Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dmytro Vovchuk has a total of 122 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Wind-Corrected Payload Assessment of a Hovering Drone via Micro-Doppler Branch Separation

    by Dmytro Vovchuk, Oleg Torgovitsky, Mykola Khobzei, Vladyslav Tkach, Sergey Geyman, Anton Kharchevskii, Andrey Sheleg, Taras Hutsul, Oleh Eliiashiv, Toms Salgals, et al.

    Remote monitoring of drones is important for airspace management and security, including assessment of unauthorized payloads. Prior radar studies have established that payload state can affect drone signatures, but wind can alter rotor speeds and confound a payload estimate. Here, we examine a hovering DJI Mini 2 under controlled anechoic-chamber and wind-tunnel conditions. A balanced, top-mounted payload shifts the dominant blade-related micro-Doppler peak, whereas axial wind produces two spectral branches. We interpret the splitting as consistent with controller-mediated body tilt and thrust redistribution; rotor speed and attitude were not independently measured. At a 7 GHz carrier, increasing payload from 0 to 120 g shifts the dominant peak from approximately 340 to 430 Hz, giving a descriptive sensitivity of about 0.75 Hz/g for this platform. In the wind tunnel, the branch separation follows Δf = (16 Hz/(m/s))v, is the axial wind speed in m/s, and reaches approximately 52.8 Hz at 3.3 m/s while remaining nearly independent of the tested payload. The separation can therefore provide a model-specific wind estimate before payload correction. The resulting relations are presented as a platform-specific empirical calibration under controlled hovering. The specific contribution is the observation and empirical modeling of wind-induced branch splitting, which complements prior payload-classification methods.

  • Open Access

    Hardware Accountability for Energy-Efficient Stream-Oriented Data-Plane Processing in 5G/6G Edge Telecommunication Nodes

    by Yurii Herman, Oleh Krulikovskyi, Dmytro Vovchuk, Vjaceslavs Bobrovs

    Continuous stream-oriented data-plane processing in 5G/6G edge nodes increases the energy and latency cost of CPU-centered execution. This paper studies this boundary on an Intel Cyclone V SoC FPGA and proposes Hardware Accountability: a partitioning discipline in which Linux performs supervisory control while high-rate payload processing remains in programmable logic. The evaluation uses the Strumok stream cipher, adopted as the Ukrainian national standard DSTU 8845:2019, as a secure fronthaul/payload workload with XOR- and shift-dominated logic. On the evaluated USB 2.0/Cortex-A9/Linux path, the software-driven stream approaches saturation near 20 MSPS. In contrast, the RTL core reaches 9.6 Gbps at 150 MHz and occupies less than 6% of the available logic. Quartus Prime vectorless power analysis estimates 24.00 mW dynamic power for the RTL computational core, corresponding to approximately 2.5 pJ/bit. Control-plane measurements show P99 orchestration jitter below 1 ms under Spatial Isolation, conservative full context reloads near 1290 per second, and more than 7200 shadow-register context/state update operations per second. A design-space exploration then projects an 83.2 Gbps multi-core data path when external DDR traffic is avoided through internal stream aggregation and elastic buffering.

  • Open Access

    A framework for chaotic signature classification: Insights from Chua’s circuit

    by Sara Becchi, Elisabetta Spinazzola, Serhii Haliuk, Fernando Corinto, Leon O. Chua, Fabio Pareschi, Dmytro Vovchuk, Jacopo Secco

  • Artificial Micro-Doppler Flashes for Aerial Vehicle Identification: Drone Vehicle Identification Number via Blade Coding

    by Andrey Sheleg, Dmytro Vovchuk, Sergey Geyman, Amir Boag, Aviel Glam, Pavel Ginzburg

    The growing deployment of aerial vehicles across various domains, including unmanned drone delivery and urban air mobility, demands robust identification mechanisms capable of adapting to a rapidly evolving landscape, especially within congested airspace and urban environments. Existing identification systems primarily rely on visual tracking or wireless communication, each with inherent limitations: the former is constrained by line-of-sight and environmental conditions, while the latter depends on continuous connectivity and GPS data, making it vulnerable to spoofing. To address these challenges, we propose a novel radar-based identification method that introduces artificial micro-Doppler flashes generated by coded scatterers mounted on rotor blades. This approach creates unique, repeatable Doppler signatures, analogous to a Vehicle Identification Number (VIN), or Aerial VIN (AVIN), that can be interrogated by standard surveillance radars. Through a combination of theoretical modeling and experimental validation in a controlled indoor environment, we demonstrate the generation and detection of structured micro-Doppler signatures with high signal-to-noise contrast. The resulting code space reliably supports more than 264 uniquely distinguishable configurations, excluding axisymmetric redundancies, thereby confirming the feasibility of micro-Doppler-based identification for aerial platforms. Extrapolation to outdoor scenarios indicates a feasible detection range of up to 30 km under typical X-band radar conditions. These results suggest a promising path toward secure, passive identification of aerial vehicles, eliminating the need for onboard power or communication modules, and providing a reliable alternative in case of system failure.

