Rajesh Kumar Upadhyay
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Rajesh Kumar Upadhyay has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
Amit Kumar
7 shared publicationsHarish J. Pant
Isotope and Radiation Application Division, Bhabha Atomic Research Centre, Trombay, Mumbai 400085, India
7 shared publicationsHarish Jagat Pant
Isotope and Radiation Application Division, Bhabha Atomic Research Centre, Trombay, Mumbai 400085, India
6 shared publications- Keshav Kumar
Department of Chemical Engineering Indian Institute of Technology Guwahati Guwahati India
5 shared publications Lipika Kalo
Department of Chemical Engineering and Technology, Indian Institute of Technology (BHU) Varanasi, Varanasi 221005 Uttar Pradesh, India
5 shared publications- Richa Sharma
Laboratory for Chemical Technology, Ghent University, Technologiepark 125, 9052 Ghent, Belgium
5 shared publications
Latest Publications
- 10 August 2026
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (10) , 6993-7017
Impact of the method of preparation of SBA-15 Intermediate layer on the performance of palladium membrane supported on porous alumina for hydrogen separation
- 10 August 2026
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (10) , 6993-7017
Impact of the method of preparation of SBA-15 Intermediate layer on the performance of palladium membrane supported on porous alumina for hydrogen separation
- 23 July 2026
- Published by Wiley in The Canadian Journal of Chemical Engineering
Performance analysis and thermal stability of Pd–Ag/ 2B ‐graphite/ α ‐ Al 2 O 3 membrane for hydrogen separation and purification from various mixture gases
Three composite Pd–Ag/2B‐graphite/ α ‐Al 2 O 3 membranes (M1, M2, and M3) were prepared following the ELP technique whose pore mouth was modified using a 2B‐graphite lead owing to its enhanced ductility, higher thermo‐electrical conductivity, and resistance to thermal shocks. The present study provides critical insight into membrane permeation and optimizing operational parameters. This systematic study is quite useful for the modelling and commercialization of such membranes. A maximum of 0.26 mol m −2 s −1 of permeate H 2 was achieved at 773 K and 300 kPa(g). The investigation also encompasses the effect of mixture gases H 2 /N 2 , H 2 /CO 2 , H 2 /CO, and H 2 /CH 4 on membrane (M1) performance. Increasing the feed load increased the permeate H 2 flux and finally reached a stationary value. The permeate H 2 flux achieved saturation at approximately 258, 645, and 1130 L min −1 of feed load for 100, 200, and 300 kPa(g), respectively. Once the permeate H 2 flux reaches saturation, there was a considerable drop in H 2 recovery. The effect of the H 2 /CO mixture gas was determined over M3 membrane. The relative H 2 flux was reduced to 0.53 at 573 K when the CO content was maintained at 20%. Lastly, the long‐term thermal heat cycle stability of the membrane (M2) was performed. The H 2 /N 2 selectivity of the membrane was found to be above 5000 after 10 thermal cycles and 60 h of continuous operation. The microstructure revealed dislocations in the grain boundaries and evidence of migration of Ag to the membrane surface due to recrystallization and grain development during long‐term operation.
- 23 July 2026
- Published by Wiley in The Canadian Journal of Chemical Engineering
Performance analysis and thermal stability of Pd–Ag/ 2B ‐graphite/ α ‐ Al 2 O 3 membrane for hydrogen separation and purification from various mixture gases
Three composite Pd–Ag/2B‐graphite/ α ‐Al 2 O 3 membranes (M1, M2, and M3) were prepared following the ELP technique whose pore mouth was modified using a 2B‐graphite lead owing to its enhanced ductility, higher thermo‐electrical conductivity, and resistance to thermal shocks. The present study provides critical insight into membrane permeation and optimizing operational parameters. This systematic study is quite useful for the modelling and commercialization of such membranes. A maximum of 0.26 mol m −2 s −1 of permeate H 2 was achieved at 773 K and 300 kPa(g). The investigation also encompasses the effect of mixture gases H 2 /N 2 , H 2 /CO 2 , H 2 /CO, and H 2 /CH 4 on membrane (M1) performance. Increasing the feed load increased the permeate H 2 flux and finally reached a stationary value. The permeate H 2 flux achieved saturation at approximately 258, 645, and 1130 L min −1 of feed load for 100, 200, and 300 kPa(g), respectively. Once the permeate H 2 flux reaches saturation, there was a considerable drop in H 2 recovery. The effect of the H 2 /CO mixture gas was determined over M3 membrane. The relative H 2 flux was reduced to 0.53 at 573 K when the CO content was maintained at 20%. Lastly, the long‐term thermal heat cycle stability of the membrane (M2) was performed. The H 2 /N 2 selectivity of the membrane was found to be above 5000 after 10 thermal cycles and 60 h of continuous operation. The microstructure revealed dislocations in the grain boundaries and evidence of migration of Ag to the membrane surface due to recrystallization and grain development during long‐term operation.
- 10 April 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 231
Performance of the Pd–Ag membrane for hydrogen separation under direct Joule's heating
- 10 April 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 231
Performance of the Pd–Ag membrane for hydrogen separation under direct Joule's heating
- 13 November 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (2) , 705-728
Effect of CeO2-YSZ intermediate layers for enhanced hydrogen permeance of palladium membrane supported on porous α-Al2O3 tube
- 13 November 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 52 (2) , 705-728
Effect of CeO2-YSZ intermediate layers for enhanced hydrogen permeance of palladium membrane supported on porous α-Al2O3 tube
- 31 October 2025
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 224, 35-54
Design Study of Multi‐pass Membrane Separator for Improved Hydrogen Recovery Using Pd-Ag Membranes for On‐site Hydrogen Generation
- 31 October 2025
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 224, 35-54
Design Study of Multi‐pass Membrane Separator for Improved Hydrogen Recovery Using Pd-Ag Membranes for On‐site Hydrogen Generation