Qiuju Ma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Qiuju Ma has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
Jianhua Chen
3 shared publicationsFushuai Guo
2 shared publicationsHui Zhang
Department of Engineering Physics Institute of Public Safety Research, Tsinghua University Beijing China
2 shared publications- Jianhua Chen
School of Emergency Management and Safety Engineering, China University of Mining & Technology (Beijing), Beijing, China
2 shared publications Jingfeng You
2 shared publicationsJuncheng Shao
State Key Laboratory of Coal Resources and Safe Mining China University of Mining & Technology (Beijing) Beijing China
2 shared publications
Latest Publications
- Open Access
- 1 September 2026
- Published by KEAI Publishing in Journal of Safety Science and Resilience
Study on the evolution of radiative view factor in aviation kerosene fires under obstacle effects
- 1 September 2026
- Published by KEAI Publishing in Journal of Safety Science and Resilience
Open AccessStudy on the evolution of radiative view factor in aviation kerosene fires under obstacle effects
- Open Access
Study on the Effects of Obstacles on Flame Radiation and View Factors in Oil Storage Tank Fires
Obstacles can significantly affect the thermal radiation distribution of oil storage tank fires; however, this issue has received relatively limited attention in previous studies. Taking aviation kerosene fires as an example, this study employed a cylindrical flame radiation model combined with the Monte Carlo method to investigate the variation in the radiative flux incident on the target and the flame-target view factor under different obstacle widths (W), heights (H) and target distances (d). The results indicate that obstacles block the flame radiation path, thereby reducing the radiative flux in the region behind the obstacle compared with the unobstructed condition. The view factor first decreases with increasing W and then approaches a stable value. The critical width (Wcr) is independent of H but increases with d. A similar relationship is observed between H and the critical height (Hcr). Based on geometric analysis, analytical expressions for Wcr and Hcr were derived. In addition, a predictive model for the view factor shielding ratio (φ) was established using three dimensionless geometric parameters, achieving a coefficient of determination of R2 = 0.976, which demonstrates good predictive accuracy. These findings provide theoretical guidance for fire risk assessment in tank farm areas.
Open AccessStudy on the Effects of Obstacles on Flame Radiation and View Factors in Oil Storage Tank Fires
Obstacles can significantly affect the thermal radiation distribution of oil storage tank fires; however, this issue has received relatively limited attention in previous studies. Taking aviation kerosene fires as an example, this study employed a cylindrical flame radiation model combined with the Monte Carlo method to investigate the variation in the radiative flux incident on the target and the flame-target view factor under different obstacle widths (W), heights (H) and target distances (d). The results indicate that obstacles block the flame radiation path, thereby reducing the radiative flux in the region behind the obstacle compared with the unobstructed condition. The view factor first decreases with increasing W and then approaches a stable value. The critical width (Wcr) is independent of H but increases with d. A similar relationship is observed between H and the critical height (Hcr). Based on geometric analysis, analytical expressions for Wcr and Hcr were derived. In addition, a predictive model for the view factor shielding ratio (φ) was established using three dimensionless geometric parameters, achieving a coefficient of determination of R2 = 0.976, which demonstrates good predictive accuracy. These findings provide theoretical guidance for fire risk assessment in tank farm areas.