  • Open Access

    Demonstration of Integrated Sensing and Communications in an ARoF-Based Radar System Utilizing Pulse Position Modulation

    by Sandis Migla, Nikolajs Tihomorskis, Kristaps Rubuls, Darja Cirjulina, Ints Murans, Viktors Kurtenoks, Janis Braunfelds, Sandis Spolitis, Oskars Ozolins, Dmytro Vovchuk, et al.

    Integrated sensing and communications (ISAC) is a key enabling technology for 6G networks, as it unifies radar sensing and data transmission within a shared infrastructure. Analog radio-over-fiber (ARoF) has emerged as a crucial technology for extending radar coverage and enabling distributed radar sensing. By incorporating pulse position modulation (PPM), it is possible to simultaneously measure the target’s range and transmit data, thereby increasing the energy efficiency of such systems. In this research, we present a novel ARoF-based ISAC-capable pulse radar system that features a custom-built PPM modulator employing a digital-to-time converter, and a high-accuracy time tagger as the demodulator, allowing for pulse time of arrival measurements with an root mean square accuracy up to 1.5 ps. The experimental results show a 5 Mbit/s data transmission along with a bit error ratio less than 5.86 × 10−7 at a 95% confidence level, using a PPM slot duration of 750 ps in an optical system featuring more than 40 km of single-mode optical fiber and a simultaneous range measurement with error less than 0.86 cm. In addition to ISAC exploration, the impact of fiber-induced chromatic dispersion on the PPM signal is studied, and the system is validated in an outdoor environment with a moving target.

  • Open Access

    Gradient-based optimization of scatterer arrangements based on the T-matrix method

    by N. Asadova, J. D. Fischbach, R. Vallée, O. Kuster, Y. Augenstein, D. Vovchuk, A. Kharchevskii, P. Ginzburg, C. Rockstuhl

    The demand for inverse design is increasing as the ability to fabricate sub-10 nm features expands the design space significantly. Efficient inverse design benefits from differentiable models of light–matter interaction. While traditional full-wave solvers based on finite differences, finite elements, or Fourier modal methods have already been presented for that purpose, a dedicated tool adapted for performing multiple scattering simulations is still lacking. To overcome this limitation, we provide a multiple-scattering framework compatible to automatic differentiation, suitable for treating periodic and non-periodic arrangements of scatterers. It yields exact gradients regarding geometric and positional parameters in finite clusters and infinite metasurfaces. In this work, we use spheres as the building blocks to demonstrate the framework’s capabilities as a standalone tool. However, the framework is adaptable to arbitrarily shaped scatterers, provided the individual T-matrices are calculated using differentiable Maxwell solvers. Since the gradients are obtained simultaneously in a single backward pass, the framework is well-suited for moderately dimensional problems. It is also possible to combine multiple performance goals into a single objective function. The versatility of our method is illustrated in proof-of-concept examples that focus on Kerker-type physics. In the first example, a finite cluster of scatterers is optimized in order to reach a high forward-to-backward scattering ratio and we show experimental feasibility of the designs. In the second example, a metasurface made from multiple scatterers per unit cell is designed to maximize the reflectance contrast between orthogonal linear polarizations of the incident light. We make the framework publicly available at https://github.com/tfp-photonics/dreams.


  • Open Access

    Experimental Demonstration of Radio‐Frequency Hong‐Ou‐Mandel Interference With Emulated Single‐Photon States

    by A. Sheleg, D. Vovchuk, K. Boiko, P. Ginzburg, G. Slepyan, A. Boag, A. Mikhalychev, A. Ulyanenkov, T. Salgals, D. Mogilevtsev

    We report an experimental demonstration of room‐temperature Hong–Ou–Mandel (HOM) interference at a radio‐wave frequency of 120 MHz using single‐photon states built from phase‐averaged coherent states by the emulation procedure proposed in the recent work. This emulation approach enables observation of quantum effects in spectral regimes where conventional single‐photon sources and detectors are unavailable or require cryogenic conditions. By constructing a high‐fidelity approximation of a single‐photon state with phase‐averaged coherent states, we observe the normalized second‐order intensity correlation dips significantly below the classical limit of 0.5. The method allows for tunable noise suppression via optimization of the state representation. Our results establish the feasibility of using conditionally prepared classical states to simulate quantum interference phenomena in the radio‐frequency domain.

