Angada B. Sachid
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Angada B. Sachid has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Chenming Hu
Department of Electrical Engineering and Computer Sciences, University of California, Berkeley, CA, USA
4 shared publicationsMin-Cheng Chen
National Nano Device Laboratories, National Applied Research Laboratory, Hsinchu, Taiwan
2 shared publications- Ali Javey
Department of Electrical Engineering and Computer Sciences, University of California, Berkeley, CA, USA
1 shared publication - Chenming Hu
International College of Semiconductor Technology, National Yang Ming Chiao Tung University, Hsinchu, Taiwan
1 shared publication Chun-Chi Chen
National Nano Device Laboratories, National Applied Research Laboratory, Hsinchu, Taiwan
1 shared publicationDarsen D. Lu
National Cheng Kung University, Tainan, Taiwan
1 shared publication
Latest Publications
- Open Access
- 27 November 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (22) , 222101
High-gain monolithic 3D CMOS inverter using layered semiconductors
We experimentally demonstrate a monolithic 3D integrated complementary metal oxide semiconductor (CMOS) inverter using layered transition metal dichalcogenide semiconductor N-channel (NMOS) and P-channel (PMOS) MOSFETs, which are sequentially integrated on two levels. The two devices share a common gate. Molybdenum disulphide and tungsten diselenide are used as channel materials for NMOS and PMOS, respectively, with an ON-to-OFF current ratio (ION/IOFF) greater than 106 and electron and hole mobilities of 37 and 236 cm2/Vs, respectively. The voltage gain of the monolithic 3D inverter is about 45 V/V at a supply voltage of 1.5 V and a gate length of 1 μm. This is the highest reported gain at the smallest gate length and the lowest supply voltage for any 3D integrated CMOS inverter using any layered semiconductor.
- 27 November 2017
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (22) , 222101
Open AccessHigh-gain monolithic 3D CMOS inverter using layered semiconductors
We experimentally demonstrate a monolithic 3D integrated complementary metal oxide semiconductor (CMOS) inverter using layered transition metal dichalcogenide semiconductor N-channel (NMOS) and P-channel (PMOS) MOSFETs, which are sequentially integrated on two levels. The two devices share a common gate. Molybdenum disulphide and tungsten diselenide are used as channel materials for NMOS and PMOS, respectively, with an ON-to-OFF current ratio (ION/IOFF) greater than 106 and electron and hole mobilities of 37 and 236 cm2/Vs, respectively. The voltage gain of the monolithic 3D inverter is about 45 V/V at a supply voltage of 1.5 V and a gate length of 1 μm. This is the highest reported gain at the smallest gate length and the lowest supply voltage for any 3D integrated CMOS inverter using any layered semiconductor.
- 30 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 5181-5187
Nanowire FET With Corner Spacer for High-Performance, Energy-Efficient Applications
Parasitic capacitance in nanoscale FETs is becoming a dominant component of the total device capacitance which degrades device and circuit performance. This problem is exacerbated with the introduction of multigate FETs such as FinFET and gate-all-around FETs. In this paper, we introduce the corner spacer design for gate-all-around nanowire FET to significantly decrease parasitic capacitance with negligible degradation in ON-current. We show that the parasitic capacitance of a well-engineered corner spacer in a nanowire FET can be reduced by over 80% compared to the device with full nitride spacers. Ring oscillator stage delay and energy consumption of the corner spacer design are lower than the full spacer by over 50% each. This paper shows the possibility of engineering the spacers as a performance booster to continue scaling.
- 30 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (12) , 5181-5187
Nanowire FET With Corner Spacer for High-Performance, Energy-Efficient Applications
Parasitic capacitance in nanoscale FETs is becoming a dominant component of the total device capacitance which degrades device and circuit performance. This problem is exacerbated with the introduction of multigate FETs such as FinFET and gate-all-around FETs. In this paper, we introduce the corner spacer design for gate-all-around nanowire FET to significantly decrease parasitic capacitance with negligible degradation in ON-current. We show that the parasitic capacitance of a well-engineered corner spacer in a nanowire FET can be reduced by over 80% compared to the device with full nitride spacers. Ring oscillator stage delay and energy consumption of the corner spacer design are lower than the full spacer by over 50% each. This paper shows the possibility of engineering the spacers as a performance booster to continue scaling.
- 14 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (10) , 3986-3990
Modeling of Back-Gate Effects on Gate-Induced Drain Leakage and Gate Currents in UTB SOI MOSFETs
The back-gate bias-dependent gate-induced drain leakage (GIDL) and gate current models of ultrathin body (UTB) silicon-on-insulator (SOI) MOSFETs are proposed. From the experimental data, the GIDL current depends on the back bias due to the electric field change in the channel/drain junction. This effect is modeled using effective gate bias as the threshold voltage shifts. The back-gate bias-dependent gate current is also analyzed and modeled. The voltage across the oxide and available charges for tunneling are the important factors. In accumulation bias condition, the gate leakage is mainly flowing through the overlap region, while in inversion bias condition the current is tunneling from the gate to the channel. Both back bias-dependent GIDL and gate current models are implemented into industry standard compact model Berkeley Short-channel IGFET Model-Independent Multi-Gate for UTB SOI transistors. The model is in good agreement with the experimental data.
