Yonglin Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yonglin Yu has a total of 108 co-authors. Here are the top co-authors by number of shared publications:
- Liam P. Barry
Radio and Optics Research Laboratory, School of Electronic Engineering, Dublin City University, Glasnevin, D09 V209 Dublin, Ireland
21 shared publications Dexiu Huang
Huazhong University of Science & Technology
16 shared publicationsJialin Zhao
Wuhan National Laboratory for Optoelectronics, Huazhong University of Science and Technology, Wuhan, People’s Republic of China
10 shared publications- Kai Shi
University College London, United Kingdom
10 shared publications R. O'DOwd
Dept. Electronic Engineering, University College Dublin Ireland
9 shared publicationsShan Jiang
Accelink Technologies Co., Ltd., Wuhan, 430074, China
9 shared publications
Latest Publications
- Open Access
- 5 September 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (19) , 30947-30960
Fabry-Pérot optical frequency comb based mm-wave RoF system using pilot-assisted equalizer
The emergence of the millimeter wave (mm-Wave; 30 GHz to 300 GHz) frequency band holds a lot of promise for addressing the congestion at low frequency in future mobile networks. Among many mm-Wave generation schemes, optical heterodyning is considered one of the most promising approaches due to its scalability and potential for integration on chip. Employing optical frequency combs (OFC) for optical heterodyning alleviates the significant phase distortions/noise introduced by the optical sources. However, any residual phase noise in these systems can deteriorate the transmission performance. Here we demonstrate a high-capacity mm-Wave radio-over-fiber (RoF) system using Fabry-Pérot (FP) laser comb overcoming the typical limitations of this source. The temporal phase perturbation induced by the frequency fluctuation of the FP laser is theoretically analyzed, and then estimated and compensated by a pilot-based phase equalizer. Performance evaluation of the proposed phase equalizer is conducted through experiment and simulation. Enabled by the proposed compensation scheme, ten 200 MHz filtered orthogonal frequency division multiplexing (f-OFDM) signal bands modulated by 16-quadrature amplitude modulation (QAM) are transmitted over 10 km fiber, with the ability to serve multiple users. The transmission of 16-QAM modulated single carrier signals with 2 GBd and 8 Gbps data rate is also performed for comparison, which offers better resilience to phase noise, demonstrating the first commercial Quantum Well FP laser-based optical heterodyning mm-Wave RoF system for both multi-carrier and single carrier signals.
- 5 September 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (19) , 30947-30960
Open AccessFabry-Pérot optical frequency comb based mm-wave RoF system using pilot-assisted equalizer
The emergence of the millimeter wave (mm-Wave; 30 GHz to 300 GHz) frequency band holds a lot of promise for addressing the congestion at low frequency in future mobile networks. Among many mm-Wave generation schemes, optical heterodyning is considered one of the most promising approaches due to its scalability and potential for integration on chip. Employing optical frequency combs (OFC) for optical heterodyning alleviates the significant phase distortions/noise introduced by the optical sources. However, any residual phase noise in these systems can deteriorate the transmission performance. Here we demonstrate a high-capacity mm-Wave radio-over-fiber (RoF) system using Fabry-Pérot (FP) laser comb overcoming the typical limitations of this source. The temporal phase perturbation induced by the frequency fluctuation of the FP laser is theoretically analyzed, and then estimated and compensated by a pilot-based phase equalizer. Performance evaluation of the proposed phase equalizer is conducted through experiment and simulation. Enabled by the proposed compensation scheme, ten 200 MHz filtered orthogonal frequency division multiplexing (f-OFDM) signal bands modulated by 16-quadrature amplitude modulation (QAM) are transmitted over 10 km fiber, with the ability to serve multiple users. The transmission of 16-QAM modulated single carrier signals with 2 GBd and 8 Gbps data rate is also performed for comparison, which offers better resilience to phase noise, demonstrating the first commercial Quantum Well FP laser-based optical heterodyning mm-Wave RoF system for both multi-carrier and single carrier signals.
