Peter Mouche
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Peter Mouche has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Weicheng Zhong
Oak Ridge National Laboratory (ORNL), Oak Ridge, TN (United States)
3 shared publications - Anna Oberbauer2 shared publications
Brent J. Heuser
2 shared publications- Eric Fuchs2 shared publications
- Jingyi Shi2 shared publications
Samuel Bell
2 shared publications
Latest Publications
- Open Access
- 19 August 2026
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 633
Kinetics of thermal and irradiation-enhanced interaction layer growth in the U-Mo/Al fuel system
- 19 August 2026
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 633
Open AccessKinetics of thermal and irradiation-enhanced interaction layer growth in the U-Mo/Al fuel system
- Open Access
- 14 April 2026
- Published by Elsevier in SSRN Electronic Journal
Kinetics of thermal and irradiation-enhanced interaction layer growth in the U-Mo/Al fuel system
Uranium-molybdenum (U-Mo) alloys are one of the primary fuels for the conversion of high-performance research reactors to low enriched fuels. At the interface between fuel and aluminium (Al) cladding, the formation of an interdiffusion layer (IDL) is frequently accompanied by void formation. These voids have been reported to contribute to degraded fuel performance, for example, fuel plate swelling under irradiation.In this work, U-Mo/Al diffusion couples are prepared by physical vapor deposition (PVD) with tungsten (W) powder introduced at the interface as Kirkendall markers, to investigate whether void formation in thermally activated diffusion couples and during irradiation-enhanced diffusion is due to the Kirkendall effect. During annealing experiments, voids form exclusively at the Al/IDL interface, towards which the Kirkendall markers migrate. This reflects Kirkendall behavior under equilibrium conditions, where the faster diffusion of Al governs the direction of Kirkendall marker motion and the location of void formation. Heavy ion irradiation experiments with ion fluences corresponding to fission densities of up to 7.9x1020 f/cm3 were conducted to examine the Kirkendall effect under irradiation conditions. For that purpose, the influence of irradiation geometry and the location of the damage peak on Kirkendall marker behavior has been studied. Void formation was consistently observed at the Al/IDL interface in both irradiation and annealing experiments. However, under irradiation, the position of the Kirkendall marker plane depended strongly on the irradiation geometry, indicating that the classical equilibrium assumptions underlying the Kirkendall effect no longer apply. Instead, irradiation-induced non-equilibrium vacancy fluxes govern Kirkendall marker motion and void formation at the U-Mo/Al interface.
- 14 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessKinetics of thermal and irradiation-enhanced interaction layer growth in the U-Mo/Al fuel system
Uranium-molybdenum (U-Mo) alloys are one of the primary fuels for the conversion of high-performance research reactors to low enriched fuels. At the interface between fuel and aluminium (Al) cladding, the formation of an interdiffusion layer (IDL) is frequently accompanied by void formation. These voids have been reported to contribute to degraded fuel performance, for example, fuel plate swelling under irradiation.In this work, U-Mo/Al diffusion couples are prepared by physical vapor deposition (PVD) with tungsten (W) powder introduced at the interface as Kirkendall markers, to investigate whether void formation in thermally activated diffusion couples and during irradiation-enhanced diffusion is due to the Kirkendall effect. During annealing experiments, voids form exclusively at the Al/IDL interface, towards which the Kirkendall markers migrate. This reflects Kirkendall behavior under equilibrium conditions, where the faster diffusion of Al governs the direction of Kirkendall marker motion and the location of void formation. Heavy ion irradiation experiments with ion fluences corresponding to fission densities of up to 7.9x1020 f/cm3 were conducted to examine the Kirkendall effect under irradiation conditions. For that purpose, the influence of irradiation geometry and the location of the damage peak on Kirkendall marker behavior has been studied. Void formation was consistently observed at the Al/IDL interface in both irradiation and annealing experiments. However, under irradiation, the position of the Kirkendall marker plane depended strongly on the irradiation geometry, indicating that the classical equilibrium assumptions underlying the Kirkendall effect no longer apply. Instead, irradiation-induced non-equilibrium vacancy fluxes govern Kirkendall marker motion and void formation at the U-Mo/Al interface.
