Yoshiei Kato
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yoshiei Kato has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
Azhar Uddin
Department of Material and Energy Science Graduate School of Environmental and Life Science Okayama University 1-1 Tsushima-naka, 3-chome, Kita-ku Okayama 700-8530 Japan
17 shared publications- Azhar Uddin
Department of Material and Energy Science, Graduate School of Environmental and Life Science, Okayama University, Okayama, Japan
8 shared publications Eiji Kiso
Nippon Slag Association(Slag & Cement Div., Nippon Steel Corporation)
3 shared publicationsHironori Tamaki
Okayama University
3 shared publicationsKatsunori Takahashi
Nippon Slag Association(Steel Research Laboratory, JFE Steel Corporation)
3 shared publications- Eiji Kiso
Marketing Development, Slag & Cement Division, Nippon Steel Corporation, Tokyo, Japan
2 shared publications
Latest Publications
- 11 October 2023
- Published by Wiley in Steel Research International
- Vol. 95 (1)
Effect of Wettability, Number of Liquid Phases, and Agitation Procedure on Agglomeration/Breakup/Transfer of Fine Particles in Liquid
To discuss nonmetallic inclusion behaviors in a secondary refining process, cold model experiments on agglomeration, breakup, and transfer of fine particles are performed varying the operating factors such as an energy input rate, wettability, agitation practice, and the number of liquid phases. When the other operating conditions are the same, the agglomeration rate of the 1‐particle (isolated particle) with a hydrophobic property is larger than that with a hydrophilic one, and the transfer rate of the 2‐particle (cluster of 2 isolated particles) has the same tendency. The number of the 1‐particle with the hydrophobicity is estimated to increase at the transfer site of the particles from an open eye to a heavy liquid due to a bubble breakup, whereas the 1‐particle with the hydrophilicity shows an opposite trend because of less adhesion on the bubbles. The 1‐particle in the dual phase transfers from the open‐eye spot to a light liquid, although the value is not so much as that of the decrease in the agglomeration. A transfer condition of the inclusion composed of Al2O3 or CaO⋅Al2O3 is calculated when a particle contacts with a solid/liquid interface, and the CaO⋅Al2O3 inclusion is estimated to be engulfed above 3.34 μm in diameter.
- 11 October 2023
- Published by Wiley in Steel Research International
- Vol. 95 (1)
Effect of Wettability, Number of Liquid Phases, and Agitation Procedure on Agglomeration/Breakup/Transfer of Fine Particles in Liquid
To discuss nonmetallic inclusion behaviors in a secondary refining process, cold model experiments on agglomeration, breakup, and transfer of fine particles are performed varying the operating factors such as an energy input rate, wettability, agitation practice, and the number of liquid phases. When the other operating conditions are the same, the agglomeration rate of the 1‐particle (isolated particle) with a hydrophobic property is larger than that with a hydrophilic one, and the transfer rate of the 2‐particle (cluster of 2 isolated particles) has the same tendency. The number of the 1‐particle with the hydrophobicity is estimated to increase at the transfer site of the particles from an open eye to a heavy liquid due to a bubble breakup, whereas the 1‐particle with the hydrophilicity shows an opposite trend because of less adhesion on the bubbles. The 1‐particle in the dual phase transfers from the open‐eye spot to a light liquid, although the value is not so much as that of the decrease in the agglomeration. A transfer condition of the inclusion composed of Al2O3 or CaO⋅Al2O3 is calculated when a particle contacts with a solid/liquid interface, and the CaO⋅Al2O3 inclusion is estimated to be engulfed above 3.34 μm in diameter.
- 30 May 2023
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 25 (4) , 2407-2416
Sequential flotation of 4 components in silicon-based waste solar cells
- 30 May 2023
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 25 (4) , 2407-2416
Sequential flotation of 4 components in silicon-based waste solar cells
- 13 December 2022
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 101 (6) , 3479-3489
Effect of operating factors on liquid–liquid mass transfer and dispersion pattern of sedimentary liquid in a mechanically stirred vessel
Liquid–liquid dispersion and mass transfer were investigated in mechanically stirred vessels without baffles by changing operation factors such as an impeller rotation speed, off‐bottom clearance, volumetric liquid ratio, etc. The dispersion regime was categorized into five groups: the sedimentary liquid was kept at the vessel bottom (I), partially elevated without any collision (II), partially dispersed by colliding with the impeller bottom (III), both liquids were partially dispersed by collisions with impeller blades (III’), and the sedimentary liquid was completely dispersed (IV). The dispersion switched to I → II → III → IV with the increasing rotation speed and decreasing off‐bottom clearance. The liquid–liquid mass transfer rate was significantly enhanced with the collision of the sedimentary liquid with the impeller bottom, and subsequently increased with the increasing rotation speed, volumetric liquid ratio, and vessel diameter and with the decreasing off‐bottom clearance. A multiple regression analysis method was applied to determine the mass transfer rates of III and III’.