- 14 August 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (10) , 3986-3990
Modeling of Back-Gate Effects on Gate-Induced Drain Leakage and Gate Currents in UTB SOI MOSFETs
The back-gate bias-dependent gate-induced drain leakage (GIDL) and gate current models of ultrathin body (UTB) silicon-on-insulator (SOI) MOSFETs are proposed. From the experimental data, the GIDL current depends on the back bias due to the electric field change in the channel/drain junction. This effect is modeled using effective gate bias as the threshold voltage shifts. The back-gate bias-dependent gate current is also analyzed and modeled. The voltage across the oxide and available charges for tunneling are the important factors. In accumulation bias condition, the gate leakage is mainly flowing through the overlap region, while in inversion bias condition the current is tunneling from the gate to the channel. Both back bias-dependent GIDL and gate current models are implemented into industry standard compact model Berkeley Short-channel IGFET Model-Independent Multi-Gate for UTB SOI transistors. The model is in good agreement with the experimental data.
- 21 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (4) , 1861-1864
Bulk FinFET With Low- $\kappa $ Spacers for Continued ScalingWe fabricate n-channel silicon bulk FinFET with silicon nitride (Si 3 N 4 ) high-$ {\kappa } $ , silicon nitride/silicon dioxide dual-$ {\kappa } $ , and silicon dioxide (SiO 2 ) low-$ {\kappa } $ spacers, and compare their performance using measurements and TCAD simulations. While all the three devices show similar dc performance, the ac and transient performance of low-$\kappa $ spacer FinFET is better due to lower parasitic capacitance (${C}_{\mathrm {par}}$ ). We show that${C} _{\mathrm {par}}$ in SiO 2 spacer FinFET is about half of that with Si 3 N 4 spacer. When the gate length is scaled, the contribution of${C} _{\mathrm {par}}$ compared with the intrinsic capacitance (${C} _{\mathrm {ox}}$ ) increases. For FinFET with Si 3 N 4 spacers,${C} _{\mathrm {par}}/{C} _{\mathrm {ox}}$ increases from 36% at 30-nm gate length to 105% when the gate length is scaled to 10 nm, while for FinFET with SiO 2 spacers, the ratio changes from 19% to 55% making the latter more suitable for scaling. For SiO 2 spacer FinFET, inverter delay is about 13% and 25% lower than Si 3 N 4 spacer FinFET for gate lengths of 30 and 10 nm, respectively.- 21 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 64 (4) , 1861-1864
Bulk FinFET With Low- $\kappa $ Spacers for Continued ScalingWe fabricate n-channel silicon bulk FinFET with silicon nitride (Si 3 N 4 ) high-$ {\kappa } $ , silicon nitride/silicon dioxide dual-$ {\kappa } $ , and silicon dioxide (SiO 2 ) low-$ {\kappa } $ spacers, and compare their performance using measurements and TCAD simulations. While all the three devices show similar dc performance, the ac and transient performance of low-$\kappa $ spacer FinFET is better due to lower parasitic capacitance (${C}_{\mathrm {par}}$ ). We show that${C} _{\mathrm {par}}$ in SiO 2 spacer FinFET is about half of that with Si 3 N 4 spacer. When the gate length is scaled, the contribution of${C} _{\mathrm {par}}$ compared with the intrinsic capacitance (${C} _{\mathrm {ox}}$ ) increases. For FinFET with Si 3 N 4 spacers,${C} _{\mathrm {par}}/{C} _{\mathrm {ox}}$ increases from 36% at 30-nm gate length to 105% when the gate length is scaled to 10 nm, while for FinFET with SiO 2 spacers, the ratio changes from 19% to 55% making the latter more suitable for scaling. For SiO 2 spacer FinFET, inverter delay is about 13% and 25% lower than Si 3 N 4 spacer FinFET for gate lengths of 30 and 10 nm, respectively.- 15 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 38 (1) , 16-19
FinFET With Encased Air-Gap Spacers for High-Performance and Low-Energy Circuits
We experimentally demonstrate n-channel bulk FinFET with encased air-gap spacers. Encased air gap in the spacer region is formed by depositing carbon sidewalls, encasing them with silicon nitride (SiN) film and finally removing carbon using mild oxygen plasma. We show that the drive current of air-spacer FinFET is improved by about 40% compared with the baseline bulk FinFET with SiN spacers likely due to enhanced tensile stress in the channel. The parasitic capacitance and ring oscillator delay of FinFET with air-spacers is about 25% and 40% lower compared with that with SiN spacers.
- 15 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 38 (1) , 16-19
FinFET With Encased Air-Gap Spacers for High-Performance and Low-Energy Circuits
We experimentally demonstrate n-channel bulk FinFET with encased air-gap spacers. Encased air gap in the spacer region is formed by depositing carbon sidewalls, encasing them with silicon nitride (SiN) film and finally removing carbon using mild oxygen plasma. We show that the drive current of air-spacer FinFET is improved by about 40% compared with the baseline bulk FinFET with SiN spacers likely due to enhanced tensile stress in the channel. The parasitic capacitance and ring oscillator delay of FinFET with air-spacers is about 25% and 40% lower compared with that with SiN spacers.