicating Ambiguous False Positives to Improve Wide-Area SAR Vessel Detection
Automatic vessel detection based on wide-area Synthetic Aperture Radar (SAR) imagery is achieved via a statistical hypothesis test in which a ship is declared detected when the pixel intensity exceeds a pre-determined threshold. Inherent to the physical principle of SAR as a pulsed radar system, not only legitimate vessels are detected but commonly also ambiguous reflections caused by the periodic sampling of the scene. These ambiguous returns occur in both directions, azimuth and range, and can originate at land or ships. Depending on the chosen beam mode and system parameters, many also exceed the threshold and can severely degrade the overall performance quality. In the literature several elaborate technological and signal-processing techniques were proposed to either entirely avoid the emerging of ambiguities, or at least to suppress them significantly. While hardware based solutions are not readily available on existing spacecraft and potentially cost prohibitive on future ones, most processing algorithm are computationally too laborious for near real-time applications. This paper presents an alternative solution. As SAR-based ship detection is not about creating neat imagery, ambiguities may be tolerated as long as they can be reliably identified as such during a follow-on examination. This step is being proposed to be a novel additional statistical test that decides which hypothesis (vessel or ambiguity probability) was more likely to have generated the prior detected pixel-cluster. The effectiveness of the method is shown theoretically and corroborated with real RADARSAT Constellation Mission (RCM) data.
- 31 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 21 (1545598X) , 1-5
Improved Vessel Detection via Quadratic Matched Filtering and Target Parameter Estimation for Dual and Compact Polarimetric SAR
Dual-polarimetric (DP) and compact-polarimetric (CP) SAR modes are preferred over quad-channel fully-polarimetric (FP) modes for wide-area maritime domain surveillance applications because they provide twice the swath width. Recently, the Multi-Look Complex (MLC) product was introduced for RADARSAT Constellation Mission (RCM) imagery, which preserves the polarimetric phase information at a considerably lower data volume over the traditional phase-preserved single-look complex (SLC) product [1]. From statistical theory, the optimal detector for polarimetric data has been previously derived and is known as the Optimal Polarimetric Detector (OPD). However, for a deterministic target model, this detector cannot be applied to MLC data, and is also impractical because it requires complete a priori knowledge of the target. Instead a sub-optimal detector, known as the Polarimetric Whitening Filter (PWF), is often used in practice. This paper proposes a new detector called “Quadratic Matched Filter (QMF)” for CP and DP data that can be applied to MLC products for improved vessel detection over the PWF. A technique to estimate target parameters at processing time is also proposed, which can be used to estimate target parameters for both OPD and QMF. The feasibility and improved performance of the QMF detector is demonstrated through simulated receiver operating characteristic (ROC) performance analysis, and by demonstrating detection performance on an image acquired by RCM. It is shown that the QMF provides approximately 1.5 dB and 3 dB improvement in Signal-to-Clutter-plus-Noise Ratio (SCNR) and Peak-Signal-to-Clutter-plus-Noise Ratio (PSCNR), respectively, over PWF.
- 31 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 21 (1545598X) , 1-5
Improved Vessel Detection via Quadratic Matched Filtering and Target Parameter Estimation for Dual and Compact Polarimetric SAR
Dual-polarimetric (DP) and compact-polarimetric (CP) SAR modes are preferred over quad-channel fully-polarimetric (FP) modes for wide-area maritime domain surveillance applications because they provide twice the swath width. Recently, the Multi-Look Complex (MLC) product was introduced for RADARSAT Constellation Mission (RCM) imagery, which preserves the polarimetric phase information at a considerably lower data volume over the traditional phase-preserved single-look complex (SLC) product [1]. From statistical theory, the optimal detector for polarimetric data has been previously derived and is known as the Optimal Polarimetric Detector (OPD). However, for a deterministic target model, this detector cannot be applied to MLC data, and is also impractical because it requires complete a priori knowledge of the target. Instead a sub-optimal detector, known as the Polarimetric Whitening Filter (PWF), is often used in practice. This paper proposes a new detector called “Quadratic Matched Filter (QMF)” for CP and DP data that can be applied to MLC products for improved vessel detection over the PWF. A technique to estimate target parameters at processing time is also proposed, which can be used to estimate target parameters for both OPD and QMF. The feasibility and improved performance of the QMF detector is demonstrated through simulated receiver operating characteristic (ROC) performance analysis, and by demonstrating detection performance on an image acquired by RCM. It is shown that the QMF provides approximately 1.5 dB and 3 dB improvement in Signal-to-Clutter-plus-Noise Ratio (SCNR) and Peak-Signal-to-Clutter-plus-Noise Ratio (PSCNR), respectively, over PWF.