- 13 December 2022
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 101 (6) , 3479-3489
Effect of operating factors on liquid–liquid mass transfer and dispersion pattern of sedimentary liquid in a mechanically stirred vessel
Liquid–liquid dispersion and mass transfer were investigated in mechanically stirred vessels without baffles by changing operation factors such as an impeller rotation speed, off‐bottom clearance, volumetric liquid ratio, etc. The dispersion regime was categorized into five groups: the sedimentary liquid was kept at the vessel bottom (I), partially elevated without any collision (II), partially dispersed by colliding with the impeller bottom (III), both liquids were partially dispersed by collisions with impeller blades (III’), and the sedimentary liquid was completely dispersed (IV). The dispersion switched to I → II → III → IV with the increasing rotation speed and decreasing off‐bottom clearance. The liquid–liquid mass transfer rate was significantly enhanced with the collision of the sedimentary liquid with the impeller bottom, and subsequently increased with the increasing rotation speed, volumetric liquid ratio, and vessel diameter and with the decreasing off‐bottom clearance. A multiple regression analysis method was applied to determine the mass transfer rates of III and III’.
- 1 February 2021
- Published by Elsevier in Inorganic Chemistry Communications
- Vol. 124
Effect of ultrasonic irradiation on γ-Fe2O3 formation by co-precipitation method with Fe3+ salt and alkaline solution
- 1 February 2021
- Published by Elsevier in Inorganic Chemistry Communications
- Vol. 124
Effect of ultrasonic irradiation on γ-Fe2O3 formation by co-precipitation method with Fe3+ salt and alkaline solution
- 6 January 2021
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 232 (1) , 1-11
Enhancement of Zinc Ion Removal from Water by Physically Mixed Particles of Iron/Iron Sulfide
- 6 January 2021
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 232 (1) , 1-11
Enhancement of Zinc Ion Removal from Water by Physically Mixed Particles of Iron/Iron Sulfide
- 12 July 2020
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 99 (1) , 410-420
Suspension pattern and rising height of sedimentary particles with low concentration in a mechanically stirred vessel
In this study, the effects of impeller rotation speed, off‐bottom clearance, blade angle, types of solid and liquid, etc., on the suspension pattern of sedimentary particles and particle rise height in liquid were investigated with a hemispherical vessel without baffles under low particle concentration. The transition conditions of suspension pattern between regimes I and II, and regimes II and III, were observed visually, and their non‐dimensional equations were expressed with an acceptable correlation by varying the above operation factors a great deal. Here, regime I is stagnation of particles on a vessel bottom, II is partial suspension, and III is complete suspension in liquid. The non‐dimensional equation of the maximum particle rise height was also successfully obtained. The combination of the non‐dimensional equations of transition and maximum particle rise height permitted us to determine the adequate solid/liquid mixing operation conditions without collision of particles with device parts.
- 12 July 2020
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 99 (1) , 410-420
Suspension pattern and rising height of sedimentary particles with low concentration in a mechanically stirred vessel
In this study, the effects of impeller rotation speed, off‐bottom clearance, blade angle, types of solid and liquid, etc., on the suspension pattern of sedimentary particles and particle rise height in liquid were investigated with a hemispherical vessel without baffles under low particle concentration. The transition conditions of suspension pattern between regimes I and II, and regimes II and III, were observed visually, and their non‐dimensional equations were expressed with an acceptable correlation by varying the above operation factors a great deal. Here, regime I is stagnation of particles on a vessel bottom, II is partial suspension, and III is complete suspension in liquid. The non‐dimensional equation of the maximum particle rise height was also successfully obtained. The combination of the non‐dimensional equations of transition and maximum particle rise height permitted us to determine the adequate solid/liquid mixing operation conditions without collision of particles with device parts.
- 3 February 2020
- Published by Springer Nature in Journal of Sustainable Metallurgy
- Vol. 6 (1) , 132-141
Alkali Elution Behavior of Steelmaking Slag Packed in an Open Channel Vessel in Seawater
- 3 February 2020
- Published by Springer Nature in Journal of Sustainable Metallurgy
- Vol. 6 (1) , 132-141
Alkali Elution Behavior of Steelmaking Slag Packed in an Open Channel Vessel in Seawater
- 23 September 2019
- Published by Springer Nature in Journal of Sustainable Metallurgy
- Vol. 5 (4) , 551-560
Separation Between Silicon and Aluminum Powders Contained Within Pulverized Scraped Silicon-Based Waste Solar Cells by Flotation Method
- 23 September 2019
- Published by Springer Nature in Journal of Sustainable Metallurgy
- Vol. 5 (4) , 551-560
Separation Between Silicon and Aluminum Powders Contained Within Pulverized Scraped Silicon-Based Waste Solar Cells by Flotation Method