VCVasileios Chatziioannou

Vasileios Chatziioannou

*This is an algorithmically generated author record based on publicly available information.

Vasileios Chatziioannou has a total of 56 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Experimental investigation of lip-specific mouthpiece forces and pressure parameters in trombone performance under realistic playing conditions

    by Paul Michael Amann, Anita Kloss-Brandstätter, Roland Willmann, Vasileios Chatziioannou, Pascal Nicolay

    Mastering brass playing depends on the fine control of the embouchure–the coordinated interaction between lips, mouthpiece, and airflow. While teachers and performers have long emphasised this balance, objective data on how lip forces and pressures interact during real performance are scarce. This study addresses this gap by introducing a novel sensor-integrated mouthpiece system capable of directly capturing lip-specific forces together with mouthpiece and intraoral pressure signals during playing. Data from 31 trombonists, ranging from beginners to professionals, were synchronised with score annotations and analysed note by note. Distinct embouchure strategies emerged across proficiency levels: advanced and professional players maintained tighter control of total and differential lip forces, operated within narrower limits, and showed greater relaxation during rests. At note onsets, they exhibited smaller relative force surges and more balanced lip contributions, reflecting a potential refined motor coordination. These findings provide the first quantitative, lip-resolved evidence of force magnitudes, distributions, and efficiencies across skill levels, offering new perspectives for brass acoustics, pedagogy, and feedback-based training.

  • Open Access

    Investigating the impact of tone hole geometry on the flow in wind instruments via particle image velocimetry

    by Titas Lasickas, Giuseppe Carlo Alp Caridi, Alfredo Soldati, Vasileios Chatziioannou

    An experimental study is conducted to investigate the effects of both the diameter and shape of wind instrument tone holes on the flow behaviour in an artificial, simplified scenario. Time-resolved particle image velocimetry is used to measure flow velocity over the entire length of a square recorder bore. Flow velocity measurements enable various approaches to analyse the flow under different tone hole configurations. Simultaneous to the flow measurements, the air pressure at the input (blowing pressure) and in the interior of the tube (at five locations along the bore) is measured. Realistic excitation conditions are emulated, incorporating a commercial bass recorder mouthpiece. The flow for three different tone hole diameters is examined, with two of the tone holes also varying in height and undercutting. The amplitude of the flow oscillations is examined and compared for all tone hole configurations. The effect of tone hole undercutting is further analysed in the frequency domain, where it is observed that undercutting concentrates more energy at the fundamental frequency. Finally, it is experimentally shown that undercutting lowers the vorticity of the flow.


  • Open Access

    An experimental approach for comparing the influence of cello string type on bowed attack response

    by Alessio Lampis, Alexander Mayer, Vasileios Chatziioannou

    This study investigates the influence of string properties on bowed string attack playability. To assess the attack playability of different string types, a variety of bow forces and bow accelerations were chosen to excite the strings and measure the transient response under different bowing control parameters. The experimentally obtained playability maps of transient duration as function of bow force and acceleration (Guettler diagram) were obtained with a robotic bowing machine, from four different types of cello G2 strings. Results indicate variations in playability across string types, suggesting that string properties impact attack duration.


  • Open Access

    Assessing playability limits of bowed-string transients using experimental measurements

    by Alessio Lampis, Alexander Mayer, Vasileios Chatziioannou

    Understanding the dynamics of bowed-string attacks involves exploring the relationship between bow acceleration, bow force, and the generation of Helmholtz motion during transients. This study addresses the following research question: How do theoretical limits of “playability” predict these parameters? Motivated by the need for experimental evidence in this domain, we present a comprehensive investigation into bowed-string transients within the bow acceleration and bow force parameter space, known as the Guettler diagram. This study exclusively employs an experimental methodology. The setup, employing a robotic arm, permits the collection of transient data under varying bowing conditions. Analysis of the bridge force waveform allows for the extraction of pre-Helmholtz transient times. Our results reveal a triangular playable region in the Guettler diagram, consistent with theoretical predictions and previous experimental findings. However, Guettler’s analytical limits for playable regions during transients show limitations. We investigate the role of friction, a key parameter idealized in the model used for obtaining these limits. Measured friction coefficients from transients reveal discrepancies with prior experimental studies, highlighting the need for further investigations in this direction.