- Open Access
- 1 December 2025
- Published by KEAI Publishing in Journal of Safety Science and Resilience
- Vol. 6 (4)
Association analysis of causative factors of fall from height accidents
- 1 December 2025
- Published by KEAI Publishing in Journal of Safety Science and Resilience
- Vol. 6 (4)
Open AccessAssociation analysis of causative factors of fall from height accidents
- 1 September 2025
- Published by Wiley in Fire and Materials
- Vol. 49 (8) , 1172-1188
Numerical Simulation Study of Methane–Air Explosion Suppression by Nonpremixed Nitrogen in a Closed Tube
To study the explosion suppression mechanism of nonpremixed inert gas, this paper uses CFD software Simtec to simulate the suppression process of methane explosion by nonpremixed nitrogen in a square tube. The closed square tube includes three sections: ignition section, suppression section, and combustible gas mixture section. The results show that the critical explosion suppression length increases first and then decreases with the increase of methane concentration. When the methane concentration is 11%, the critical explosion suppression length is the biggest, which is 1.6 m. With the increase of the length of the suppression section, the overpressure curve first changes from a high‐pressure single peak to a double peak and finally to a low‐pressure single peak. After ignition, the nitrogen in the suppression section moves to the right with the flame under the driving effect of thermal expansion of combustion products. When the flame propagates near the suppression section, the nitrogen section stops moving right. Then, under the disturbance of the explosion wave, the suppression section is stretched. When the length of the suppression section is less than the critical explosion suppression length, the flame passes through the suppression section to ignite the combustible mixture, causing a secondary explosion. If the suppression length is greater than the critical explosion suppression length, the flame will gradually extinguish in the suppression section. The feasibility of suppression explosion by nonpremixed inert gas was verified, and the suppression mechanism of nonpremixed inert gas is inertial isolation rather than dilution.
- 1 September 2025
- Published by Wiley in Fire and Materials
- Vol. 49 (8) , 1172-1188
Numerical Simulation Study of Methane–Air Explosion Suppression by Nonpremixed Nitrogen in a Closed Tube
To study the explosion suppression mechanism of nonpremixed inert gas, this paper uses CFD software Simtec to simulate the suppression process of methane explosion by nonpremixed nitrogen in a square tube. The closed square tube includes three sections: ignition section, suppression section, and combustible gas mixture section. The results show that the critical explosion suppression length increases first and then decreases with the increase of methane concentration. When the methane concentration is 11%, the critical explosion suppression length is the biggest, which is 1.6 m. With the increase of the length of the suppression section, the overpressure curve first changes from a high‐pressure single peak to a double peak and finally to a low‐pressure single peak. After ignition, the nitrogen in the suppression section moves to the right with the flame under the driving effect of thermal expansion of combustion products. When the flame propagates near the suppression section, the nitrogen section stops moving right. Then, under the disturbance of the explosion wave, the suppression section is stretched. When the length of the suppression section is less than the critical explosion suppression length, the flame passes through the suppression section to ignite the combustible mixture, causing a secondary explosion. If the suppression length is greater than the critical explosion suppression length, the flame will gradually extinguish in the suppression section. The feasibility of suppression explosion by nonpremixed inert gas was verified, and the suppression mechanism of nonpremixed inert gas is inertial isolation rather than dilution.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Effect of ambient pressure on smoke movement and temperature distribution in dual-source fire in tunnels
In high-altitude tunnel environments, fire behavior is significantly altered due to reduced ambient pressure and diminished oxygen availability. In this study, full-scale numerical simulations were conducted to investigate the thermal behavior of multiple fire sources in a tunnel under natural ventilation, focusing on the effects of ambient pressure and fire source spacing on smoke temperature distribution. The simulation results reveal that at close spacing, strong thermal interaction between fire sources leads to the formation of a single, unified high-temperature zone. In contrast, at larger spacings, two distinct heat-affected regions emerge with minimal overlap. As ambient pressure decreases, both the overall peak temperature and the intensity of the thermal field decline, while the location of the maximum temperature shifts further downstream. These findings demonstrate that fire source spacing and altitude-induced pressure variation jointly influence the magnitude, geometry, and extent of the thermal hazard zone in tunnel fires. Based on the simulation outcomes, two empirical models are proposed to predict the maximum smoke temperature and ceiling temperature distribution under varying fire configurations and environmental conditions. The models exhibit good agreement with both simulation and experimental data. This study provides a valuable reference for the design and evaluation of fire safety systems in tunnels, particularly those located in high-altitude regions.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Effect of ambient pressure on smoke movement and temperature distribution in dual-source fire in tunnels
In high-altitude tunnel environments, fire behavior is significantly altered due to reduced ambient pressure and diminished oxygen availability. In this study, full-scale numerical simulations were conducted to investigate the thermal behavior of multiple fire sources in a tunnel under natural ventilation, focusing on the effects of ambient pressure and fire source spacing on smoke temperature distribution. The simulation results reveal that at close spacing, strong thermal interaction between fire sources leads to the formation of a single, unified high-temperature zone. In contrast, at larger spacings, two distinct heat-affected regions emerge with minimal overlap. As ambient pressure decreases, both the overall peak temperature and the intensity of the thermal field decline, while the location of the maximum temperature shifts further downstream. These findings demonstrate that fire source spacing and altitude-induced pressure variation jointly influence the magnitude, geometry, and extent of the thermal hazard zone in tunnel fires. Based on the simulation outcomes, two empirical models are proposed to predict the maximum smoke temperature and ceiling temperature distribution under varying fire configurations and environmental conditions. The models exhibit good agreement with both simulation and experimental data. This study provides a valuable reference for the design and evaluation of fire safety systems in tunnels, particularly those located in high-altitude regions.