- 4 September 2025
- Published by Elsevier in Scripta Materialia
- Vol. 271
Thermal conductivity measurement of U-Mo and U-Mo/Al interaction layers generated from in-pile irradiation using the suspended-bridge method
- 4 September 2025
- Published by Elsevier in Scripta Materialia
- Vol. 271
Thermal conductivity measurement of U-Mo and U-Mo/Al interaction layers generated from in-pile irradiation using the suspended-bridge method
- 20 March 2023
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 188
Effects of Cr/Zircaloy-4 coating qualities for enhanced accident tolerant fuel cladding
- 20 March 2023
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 188
Effects of Cr/Zircaloy-4 coating qualities for enhanced accident tolerant fuel cladding
- 16 June 2022
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 176, 109275
Chromium-coated cladding analysis under simulated LOCA burst conditions
- 16 June 2022
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 176, 109275
Chromium-coated cladding analysis under simulated LOCA burst conditions
- 15 January 2021
- Published by Office of Scientific and Technical Information (OSTI)
Development of Standardized Property Requirements, Measurement Methods, and Reporting Guidance for Coatings
The U.S. Department of Energy's Office of Scientific and Technical Information
- 15 January 2021
- Published by Office of Scientific and Technical Information (OSTI)
Development of Standardized Property Requirements, Measurement Methods, and Reporting Guidance for Coatings
The U.S. Department of Energy's Office of Scientific and Technical Information
- 12 September 2020
- Published by Office of Scientific and Technical Information (OSTI)
Technology Enabling Zero-EPZ Micro Modular Reactors: Fabrication of Zirconium Hydride with Controlled Hydrogen Loading
The U.S. Department of Energy's Office of Scientific and Technical Information
- 12 September 2020
- Published by Office of Scientific and Technical Information (OSTI)
Technology Enabling Zero-EPZ Micro Modular Reactors: Fabrication of Zirconium Hydride with Controlled Hydrogen Loading
The U.S. Department of Energy's Office of Scientific and Technical Information
- 1 March 2020
- Published by Office of Scientific and Technical Information (OSTI)
Stability of zirconium hydride
- 1 March 2020
- Published by Office of Scientific and Technical Information (OSTI)
Stability of zirconium hydride
- 9 October 2019
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (3) , 2062-2075
Steam pressure and velocity effects on high temperature silicon carbide oxidation
The effects of steam pressure, velocity, and composition on SiC oxidation kinetics were studied. Pressure effects were tested at 1200°C from 0.1 to 1.4 MPa at a steam velocity of 0.25 cm/s. Velocity effects were tested in two furnaces at 0.45 MPa, 1200°C and 0.1 MPa, 1600°C with velocities ranging from 0.25 to 137 cm/s. Steam composition was altered by changing the reaction vessel material. Oxide morphology and composition were determined using optical and electron microscopy, and X‐ray diffraction. Porous oxides were observed whenever structural SiC from the reaction vessel saturated the steam with volatilized silica, H2, and CO. Oxidation kinetics were calculated by the change in SiC thickness. The steam velocity/recession rate followed a power‐law relationship of ~ 0.35 while the steam pressure/recession rate followed a power‐law relationship of ~ 1.78.
- 9 October 2019
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (3) , 2062-2075
Steam pressure and velocity effects on high temperature silicon carbide oxidation
The effects of steam pressure, velocity, and composition on SiC oxidation kinetics were studied. Pressure effects were tested at 1200°C from 0.1 to 1.4 MPa at a steam velocity of 0.25 cm/s. Velocity effects were tested in two furnaces at 0.45 MPa, 1200°C and 0.1 MPa, 1600°C with velocities ranging from 0.25 to 137 cm/s. Steam composition was altered by changing the reaction vessel material. Oxide morphology and composition were determined using optical and electron microscopy, and X‐ray diffraction. Porous oxides were observed whenever structural SiC from the reaction vessel saturated the steam with volatilized silica, H2, and CO. Oxidation kinetics were calculated by the change in SiC thickness. The steam velocity/recession rate followed a power‐law relationship of ~ 0.35 while the steam pressure/recession rate followed a power‐law relationship of ~ 1.78.
- 10 November 2018
- Published by Springer Nature in Oxidation of Metals
- Vol. 91 (3-4) , 259-277
Steam Oxidation of Zirconium–Yttrium Alloys from 500–$1100\,^{\circ }\text {C}$- 10 November 2018
- Published by Springer Nature in Oxidation of Metals
- Vol. 91 (3-4) , 259-277
Steam Oxidation of Zirconium–Yttrium Alloys from 500–$1100\,^{\circ }\text {C}$