- 20 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 41 (8) , 2343-2350
Demonstration of High Capacity Bidirectional A-RoF System Using Wavelength Reuse and Frequency Multiplexing
We demonstrate a practical wavelength reuse bidirectional analog radio-over-fiber (A-RoF) system served by a single distributed feedback (DFB) laser. Frequency interleaving of downlink and uplink signals is proposed to ameliorate the spectral efficiency and mitigate the interference raised by the bidirectional transmission. Pre-emphasis is exploited to counteract the performance impairment brought about by the interaction between laser chirp and fiber chromatic dispersion. Through employing 64-QAM modulated 16 bands and 16-QAM modulated 12 bands filtered orthogonal frequency division multiplexing (f-OFDM) signals with 200 MHz bandwidth, asymmetric transmission with superior flexibility over 25 km fiber is attained, with an aggregate capacity of 20 Gb/s for downlink and 10 Gb/s for uplink. The mutual interference between the downlink and uplink is explored by overlapping the downlink and uplink signal spectra to varying degrees. Using the optimum frequency configuration, system performance is evaluated in terms of EVM and phase noise. To further investigate the effects caused by the Rayleigh backscattering and the stimulated Brillouin scattering (SBS), simulations are conducted on the proposed architecture, validating the conclusion from the experiment that the bidirectional transmission is primarily limited by the Rayleigh backscattering than the stimulated Brillouin scattering.
- 20 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 41 (8) , 2343-2350
Demonstration of High Capacity Bidirectional A-RoF System Using Wavelength Reuse and Frequency Multiplexing
We demonstrate a practical wavelength reuse bidirectional analog radio-over-fiber (A-RoF) system served by a single distributed feedback (DFB) laser. Frequency interleaving of downlink and uplink signals is proposed to ameliorate the spectral efficiency and mitigate the interference raised by the bidirectional transmission. Pre-emphasis is exploited to counteract the performance impairment brought about by the interaction between laser chirp and fiber chromatic dispersion. Through employing 64-QAM modulated 16 bands and 16-QAM modulated 12 bands filtered orthogonal frequency division multiplexing (f-OFDM) signals with 200 MHz bandwidth, asymmetric transmission with superior flexibility over 25 km fiber is attained, with an aggregate capacity of 20 Gb/s for downlink and 10 Gb/s for uplink. The mutual interference between the downlink and uplink is explored by overlapping the downlink and uplink signal spectra to varying degrees. Using the optimum frequency configuration, system performance is evaluated in terms of EVM and phase noise. To further investigate the effects caused by the Rayleigh backscattering and the stimulated Brillouin scattering (SBS), simulations are conducted on the proposed architecture, validating the conclusion from the experiment that the bidirectional transmission is primarily limited by the Rayleigh backscattering than the stimulated Brillouin scattering.
- 21 November 2022
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (1) , 1-11
Understanding the photon-photon resonance of DBR lasers using mode expansion method
- 21 November 2022
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (1) , 1-11
Understanding the photon-photon resonance of DBR lasers using mode expansion method
- Open Access
- 29 November 2021
- Published by Springer Nature in Research Square
Understanding the photon-photon resonance of DBR lasers using mode expansion method
A theoretical model based on the mode expansion of the traveling wave equations is developed to investigate the mode interaction processes behind the photon-photon resonance (PPR) effect in distributed Bragg reflector (DBR) lasers. With dual-mode rate equations, strength of mode interactions is characterized by the cross power and the coupling factors, which arise from the non-orthogonality of the main mode and the PPR mode. Small signal analysis and large-signal dynamics are performed, and results indicate that the cross power is a key contributor to the PPR effect.
- 29 November 2021
- Published by Springer Nature in Research Square
Open AccessUnderstanding the photon-photon resonance of DBR lasers using mode expansion method
A theoretical model based on the mode expansion of the traveling wave equations is developed to investigate the mode interaction processes behind the photon-photon resonance (PPR) effect in distributed Bragg reflector (DBR) lasers. With dual-mode rate equations, strength of mode interactions is characterized by the cross power and the coupling factors, which arise from the non-orthogonality of the main mode and the PPR mode. Small signal analysis and large-signal dynamics are performed, and results indicate that the cross power is a key contributor to the PPR effect.