  • Open Access

    Radar QR Code Based on Metasurfaces With Phase-Gradient Dispersion

    by Assaf Stav, Dmytro Vovchuk, Konstantin Grotov, Mykola Khobzei, Vladyslav Tkach, Vjaceslavs Bobrovs, Pavel Ginzburg

    Coded radar reflectors are increasingly employed in applications requiring reliable identification, tracking, and improved signal integrity. In contrast to conventional active transponders, passive solutions offer greater robustness by placing the task of information retrieval on the radar interrogation system, thereby supporting the joint communication paradigm of enhancing the capabilities of existing channels. We introduce passive radar QR codes composed of engineered metasurface pixels, designed to interface with automotive FMCW radar systems widely deployed on modern vehicle platforms to enhance road safety. Designed for the 76-81 GHz automotive range, the metasurface pixels generate a strong reflection phase gradient across the band. We demonstrate that FMCW signal processing, which maps phase information to estimated range, interprets a phase chirp as an artificial shift in the detected target distance. Consequently, metasurfaces with distinct phase chirps encode information analogous to Braille, enabling radar systems with adequate angular resolution to decode them as QR codes. We validated this concept by designing and fabricating several phase-chirped metasurfaces on PCB substrates and characterizing their performance in an anechoic chamber. The single-ring metasurface design achieves approximately 330° of phase excursion and yields a measured artificial range shift of 7.43 cm over a 500 MHz band centered at 80 GHz. Multiple QR code patterns were constructed and successfully detected. To expand the dataset, data augmentation techniques were applied, and a custom-designed convolutional neural network (CNN) demonstrated strong detection capabilities for the proposed system. On an augmented dataset of 1024 QR code samples represented as 224×224×3 heatmaps, a ResNet50V2-based CNN exceeds 85% classification accuracy at SNR values of 10-15 dB and achieves a pixel position mean absolute error below 10% at SNR values above 15 dB. Radar QR codes hold promises for serving as passive Vehicle Identification Numbers (VINs), enabling direct interrogation by standard automotive radar systems and paving the way for secure, infrastructure-independent identification in future autonomous mobility scenarios.


  • Open Access

    Chaos-Based Dynamical Parameter Estimation for Physical Layer Authentication in Wireless IoT Networks

    by Ruslans Babajans, Darja Cirjulina, Sergejs Tjukovs, Sara Becchi, Jacopo Secco, Dmytro Vovchuk, Deniss Kolosovs, Dmitrijs Pikulins

    The proliferation of Internet of Things (IoT) devices and services creates not only significant benefits but also new security threats. Classical information encryption techniques are not suitable for resource-constrained edge modules, thereby generating the demand for lightweight and efficient data protection algorithms. This work presents a novel dynamical parameter estimation scheme for chaotic oscillators, applied to physical-layer authentication (PLA). The proposed approach relies on the receiver’s capability to estimate a selected parameter of the transmitter’s oscillator determined by circuit configuration from the received chaotic signal using a locally synchronized oscillator, thereby enabling secure authentication based on a hardware-encoded identifier. The scheme is intended to complement a chaos-based wireless sensor network (WSN) architecture, where sensor nodes (SNs) implement analog chaotic oscillators, and the gateway operates discrete-time models. The Vilnius chaotic oscillator was chosen to validate the proposed PLA scheme. A rigorous bifurcation analysis of analytical, SPICE and discrete oscillator models was first conducted to identify parameter regions that preserve chaotic dynamics, establishing correspondence between models to guarantee the feasibility of parameter estimation across implementations. The digital realization of the parameter estimator demonstrated accurate and stable operation, with a small and nearly constant estimation relative error not exceeding 1.01%. Key performance metrics were analyzed, including estimation time, precision, and noise robustness. A tradeoff between estimation speed and accuracy was identified, particularly under noisy channel conditions. Finally, the influence of the receiver’s native oscillator parameter on distinguishable transmitter parameter ranges was demonstrated, highlighting the configurability and security potential of the proposed system against unauthorized transmissions.


  • Open Access

    A Framework for Chaotic Signature Classification: Insights from Chua’s Circuit

    by Sara Becchi, Elisabetta Spinazzola, Serhii Haliuk, Fernando Corinto, Leon O. Chua, Fabio Pareschi, Dmytro Vovchuk, Jacopo Secco

    In this preliminary work we investigate the possibility to extract, from the analysis of a chaotic signal, a signature of the circuit that generated it. It is widely known that even small deviations in parameters of a chaotic circuit are reflected into generated signals with different dynamics and characteristics, not detectable by simple inspection and impossible to reproduce in another circuit. Being able to identify these differences, and being also able to verify if a sequence has been effectively generated by a given circuit will pave the way to new applications of chaotic circuits including, but not limiting to, security applications. In this paper we consider Chua’s circuit, that is one of the simplest known chaotic circuits, and we show that by using deep learning and time-frequency transformations it is possible to extract a signature from chaotic sequences. Results are provided using two simulated datasets, and also one experimental dataset acquired from four hardware realizations of Chua’s circuit. All signals are transformed into Short-Time Fourier Transform and classified with Convolutional Neural Network (CNN) models, achieving 98% macro-averaged balanced accuracy across the evaluated test sets, including 424 chaotic parameterizations, unveiling a data-driven route to fingerprint chaos. As additional results, gradient-based interpretability and Permutational Multivariate Analysis of Variance (PERMANOVA) based statistical analysis are provided to support distinctive time-frequency features of the signatures.