- Open Access
Research on Safety Risk Assessment Grading by Combining AHP-FCE and Risk Matrix Method-Taking Emergency Industrial Park of Fangshan District in Beijing as an Example
As an emerging development field, in recent years, emergency industrial parks in China have faced increasingly complex and high-risk challenges. This article proposes the establishment of a scientific safety risk assessment and grading model to help improve the safety management level of emergency industrial parks, in response to the problems of the multi-source heterogeneity of fire risks in emergency industrial parks and the difficulty of comprehensive assessment using traditional methods. This approach combines enterprise type classification with multi-level assessment for the first time, effectively identifying high-risk links such as fires and explosions and playing an effective role in preventing accidents such as fires in the park. Enterprises within the park are categorized into seven distinct groups based on their characteristics and associated safety risks: medical and healthcare, new energy storage, composite materials and new materials, intelligent manufacturing, mechanical manufacturing, consulting and technical services, and construction and installation. The following models are constructed: (1) a risk assessment model based on AHP-FCE, which can assess the safety risk levels of individual enterprises and the industrial park at a macro level; (2) a risk grading model based on the risk matrix method, which can inspect and control specific risk sources at a micro level. The integration of these two methods establishes a comprehensive model for safety risk assessment and grading in emergency industrial parks, significantly improving both the accuracy and the systematic nature of risk management processes.
Open AccessResearch on Safety Risk Assessment Grading by Combining AHP-FCE and Risk Matrix Method-Taking Emergency Industrial Park of Fangshan District in Beijing as an Example
As an emerging development field, in recent years, emergency industrial parks in China have faced increasingly complex and high-risk challenges. This article proposes the establishment of a scientific safety risk assessment and grading model to help improve the safety management level of emergency industrial parks, in response to the problems of the multi-source heterogeneity of fire risks in emergency industrial parks and the difficulty of comprehensive assessment using traditional methods. This approach combines enterprise type classification with multi-level assessment for the first time, effectively identifying high-risk links such as fires and explosions and playing an effective role in preventing accidents such as fires in the park. Enterprises within the park are categorized into seven distinct groups based on their characteristics and associated safety risks: medical and healthcare, new energy storage, composite materials and new materials, intelligent manufacturing, mechanical manufacturing, consulting and technical services, and construction and installation. The following models are constructed: (1) a risk assessment model based on AHP-FCE, which can assess the safety risk levels of individual enterprises and the industrial park at a macro level; (2) a risk grading model based on the risk matrix method, which can inspect and control specific risk sources at a micro level. The integration of these two methods establishes a comprehensive model for safety risk assessment and grading in emergency industrial parks, significantly improving both the accuracy and the systematic nature of risk management processes.
- 12 August 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 83, 335-354
Numerical simulation of high-pressure jet fire in on-board hydrogen storage cylinders under fire conditions
- 12 August 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 83, 335-354
Numerical simulation of high-pressure jet fire in on-board hydrogen storage cylinders under fire conditions