- Open Access
- 15 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 9597-9608
Retrieval of Ocean Surface Radial Velocities With RADARSAT-2 Along-Track Interferometry
This work provides a detailed presentation of dualaperture synthetic aperture radar (SAR) data processing scheme for the retrieval of ocean surface radial velocities. This scheme includes processing of raw SAR data, co-registration of alongtrack interferometric samples, magnitude and absolute phase calibration, and coherent averaging (multi-looking). Several approaches for absolute phase calibration are provided and compared. Some of the attempted approaches can potentially be used over open ocean (i.e. in scenes that do not contain any land). Main goal of attempting different approaches for absolute phase calibration was to determine their relative performance, and determine the potential feasibility of some approaches over open ocean. Data processing scheme is applied to a RADARSAT-2 dualchannel MODEX-1 acquisition over a section of Florida Current. For the dataset used in this study, different absolute phase calibration methods yielded similar radial velocity estimates, with relative mean and RMS differences within approximately 0.1 m/s. Estimates from SAR ATI were also compared to estimates from NASAs OSCAR dataset. Comparison of visually identified currents showed close spatial overlap between estimates from the two sources. RMS difference was found to be approximately 0.30 m/s. This difference can be attributed to the physical and temporal differences between the estimates.
- 15 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 14 (19391404) , 9597-9608
Open AccessRetrieval of Ocean Surface Radial Velocities With RADARSAT-2 Along-Track Interferometry
This work provides a detailed presentation of dualaperture synthetic aperture radar (SAR) data processing scheme for the retrieval of ocean surface radial velocities. This scheme includes processing of raw SAR data, co-registration of alongtrack interferometric samples, magnitude and absolute phase calibration, and coherent averaging (multi-looking). Several approaches for absolute phase calibration are provided and compared. Some of the attempted approaches can potentially be used over open ocean (i.e. in scenes that do not contain any land). Main goal of attempting different approaches for absolute phase calibration was to determine their relative performance, and determine the potential feasibility of some approaches over open ocean. Data processing scheme is applied to a RADARSAT-2 dualchannel MODEX-1 acquisition over a section of Florida Current. For the dataset used in this study, different absolute phase calibration methods yielded similar radial velocity estimates, with relative mean and RMS differences within approximately 0.1 m/s. Estimates from SAR ATI were also compared to estimates from NASAs OSCAR dataset. Comparison of visually identified currents showed close spatial overlap between estimates from the two sources. RMS difference was found to be approximately 0.30 m/s. This difference can be attributed to the physical and temporal differences between the estimates.
- 27 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 55 (11) , 6031-6043
Cramér–Rao Lower Bound Derivation and Performance Analysis for Space-Based SAR GMTI
This paper derives the Cramér-Rao for a general multichannel spaceborne synthetic aperture radar system for ground moving-target indication and provides a theoretical analysis of across-track velocity estimation for RADARSAT-2 and a fictitious satellite. The signal model assumes a deterministic target signal in Gaussian clutter and noise. In estimation theory, the CRLB provides a lower bound on the achievable variance of any unbiased estimator. An estimator that achieves this bound is called efficient; however, there is no guarantee that an efficient estimator can be found. Nonetheless, the theoretical variance of the efficient estimator provides a good measure of the capability of the system and serves as a valuable system performance validation tool. Even if an efficient estimator cannot be found, for radar systems, the CRLB provides a necessary, but not sufficient design baseline for measurement parameters, such as the number of subapertures for transmit and receive, power levels, pulse-repetition frequency, and so on. CRLBs for a limited number of system configurations for RADARSAT-2 and TerraSAR-X are presented by Cerutti-Maori et al. and Ender et al.; however, the complete analytical form of CRLB for a general system, which can be readily applied to an arbitrary antenna switching configuration, has not been previously derived.
- 27 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 55 (11) , 6031-6043
Cramér–Rao Lower Bound Derivation and Performance Analysis for Space-Based SAR GMTI
This paper derives the Cramér-Rao for a general multichannel spaceborne synthetic aperture radar system for ground moving-target indication and provides a theoretical analysis of across-track velocity estimation for RADARSAT-2 and a fictitious satellite. The signal model assumes a deterministic target signal in Gaussian clutter and noise. In estimation theory, the CRLB provides a lower bound on the achievable variance of any unbiased estimator. An estimator that achieves this bound is called efficient; however, there is no guarantee that an efficient estimator can be found. Nonetheless, the theoretical variance of the efficient estimator provides a good measure of the capability of the system and serves as a valuable system performance validation tool. Even if an efficient estimator cannot be found, for radar systems, the CRLB provides a necessary, but not sufficient design baseline for measurement parameters, such as the number of subapertures for transmit and receive, power levels, pulse-repetition frequency, and so on. CRLBs for a limited number of system configurations for RADARSAT-2 and TerraSAR-X are presented by Cerutti-Maori et al. and Ender et al.; however, the complete analytical form of CRLB for a general system, which can be readily applied to an arbitrary antenna switching configuration, has not been previously derived.