  • Open Access

    A method for the reproduction of cello bow kinematics using a robotic arm and motion capture

    by Montserrat Pàmies-Vilà, Alexander Mayer, Ewa Matusiak, Vasileios Chatziioannou

    Numerous experimental and theoretical methods have focused on the bow–string interaction in bowed string instruments, including several artificial bowing setups. The current research aims to present an experimental approach to reproduce bowing techniques using a robotic arm. First, optical motion capture is used to track the 3D kinematics of the bow. The cello bow and corpus are equipped with reflective markers. The cello is mounted on a playing platform. The recorded 3D trajectories of the bow markers are used to control the motion of the robotic arm. This process requires converting the 3D data between the coordinate frames of the two systems. This conversion is described in detail in this paper. To demonstrate the performance of the proposed method, an experienced cellist was asked to play an adapted piece on the cello, which was then repeated using the robotic arm. The robotic arm is capable of accurately reproducing the bow velocity, but even minimal variations in position can compromise proper bow–string contact. To illustrate this, the study compares two similar robotic situations and discusses the challenges of adapting the robot’s coordinates as a function of a given playing parameter or the sound produced.


  • Open Access

    Elasto-plastic friction modeling toward reconstructing measured bowed-string transients

    by Ewa Matusiak, Vasileios Chatziioannou

    Physical modeling may be used to simulate the motion of a vibrating string under frictional excitation by a bow. This study compares the measured transient behavior of a bowed string with predictions from a physics-based simulation that assumes a finite-width bow, incorporates bow-hair compliance, considers the string's torsional motion, and utilizes an elasto-plastic friction model. The model is first evaluated by comparing simulated Guettler playability diagrams to a measured diagram obtained from a robot arm bowing a monochord. The playability regions are qualitatively similar, but some significant differences in the underlying waveforms are not captured. In order to improve the reconstructions of individual waveforms, inverse modeling is employed to derive parameter values for the elasto-plastic friction model, demonstrating the ability to generate accurate reconstructions of measured signal transients. The findings highlight the importance of accounting for variable friction coefficients that change with bow force and bow acceleration. This observation is consistent with prior research indicating that static and dynamic friction coefficients vary within a Guettler diagram.


  • Open Access

    Physics-based playability maps for single-reed woodwind instruments

    by Vasileios Chatziioannou, Montserrat Pàmies-Vilà, Alex Hofmann

    Musical instrument playability can be analyzed by visualizing a subspace defined by musicians' control parameters. This is common for bowed-string instruments in the form of Schelleng diagrams. Such diagrams can be populated either through experimental measurements or physical modeling. It was recently suggested to use similar diagrams for analyzing wind instrument playability. This study explores this direction using a physical model, previously validated against experimental measurements. It is shown that reed beating needs to be taken into account before playability analysis. This could help arrive at specific reed and mouthpiece designs according to the musicians' desires.


  • Open Access

    Two-dimensional playability maps for single-reed woodwind instruments

    by Vasileios Chatziioannou, Alex Hofmann

    One method to analyze musical instrument playability is by visualizing a two-dimensional subspace of the musician's control parameters. This hasbeen widely used in the form of Schelleng diagrams for bowed string instruments. There, it is possible to identify regions within the bow force—bowing position subspace where Helmholtz motion is achieved. Such diagrams may be populated either on the basis of experimental measurements, or via physical modeling. In fact, physical modeling is particularly suited to this task, since playing parameters can be directly controlled. It has been recently suggested (Woodhouse, in Proc. SMAC 2023) that similar diagrams may be used for analyzing wind instrument playability. This study aims at exploring this direction using a physical model which has been previously validated against experimental measurements. Initially, an informed decision is made on which parameters should be chosen for plotting an equivalent playability diagram. Subsequently, various diagram versions are generated, focusing on different aspects of the generated tones. As already pointed out by Woodhouse, similarities appear between the diagrams for bowed-string and woodwind instruments. It remains to examine how valuable information regarding woodwind playability may be extracted from such studies.

  • Open Access

    Direction specific ambisonics source separation with end-to-end deep learning

    by Francesc Lluís, Nils Meyer-Kahlen, Vasileios Chatziioannou, Alex Hofmann

    Ambisonics is a scene-based spatial audio format that has several useful features compared to object-based formats, such as efficient whole scene rotation and versatility. However, it does not provide direct access to the individual source signals, so that these have to be separated from the mixture when required. Typically, this is done with linear spherical harmonics (SH) beamforming. In this paper, we explore deep-learning-based source separation on static Ambisonics mixtures. In contrast to most source separation approaches, which separate a fixed number of sources of specific sound types, we focus on separating arbitrary sound from specific directions. Specifically, we propose three operating modes that combine a source separation neural network with SH beamforming: refinement, implicit, and mixed mode. We show that a neural network can implicitly associate conditioning directions with the spatial information contained in the Ambisonics scene to extract specific sources. We evaluate the performance of the three proposed approaches and compare them to SH beamforming on musical mixtures generated with the musdb18 dataset, as well as with mixtures generated with the FUSS dataset for universal source separation, under both anechoic and room conditions. Results show that the proposed approaches offer improved separation performance and spatial selectivity compared to conventional SH beamforming.