- 26 November 2019
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 52 (1) , 1-10
High-speed and low-power thermally tunable devices with suspended silicon waveguide
- 26 November 2019
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 52 (1) , 1-10
High-speed and low-power thermally tunable devices with suspended silicon waveguide
- 17 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 37 (16) , 3875-3881
Experimental Demonstration of a WDM-RoF Based Mobile Fronthaul With f-OFDM Signals by Using Directly Modulated 3s-DBR Laser
- 17 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 37 (16) , 3875-3881
Experimental Demonstration of a WDM-RoF Based Mobile Fronthaul With f-OFDM Signals by Using Directly Modulated 3s-DBR Laser
- 3 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 31 (14) , 1171-1174
Chirp Compensation of Directly Modulated 3s-DBR Laser for WDM-RoF-Based Mobile Fronthaul
In this paper, we propose and demonstrate through simulations, a chirp compensation scheme with a directly modulated three section distributed Bragg reflector (3s-DBR) laser, for use in a WDM-RoF based mobile fronthaul network to eliminate the signal distortion caused by the interplay between laser chirp and fiber dispersion, including RF power fading and the composite second-order (CSO) distortion. Employing the phase section characteristics of the 3s-DBR laser, the frequency chirp of the device is reduced with reverse modulation current injection into the phase section. Simulation results show that with the chirp compensation scheme, reduced DBR laser chirp can be achieved, and error vector magnitude (EVM) of a 12 channel 211 MHz bandwidth filtered-OFDM (f-OFDM) signal with 64-QAM after transmission over 20 km standard single mode fiber (SSMF), can still satisfy the 3GPP’s requirement.
- 3 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 31 (14) , 1171-1174
Chirp Compensation of Directly Modulated 3s-DBR Laser for WDM-RoF-Based Mobile Fronthaul
In this paper, we propose and demonstrate through simulations, a chirp compensation scheme with a directly modulated three section distributed Bragg reflector (3s-DBR) laser, for use in a WDM-RoF based mobile fronthaul network to eliminate the signal distortion caused by the interplay between laser chirp and fiber dispersion, including RF power fading and the composite second-order (CSO) distortion. Employing the phase section characteristics of the 3s-DBR laser, the frequency chirp of the device is reduced with reverse modulation current injection into the phase section. Simulation results show that with the chirp compensation scheme, reduced DBR laser chirp can be achieved, and error vector magnitude (EVM) of a 12 channel 211 MHz bandwidth filtered-OFDM (f-OFDM) signal with 64-QAM after transmission over 20 km standard single mode fiber (SSMF), can still satisfy the 3GPP’s requirement.
- 1 May 2019
- Published by Elsevier in Optics Communications
- Vol. 439, 239-243
Optimization of thermally tunable grating filters with air trench and beam-pillar structures
- 1 May 2019
- Published by Elsevier in Optics Communications
- Vol. 439, 239-243
Optimization of thermally tunable grating filters with air trench and beam-pillar structures
- 12 February 2019
- Published by Optica Publishing Group in Optics Letters
- Vol. 44 (4) , 951-954
Performance-enhanced silicon thermo-optic Mach–Zehnder switch using laterally supported suspended phase arms and efficient electrodes
We report a silicon thermo-optic Mach–Zehnder switch with a broadband, low switching power, and fast response. A broadband 3 dB directional coupler is used to act as a power splitter. Laterally supported suspended phase arms are employed to substantially reduce the switching power without sacrificing too much on the temporal response. Furthermore, two metallization steps are utilized to further decrease the power consumption. We experimentally obtain a switching power as low as 1.1 mW, as well as a fast response of 76 and 48 μs for rise time and fall time, respectively. The demonstrated device also has a relatively high mechanical strength and compact size, making it promising to be applied in silicon photonic integrated circuits.
- 12 February 2019
- Published by Optica Publishing Group in Optics Letters
- Vol. 44 (4) , 951-954
Performance-enhanced silicon thermo-optic Mach–Zehnder switch using laterally supported suspended phase arms and efficient electrodes
We report a silicon thermo-optic Mach–Zehnder switch with a broadband, low switching power, and fast response. A broadband 3 dB directional coupler is used to act as a power splitter. Laterally supported suspended phase arms are employed to substantially reduce the switching power without sacrificing too much on the temporal response. Furthermore, two metallization steps are utilized to further decrease the power consumption. We experimentally obtain a switching power as low as 1.1 mW, as well as a fast response of 76 and 48 μs for rise time and fall time, respectively. The demonstrated device also has a relatively high mechanical strength and compact size, making it promising to be applied in silicon photonic integrated circuits.