GPGiona Preisig

Giona Preisig

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Giona Preisig has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A Tool for Forecasting the Arrival Time of a Tracer or a Pollutant at a Karst Spring

    by Giona Preisig, Léa Perrochet

    Karst aquifers are a groundwater resource of global importance. Protection and contamination of karst water resources are often tackled by means of land‐use planning and monitoring of physico‐chemical and microbial water properties coupled to early‐warning systems. However, these solutions of management do not integrate observational data on karst hydrodynamic, for example, tracer tests. Thus, this technical note aims at introducing a straightforward method for forecasting the arrival time of a tracer or a pollutant at a karst spring. Deliverables from the proposed method can assist professionals in the case of a pollution involving a swallow hole of the karst network. The approach is based on repeated tracer testing, gauging of spring flow rate and mathematical curve fitting. Tracer tests and gauging of spring flow rates are repeated under low, middle, and high flow periods. Arrival times of tracer from a given swallow hole of the network are plotted as a function of measured flow rates at the karst spring. The observational data are finally fitted by a mathematical function. Flow rate monitoring at high‐temporal resolution at the karst spring and the mathematical functions allow forecasting the arrival of a tracer or a pollutant at the spring in the case of an accident involving a swallow hole of the network or estimating the duration of a pollution if hydrodynamic conditions do not change abruptly. The applicability of the method is documented by three study sites in Switzerland.


  • Long-term effects of deep-seated landslides on transportation infrastructure: a case study from the Swiss Jura Mountains

    by Giona Preisig

    Deep-seated landslides (DSLs) involve large-scale deformation and likely affect transportation infrastructure. Movement rates are in general very slow (less than a metre per year) with acceleration periods controlled by external factors such as the seasonal fluctuation of groundwater pressure. Acceleration response may change from season to season depending on hydrogeological conditions, changes in slope geometry and degradation of geological materials. More localized landslide types are associated with and develop within DSLs, such as rock falls, topples and debris slides. Management of hazards related to DSLs requires first the assessment of geological, hydrogeological and geomechanical processes. This is the starting point for developing a management strategy. This paper presents the characterization of a deep-seated landslide located in the Swiss Jura Mountains, Les Buges landslide, where a railway line, a power line and an aqueduct of regional importance cross the slide, as well as a highly frequented hiking trail beneath the landslide toe. Slide kinematics is governed by the geology and hydrogeology of the slope, which can be subdivided into two dominant bodies. A management strategy is subsequently discussed for this DSL. Les Buges is a good example illustrating that hazards related to deep-seated landslides must be tackled first of all by means of the observational method.


  • Regional Flow and Deformation Analysis of Basin‐Fill Aquifer Systems Using Stress‐Dependent Parameters

    by Giona Preisig, Fabien Joel Cornaton, Pierre Perrochet

    Changes in effective stress due to water pressure variations modify the intrinsic hydrodynamic properties of aquifers and aquitards. Overexploited groundwater systems, such as basins with heavy pumping, are subject to nonrecoverable modifications. This results in loss of permeability, porosity, and specific storage due to system consolidation. This paper presents (1) the analytical development of model functions relating effective stress to hydrodynamic parameters for aquifers and aquitards constituted of unconsolidated granular sediments, and (2) a modeling approach for the analysis of aquifer systems affected by effective stress variations, taking into account the aforementioned dependency. The stress‐dependent functions were fit to laboratory data, and used in the suggested modeling approach. Based on only few unknowns, this approach is computationally simple, efficiently captures the hydromechanical processes that are active in regional aquifer systems under stress, and readily provides an estimate of their consolidation.


  • Modelling Discharge Rates and Ground Settlement Induced by Tunnel Excavation

    by G. Preisig, A. Dematteis, R. Torri, N. Monin, E. Milnes, P. Perrochet


  • Open Access

    Regional Flow Simulation in Fractured Aquifers Using Stress-Dependent Parameters

    by G. Preisig, F. J. Cornaton, P. Perrochet

    A model function relating effective stress to fracture permeability is developed from Hooke's law, implemented in the tensorial form of Darcy's law, and used to evaluate discharge rates and pressure distributions at regional scales. The model takes into account elastic and statistical fracture parameters, and is able to simulate real stress-dependent permeabilities from laboratory to field studies. This modeling approach gains in phenomenology in comparison to the classical ones because the permeability tensors may vary in both strength and principal directions according to effective stresses. Moreover this method allows evaluation of the fracture porosity changes, which are then translated into consolidation of the medium.

  • Regional Flow Simulation in Fractured Aquifers Using Stress‐Dependent Parameters

    by Giona Preisig, Fabien Joel Cornaton, Pierre Perrochet

    A model function relating effective stress to fracture permeability is developed from Hooke's law, implemented in the tensorial form of Darcy's law, and used to evaluate discharge rates and pressure distributions at regional scales. The model takes into account elastic and statistical fracture parameters, and is able to simulate real stress‐dependent permeabilities from laboratory to field studies. This modeling approach gains in phenomenology in comparison to the classical ones because the permeability tensors may vary in both strength and principal directions according to effective stresses. Moreover this method allows evaluation of the fracture porosity changes, which are then translated into consolidation of the medium.